• Journal of the Korea Concrete Institute
• /
• v.24 no.4
• /
• pp.399-406
• /
• 2012

Beam-column joints are generally recognized as the critical regions in the moment resisting reinforced concrete (RC) frames subjected to both lateral and vertical loads. As a result of severe lateral load such as seismic loading, the joint region is subjected to horizontal and vertical shear forces whose magnitudes are many times higher than in column and adjacent beam. Consequently, much larger bond and shear stresses are required to sustain these magnified forces. The critical deterioration of potential shear strength in the joint area should not occur until ductile capacity of adjacent beams reach the design demand. In this study, a method was provided to predict the deformability of reinforced concrete beam-column joints failing in shear after the plastic hinges developed at both ends of the adjacent beams. In order to verify the deformability estimated by the proposed method, an experimental study consisting of three joint specimens with varying tensile reinforcement ratios was carried out. The result between the observed and predicted behavior of the joints showed reasonably good agreement.

• Journal of Korean Society for Geospatial Information Science
• /
• v.22 no.4
• /
• pp.127-133
• /
• 2014

The purpose of this study is to evaluate the accuracy of Network-RTK(VRS) survey for applying to Ground Control Points(GCPs) survey required for mapping aerial photographs. Network-RTK has been serviced by National Geographic Information Institute since 2007. On the basis of the global coordinates system(ITRF2000), the coordinates of GCPs determined by Static GNSS survey with relative positioning techniques were regarded as accurate values. The coordinates of GCPs were also determined by Network-RTK survey using two kinds of receivers, and then they were converted into the global coordinates system(ITRF2000) by applying suitable geoid model and coordinate transformation. These coordinates of GCPs were compared with those from Static GNSS survey. The root mean squares error (RMSE) of coordinate differences between Network-RTK and Static GNSS was ${\pm}2.0cm$ in plane and ${\pm}7.0cm$ in height. Therefore, Network-RTK survey that enables single GNSS receiver to measure positions in short time is a practical alternative in positioning GCPs to either RTK survey that uses more than two sets of GNSS receivers or Static GNSS survey that requires longer observation time.

• Korean Journal of Ichthyology
• /
• v.19 no.4
• /
• pp.324-331
• /
• 2007

Age and growth of the robust tonguefish, Cynoglossus robustus were estimated using scale of 353 fish specimens from February, 2004 to December, 2005 in the Southern Sea of Korea. Marginal increment of the scale formed annual rings from October to November at the beginning of autumn season. In the relationship between total length and body weight, a multiplicative error structure was assumed because variability in growth increased as a function of the length, and the estimated equation was $BW=0.0013TL^{3.399}$ ($R^2=0.916$). The relative growth as body weight at total length has significant difference between females and males (p<0.05). For describing growth of the robust tonguefish, C. robustus a von Bertalanffy growth model was adopted. The von Betalanffy growth curve had a additive error structure and the growth parameters estimated from Walford method were $L_{\infty}=43.77cm$, K=0.186/year and $t_0=-2.295year$. Growth at age of females and males shows no significant difference (P>0.05).

• Analytical Science and Technology
• /
• v.14 no.4
• /
• pp.317-323
• /
• 2001

Dissolution procedures of Monsanto catalyst which has been used to produce acrylronitrile by ammoxidation of propylene have been studied. Optimum dissolution condition of the catalyst supported on silica was obtained by microwave digestion system with mixed of HCl, HF and $H_2O_2$. When a safety device was activated by increased pressure in microwave vessel, Bi, Fe, Mo, Sb and U were not volatilized even though silica was volatilized as $SiF_4$. Quantification results by this method were $SiO_2$ $50.5{\pm}0.4%$, $Sb_2O_3$ $29.6{\pm}0.6%$, $UO_2$ $10.2{\pm}0.1%$, $Fe_2O_3$ $6.1{\pm}0.1%$, $MoO_3$ $0.73{\pm}0.01%$ and $Bi_2O_3$ $0.49{\pm}0.01%$ by ICP-AES and the relative error was within ${\pm}10%$ except bismuth.

• Applied Chemistry for Engineering
• /
• v.8 no.5
• /
• pp.790-795
• /
• 1997

Polychlorinated dibenzo-p-dioxins and polychlorinated dibenzofuransfurans are the archetype of toxic chemicals. So it has absorbed public attention. The majors primary sources of PCDDS and PCDFs are chemical, thermal and photochemical reactions. Municipal solid waste incinerator facilities has been reported as the major contributors of dioxins to the environment. In this paper, Dioxins and furans were examined emission gas and fly ash produced during combustion in municipal solid waste incinerator. More effective method for sampling, extraction was described. The sample was extracted using a soxhlet method and purified using silicagel, alumina and carbon fibre HPLC to remove interfering compound. The extract was then analyzed by HRGC/HRMS. The result of this study showed recovery standard was good and the data resembled those of thermal processes. Total dioxins and furans were $1076.20pg/Nm^3$ and $1452.34pg/Nm^3$ respectively. The amount of highly chlorinated compound was more than that of lowly chlorinated compound. The 2,3,7,8-substituted TCDD was Just 0.34% of the total dioxins/furans amount.

• Journal of the Korean earth science society
• /
• v.38 no.7
• /
• pp.496-510
• /
• 2017

This study presents a new nationwide quantitative precipitation estimation (QPE) based on the hybrid surface rainfall (HSR) technique using the weather radar network of Korea Meteorological Administration (KMA). This new nationwide HSR is characterized by the synthesis of reflectivity at the hybrid surface that is not affected by ground clutter, beam blockage, non-meteorological echoes, and bright band. The nationwide HSR is classified into static (STATIC) and dynamic HSR (DYNAMIC) mosaic depending on employing a quality control process, which is based on the fuzzy logic approach for single-polarization radar and the spatial texture technique for dual-polarization radar. The STATIC and DYNAMIC were evaluated by comparing with official and operational radar rainfall mosaic (MOSAIC) of KMA for 10 rainfall events from May to October 2014. The correlation coefficients within the block region of STATIC, DYNAMIC and MOSAIC are 0.52, 0.78, and 0.69, respectively, and their mean relative errors are 34.08, 30.08, and 40.71%.

• Journal of Radiation Protection and Research
• /
• v.39 no.1
• /
• pp.46-53
• /
• 2014

For the case of radiation emergency, it is required to assess internal contamination of the public, including children as well as adults. The objective of the present study was to assess counting efficiency of a whole body counter by human body size and standing position of the measurement person. In this study, the FASTSCAN whole body counter used at National Radiation Emergency Medical Center of Korean Institute of Radiological and Medical Science was simulated by a radiation transport computer code. The simulation results of the counting efficiencies agreed well with measurements within the 2% of discrepancy for 4-year child and 5% for adults. The standing positions of the people were adjusted by body size to find the consistent trend of the counting efficiencies by human body size. Body size scaling factors of the whole body counter were derived to consider human body size and improve the measurement accuracy. The counting efficiency assessment methodology in this study can be successively used to improve the measurement accuracy when using a whole body counter for the case of radiation emergency.

• Journal of Environmental Impact Assessment
• /
• v.23 no.6
• /
• pp.432-444
• /
• 2014

When the water quality modelling is done with a manual calibration, it is possible that the researcher's opinion may affect the objectivity of the research. Hence, the role of the automatic calibration is highly important. This research applies a technique to automatically calibrate the water quality parameters by implementing an optimization method. This involves estimating the optimum water quality parameters targeting influential parameters towards the lake's BOD, DO, Phosphorus, Nitrogen and Phytoplankton. To accurately calculate the water temperature and hydraulic characteristics of a deep, stratifying lake, EFDC, a 3-dimensional hydraulic model which can be linked to the WASP7 was applied. With EFDC, the segment of the lake is formed and utilized as an input data of the WASP7. For the calibration of the water quality parameters of the WASP7, an influence coefficient algorithm and a genetic algorithm was applied. Of the five water quality variables for calibration, the normalized residuals of the observed and calculated values of DO, TN, CBOD were relatively small and the three water quality variables were calibrated properly. Yet the accuracy of the calibration of TP and Chl-a was relatively low.

• Economic and Environmental Geology
• /
• v.35 no.6
• /
• pp.545-552
• /
• 2002

In order to investigate the influence of nuclear power plant operation on its nearby environment, soil, stream and marine sediment samples were collected in the vicinity of the Youngkwang Nuclear Power Plant in Korea, and analyzed for artificial and natural radionuclide radioactivity. From the analytical result, Cs-137 was detected in most soil samples. but it may have been derived fiom past nuclear weapon tests because Cs-134 having short half-live was not detected. The radioactivities of Cs-137 in the sediment samples were also detected which are within the normal range in the sediments based upon the published literature between 1997 and 1999. For the quality control of radioactivity analysis of environmental samples, sets of marine sediments in the Gamami area were analyzed using two HPGe Gamma-ray Spectroscopes (30% and 45%) according to the geostatistical sampling strategy, and Cs-137 and K-40 results were interpreted by analysis of variance (ANOVA). In the two-way ANOVA, variances derived from the geochemical variation were significant, but errors from sampling and analytical procedures are negligible. In conclusion. all the radioanalytical procedures of this study including sampling are validated to be acceptable.

• Journal of Broadcast Engineering
• /
• v.19 no.6
• /
• pp.866-876
• /
• 2014

Generating of digital hologram of video contents with computer graphics(CG) requires natural fusion of 3D information between real and virtual. In this paper, we propose the system which can fuse real-virtual 3D information naturally and fast generate the digital hologram of fused results using multiple-GPUs based computer-generated-hologram(CGH) computing part. The system calculates camera projection matrix of RGB-Depth camera, and estimates the 3D information of virtual object. The 3D information of virtual object from projection matrix and real space are transmitted to Z buffer, which can fuse the 3D information, naturally. The fused result in Z buffer is transmitted to multiple-GPUs based CGH computing part. In this part, the digital hologram of fused result can be calculated fast. In experiment, the 3D information of virtual object from proposed system has the mean relative error(MRE) about 0.5138% in relation to real 3D information. In other words, it has the about 99% high-accuracy. In addition, we verify that proposed system can fast generate the digital hologram of fused result by using multiple GPUs based CGH calculation.