• The Journal of the Acoustical Society of Korea
• /
• v.24 no.8
• /
• pp.454-461
• /
• 2005

Time spread due to the multipath in underwater acoustic channel, induces ISI (Inter-Symbol Interference) which degrades the performance of the underwater acoustic communication system. The passive phase conjugation (PPC) which improves the signal to multipath interference ratio (SMR) and therefore reduces the frequency selectivity. is a diversity communication technique giving a less ISI under multipath fading channel. Its frequency selectivity depends on the number of receiver array sensors and time varying source to receiver range. In this study, frequency selectivity of the PPC and its effects on bit error of underwater acoustic communication is analyzed by numerical simulation.

• The Journal of the Acoustical Society of Korea
• /
• v.28 no.6
• /
• pp.506-513
• /
• 2009

In this paper, we propose a bi-directional communication method applying time reversal technique in underwater acoustic channel in order to exchange data between sensor nodes with an available relay node. The proposed method reduces the conventional 4-step relaying procedure to 2-step and improves the system capacity. Moreover, it increases transmission range efficiently while the relay node can be implemented with low complexity. Simulation results demonstrate that the proposed scheme achieves 3.2 bps/Hz higher capacity than that of the conventional method at SNR 20 dB.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2011.05a
• /
• pp.336-339
• /
• 2011

In the RTLS(Real Time Location Based System), in case of existing a number of moving target, extremely complecated data flow is can be occurred. In the network where single gateway exists, various data which was collected from sensor node is transmitted along the simple route as time goes by. In case of multi-gateway configuration, the collected data is transmitted through diverse routes rather than simple route. This kind of data causes jams on nodes and this brings down the performance of the network. Different from existing studies, in this thesis, MAC (Media Access Control) protocol which minimizes data collision between nodes and guarantees QoS(Quality of Service) is suggested, in order to communicate efficiently in multi-gateway underwater sensor network environment. In the suggested protocol, source node which wants to transmit data makes a channel reservation to a number of destination node using a RTS packet. Source node reserves a channel without collision, by scheduling CTS response time using expected delay information from neighbor nodes. Once the reservation is made, source node transmit data packet without collision. This protocol analyzes/estimates the performance compared to a method provided from existing studies via simulation. As a results of the analysis, it was comfirmed that the suggested method has better performance, such as efficiency and delay.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2013.10a
• /
• pp.402-404
• /
• 2013

The wireless communication channel different speed by depth of water or salt and it is influenced by multi-path according underwater. In the paper, MIMO(Multi-input-Multi-Output) system used turbo Equalizer combining Equalizer with Turbo codes for data rates by multi-path channel. we proposed and simulated that the Decision-Directed method used for phase offset. The simulation of proposed method show that the bit-error rate performance can be severely affected by phase errors.

• The Journal of the Acoustical Society of Korea
• /
• v.22 no.5
• /
• pp.418-424
• /
• 2003

In this paper we analyzed the performance of data transmission using BFSK modulation. The system performances were evaluated by the experiments in water tank. As a result we showed the influences of reverberation due to the multipath. In order to simplify the experiment procedure the channel coding etc. were omitted. The experimental result shows that the maximum transmission data rate in used water tank is about 800 bps. We also verified that the reverberation effect m reduced using a deconvolution with a measured channel impulse response. This method improved the bit rate by about 100 bps than simple noncoherent demodulator at bit error rate of 10/sup -3/.

• The Journal of the Acoustical Society of Korea
• /
• v.20 no.5
• /
• pp.110-115
• /
• 2001

In this paper, we propose a beamformer adequate for the nested away that is generally used for multiple frequency band signal processing. The nonisotropic beam pattern of channel in this array causes two problems: the bearing-estimate error of mainlobe and the difference between design and output in sidelobe level. By separating the time delay among channel signals and the time delay among sensor signals in channel, we can remove the effects of the nonisotropic beam pattern of channel in the beamformer output. Through this process, a method to correct simultaneously these problems is proposed.

• The Journal of the Acoustical Society of Korea
• /
• v.36 no.6
• /
• pp.378-386
• /
• 2017

Accurate distance measurement between maneuver target in underwater and measuring devices is required to perform quantitative test evaluation in marine weapons system R&D process. In general, the target distance is measured using a one-way ToA (Time of Arrival) method that calculates the time difference between transmitted and received signals from the two accurately synchronized devices. However, the distance estimation performance is degraded because of the multi-path environments. In this paper, the time-variant transfer function of complex underwater environment is estimated from each received data frame using RBD (Ray-based Blind Deconvolution), and the estimated time-variant transfer function is then used to get rid of the effect about complex underwater environment and to recover the data signal using PTRM (Passive Time Reversal Mirror). The result from the simulation and experimental data show that the suggested method improve the distance estimation performance when comparing with the conventional ToA method.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.36 no.5B
• /
• pp.539-548
• /
• 2011

We propose an efficient cooperative ARQ (Automatic Repeat reQuest) scheme for single-hop and multi-hop underwater acoustic communications, in which cooperative nodes are used to provide more reliable alternative paths for a specific source-to-destination connection. This alternative path has higher channel quality than that of the direct source-destination path. In addition, during a packet-relay through multiple hops, the typical acknowledgement (ACK) signal is replaced with overhearing data packet returned back from the next hop. The usage of overhearing as an ACK improves the system performance. In this paper, we evaluate the proposed scheme by comparing it with a conventional S&W ARQ in terms of throughput efficiency. Computer simulation results show that the proposed cooperative retransmission scheme can significantly improve the throughput by increasing the probability of successful retransmission.

• The Journal of the Acoustical Society of Korea
• /
• v.35 no.5
• /
• pp.368-374
• /
• 2016

This paper presents constructing transmitter and receiver by using a direct sequence spread spectrum techniques to DPSK (Differential Phase-Shift Keying) scheme in underwater acoustic communication. Since DPSK signal can be demodulated if the receiver knows only the phase difference between the adjacent bits, DPSK receiver structure has the advantage of being simplified. In the conventional receiver, two adjacent symbols of transmitted signal before despread are passed to the transition correlator that detects data by comparing maximum correlation outputs. At this time, the error for maximum value of the correlator output may increase because of low SNR (Signal to Noise Ratio) or high Doppler shift frequency according to the underwater channel. In this paper, we propose a method for accurate detection result using the width as well as the magnitude among outputs produced by the correlator. The performances of the proposed method was evaluated by simulation and lake trial data.

• The Journal of the Acoustical Society of Korea
• /
• v.40 no.4
• /
• pp.304-313
• /
• 2021

This paper presents the results of a sea trial for long range underwater acoustic communication conducted in the East Sea in November 2020. Signals were collected through a moving transmitter and 16 vertically arranged receivers, and the range between the transmitter and receiver was about 20 km. The signal in the experiment is a conventional Direct Sequence Spread Spectrum (DSSS) method and a superimposed DSSS method that increases data rate by superimposing of multiple circulated Pseudo Noise (PN) sequences for each symbol. The results show that the uncoded bit error rate averaged over 16 channels to which the channel coding technique was not applied was 0.0005 for the conventional direct sequence spreading method, and was 0.00124 for the superimposed direct sequence spreading method.