• Proceedings of the Korea Air Pollution Research Association Conference
• /
• 2003.05b
• /
• pp.397-398
• /
• 2003

대기 중 분진을 제거하는 방식으로 여과 이론을 적용할 수 있는 경우는 섬유 여과기, 입자상 여과기, 액적에 의한 습식 세정기 그리고 기포를 이용한 분진 제거 방법 등을 들 수 있다. 이러한 여과 원리를 이용한 집진 설비를 설계하는데 있어, 액적 또는 기포 주위의 유동장을 정확히 파악하는 것은 매우 중요하다. 특히, 포집구의 크기가 작아지고 화학적으로 반응성을 갖는 고온의 함진가스가 유입되는 경우 및 저압에서 운영되는 경우에 누드센수(Knudsen number)의 영향을 무시할 수 없는데 이러한 영역을 저 누드센 영역(low Kundsen number regime)이라고 한다(Lee et al., 1978). (중략)

• Korean Journal of Air-Conditioning and Refrigeration Engineering
• /
• v.26 no.1
• /
• pp.38-41
• /
• 2014

Fixture units and the diversity curve are used, in order to determine the required size of water supply pipe. However, the values of the National Plumbing Code, International Plumbing Code and National Standard Plumbing Code of America are not the same. The objective of this study is to comparatively analyze the fixture units and the peak flows of a 10th story office building, at any instant of time, according to the three codes.

• Proceedings of the SAREK Conference
• /
• 2004.06a
• /
• pp.56-56
• /
• 2004

• Korean Journal of Air-Conditioning and Refrigeration Engineering
• /
• v.18 no.9
• /
• pp.745-752
• /
• 2006

DOS and NaCl aerosol particles were used to determine collection efficiencies of a 2-stage electrostatic wet scrubber with respect to particle size. The DOS and NaCl aerosols have geometric mean diameters of 0.1-3.0 urn, geometric standard deviations of $1.1{\sim}1.8$ and total number concentrations of $450{\sim}2,400\;particles/cm^3$. The tested operating variables for the electrostatic wet scrubber included air velocity and water injection rate. It was shown from the experimental results that particle collection efficiencies increased in the submicron particle size range when different polarities were applied on the water nozzle and corona wire, respectively. This increase in the collection efficiency is attributed to strong electrostatic attraction between the negative water droplets and positive submicron particles. The collection efficiencies also increased when water injection rate was increased or air velocity was decreased. Meanwhile, the pressure drop across the wet scrubber decreased by 90% compared with the existing mechanical wet scrubber. Finally, ammonia gas was used to determine gas removal efficiencies. It was observed that the gas removal efficiencies increased when the air velocity was decreased or the water injection rate was increased.

• Journal of the Korean Society for Marine Environment & Energy
• /
• v.5 no.2
• /
• pp.35-40
• /
• 2002

By the introduction of cleaning and drying processes, thermal extrusion system for the volume reduction of used polystyrene buoys was developed. It was tested in the costal area for the determination of operational reliability. By the removal of oyster shells and cleaning of salt, waste polystyrene buoys was changed to the raw material of plastics. The lower cost of one-tenth compared with that of the outer request treatment is promising the practical use of waste buoys' volume reduction system.

• Proceedings of the SAREK Conference
• /
• 2009.06a
• /
• pp.1306-1311
• /
• 2009

In recent semiconductor manufacturing clean rooms, in order to improve clean room air quality, air washers are used to remove airborne gaseous contaminants such as $NH_3$, SOx and organic gases from the outdoor air introduced into clean room. Meanwhile, there is a large amount of exhaust air from a clean room. From an energy conservation point of view, heat recovery is therefore useful for reducing the outdoor air conditioning load for a clean room. Therefore it is desirable to recover heat from the exhaust air and use it to reheat the outdoor air. In the present study, numerical analysis and experiment was conducted to simulate the amount of energy reduction of exhaust air heat recovery type air washer system. The present numerical results showed good agreement with the results of the experimental data.

• Proceedings of the SAREK Conference
• /
• 2008.06a
• /
• pp.720-724
• /
• 2008

The purpose of this study is to evaluate the PM10 removal efficiencies of an Air-washer and an Ultrasonic humidifier by mock-up experiments. The concentrations of PM10 were measured at 5 minute intervals using $\beta$-Ray method. The average PM10 removal efficiency of the Air-washer was 79.8%, while the PM10 concentrations increased with the operation of Ultrasonic humidifier. In the case of operating the Air-washer, the R.H(Relative Humidity) level of the test room was maintained at around 45%, regardless of initial R.H condition. The R.H of the test room with Ultrasonic humidifier was influenced by the initial R.H condition.

• Korean Journal of Air-Conditioning and Refrigeration Engineering
• /
• v.19 no.11
• /
• pp.789-796
• /
• 2007

It has been noted, in case of the apartments in collective form, the drainage noise from cleaning of toilet causes many problems in the basement and adjacent rooms, mainly hampering the pleasant housing environment. The problems are increasingly raised by civil complaints with the public offices. Therefore, if the drainage noise generates when wash out of toilet bowl is grasped how the characteristics change according to the sorts of drainpipe, it is considered that the establishment of an effective sound insulation countermeasure could be possible when a civil petition against the drainage noise of apartment house is submitted hereafter. On such viewpoint, this study measured and analyzed the characteristics of drainage noise per the type of drainage pipe, according to KS A ISO $1996-1{\sim}3$, with the horizontal branch pipe and riser pipes in the drainage noise experiment chamber which has the characteristics of the anechoic room. In the result, the pipe type with excellent noise reduction function. The result of this study is considered to become available as fundamental data, to take actions on reduction of drainage noise of the ceiling piping method.

• Proceedings of the Korean Institute of Industrial Safety Conference
• /
• 1997.11a
• /
• pp.267-270
• /
• 1997

악취 물질은 주로 정유공장, 분뇨 처리장, 축산$\cdot$수산 가공업, 화학공장 등에서 발생하며 작업장 내의 직원 뿐만 아니라 인근 지역주민들에게 정신적인 불쾌감을 주는 동시에 인체에 매우 유해한 물질들이다. 이들 악취의 주성분은 메틸머켑탄, 황화수소, 암모니아, 트리메틸아민 등의 물질이다. 이들 물질의 제거 방법에는 약액세정법, 직접연소법, 활성탄흡착법 등이 있다. 이중 활성탄 홉착법은 설비비와 운영경비상의 잇점으로 오랫동안 사용되어져 왔고, 현재도 악취가 많이 발생하는 사업장의 악취 제거 방법으로 널리 사용되고 있다. 그러나 기존의 활성탄을 이용한 흡착제거는 처리효율이 낮고, 이에 따른 흡착제의 충진량이 많아지고 시설용량이 커지는 등의 결점이 있다. 이러한 문제점을 해결하기 위해 활성탄의 성질의 개선과 ACF와 같은 흡착제의 활용등에 대한 연구들이 진행되고 있다. (중략)

• Proceedings of the KAIS Fall Conference
• /
• 2011.05a
• /
• pp.496-497
• /
• 2011

원자력발전소 증기발생기, 보일러, 열교환기, 각종 설비 및 기기의 모재표면, 구성품표면, 틈새에 발생되었거나 침적된 슬러지를 제거하는데 있어 각 세정용액에 기체질소를 주입하여 기포발생주기에 따른 마그네타이트 탈착율을 비교 측정하였다.