• Journal of Korean Society of Transportation
• /
• v.21 no.4
• /
• pp.67-77
• /
• 2003

The purpose of this study is to provide the criteria for implementing unprotected left turn at intersections with variation of traffic volume on a cross road approach. Using Transyt-7F model, the delays calculated from permissive and protected left turn signal system were compared by gradually increasing the left turn volume for a certain opposing through volume up to the volume limits to which permissive left turn is more effective, Average stopped delay of the intersection was used as the measure of effectiveness in this study. The major conclusions are (1) the lighter the traffic gets in a cross road, the more the allowable left turn volume increases. The allowable left turn volume when the ratio of cross traffic to the concerned approach traffic is 0.6 appears about 50% more than the volume when the ratio is 1.0. (2) Comparing to the criteria of the manual of traffic safety facility, the results when the traffic ratio is 0.6 seem to be most similar the criteria of manual and the results when the traffic ratio are 0.8 and 1.0 appears to be lower than the criteria of manual. (3) The possible amount of making a left turn that is inversely proportional to the opposing through traffic, decreases as the number of opposing through lanes increases. The products of volume need to be used as the criteria of permissive left turn with considerable cautions because of its low consistency.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.9 no.6
• /
• pp.94-104
• /
• 2010

The capacity of highway is restricted and traffic congestion is caused by increasing traffic demand. Also, greenhouse gases are increased by traffic congestion. CDM (Clean Development Mechanism) is an idea of interest to reduce greenhouse gases. However, CDM's cases applied in traffic field are rare. Thus, it is necessary that methodology to reduce greenhouse gas should be developed and applied to CDM. A methodology for identifying greenhouse gas emissions was developed in this paper. This methodology was developed on the basis of baseline methodology registered at UN. Travel time and speed in the conventional traffic condition and in the automated traffic condition are compared by BPR function. The calculated speed applied to emission factor equation and then $CO_2$ emissions was calculated. A simulation was executed to evaluate the validity of the developed methodology. In the result, advanced vehicle's $CO_2$ emissions are more than conventional vehicle's $CO_2$ emissions in the stable flow condition. However, advanced vehicle's $CO_2$ emissions are less than conventional vehicle's $CO_2$ emissions in the unstable flow condition. It is assure that capacity of highway is enhanced and efficiency of highway is improved by adopting advanced safety vehicle in the smart road.

• Journal of the Earthquake Engineering Society of Korea
• /
• v.12 no.6
• /
• pp.47-53
• /
• 2008

This research focuses on the issue of seismic retrofit prioritization based on the Caltrans' highway network serving Los Angeles and Orange counties. Retrofit prioritization is one of most important problems in earthquake engineering, and it is a problem that most decision makers face in the process of resource allocation. This study demonstrates the methods of prioritized resource allocation in the process of retrofitting a regional highway network. For the criteria of a retrofit ranking, seismic vulnerability and the importance of network link are first introduced. Subsequently, link-based seismic retrofit cases are simulated, investigating the effects of the seismic retrofit in terms of seismic performance, such as driver's delay. In this study, probabilistic scenario earthquakes are used to perform a probabilistic seismic risk analysis. The results show that the retrofit prioritization can be differently defined and ranked depending on the stakeholders. This study provides general guidelines for prioritization strategy for the effective retrofitting of a highway network system.

• Journal of Practical Engineering Education
• /
• v.14 no.2
• /
• pp.341-350
• /
• 2022

In this paper, we propseded the Youngwoo keyboard to help the communication disorders experienced by patients with dysarthria. Existing methods for communication by patients with dysarthria include a letter board with consonants and vowels, a mouse using eye tracking, and communication assistance applications. However, there was a delay of more than 5 minutes per sentence, so there were many difficulties in communication. However, unlike the existing method, the proposed method has been improved so that the patient with dysarthria can communicate by completing the sentences with eye movements. In the conclusion and future work of this paper, the educational use value for Yeongwoo keyboard was analyzed, and it was shown that this training can be of great help to families with ALS patients. The proposed keyboard will be able to improve the difficulties of families by facilitating communication of patients with dysarthria.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.20 no.4
• /
• pp.224-231
• /
• 2019

The current paper was conducted to unravel the influence of affect induction as a background emotion in the process of cognitive task to judge the degree of sequence in groups with or without anxiety symptoms. Four types of affect induction and two sequential task types were used as within-subject variables, and two types of college students groups classified under the Beck Anxiety Inventory (BAI) as a between-subject variable were selected to determine reaction times involving sequential judgment among the lexical relevance information. DmDx5 was used to present a series of stimuli and elicit a response from subjects. Repeated measured ANOVA analyses revealed that reaction times and error rates were significantly larger with anxiety participants compared to the normal group regardless of affect and task types. Within-subject variable effects found that specific affect type (sorrow condition) and number-related task type showed a more rapid response compared to other affect types and magnitude-related task type, respectively. In sum, these findings confirmed the difference in tendency with reaction time and error rates that varied as a function of accompanying affect types as well as anxiety level and task types suggesting the that underlying background affect plays a major role in processing affect-cognitive association tasks.

• Proceedings of the Korea Water Resources Association Conference
• /
• 2023.05a
• /
• pp.371-371
• /
• 2023

담양 및 화순 홍수조절지는 홍수 시 본류에 계획방류량만 흘러가도록 제수문을 운영하고, 계획방류량을 초과하는 홍수량은 하도 및 조절지 내에 저류하여 홍수를 지체시킨 후 저류된 홍수량은 첨두홍수가 지나간 이후 방류하는 방법으로 영산강 유역의 홍수를 방어하기 위해 '12년 건설되었다. 그러나 홍수조절지는 200년 빈도의 홍수량을 저감 시키도록 설계됨에 따라 준공 이후 10년간 '20년 8월 홍수 등 3회만 홍수방어용으로 활용되었다. 영산강은 오염부하량 대비 유출량 부족 등으로 수질관리에 취약하고 하천유지용수를 공급하는 다목적댐이 없는 등 수자원 확보가 어려우므로, 비홍수기 홍수조절지에 환경대응용수를 담수 및 방류하여 영산강의 유량확보 및 수질개선 등 활용 다변화 방안을 모색하고자 한다. 이와 관련하여 '16년 및 '19년에 시범담수를 실시하였으나, 담수 수질 관리의 어려움, 방류 전후 강우 등 제한적 여건으로 인해 하류 유량증가 및 수질 개선 효과의 확인은 어려웠으며, 제방 물비침 등을 발견하여 시설 안정성 확보가 필요한 것으로 확인되었다. '21년 안정성 확보를 위한 보강 그라우팅을 시행했으며, '19년부터 '21년 2월까지 「홍수조절지를 활용한 영산강 수질개선 방안」연구용역을 실시하여, 비홍수기 활용방안을 수립하였다. '21년 4/4분기 댐과 보 등의 연계운영협의회에 '시범담수 계획' 안건 상정 및 의결을 거쳤고, '22년 3월 25~26일까지 담양 74mm, 화순 61mm 비가 내려 담양 63만m³, 화순 151만m³를 담수하고 18~19일간 저류 후 담양은 평균 3.0m³/초로 25시간 동안, 화순은 평균 5.0m³/초로 32시간 동안 하류로 방류하였다. 방류 후 담양·화순 모두 가까운 하류 수위국 수위 상승을 확인했으며, 화순의 경우 하류 수질에 일부 영향이 있음을 확인하였다. 다만, 초기유출수 배제 등을 고려하지 않아 담수의 수질이 본류보다 좋지 않았으며, 이에 따라 수질 영향의 인과관계 확인이 어려웠다. 기존 연구용역에서 제시한 비홍수기 활용방안의 검증·보완을 위한 연구용역이 '22.5월부터 '23.12월까지 진행될 예정이며, 초기유출수 배제를 위한 조건 재수립, 수질 모니터링지점 확대 등 보완된 '시범담수 계획'을 '23.3월 댐과 보 등의 연계운영협의회에 보고하였다. 연말까지 연구용역과 연계한 시범담수·방류 시행 및 모니터링·효과분석을 통해 비홍수기 홍수조절지 최적운영방안을 마련할 계획이다.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.1 no.1
• /
• pp.58-69
• /
• 2002

Most of the traffic accidents are a rear-end collision and a clash generated in the signalized intersection on the local roads. So, it is demanded that the high-quality of signal control and dilemma zone control. According to the cases generated by foreign countries, we established the strategies which are composed of Volume-Density Control, strategy of the dilemma zone control using R-detector (microwave detector) In Japan and EC-DC Control. MOEs(Measure of effectiveness) are car numbers in the dilemma zone , max-out probability in the safe side and the average stopping delay in the progress side. We choose a signalized intersection in rural highway to analyze the effect of the strategies and practiced an on-the-spot survey. The result of the survey is applied to the basic data in the simulator. Consequently, strategy of the dilemma zone control using R-detector(microwave detector) in Japan is the best effective in the safe side and EC-DC control is the best in the progress side. Based on the result, we developed the effective strategy of the signal control . This strategy is composed of the strategy of Japan and the detector on the stopping line used in the EC-DC control. On the result of the analysis, new strategy is the best effective in two sides.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.41 no.3
• /
• pp.229-235
• /
• 2021

Globally, due to climate change and urbanization, problems with water cycle destruction in urban areas frequently occur. In order to solve this problem, LID technique is being actively conducted the application in urban and research. In this study, some areas of the new city located in Busan was constructed using a widely used SWMM model to verify the effectiveness of the LID technique. This is to present a plan to maximize the efficiency of urban water cycle of the stormwater management target figure and the LID scale calculation method. In addition, the efficiency of runoff reduction using stormwater storage basin was analyzed in urban development projects. By calculating the scale of customized LID for each sub basin, the amount of runoff and peak runoff after LID application was reduced by 86.8 % and 69.5 %, respectively. Depending on the application of the stormwater storage basin, the reduction effect of peak runoff from 0.5 m³/s to 4.9 m³/s and delay effect of 8 minutes to 10 minutes was shown.

• Analytical Science and Technology
• /
• v.11 no.2
• /
• pp.112-119
• /
• 1998

A Siemens SemiQuant (SSQ) 3000 program, a precalibrated 'standardless' analytical program handling up to 90 elements, was evaluated for the fast analysis of various types of reference materials using a wavelength dispersive X-ray spectrometer. Various types of standard reference materials such as metal discs, metal chips, and geological materials in powder form were analysed and it took 23 minutes of measuring time for 75 elements. Measurements of geological reference materials using different sampling methods were carried out and their data were interactively evaluated. The analysis of materials of a known matrix concentration such as stainless steels provided higher precision value compared to totally unknown samples. The analyses of materials prepared as pressed pellets or fused glass beads provided higher precision values compared to the measurement of loose powders with a foil on the sample surface and helium operation, though their sampling procedures were more complicate and took more time. Since very light elements such as boron, carbon, and oxygen have a strong influence on the matrix effects and also on the calculation of effective matrix corrections, the rhodium Compton check was applied to verify the reliability of the defined light element concentrations of light matrix materials and the defined major sample compounds. Failure of defining correct matrix resulted in an unoptimized matrix correction and therefore in the wrong calculation of the element concentration.

• Journal of Korean Society of Transportation
• /
• v.33 no.1
• /
• pp.70-80
• /
• 2015

In recent years, tram has been the focus of a new mode of public transportation that can solve traffic jams and decrease public transit usage and environmental problem. This research is in the works to develop a tram signal controller and signal control strategies, and aim to resolve the problem of what could happen if a tram system was installed in general road. We developed the hierarchical signal control strategies to obtain a minimum tram bandwidth and to minimize vehicle delay, in order to perform a priority control to include passive and active signal priority control strategies. The strategies was produced for S/W and H/W, it is based in standard traffic signal controller. We conducted a micro simulation test to evaluate the hierarchical signal control strategies, which showed that the developed optimization model is effective to prevent a tram's stop in intersection, to reduce a tram's travel time and vehicle's delay.