• The Journal of the Convergence on Culture Technology
• /
• v.7 no.2
• /
• pp.443-451
• /
• 2021

This study compared and analyzed the thermal characteristics based on the ratio of moisture content of infected and non-infected Bursaphelenchus Xylophilus by heat of combustion experiment. The experiment results are as follows. The analysisresult of the ratio of water content shows that 19.92% on average for infected Bursaphelenchus Xylophilus and 26.27% for non-infected which decreases water content as the size of conduction, convection, and radiant heat increases in case of fire. As the vaporization of the moisture content accelerates, the average moisture content is reached, and the result is contrary to the thermal characteristics of the wood that the moisture content is not ignited by a heat source when the moisture content is under 15%. The combustion heat analysis result showed that infected and non-infected Bursaphelenchus Xylophilus had no significant difference in combustion heat at about 3%. However, it shows that combustion heat is higher than other species. In conclusion, decreasing in moisture content based on the increasing conduction, convection, and radiant heat is one of the direct causes of ignition, and the lower the moisture content, the faster the fire spreads.

• Korean Journal of Remote Sensing
• /
• v.11 no.3
• /
• pp.117-127
• /
• 1995

In this paper several methods for retriving appropriate values of effective soil moisture contents from natural soil surfaces are introduced and compared each other. The soil medium has usually a nonuniform moisture profile; i.e., relatively dry at the top layer and relatively wet at the bottom layer. The effective soil moisture represents the quantitative value of soil moisture of the inhomogeneous soil medium in an average sense. A simple method is an arithmetic averaging of soil moisture values obtained from several layers of a soil surface. Otherwise, the penetration depths can be computed from a homogeneous and an inhomogeneous soil surfaces and compared in order to obtain the effective soil mosture. The other method is to obtain the effective soil moisture by comparing the reflectivities from both of a homogeneous and an inhomogeneous surfaces. Those methods are compared and the reflectivity technique is examined in more detail since the rader scattering is dominated by the reflectivity instead of the penetration.

• Korean Journal of Remote Sensing
• /
• v.13 no.2
• /
• pp.151-163
• /
• 1997

In this paper, an algorithm for retrieving soil moisture from measurement of microwave reflection at the end of a coaxial canble is presented. Because the wave reflection from the boundary between air and soil layers depends on the dielectric constant of the soil layer, the dielectric constant can be obtained from measured reflection coefficient. At first, an equivalent circuit for the coaxial probe contaced on the soil surface was chosen with two unknown circuit elements. Then, the unknown circuit elements are obtained experrmentally by measuring the reflection constants of 20 soil samples, and consequently, an empirical formula for computing the dielectric constant from the reflection coefficient is obtained. The dielectric constant is mainly influenced by the soil moisture, and the soil moisture can be computed from the dielecfic constant using an existing empirical formula. HP Network Analyzer 8510C was used to measure the magnitude and the phase of the reflection coeffcient at 4.65 GHz, and the measured data set were used to obtain an empirical formula for computing the dielectric constant. The empirical formula obtained in this study was proven by other soil samples.

• Analytical Science and Technology
• /
• v.16 no.4
• /
• pp.277-282
• /
• 2003

The amount of water for the cultivation of citrus is different based on the growing period. The effect of water stress induces to enhance of sugar accumulation in citrus. The water content in the leaves of citrus can be a index for watering during cultivation. The purpose of this study is to determine the water content of citrus leaves non-destructively by using near infrared spectroscopy (NIRS). Citrus leaves were prepared from 'Okitsu' Satusuma mandarin leaves (Citrus unshiu Marc.) ranging from 20.80 to 69.98% of water content by loss on drying method, and NIR reflectance spectra of citrus leaves were acquired by using a fiber optic probe. It was found that the variation of absorbance band 1450 nm from OH vibration of water depending on the water content change. Partial least squares regression (PLSR) was applied to develop a calibration model over the spectral range 1100-1700 nm. The calibration model predicted the water content for the validation set with a standard errors of prediction (SEP) of 0.97%. In order to validate the developed calibration model, routine analyses were performed using independently prepared citrus leaves. The NIR routine analyses showed good results with those of loss on drying method with a SEP of 0.81%. The rapid and non-destructive determination of the water content in citrus leaves was successfully performed by portable NIR system.

• Journal of the Korea institute for structural maintenance and inspection
• /
• v.24 no.1
• /
• pp.142-147
• /
• 2020

This study investigates the effects of moisture content on diffuse ultrasound to be applied for the evaluation of micro-structural damage in concrete subjected to various environmental conditions. We monitored diffuse wave parameters for concrete samples in process of water saturation for 5 days. Dried samples were immersed in a water bath, and the change of moisture content in concrete were estimated by measuring the change of mass. For the diffuse wave analysis, a frequency range of 500 kHz, which represents a scattering regime of ultrasound in concrete, was selected. The test results reveal that the ultrasonic diffusivity slightly changed, and the ultrasonic dissipation significantly increased by approximately 120% in the process of water saturation. Therefore, the moisture content in concrete should be considered for the evaluation of micro-structural damage using diffuse wave techniques.

• Proceedings of the Korean Society for Agricultural Machinery Conference
• /
• 1999.07a
• /
• pp.185-190
• /
• 1999

대부분의 물질에 함유된 수분은 물질의 중요한 구성성분중의 하나이며 특히 농산물이나 식품 등에 함유된 수분은 각 품질을 평가하기 위한 중요한 인자중의 하나이다. 각종 농산물 및 식품가공공정 뿐만 아니라 저장단계에서 원료의 수분함량을 신속 정확하게 측정할 수 있는 시스템의 개발이 요구되고 있다. 이러한 원료의 수분함량을 간접적으로 측정하는 방법으로서 주로 전기저항, 고주파 정전용량, 근적외선, 마이크로파 등이 이용되고 있다. (중략)

• Asian Journal of Turfgrass Science
• /
• v.18 no.2
• /
• pp.97-104
• /
• 2004

Anaerobic soils limit the amount of free oxygen available in the rhizosphere and therefore will impede grass root development and restrain nutrient availability for turf growth. An in-situ study was conducted on existing greens to investigate the relationship between $CO_2$ content in the rhizosphere and turf quality. Nine greens were selected in the study. On each green, five 1-m diameter circular plots were randomly selected for conducting the experiment. The greens were sampled 7 times from August, 1998 to August, 1999. Data collected from each plot included turf quality index, $CO_2$ content, and physical properties of the rooting mixtures. Turf quality declined drastically when $CO_2$ content in rhizosphere increased to $5\;to\;6{\mu}LL^{-1}$ during the late summer season. The $CO_2$ content increased as water content in the root zone increased, but was inversely related to infiltration rate. Cultivation of a golf green may reduce $CO_2$ content in the rhizosphere, but the benefit of cultivation decreased with time.

• The Journal of Korea Institute of Information, Electronics, and Communication Technology
• /
• v.8 no.5
• /
• pp.354-358
• /
• 2015

The results of between resistance and optical transparency measurement in DOT-3 brake fluid contaminated moisture and particles generated from fraction of brake system was compared. Conventional resistance measurement method was known to be effaced by it's hygroscopic characteristics. However, the particle is a significant element of the contamination sources. Proposed optical transparency measurement is linear and effective than that of contamination in brake fluid.

• Proceedings of the Korean Society of Dyers and Finishers Conference
• /
• 2011.03a
• /
• pp.54-54
• /
• 2011

방사 공정 최적화를 위해 칩(chip)건조를 실시하여 칩의 수분을 모두 제거한 후 실험을 진행하게 된다. 칩은 그 자체가 공정수분율(0.4%) 또는 그 이상의 수분을 함유하고 있으므로 건조하지 않고 방사하면 현저히 가수분해가 일어난다. 가수분해가 일어난다면 PET 분자량도 저하되어 고분자의 성질을 잃게 되어 방사된 섬유의 물리 화학적 성질에 중요한 영향을 받게 된다. 그러므로 가수분해를 방지하기 위하여 칩내 수분을 제거하는 건조 공정을 거치는 것이다. 개발된 나노은입자을 함유한 Ag/PET 마스터배치의 제사성 및 가연성 평가을 위한 파일럿연구를 행했다. 본 연구에서 사용한 은나노 M/B 칩(chip)의 경우 일반적으로 사용하는 PET 칩에 비하여 낮은 고유점도를 가지므로 방사성에 칩의 수분이 더욱 영향을 미칠 것이라 판단되어 건조공정에 특별한 주의을 하여 진행하였다. 마스터배치의 고유점도(IV)값의 변화에 따른 제사성 및 가연성 평가를 관찰하였다. #3 M/B 칩의 제사성이 #1 M/B 칩 대비 공정성이 개선되어 두 품종 모두 비출사가 발생하지 않았으며, M/B 제조시 분산제 유무에 따른 방사공정성의 차이는 없는 것으로 보인다. 따라서 #1 M/B 대비 공정성이 개선된 점은 M/B의 IV개선에 기인하는 것으로 판단되었다.

• Proceedings of the Korea Institute of Fire Science and Engineering Conference
• /
• 2010.04a
• /
• pp.340-345
• /
• 2010

국내의 건축물은 강한 내력을 갖기 위해 사용되는 HSC빈도가 점진적 증가하고 있으며, HSC로 시공되어진 건축구조물에서의 화재 발생시 폭렬현상의 문제점이 대두되고 있다. 이에 국내외에서 폭렬현상에 대한 연구들이 진행되었고, 이를 통해 폭렬현상에 원인을 알게 되어 이를 토대로 폭렬 방지 방안을 세웠다. 이에 따라 폭렬현상의 원인 중 합수율이 있으며, 이는 콘크리트가 함유하고 있는 수분으로 고온시에 팽창하여 폭렬현상의 매커니즘이 형성된다. 또한 이러한 함수율이 폭렬 발생에 미치는 영향을 크게 하는 요인으로 탄산화와 양생방법이 있다. 우선 탄산화는 반응을 일으킬 경우, 생성물이 공극을 채워 고온시 팽창된 수분이 외부로 나가는 것을 방해하여 수증기압을 축적시키고, 양생방법에 따라 함수율이 달라지게 되어 고온시 팽창될 수분의 양을 결정하게 된다. 특히, 함수율에 의해 발생되는 폭렬을 방지하기 위해 고강도 콘크리트 내부의 수분을 제거하는 강제건조를 하거나 팽창된 수분이 빠져나갈 곳을 만들기 위해 고온에서 녹는 PP섬유를 사용해 공극을 만들어주는 방법이 있다. 따라서 본 연구는 HSC의 폭렬현상방지 대책을 위한 기초자료를 제시하고자 한다.