• Composites Research
• /
• v.35 no.6
• /
• pp.425-430
• /
• 2022

In this study, the mechanical properties of the pressure vessel composite exposed to the thermal environment were evaluated to establish the standard for high temperature static pressure test of the pressure vessel for hydrogen bus. As the tensile strength of the composite material approaches the glass transition temperature of the epoxy resin, the strength decreases due to the deterioration of the epoxy resin. In addition, it was confirmed that the tensile strength increased again due to the post-curing of the epoxy resin during long-term exposure. Therefore, the accelerated stress rupture test conditions of the pressure vessel for the hydrogen bus should be set based on the epoxy resin properties of the carbon fiber composite material.

• Journal of Environmental Science International
• /
• v.16 no.2
• /
• pp.179-185
• /
• 2007

Nitrous oxide ($N_2O$) is an important trace gas in the atmosphere not only because of its large global warming potential (GWP) but also because of the role in the ozone depletion in the stratosphere. It has been known that soil is the largest natural source of $N_2O$ in global emission. However, anthropogenic sources contributing from industrial section is likely to increase with rising the energy consumption, and transportation as well. In this study, a total of 32 gasoline-powered passenger vehicles (ranging from small to large engine's displacement and also ranging from aged catalyst to new catalyst) were tested on the chassis dynamometer system in order to elucidate the characteristics of $N_2O$ emission from automobiles under different driving modes. Ten different driving modes developed by NIER were adapted for the test. The results show that the $N_2O$ emission decreases logarithmically with increase of vehicle speed over the all test vehicles ($N_2O$) emission = -0.062 Ln (vehicle speed) + $0.289,\;r^2=0.97$). It revealed that the larger engine's displacement, the more $N_2O$ emission were recorded. The correlation between $N_2O$ emission and catalyst aging was examined. It found that the vehicles with aged catalyst (odometer record more than 8,0000km) emit more $N_2O$ than those with new catalyst. Average $N_2O$ emission was $0.086{\pm}0.095\;N_2O-g/km$ (number of samples=210) for the all test vehicles over the test driving modes.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.15 no.2
• /
• pp.58-64
• /
• 2007

As the concerns regarding global worming were increased, the pressure of greenhouse gas(GHG) emission reduction on mobile source was also increased. Carbon dioxides contribute over 90% of total GHG emission and the mobile source occupies about 20% of this $CO_2$ emission. Therefore automotive exhaust is suspected to be one of the major reasons of the rapid increase in greenhouse effect gases in ambient air. In this study, in order to investigate $CO_2$ emission characteristics from gasoline passenger cars(PC), which is the most dominant vehicle type in Korea, 106 vehicles were tested on the chassis dynamometer. $CO_2$ emissions and fuel efficiency were measured. The emission characteristics by displacement, gross vehicle weight, vehicle speed and CVS-75/vehicle speed mode were discussed. Test modes were vehicle speed modes and CVS-75 mode that have been used to develop emission factors and to regulate for light-duty vehicle in Korea. It was found that $CO_2$ emissions showed higher large displacement, heavy gross vehicle weight, low vehicle speed and CVS-75 mode than small displacement, light gross vehicle weight, high vehicle speed and vehicle speed mode, respectively. From these results, correlation between $CO_2$ emission and fuel efficiency was also determined. The results of this study will contribute to domestic greenhouse gas emissions calculation and making the national policy for climate change.

• Resources Recycling
• /
• v.23 no.5
• /
• pp.44-54
• /
• 2014

A standard plastic garbage bag which was discarded from Incheon Metropolitan City was composed of 4.5% recyclable resources (aluminum cans 0.2%, steel cans 2.5%, glass 1.8%), 92.5% resources with recoverable energy (papers 23.0%, plastics 15.5%, combustible etc. 54.0%) and 3.0% non-combustible etc. Recycling is more effective than landfilling for aluminum cans, steel cans, and glass. The energy recovery process using solid refuse fuel (SRF) is more effective than incineration for papers and plastics. Incineration is more effective than recycling for combustible etc. 2,068,948 Million Btu of total energy savings and 21,008 $MTCO_2E$ of total GHG reductions were obtained by the application of the proposed scheme. The total energy savings were equivalent to an economic benefit of 422 billion won per year. The total GHG reductions were equivalent to a GHG benefit of 4,119 passenger cars not running per year. The lower calorific value of the combustible materials was obtained to be 1,936 kcal/kg of papers, 5,079 kcal/kg of plastics and 2,462 kcal/kg of combustible other resources, respectively. If papers and plastics are properly mixed, the mixture can be used as SRF. The lower calorific value of combustible other resources does not meet the quality criteria for refuse derived fuel, therefore its components are inappropriate to used as solid refuse fuel.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.44 no.3
• /
• pp.349-360
• /
• 2024

The purpose of this study is to analyze the performance of the road network according to the penetration rate of autonomous vehicles (AV) of Level 4 or higher and the change in traffic volume. First, prior studies related to vehicle control variables of AV were reviewed, and future traffic demand in 2040, which is predicted to have a 50 % market share of AVs, was reflected in the simulation analysis. In addition, the change in traffic flow of continuous and intermittent flows was analyzed by increasing the AV market penetration rate and traffic volume of passenger cars, trucks, and buses by 25 % step by step from 0 to 100 %. As a result of the analysis, it was confirmed that the travel time increased as the traffic increased, and the pattern of decreasing the travel time due to the increase in the share of AVs, that is, the development of technology, can also be confirmed. Furthermore, it was also confirmed that the traffic speed showed a trend of increasing as the share of AVs increased. In this study, it was confirmed that the law of diminishing marginal rate of substitution (MRS) was satisfied by calculating the MRS according to the combination of traffic volume and speed while increasing the market penetration rate of AVs. Furthermore, it was confirmed that the convexity of the indifference curve was also satisfied in both intermittent and continuous traffic flow environments.

• Resources Recycling
• /
• v.9 no.1
• /
• pp.27-35
• /
• 2000

Characteristics of pyrolytic gasification were examined for the waste tire and 7 types of waste synthetic resin, using a bench scale experimental facility. the product gas temperature of waste tires was $150~300^{\circ}C$ and the temperature profile in the combustion zone of the lower reactor part tended to be clearly distinguished from that in the gasification zone of the upper part. However, in the case of waste synthetic resins, there were no clear distinction and temperature fluctuation was severe, depending on the reaction time. Product gas quantity, which depends on that of supplied (1st) air, was found to be 105~135% of the 1st air amount at the steady state. The concentration of noncombustible components in product gas was 80~90 vol.% and the high heating value of the product gas calculated from gas compositions was 1,500~3,000 kcal/N㎥ for waste tire, and 300~2,900 kcal/N㎥ for waste synthetic resins, respectively. Heating value of product gas and combustible gas concentration were increased in proportion to 1st air amount when 1st air amount is below $0.35N\textrm{m}^3$/min.

• Journal of the Korean Society for Railway
• /
• v.17 no.3
• /
• pp.216-222
• /
• 2014

In general, the rail transportation recognized as a better transportation mode than road transportation in terms of the environment. However, due to a lack of quantitative analysis based on Korean data, foreign cases for environmental advantages of the railway have often been cited in Korea. To address this issue, we estimated the energy consumption of passenger and freight transportation using certified activity data from Korea Railroad Statistics and the Electrical Work Report for railway and the Energy Consumption Survey for road. We estimated the Green House Gas emission of passenger and freight transportation on a Tier 1 level by applying the IPCC 2006 Guideline. Finally, we calculated the energy consumption unit and GHG emission unit to determine the environmental impact of rail and road transportation. We also compared the analyzed results of high-speed rail and auto as typical means of rail and road transportation.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.13 no.2
• /
• pp.498-503
• /
• 2012

It happens that the fuel is not injected when the driver doesn't push the acceleration pedal of vehicle with engine speed higher than 1,500rpm above the mid range of vehicle speed. This is called "fuel-cut function" and almost every modern vehicle is equipped with this function. This is activated frequently on the downhill area of highway and the quantity of vehicle-exhausted $CO_2$ gas can be zero on this area. With this fuel-cut function on the test highway, $CO_2$ gas from passenger car(2,000cc engine volume) can be reduced up to 4%. The fuel-cut function with CRUISE made in company AVL is simulated to find the most effective driving pattern on the downhill area. By simulating with CRUISE software, it is found that the lower limit of vehicle speed for fuel-cut should be raised to improve the fuel economy on the steeper downhill road. The fuel economy can be most economical when fuel-cut driving and reacceleration are completed on the section of downhill road.

• Journal of Korean Society for Atmospheric Environment
• /
• v.28 no.4
• /
• pp.396-410
• /
• 2012

The purpose of this study is to quantify the contribution of high emitting vehicles to mobile emission inventories. Analyzed emission data include $NO_x$, HC, and CO results, which were measured through the vehicle Inspection and Maintenance (I/M) program in Seoul metropolitan area. The high emitting vehicles were identified as the top 5% worst polluting cars of the fleet. We estimated that 5% of the gasoline passenger car fleet, which is high emitters, generated 25.5% of $NO_x$, 34.5% of HC, and 66.1% of CO emissions of total inventories for gasoline passenger car fleet in year 2010. In the study, we identified that the older vehicles (older than ten years) and high mileage vehicles (more than 120,000 km driven) comprised high emitter fleet with 70.9% and 71.2%, respectively. The emission contribution of high emitters became larger in younger fleet than in the older fleet. This is due to the reduced emission rates in newly manufactured vehicles, which were developed under the more stringent emission regulation limits. This analysis implies that high emitters could be responsible for an even larger fraction of total vehicular emissions as more advanced technology vehicles are being incorporated into the current vehicle fleet. The findings suggested that the high emitting vehicles should be primarily considered for in-use vehicle emission management program, such as I/M, accelerated vehicle retirement, or catalytic converter replacement, in order to enhance the effectiveness of selected program.

• Journal of Korean Society of Transportation
• /
• v.34 no.6
• /
• pp.510-522
• /
• 2016

In studies involving public transport, social welfare improvement is simply explained by the increase in public transport demand. However, the increase in the demand for public transport is mostly observed by the change in the frequency of public transport service, and in-vehicle crowding in public transport has not been an object of concern. This study examines and tries to reveal the cause of the changes of the social welfare and in-vehicle crowding of the changing public transport from imposing congestion pricing. We observe that congestion pricing increases in-vehicle crowding in public transport. This predictable phenomenon is more exacerbated in case of not operating bus-only lane. It should be noted that in-vehicle crowding is more increased in suburban, but in First-best toll system it tends to get worse less than it in other congestion pricing systems. We identify that the change of in-vehicle crowding is affected by the change of proximity of the housing to workplace, the number of commuting trips, and unpredictable distortion effect of the congestion charge.