• Solar Energy
• /
• v.13 no.2_3
• /
• pp.53-64
• /
• 1993

This study investigated heat transfer phenomena during the freezing of an initially superheated or non-superheated liquid in a cooled cylinder tube. Numerical and experimental method were performed to obtatin the temperature and velocity distribution, the shape of interface. Natural convection effects in the superheated liquid were confined and moderated a short freezing time. After natural convection ceases, heat conduction dominated in the whole paraffin, so Crystal and much-zone were found out in PCM. Initial superheating of liquid tended to morderatly diminish the frozen layer thickness at short freezing times but little effect on the these quantities at longer times. On the amount of frozen mass, Iintial liquid superheating is less affected than tube wall subcooling.

• Transactions of the Korean Society of Mechanical Engineers
• /
• v.16 no.1
• /
• pp.142-155
• /
• 1992

Numerical analysis is performed for the unsteady axisymmetric two dimensional phase change problem of freezing of water around a vertical tube. Heat conduction in the tube wall and solid phase, natural convection in liquid phase and volume expansion caused by density difference between solid and liquid phases are included in the numerical analysis. Existing correlation is used for estimating density-temperature relation of water, and the effect of volume expansion is reflected as fluid velocity at the interface and the free surface. As pure water has maximum density at 4.deg. C, it is found that there exists an initial temperature at which the flow direction reverses near the interface and by this effect the slope of interface becomes reversed depending on the initial temperature of water. By considering natural convection and solid-liquid density difference in the calculation, their effects on phase change process are studied and the effects of various parameters are also studied quantitatively.

• Solar Energy
• /
• v.15 no.2
• /
• pp.77-90
• /
• 1995

An effective heat transfer during freezing process was proposed in the vertical cylinder to improve the effectiveness of the heat storage. Vertical cylinder was filled with pure water in order to investigate ice-shape, temperature distribution of the liquid, temperature distribution of the cylinder tube wall, total heat storage per unit mass in the test section under the two experimental conditions; inlet temperature of working fluid is constant($-10^{\circ}C$) and inlet direction of working fluid is either upward flow or downward. Both the mean temperature of the liquid and temperature difference of cylinder tube wall in the upward were lower than those in the downward. In case that the initial temperature of water was $7^{\circ}C$ and $4^{\circ}C$, the shape of ice layer in the upward was more uniform than that in the downward. In case of $1^{\circ}C$, the shape of ice layer is formed by inlet direction of working fluid. Finally, time-varying total heat energy stored in the water in the upward was higher than that in the downward.

• Solar Energy
• /
• v.12 no.3
• /
• pp.60-69
• /
• 1992

Heat transfer characteristics and heat storage rate for vertical cylinder packed with paraffin as a latent heat storage material were theoretically studied. Conduction and convection mechanism were applied to the solid and liquid phase, respectively, and the results were compared with that of pure conduction model. The effects of heating temperature, initial solid temperature and aspect ratio on rate of storage were also studied. In the initial stage of melting, the natural convection is nearly restricted by the friction at the wall and the phase boundary. But it is generated when about 40% of solid melts and again it shrinks by the hot liquid situated on the upper part of the cylinder. So overall melting rate is higher then that for pure conduction model. The increase in heating temperature and aspect ratio activates the natural convection, so melting rate becomes higher. And the larger the aspect ratio, the greater the difference between upper and lower size of the solid. In the initial stage of melting, the initial temperature of solid paraffin has great effect on the melting rate, but as melting proceeds its effect lessens gradually.

• Korean Journal of Air-Conditioning and Refrigeration Engineering
• /
• v.14 no.10
• /
• pp.844-853
• /
• 2002

A dynamic model which simulates the coupled heat and mass transfer within a vertical tube absorber was developed. The liquid film is a binary mixture of two components, and both of these components are present in the vapor phase. The pressure, concentration, temperature and mass flow rate of the vapor are obtained by assuming that the pressure is uniform within an absorber. The model was applied to an absorber for an ammonia/water absorption refrigerator. The transient behaviors of the pressure, the outlet temperature and the concentration of the solution and the cooling water outlet temperature on a step change at the absorber inlet of the cooling water temperature, the vapor mass flow rate and the concentration of the solution were shown.

• Magazine of the Korean Society of Agricultural Engineers
• /
• v.29 no.2
• /
• pp.74-81
• /
• 1987

지표에서 토양속으로 흐르는 물의 침수를을 동심원관형침수계를 사용하여 측정하였다. 내부관과 외부관을 비교함으로서 침투율 측정시 침투계 바깥쪽으로 흐르는 수평방향으로 흐름을 예상할수 있으며 서로 다른 초기함수조건에서 침투율을 측정, 비교함으로써 초기함수 상태의 침투율에 대한 영향을 고찰하였다. 측정치를 분석한 결과 예상한 대로 바깥쪽으로 흐르는 수평방향의 토양수분으로 인하여 외부관에서의 침투율이 내부관에서 보다 평균90% 컸으며, 또 초기 함수량이 작은 경우가 큰 경우보다 침투율이 켰다. 침수가 끝난 후 재분배시의 토양 수분 흐름은 수리지표를 검사함으로써 추정하였다.수평 및 수직방향의 수리지표는 다단 텐시오미터(multiple-depth tensiometer)를 사용하여 토양속의 공극수압을 측정하여 계산하였다 수리지표를 검사한 결과 재분배시 수평방향의 토양수분 흐름은 일정한 방향이 아니라 경우에 따라서 원관 침투계의 중심쪽으로 또는 바깥쪽으로 흘렀다. 이느 토양의 물리적 성질이 장소에 따라서 균일하지 않았음에 기인한 것이라 판단된다. 재분배시 수평 및 수직방향의 평균수리지표의 비율을 검사한 결과 시간이 경과할수록 비율이 감소 되었으며 또 깊이가 깊어질수록 감소하였다.이는 즉 시간이 지날수록 깊이가 깊어질수록 토양수분 흐름의 수평방향 성분이 감소한다는 것을 나타낸다.

• Journal of Energy Engineering
• /
• v.15 no.1 s.45
• /
• pp.28-34
• /
• 2006

The convective heat transfer on the outer surface of tube arrays perpendicular to the flow direction was experimentally investigated. The test sections which include the aligned and staggered arrangements were made and the local heat transfer coefficients on the outer surface of the tube were measured after the Hour has been fully developed. The results showed that the local heat transfer coefficients of the staggered arrangement, which has transverse pitch of 0.075 m and longitudinal pitch of 0.08 m, were about 15% greater than that of the aligned arrangement. Also, the overall mom Nusselt number of the former was greater thu that of the latter.

• Transactions of the Korean Society of Mechanical Engineers
• /
• v.11 no.5
• /
• pp.856-866
• /
• 1987

In the present paper a statistical method using probability density function has been applied to investigate experimentally the flow patterns and fluctuations of time-averaged local void fraction in air-water two-phase mixtures which flow vertically upwards in concentric annuli. This study was carried out using three vertical concentric annuli. The annular test section consists of a lucite outer tube whose inside diameter is 38mm and a stainless steel inner rod. The rod diameter is either 12mm, 16mm or 20mm. The two-phase flow patterns observed in the experiment were bubbly, slug, annular and each transition patterns. It was first demonstrated that the variance, coefficients of skewness and kurtosis calculated from probability density function on time-averaged local void fraction can be used to identify the flow patterns in the annular passage, and the fluctuation of time-averaged local void fraction varies with the radial position in annular gap and the flow pattern.

• Proceedings of the KSME Conference
• /
• 2007.05b
• /
• pp.2217-2221
• /
• 2007

Because of the ozone layer depletion and global warming, new alternative refrigerants are being developed. In this study, evaporation heat transfer characteristics of carbon dioxide flowing upward in a vertical tube have been investigated by experiment. Before the test section, a pre-heater is installed to adjust the inlet quality of the refrigerant to a desired value. A smooth tube with outer diameter of 5 mm and length of 1.44 m was selected as a test tube. The test was conducted at mass fluxes of 212 to 530 kg/$m^2s$, saturation temperature of -5 to 20$^{\circ}C$, and heat fluxes of 20 to 45 kW/$m^2$. As the vapor quality and mass fluxes increase, the heat transfer coefficients of carbon dioxide are decreased, and the heat transfer coefficients increase when the heat fluxes and saturation temperatures increase.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.20 no.10
• /
• pp.3293-3303
• /
• 1996

Numerical analyses have been performed to estimate the absorption heat and mass transfer coefficients in absorption process of the LiBr aqueous solution and the total heat and mass transfer rates in a vertical tube absorber which is coolING ed by air. Axisymmetric cylindrical coordinate system was adopted to model the circular tube and the transport equations were solved by the finite volume method. Absorption behaviors of heat and mass transfer were analyzed through falling film of the LiBr aqueous solution contacted by water vapor in tube. Effects of film Reynolds number on heat and mass transfer coefficients have been also investigated. Especially, effects of tube diameter have been considered to observe the total heat and mass transfer rates through falling film along the tube. Based on the analysis it has been found that the total mass transfer rate increases rapidly in a region with low film Reynolds number(10 ~ 40) as the film Reynolds number increases, while decreases beyond that region. The total heat and mass transfer rates increase with increasing the tube diameter.