• 한국철도학회논문집
• /
• 제20권3호
• /
• pp.329-338
• /
• 2017

최근 철도차량용 보조전원장치는 시스템의 경량화를 위해 기존 60Hz 저주파 변압기를 제거하고 고주파 구동과 절연 특성을 갖는 '절연형 dc/dc 컨버터'를 적용하는 구조가 주목받고 있다. 본 논문에서는 '절연형 dc/dc 컨버터를 적용한 보조전원장치 구조'에 대해서 설명하고, 다양한 분석을 통해 보조전원장치의 고효율 및 경량화에 적합한 dc/dc 컨버터 및 구조를 제안하고자 한다. 대용량 IGBT 소자의 고주파 스위칭(경량화)을 위해 필수적인 '영전압-영전류-스위칭'특성을 갖는 '공진형 컨버터'를 활용하여 다양한 보조전원장치용 전력변환장치 구조(1-Stage와 2-Stage)를 제안하였고, 각각의 구조에 적합한 컨버터 회로를 선정한 후 설계 및 시뮬레이션을 통해 비교하였다. 1-Stage 구조의 경우 공진형 컨버터만을 사용하였고, 2-Stage 구조의 경우 공진형 컨버터와 공진형 컨버터의 입력전압 변동을 최소화하는 Pre-regulator를 적용하였다. Pre-regulator로서 감압 컨버터 또는 승압 컨버터를 각각 적용하여 서로 다른 2-Stage 구조를 구성하고 각 방식의 손실을 비교하였다. 회로에 사용되는 소자들의 전압 및 전류 스트레스를 고려하여 소자를 선정하고 시뮬레이션을 통해 동작을 검증하였으며, 손실 분석을 통해 고효율 및 경량화에 가장 적합한 구조 및 회로를 제안하였다.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2002년도 하계학술대회 논문집 B
• /
• pp.1123-1125
• /
• 2002

In this paper, interleaved boost converter is applied as a pre-regulator in switch mode power supply. Interleaved Boost Power Factor Preregulator (IBPFP) can reduce input current ripple as a simple voltage control loop only without inner current loop, because input current is divided each 50% by two switching devices. IBPFP can be classified as three cases from duty ratio condition in continuous current mode and be carried out state space averaging small signal modeling. According to modeling, the PID controller is applied and voltage control loop is constructed for suitable design condition. From frequency domain analysis, it is verified that control system is satisfied with design condition of switch mode power supply.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2011년도 제42회 하계학술대회
• /
• pp.1224-1225
• /
• 2011

This paper proposes a novel soft-switching interleaved boost converter composed of two shunted elementary PFC boost conversion units and an auxiliary inductor. This converter is able to turn on both the active power switches at zero voltage to reduce their switching losses and evidently raise the conversion efficiency and power factor. Since the two parallel-operated elementary boost units are identical, operation analysis and design for the converter module becomes quite simple. A laboratory test circuit is built, and the circuit operation shows satisfactory agreement with the theoretical analysis. The performance of the proposed PFC rectifier was evaluated on an experimental 300[W] PFC prototype.

• 전기학회논문지
• /
• 제58권7호
• /
• pp.1405-1410
• /
• 2009

Output voltage of a DC/DC power converter system is likely to be distorted if variable loads exist in the output terminal. This paper presents a new disturbance observer(DOB) approach to maintain a robust regulation of the output voltage of a boost type DC/DC converter. Unlike the buck-type converter case, the regulation problem of the boost converter is very complicated by the fact that, with respect to the output voltage to be regulated, the system is non-minimum phase. Owing to the non-minimum phase property the classical DOB approach has not been applied to the boost converter. Motivated by a recent result on the application of DOB to non-mimimum phase system, an output feedback control law is proposed by using a parallel feedforward compensator. Simulation results using the Simulink SimPowerSystems prove the performance of the proposed controller against load variation.

• 조명전기설비학회논문지
• /
• 제29권9호
• /
• pp.96-102
• /
• 2015

This paper presents battery charging method using 3-phase AC-DC boost converter. General battery charging method is that charging the battery voltage to the reference voltage according to the constant current(CC) control, when it reaches the reference voltage, charging the battery fully according to the constant voltage(CV) control. However, battery chaging time is increased because of the battery impedance, constant current charging section which shoud take the large amount of charge is narrow, and constant voltage charging section which can generate insufficient charge is widen. To improve this problem, we proposes the method to reduce the charging time according to the SOC(State of Charge) estimation using battery impedance.

• 전기학회논문지
• /
• 제65권11호
• /
• pp.1925-1930
• /
• 2016

Fuel cell power generation system, unlike conventional energy sources, converts chemical energy into electrical energy through electrochemical reaction of hydrogen and oxygen. This paper presents the control of interleaved multi-phase boost converter as the feasibility study on small-scale prototype electric railway vehicle application using fuel cell generation system. PSIM simulation program is to be used to implement the modeling of the electrical fuelcell as well as traction motor control with interleaved multi-phase boost converter. Comparing the input current ripple rate, two-phase interleaved boost converter is less than the boost converter. But the more multi-phase not less proportional to the ripple factor. we confirmed that the amplitude of the input current ripple rate of converter depend on duty ratio.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2004년도 전력전자학술대회 논문집(1)
• /
• pp.330-334
• /
• 2004

A new SEPIC-Flyback converter is proposed. The proposed converter is the integration of SEPIC and Flyback converter. Not only SEPIC output but also Flyback output could be fully regulated by constant frequency PWM control. Merged SEPIC and Flyback topology can share the transformer and power MOSFET. When the switch turns on, one topology operates via capacitive energy transfer. The other topology acts as inductive energy transfer while the switch is off. So, it can increase power density per one cycle. The experimental result is presented and verified.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2001년도 하계학술대회 논문집 B
• /
• pp.1052-1054
• /
• 2001

This paper describes a boost converter to be operated at the boundary of continuous current mode(CCM) and discontinuous current mode(DCM) for power factor correction and low cost. A control method to be utilized in simulation is a average-current mode method in case of operating in CCM. The simulation results show that Better is the CCM converter then the DCM converter in harmonic content and input current waveform. And A Double-boost converter is superior to single-boost converter for input-current harmonic.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2001년도 하계학술대회 논문집 B
• /
• pp.1005-1008
• /
• 2001

This paper presents average current-mode control AC/DC ZVT(Zero Voltage Transition) Boost Converter. This boost converter perceives feed forward signal of input and feedback signal of output for average current-mode control proposed converter employs active-clamp method for ZVT. This converter gives the good PFC(Power Factor Correction), low line current hormonic distortions and tight output voltage regulations. This converter also has a high efficiency by active-clamp method. The principle of operation, feature, and design considerations are illustrated and verified through the experiment with a 150W, 120kHz prototype converter.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2014년도 추계학술대회 논문집
• /
• pp.35-36
• /
• 2014

양방향 QZSI(Quasi Z-Source Inverter)를 이용한 유도전동기 제어 시스템은 암단락 상태를 제어에 이용할 수 있어서 추가 컨버터 없이도 단일 구조로 가변 배터리 전압을 일정하게 승압할 수 있다. 암단락을 이용한 승압은 직류단 전압제어가 보장되어야 하며 전압 제어기 성능이 인버터 출력 전류 제어에 상당한 영향을 미친다. 전압제어는 임피던스 네트워크의 커패시터 전압을 일정하게 제어하거나 직류단 전압을 직접적으로 또는 간접적으로 일정하도록 제어하여 구현할 수 있다. 본 논문에서 양방향 전력 전달이 가능한 QZSI를 통해 유도 전동기를 제어하며 시뮬레이션과 실험을 통해 이를 검증한다.