• Journal of the Society of Disaster Information
• /
• v.14 no.2
• /
• pp.165-173
• /
• 2018

Purpose: The area such as historic sites where distributed in the hills surrounded by the mountains in the past, if heavy rains occur, soil that distributed in the substructure of a sedimentary layer's permeability decreases therefore, water do not smoothly drainage and increases surface structures' moisture content. Therefore, many phenomena occur such as the muddy ground. This experiment tried to figure out the cause of poor drainage, predicting poor drainage system when rainfall occur. So not only the base of cultural properties distributed in the historic site, but also have big influences on the upper structure. Method: We are going to propose an improvement plan through the various sites exploration and the field permeability test. In addition, analyze interrelationship to figure out the cause of the poor drainage through monitoring under ground water. Conclusion: As the result of the experiment, the cause of the poor drainage system formed on shallow depth of ground level inside of a land. We can see that soil of surface and fill deposit permeability was in poor condition. Therefore, it was in very inappropriate hydrogeological condition when surface water permeate into the underground when rainfall occurs.

• Proceedings of the Korean Society of Dyers and Finishers Conference
• /
• 2011.03a
• /
• pp.104-104
• /
• 2011

섬유가 가늘어지면 굽힘 강성이 저하되고 비표면적이 증가하는 등의 많은 특징을 발휘한다. 특히 폴리에스테르 극세사는 실크와 같은 외관, 유연한 태 등의 감각적으로 우수한 특성을 가지므로 제품의 태에 대한 질적 향상을 요구하는 소비자의 욕구와 맞아떨어져 다양한 용도로 전개되고 있다. 초극세 섬유를 제조하는 방법은 통상적으로 멜트블로운법, 플래쉬법, 전기방사법 그리고 해도형 복합방사법의 4가지로 분류된다. 그중 해도형 복합방사법은 가장 안정적인 방법으로 PET기준으로 0.01데니어 급까지 상용화가 되어 있다. 해도형 복합섬유의 개발에 있어서 중요한 것 중에 하나가 해성분 폴리머의 용출기술이다. 초극세화를 목적으로 해성분인 변성폴리에스테르를 제거시키기 위해서 실시되는 알칼리(NaOH)에 의한 감량공정은 그 처리조건에 따라서 초극세사로 잔존해야하는 도성분의 정규 폴리에스테르까지 손상시킬 수 있기 때문에 균일한 용출조건의 확립은 매우 중요하다. 그러나 초극세화가 진행될수록 알칼리가 필라멘트의 가운데 영역까지 균일하게 침투하기가 어려우며 감량된 도성분도 비표면적이 증가하기 때문에, 해성분의 균일한 용출 및 감량을 위한 안정적인 조건을 선정하기가 어렵다. 따라서 본 연구에서는 울트라마이크로-나노급(800nm) 해도형 폴리에스테르 섬유를 이용하여 해성분 용출공정에서 정규 폴리에스테르를 손상시킬 수 있는 알칼리 감량 조건을 완화시키면서 기존과 동일한 감량 효과를 얻을 수 있는 용출 공정을 확립하고자 한다. 이를 위하여 유기산을 이용한 전처리 조건 및 알칼리 감량공정에서 NaOH의 농도, 처리시간, 처리온도의 변화가 울트라마이크로-나노급 해도형 섬유의 용출에 미치는 영향에 대하여 검토하였다.

• Magazine of the Korean Society of Agricultural Engineers
• /
• v.43 no.2
• /
• pp.59-68
• /
• 2001

A water balance analysis was performed for a paddy field neighboring the Dongchang stream, downstream of the Unmun reservoir, which is constructed for the urban water supply. Daily rainfall data were collected and irrigation water flow rate, drainage flow rate, evaportranspiration, infiltration, and piezometeric head were measured in the field. The flow rates were continuously observed by water level logger during the growing season. The evaportranspiration and the infiltration were measured by N-type depletion meter and cylindrical infiltrometer, respectively. PVC pipes with 12mm diameter were used for piezometric head measurement. Total Irrigation and drainage flows were 3,608mm and 1,170mm in 1999, and 3,971mm and 1,548mm in 2000, respectively. The mean and range of the daily infiltration rate were 4.4mm/d and 3.4mm/d to 5.5mm/d in 1999 and 5.1mm/d and 4.1mm/d to 6.5mm/d in 2000, respectively. The net ground water flow including the change of soil water storage was 2,855mm in 1999 and 2,540mm in 2000. The evapotranspiration was 458.3mm in 1999 and 553.5mm in 2000. The range of daily evapotranspiration rate was from 1.6 to 8.7mm/d. The return flow ratio was about 32% in 1999 and 39% in 2000 and three year average was 35% including previous study in 1997. The amount of irrigation water was much higher than design standards or references in this study, This was caused by the inadequate water management practice in the area where water was oversupplied on farmers’ request rather than following sound water management principles.

• Journal of Wetlands Research
• /
• v.14 no.4
• /
• pp.657-665
• /
• 2012

The development projects distort the natural water circulation system and increase the non-point source pollution by changing the natural cover type. The low impact development (LID) techniques are considering as new development approach to decrease the ecological- and hydrological impacts from high imperviousness rate. The high imperviousness rate is because of the construction of building, parking lot and road for human activities. Knowing the basic characteristics of rood runoff can give the direction for setting up the water management strategy. The monitoring results show the pollutant EMCs of roof runoff are 3~13 times lower than EMCs of the road and parking lot. The pollutant sources from roof runoff are mainly from leafs, cigarette butts, atmospheric deposition and materials of the roof. The EMC is occurred around 15minutes later after starting runoff and more than 8 storm events are needed to have the average EMCs.

• The Korean Journal of Pesticide Science
• /
• v.9 no.3
• /
• pp.185-190
• /
• 2005

Solid phase synthesis of 16, which is a derivative of the first systemic fungicide, carboxin 1 was described. Reaction of 1,3-oxathiolane derivative with solid resin of 4-hydroxy-3-nitrobenzophenone 6 gave 9 in 82% yield. Oxidation of sulfur in the solid 1,3-oxathiolane 9 by MCPBA followed by a ring expansion reaction under the acid catalyst afforded the corresponding dihydro-1,4-oxathiin derivative 12. Treatment of the solid 1,3-oxathiolane 9 with p-methoxyaniline resulted in 1,3-oxathiolane 14, 1,3-oxathiolane sulfoxide 15, dihydro-1,4-oxathiin 16, and acetoacetanilide derivative 17 in 41%, 35%, 14%, 10% yields, respectively.

• Applied Chemistry for Engineering
• /
• v.10 no.6
• /
• pp.902-906
• /
• 1999

Electrically conducting composite films were prepared by a vapor phase in situ polymerization of pyrrole in the methyl cellulose film containing a copper(II) perchlorate. Methylcellulose had high affinity to pyrrole and was used as a matrix polymer. Conducting polypyrrole was embedded in the methylcellulose film forming a conducting network and the conductivity of the composite films ranged $10^{-1}$ to $10^{-7}S/cm$. The conductivities of conducting composite films were dependent on the nature of the matrix polymers, concentration of oxidant and polymerization time. In situ polymerization of pyrrole was observed in the matrix polymer and confirmed by UV-vis spectra. From the results of the thermogravimetric analysis, the chemical oxidative polymerization of pyrrole in the matrix polymers did not give any negative effects on the thermal stability of the composite films. Electron micrograph of composites indicated good penetration of PPy in the matrix polymer. DMA suggested a certain degree of incompatibility of the polypyrrole in the composites.

• Journal of Korea Water Resources Association
• /
• v.31 no.1
• /
• pp.71-84
• /
• 1998

The SSARR model adopting IS(integrated snowband) watershed model is applied to the Nakdong River basin for low flow analysis. The IS watershed model is added to new version of the SSARR which has functions of simulating evapotranspiration. infiltration and lower zone routing. It provides annual water budget information as an output file and can be operated by interactive mode. Sensitivity analysis for both cases of high and low flows was carried out, which becomes the knowledge base for model calibration. Model verification was performed using the relative errors of high flows and absolute errors of low flows at the control points. Monthly water budget analysis was done by IS watershed model. and it reveals that runoff coefficient is 52.6%

• Membrane Journal
• /
• v.24 no.4
• /
• pp.292-300
• /
• 2014

Chlorine-resistant sulfonated poly(arylene ether sulfone) random copolymer (SPAES)-thin film composite (TFC) membranes for desalination are prepared using monoglyme as a selective solvent, which dissolves SPAES, but should be inert to porous polysulfone layer (e.g., Udel$^{(R)}$). Different from formic acid and diethylene glycol used as other selective solvents, monoglyme is environmentally friendly and has much lower boiling temperature. After a pretreatment of Udel$^{(R)}$ support film in isopropyl alcohol-glycerine mixture to minimize pore penetration leading to fairly reduced water flux, coating of SPAES solution in monoglyme onto the support and stepwise drying processes are conducted for defect-free TFC formation. The transport behavior through SPAES-TFC membranes is observed, correlating with the effects of sulfonation level, protonation, and physical and chemical crosslinking of SPAES selective layers.

• Journal of the Society of Cosmetic Scientists of Korea
• /
• v.30 no.2
• /
• pp.207-210
• /
• 2004

Glycyrrhiza uralensis (licorice root) is very useful medicinal herb because of strong anti-inflammatory and anti-wrinkle effect. Therefore, it is widely used in functional cosmetics. However, it is insoluble and easily decomposed by light, heat, oxygen, etc. In this study, we first prepared NanoSolve-Licorice (30-50nm) using Glycyrrhiza uralensis and propylene glycol! hydrogenated lecithin/caprylic/capric triglyceride/glycerin/water system with microfluidizer. And then, NanoSolve-Licorice and porous PMMA are dispersed in ethanol. Finally, we could get a stabilized system with high-pressure homogenizer (1,000 Bar, 3 passes). According to HPLC measurement for glabridin content, our system is more stable compared with general liposome ones. Capsulated licorice has an enhanced anti-inflammatory effect on account of excellent skin penetration. We also evaluated our final product through image analyzer, particle size analyzer, FF-TEM and chromameter.

• Journal of the Society of Cosmetic Scientists of Korea
• /
• v.21 no.2
• /
• pp.1-21
• /
• 1995

In this context, it should be mentioned that multilamellar vesicles can be prepared with the main compounds of the intercellular lipids, ceramides, cholesterol, cholesteryl ester, squalane, lecithin, wax ester by effect of the wetting. We investigated properties formation of MLV with use of the AHAsomes and Microfluidizer. The multilamellar vesicles are formed merely adding polyol and water phase, followed with the microfluidizer. Formation of a practically pure AHAsomes system, containing the active ingredients directly incorporated without need for preservatives. There were very good encapsulated properties of the active ingredients whether hydrophilic(malic acid, tartaric acid, lactic acid, allantoin, urea) and hydrophobic(vitamin-I acetate, vitamin-A palmitate). Optimum condition (ormatiom of MLV was passed three times in the microfluidizer, particle size of the vesicles should be within range 50-523nm (mean=163.5nm). As application, It was compared that horny layer of the sole of foots removal with the general OM emulsion and the AHAsomes cream. There was used for three months, those got recovery wrinkles about 151.8% and elasticity three times more the AHAsomes than O/W emulsions, It was confirmed with the Image Analyzer and the Cutometer.