• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 1999.05a
• /
• pp.420-424
• /
• 1999

In this paper, an optical switching circuit and several types of all-optical transmitter/receiver circuits which are configured with photodiodes, multiple quantum-well(MQW) optical modulators, and field-effect transistors(FETs) were simulated using PSPICE and their results of these are examined and discussed. 20 $\mu\textrm{m}$ ${\times}$ 20 $\mu\textrm{m}$ of window size was used for the optical modulators and 100 $\mu\textrm{m}$ wide FETs with the transconductance value of 55 mS/mm were used for the simulations. Simulation results clearly show that in order for the high speed operation of the all-optical circuits, the size of each device should be minimized to reduce the parasitic capacitance, the circuits should be designed to operate at the wavelength where the resposivity of photodiodes becomes the maximum peak, and the use of short, high-intensity input optical signal beams is very advantageous.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.49 no.1
• /
• pp.85-91
• /
• 2012

In this paper, we implemented a Ka-band frequency synthesizer for millimeter wave seeker. we designed for high frequency resolution and frequency hopping response time in the digital synthesis method which uses DDS(Direct Digital Synthesizer). but frequency bandwidth was limited low frequency because DDS output frequency was limited 1/2 by system clock. thus, frequency synthesizer was converted to Ka-band using the frequency multiplier ${\times}4$ and local oscillator. proposed frequency synthesizer was bandwidth 500MHz, frequency switching time was $0.7{\mu}s$, spurious level was suppressed below -52dBc. phase noise was -99dBc/Hz at offset 100kHz and flatness was ${\pm}1dB$.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.32 no.8C
• /
• pp.775-781
• /
• 2007

In this paper, a modified PTS(Partial Transmit Sequences) technique that uses erasure decoding of RS (Reed-Solomon) codes is presented. At the transmitter, some check symbols in a RS codeword partitioned into subblocks are phase-rotated by phase factors. The receiver decodes received codewords by regarding the phase-rotated check symbols as erasures. Hence, this technique does not need to transmit the side information about the phase factors chosen at the transmitter. The complexity of the receiver is also reduced since the estimation process for the phase factors is not required in the receiver. There is no performance degradation due to the transmission error of the side information or the estimation error of the phase factors. To evaluate the performance of the proposed PTS technique, the CCDF(Complementary Cumulative Distribution Function) of PAPR and the BER(Bit Error Rate) are compared with those of the conventional PTS techniques.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.49 no.7
• /
• pp.30-38
• /
• 2012

This paper presents packet detection, frequency offset estimation architecture and performance analysis for OFDM-based wireless personal area network (WPAN) systems. Packet detection structure is used to find the start point of a packet exactly in WPAN system as the correlation value passes the constant threshold value. The applied autocorrelation structure of the algorithm can be implemented simply compared to conventional packet detection algorithms. The proposed frequency offset estimation architecture is designed for phase rotation process structure, internal bit reduction to reduce hardware size and the frequency offset adjustment block to reduce look-up table size unlike the conventional structure. If the received signal can be compensated by estimated frequency offset through the correction block, it can reduce the impact on the frequency offset. Through the performance result, the proposed structure has lower hardware complexity and gate count compared to the conventional structure. Thus, the proposed structure for OFDM-based WPAN systems can be applied to the initial synchronization process and high-speed low-power WPAN chips.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.19 no.5
• /
• pp.805-814
• /
• 1994

In this paper, we introduce a new method which is available for analyzing the throughput of the packet radio network by using the auxiliary Markov transient matrix with a failure state and a success state. And we consider the effect of symbol error for the network state(X, R) consisted of the number of transmitting PRU X and receiving PRU R. We examine the packet radio network of a continuous time Markov chain model, and the direct sequence binary phase shift keying CDMA radio channel with hard decision Viterbi decoding and bit-by-bit changing spreading code. For the unslotted distributed multi-hop packet radio network, we assume that the packet error due to a symbol error of radio channel has Poisson process, and the time period of an error occurrence is exponentially distributed. Through the throughputs which are found as a function of radio channel parameters, such as the received signal to noise ratio and chips of spreading code per symbol, and of network parameters, such as the number of PRU and offered traffic rate, it is shown that this composite analysis enables us to combine the Markovian packet radio network model with a coded DS/BPSK CDMA radio channel.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.38 no.4
• /
• pp.302-312
• /
• 2001

As the data transfer rate between chips gets higher, both crosstalk and SSN (Simultaneous Switching Noise) deteriorate seriously the performance of a system. The proposed interface scheme uses P-CTR and N-CTR(Positive/Negative Constant Transition Rate) which encodes data at both falling and rising edges, where the transition directions of N-CTR and P-CTR are opposite. And the proposed bus system places two P-CTR drivers and two N-CTR drivers alternatively. In the proposed P/N-CTR interface scheme, the signals of neighboring interconnection lines at both sides of a bus will not switch simultaneously in the same direction, which leads to reduction in the maximum crosstalk and SSN compared to conventional interfaces. For verification of noise reduction of the proposed interface scheme, the scheme is applied to several kinds of bit-wide buses with various interconnection structures, and HSPICE simulation was performed with 0.35 ${\mu}{\textrm}{m}$ SPICE parameters. The simulation results show that in the 32-bit or less wide bus, the maximum SSN and crosstalk are reduced to at least 26.78% and 50%, respectively in comparison with the conventional interface scheme.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.19 no.4
• /
• pp.712-720
• /
• 1994

In digital mobile communication systems, the convolutional coding is considered as the optimum error correcting scheme. Recently, the Viterbi algorithm is widely used for the decoding of convolutional code. Most Viterbi decoder has been proposed in conde rate R=1/2 or 2/3 with memory components (m) less than 3. which degrades the error correcting capability because of small code constraints (K). We consider the design method for typical code rate R=1/2, K=7(171,133) convolutional code with memory components, m=6. In this paper, a novel construction method is presented which combines maximum likelihood decoding with a state transition double detection and comparison method. And the designed circuit has the error-correcting capability of random 2 bit error. As the results of logic simulation, it is shown that the proposed Viterbi decoder exactly corrects 1 bit and 2 bit error signal.

• Proceedings of the Korea Water Resources Association Conference
• /
• 2019.05a
• /
• pp.259-259
• /
• 2019

시계열 자료들을 분석하고자 하는 경우 자료가 정상성(stationarity)을 만족하는 경우는 드물다. 특히 계절성을 제거한 자료들에서는 정량화하기 어려운 주기성이 많이 관찰된다. 즉, 어떤 특정지역에서 나타나는 현상이 다른 기상 현상에 영향을 미칠 것은 자명한 일이나 그 관련성이 선형(linearity)일 가능성은 극히 드물다. 따라서 그들 사이의 관련성이 선형성에 근거한 지표들로 정량화되어야 한다. 이러한 문제점을 해결하기 위해서 다양한 방법이 사용되며 그중에서 웨이블릿 분석을 통해 본 연구를 진행하였다. 웨이블릿 변환(wavelet transforms)은 특수한 함수의 집합으로 구성되어 기존 웨이블릿 신호의 분석을 위해 사용되는 방법이다. 이 변환은 푸리에 변환에서 변형된 방법으로 특정한 기저 함수(base function)를 이용하여 기존의 시계열 자료를 주파수로 바꾸는 변환이다. 웨이블릿 변환에서 기저 함수를 모 웨이블릿이라고 하며 이를 천이, 확대 및 축소 과정을 통해 주파수를 구성한다. 웨이블릿 분석은 모 웨이블릿을 분해하고 재결합하여 시계열 분석을 할 수 있다. 모 웨이블릿 함수에는 Haar, Daubechies, Coiflets, Symlets, Morlet, Mexican Hat, Meyer 등의 여러 가지 종류의 모 웨이블릿 함수가 있으며 모 웨이블릿이 달라지면 결과가 다르게 나타난다. 기존에는 Morlet 웨이블릿을 주로 이용하여 주파수분석에 사용하여 결과를 도출하였다. 그리고 시계열 자료는 크게 백색잡음(White Noise), 장기기억(Long Term Memory), 단기기억(Short Term Memory)으로 나뉜다. 각 시계열 자료의 종류에 따라 임의의 시계열 자료를 산정하여 그에 따른 웨이블릿 분석을 통해 모 웨이블릿의 특성을 도출하였다. 본 연구에서는 웨이블릿 분석을 통해 시계열 자료의 최적 모 웨이블릿을 결정하고자 남방진동지수(SOI), 북극진동지수(AOI)의 자료를 이용하여 웨이블릿 분석을 시도하였다. 웨이블릿 분석은 모 웨이블릿에 따라 달라지는 결과를 토대로 분석하였으며 이를 정상성과 지속성에 따라 분류된 시계열에 적용하여 최적 모 웨이블릿을 결정하고자 하였다. 본 연구에서는 임의의 시계열 자료에서 설정한 최적의 모 웨이블릿을 AOI와 SOI와 같은 실제 시계열 자료에 대입하여 분석을 진행하였다. 본 연구에서는 시계열 자료의 종류를 구분하고 자료의 특성에 따라 가장 적합한 모 웨이블릿을 구하고자 하였다.

• The Journal of the Acoustical Society of Korea
• /
• v.33 no.1
• /
• pp.10-20
• /
• 2014

To study the water-entry impact noise, on-board experiment using a small launcher firing various objects was performed in the Yellow Sea. As the launcher fires a cylindrical object from the ship vertically, generated noise is measured with a hydrophone on the starboard of Chung-hae, Marine surveyor. Three types of cylindrical objects, which have noses of flat-faced, conical, and hemisphere, were used during the experiment. The measured noise exhibits a time-dependency which can be divided into three phases: (1) initial impact phase, (2) open cavity flow phase, (3) cavity collapse and bubble oscillation phase. In most cases, the waveform of bubble oscillation phase is dominant rather than that of initial impact phase. Pinch-off time, where a cavity begins to collapse, occurs at 0.18 ~ 0.2 second and the average lasting time of bubble was 0.9 ~ 1.3 second. The energy of water-entry impact noise is focused in the frequency region lower than 100 Hz, and the generated noise is influenced by the nose shapes, object mass, and launching velocity. As a result, energy spectral density on the bubble frequency is higher in the order of flat-faced, conical, hemisphere nose, and the increase of initial energy raises the energy spectral density on the bubble frequency in the cylinder body of same shape. Finally, we compare the measurements with the simulated signals and spectrum based on the bubble explosion physics, and obtain satisfactory agreements between them.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.27 no.8A
• /
• pp.739-752
• /
• 2002

Recently, to utilize the limited bandwidth effectively, the concept of partial response (PR) signaling has widely been adopted in both the high-speed data transmission and high-density digital recording/playback systems such as digital microwave, digital subscriber loops, hard disk drives, digital VCR's and digital versatile recordable disks and so on. This paper is concerned with adaptive equalization of partial response channels particularly for the magnetic recording channels. Specifically we study how the PR channel equalizers work for different choices of desired or reference signals used for adjusting the equalizer weights. In doing so, we consider three different configurations that are actually implemented in the commercial products mentioned above. First of all, we show how to compute the theoretical values of the optimum Wiener solutions derived by minimizing the mean-squared error (MSE) at the equalizer output. Noting that this equalizer MSE measure cannot be used to fairly compare the three configurations, we propose to use the data MSE that is computer just before the final detector for the underlying PR system. We also express the data MSE in terms of the channel impulse response values, source data power and additive noise power, thereby making it possible to compare the performance of the configurations under study. The results of extensive computer simulation indicate that our theoretical derivation is correct with high precision. Comparing the three configurations, it also turns out that one of the three configurations needs to be further improved in performance although it has an apparent advantage over the others in terms of memory size when implemented using RAM's for the decision feedback part.