• Korean Journal of Food Science and Technology
• /
• v.29 no.1
• /
• pp.126-132
• /
• 1997

Calcium carbonate ($CaCO_3$) immobilized with alginate was studied as buffer system to enhance the cultivation efficiency of Bifidobacterium longum (ATCC 15707) which is inhibited at low pH. To test the bufferring effect of the immobilized $CaCO_3$ beads, pH value in each modified trypticase-proteose peptone-yeast (TPY) broth which is adjusted to pH 4.0 with acetic acid, lactic acid and complex solution of acetic and lactic acid, 3:2 (M:M) was tested by concentration of $CaCO_3$ bead and reaction time. The bufferring effect of $CaCO_3$ bead became higher with increasing the amount of $CaCO_3$ bead in the acidic solution. The growth rate of bifidobacteria and bufferring effect were examined in relation to the amount of $CaCO_3$ bead and concentration of glucose in the modified TPY media. The growth rate of bifidobacteria and bufferring effect were increased with increasing the amount of $CaCO_3$ bead and concentration of glucose. Also, the exponential time of bifidobacteria became longer with increasing the amount of $CaCO_3$ bead and concentration of glucose in the modified TPY media. When we observed the growth rate of bifidobacteria by the method of pH-controlled culture and $CaCO_3$ buffer system, the $CaCO_3$ buffer system was more effective than that of pH-controlled culture. Therefore, this $CaCO_3$ buffer system may be useful as a method to enhance of the cultivation efficiency of bifidobacteria.

• Journal of the Korean Chemical Society
• /
• v.44 no.5
• /
• pp.422-428
• /
• 2000

Optimum analytical conditions of the aluminium ion were established by flow injection analysis. Eriochrome Cyanine R(ECR) dye reacts with the aluminium ion at pH 6.0 to form a complex that exhibits maximum absorption at 535 nm. Reaction conditions including the mixing and the reaction coil length, the concentration and the pH of the buffer solutio, temperature, and injection loop volume were optimized to intro-duce this reaction into flow injection analysis. The results were as follows. A mixing coil length of 0.5 m and a reaction coil length of 4.0 m, the pH 6.0 and 1M of acetate buffer solution, the ECR concentration of 0.56 mM, the reaction temperature of 40$^{\circ}C$, the injection loop volume of 300${\mu}L$ were chosen as optimum conditions. Under these conditions the detection limit of the aluminiumion was less than 0.05 mg/L and the repeatability was better than 1%. A sampling frequency of 24 times for an hour was achieved. Interfering ions such as $F^-$, HP$O_4^{2-}$, $Fe^{2+}$, $Fe^{3+}$, $Mn^{2+}$, and other anions were tested, interference did not occur up to 1,000mg/L of ion concentration and up to 2,CO0mg/L of sulfate ion con-centration. This method was applied for the determination of aluminium ion in tap water and ground water of Jeonju and the Gochang area. The results showed that the aluminium residual in tap water of the Jeonju area was at a mean of 0.478mg/L and that in tap water of the Gochang area was at a mean of 0.278mg/L. Aluminium ion residual of the tap waters in the Jeonju area was higher level than that in the Gochang area. Aluminium residual in the ground water of the Jeonju area was 0.386 mg/L and was lower compared to 0.564 mg/L for the Gochang area.

• Analytical Science and Technology
• /
• v.10 no.2
• /
• pp.119-125
• /
• 1997

A stripping voltammetric procedure for determining ruthenium was developed, based on the adsorptive accumulation of ruthenium in the presence of hydrazine in acidic acetate buffer. After preconcentration of ruthenium compelex and reduction, the ruthenium-catalyzed hydrogen current at -0.84V was measured by differential pulse voltammetry. Optimal experimental conditions were found to be a stirred acetate buffer solution(pH 2.0) containing 0.01M acetate and 0.01M hydrazine, accumulation potential of -0.76V, and a scan rate of 5mV/s. The detection limit was $2{\times}10^{-9}M$ for a 7 min accumulation period. The possible interferences by other platinum group metals were also investigated.

• Journal of the Korean Chemical Society
• /
• v.46 no.5
• /
• pp.412-429
• /
• 2002

Chiral separation of gemifloxacin, an quinolone antibacterial agent, using (+)-(18-crown-6)-tetracar-boxylic acid $(18C6H_4)$ as a chiral selector was performed by capillary electrophoresis (CE). Direct analysis of quinolone antibacterial agent in body fluid is beneficial in terms of fast analysis time, multicomponent analysis. However, high con-centration of sodium ion in body fluid can prevent gemifloxacin from interacting with $18C6H_4$ since sodium ion has high affinity with $18C6H_4$ due to the strong charge interaction. Ethylenediaminetetraacetic acid (EDTA), as a chelating ligand, was added in the running buffer in order to reduce the interaction between sodium ion and the chiral selector. Increased separation efficiency and reduced migration time were observed while sodium ion exists in the sample solution at the concentration up to 150 mM.

• Journal of the Korean Chemical Society
• /
• v.35 no.5
• /
• pp.545-552
• /
• 1991

A mercury ion-sensitive carbon-paste electrode (CPE) was constructed with l-sparteine. Mercury (II) ion was chemically deposited by the complexation with l-sparteine onto the CPE. The surface of CPEs was characterized by cyclic voltammetry and anodic stripping voltammetry in an acetate buffer solution, separately. Exposure of CPEs to acid solution could regenerate surface and reuse it for deposition. In 5 deposition/measurement/regeneration cycle, the response was reproducible and in licnear up to $2.0\;{\times}\;10^{-6}$ M with linear sweep voltammetry. In case of using the differential pulse technique, we have obtained the linear response up to $7.0 {\times}10^{-7}$ M with relative standard deviation of ${\pm}5.1$%. The detection limit was $5.0{\times}10^{-7}$ M for 20 minutes of the deposition. We have investigated the interference effect of various metal ions, which are expected to form the complex with ligand. Silver (I) ion of these has interfered with the analysis of Hg (II) ions. However, pretreatment of the silver (I) ion with potassium chloride led to no interference on the analysis of mercury ions in aqueous solution.

• Journal of the Korean Chemical Society
• /
• v.37 no.8
• /
• pp.723-729
• /
• 1993

Cu(II) ion-responsive chemically modifed electrodes (CMEs) were constructed by incorporating 1-(2-pyridylazo)-2-naphthol (PAN) into a conventional carbon-paste mixture of graphite powder and Nujol oil. Cu(II) ion was chemically deposited on the surface of the PAN-chemically modified electrode in the absence of an applied potential by immersion of the electrode in a buffer solution (pH 3.2) containing Cu(II) ion, and then reduced at a constant potential in 0.1 M KNO$_3$. And a well-defined voltammetric peak could be obtained by scanning the potential to the positive direction. The electrode surface could be regenerated with exposure to acid solution and reused for the determination of Cu(II) ion. In 5 deposition / measurement / regeneration cycles, the response could be reproduced with 6.1${\%}$ relative standard deviation. In case of using the differential pulse voltammetry, the calibration curve for Cu(II) was linear over the range of 2.0 ${times}$ 10$^{-7}$ ∼ 1.0 ${times}$ 10$^{-6}$ M. And the detection limit was 6.0 ${times}$ 10$^{-8}$ M. Studies of the effect of diverse ions showed that Co, Ni, Zn, Pb, Mg and Ag ions added 10 times more than Cu(II) ion did not influence on the determination of Cu(II) ion, except EDTA and oxalate ions.

• Journal of the Mineralogical Society of Korea
• /
• v.32 no.4
• /
• pp.249-258
• /
• 2019

Acid spill accidents are frequently occurring in Korea with increasing production, use, storage, and transport of acids, accompanying industrialization and economic growth. The acids introduced to the subsurface environments would eventually be neutralized by reactions with geomedia. However, the spatial and temporal extent to which the spilled acids would affect will be dependent on the characteristics of the geomedia exposed to the acids. In this work, sulfuric acid, the most used acid in Korea, was reacted with a set of model geomedia representative of the geology of Korea. The buffering capacity of the model geomedia was determined through batch-type experiments using pH changes as an indicator. X-ray diffraction was used to identify the mineral phases contributing to the acid neutralization. The results showed that sandstone had the largest acid neutralization capacity among the tested geomedia, while kaolinite had the smallest. The findings of this study would contribute to quantitatively assessing the impact of spilled acids on geomedia and hence to predicting the vulnerability of geomedia to the spilled acid.

• Analytical Science and Technology
• /
• v.25 no.3
• /
• pp.171-177
• /
• 2012

A determination method of aromatic amino acids such as trytophan (Trp), tyrosine (Tyr), and phenylalanine (Phe) using luminol-$H_2O_2$-Cu(II) system has been presented. In the presence of an aromatic amino acid, the enhanced chemiluminescence (CL) intensity of luminol-$H_2O_2$-Cu(II) system was obtained by forming a complex between Cu(II) and the amino acid. Based on the above phenomenon, a sensitive and fast determination of three aromatic amino acids was performed using the CL method in batch-type detection system. To optimize determination conditions, the kinetic influence of an aromatic amino acid on the luminol-$H_2O_2$-Cu(II) system and the effects of $H_2O_2$ and Cu(II) concentration, pH, and buffers were investigated. Under the optimized conditions, the calibration curve was linear over the range from $1.0{\times}10^{-6}$ to $2.0{\times}10^{-5}\;M$ for Trp, $1.0{\times}10^{-6}$ to $2.0{\times}10^{-5}\;M$ for Try, and $2.0{\times}10^{-6}$ to $2.0{\times}10^{-5}\;M$ for Phe, respectively. In this range, reproducibility (RSD, n = 4) of Trp, Try, and Phe were 3.21%, 2.64%, and 2.48%, respectively. The limit of detection ($3{\sigma}/s$) was calculated to be $6.8{\times}10^{-7}\;M$ for Trp, $5.7{\times}10^{-7}\;M$ for Try, and $9.6{\times}10^{-7}\;M$ for Phe.

• Analytical Science and Technology
• /
• v.13 no.2
• /
• pp.189-193
• /
• 2000

Arsenic (III) and arsenic (V) in disused mine tailing samples have been determined simutaneuously by hydride generation inductively coupled plasma atomic emission spectrometry (HG-ICP-AES). Total arsenic was determined using 2% $NaBH_4$ and 6 M HCl after prereduction of As(V) to As(III) with) 1M KI. Arsenic (III) was determined selectively using citrate/citric acid buffer with range of pH 5-6, it was determined by HG-ICP-AES. Arsenic (V) can be evaluated by the differences. According to the results, arsenic (V) was over 90% among the total arsenic extracted from disused mine tailing samples.

• KSBB Journal
• /
• v.10 no.1
• /
• pp.63-70
• /
• 1995

The effect of operating conditions on separation of soybean proteins in a home-made free-flow electrophoresis apparatus was investigated. Measurement of the pH, conductivity, and UV-absorbance(280 nm) were carried out at each run and the purity of the sample was tested with SDS-PAGE analysis. The soybean extract pretreated with Tris and boric acid was mixed with the amino acids composed of glutamic acid, histidine, arginine, glycine(1 mM each) with glycyl-glycine(2mM) and KCl(1mM). When the cellulose acetate was used as a compartment between the electrode and the buffer solution in the cell, pH distribution in the separation cell varied from 3.0 at the anodic side to 8.0 at the cathodic side and had two inflection point. The applied voltage was from 300V to 1000V and the separation was better at a higher voltage but the voltage was limited by the capability of the cooling system due to Joule heat. The proteins focused near the middle of the channel. From the change of pH and conductivity it was found that the ions in the channel moved out to the electrodes through the membrane. In the case when the concentration of the buffer solution was increased 5 times, proteins were focused at 300V. We could not increase up to the ten times of the concentration since the temperature difference between inlet and outlet was more than $25^{\circ}C$ and denaturation of proteins was expected. When ion-exchange membranes were used U-type pH distribution was set up due to the ionic polarization near the membrane. The commercial ampholytes, instead of the mixed amino acids showed not much improvements in purity of the separated sample.