• Journal of the Computational Structural Engineering Institute of Korea
• /
• v.15 no.3
• /
• pp.421-432
• /
• 2002

In this study the modal characteristics and responses of an asymmetric structure with added viscoelastic dampers were investigated for design parameters such as eccentricity of stiffness and added dampers, the loss factor of the damping materials used. For modal characteristics, variation of the quantities such as natural frequencies, modal damping ratios, modal participation factors, and dynamic amplification factors were observed, and displacements at flexible and stiff edges, and at center of mass were obtained. Based on the results, the problem of the optimum damper distribution to minimize the torsional effects was addressed, and the proposed method for optimum damper distribution was applied to a multi-story structure to verify the applicability Finally the effect of viscous and viscoelastic dampers were compared by varying the loss factor of the viscoelastic material.

• Journal of Sensor Science and Technology
• /
• v.8 no.5
• /
• pp.407-413
• /
• 1999

The resonant frequency of dielectric rod resonator can be calculated very accurately by means of the concept of electric and magnetic walls from the symmetry. But in a real situation, when the supporter is placed in the cavity, asymmetry appears due to the supporter and its dielectric constant. Then we need research into the resonance characteristic of asymmetric dielectric resonator. In this paper, for the dielectric rod resonator which is placed in the asymmetric position in the conducting cavity, the equation for resonance characteristic was derived and the resonant frequency was calculated with the eigenfunction expansion method. We found that the calculated resonant frequency is very accurate when it was compared with the experimental result and that asymmetry affects the resonant frequency more in TM mode than in TE or in hybrid mode.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.24 no.10B
• /
• pp.1885-1894
• /
• 1999

The higher mode cutoff frequencies in Crawford TEM cells computed by the Galerkin method(GM) describe in this paper. The authors also report the half mode boundaries to solve not only the cut-off frequencies of symmetric TEM cells and those of asymmetric TEM cells. It is shown that the measured resonant frequencies of the present symmetric TEM cells and a designed asymmetric TEM cell are agreed with the calculated results.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.22 no.9
• /
• pp.1968-1974
• /
• 1997

In this paper, the spectral domain approach is employed to investigate the characteristics of symmetrical and asymmetrical broadside-coupleed coplanar waveguides(BSC-CPW). These structures have large even(c)-odd(.pi.) mode-velocity ratio, suitable for wide-band and tight-coupling microwave circuit design. Efficient design parameters can be obtained from the effective dielectric constants and characteristic impedances calculated by varying the strip widths and slot widths in the BSC-CPW structure.

• Proceedings of the KIPE Conference
• /
• 2006.06a
• /
• pp.119-121
• /
• 2006

본 논문은 중 전력, 고 입력 전압응용에서 많이 이용되는 비대칭 하프브릿지 PWM DC-DC 컨버터의 다중 출력 구성을 위한 최적의 설계 방식을 제안한다. 제안된 방식은 기본 PWM에서 부하에 따른 연속전류동작모드(CCM)의 구간을 늘여, 제어되는 전원의 부하 변동이 크더라도, 다중출력 되어지는 전원의 정상상태 동작점의 변동이 크게 발생하지 않도록 한다. 제어되는 비대칭 하프브릿지(ASHB)의 부하에 따른 시비율 변화가 작아지면 경 부하에서 변압기에 인가되는 전압의 크기가 줄어들어 다중 출력 되어지는 단의 전체적인 전압 스트레스가 감소한다. 또한 제안된 방식의 비대칭 하프브릿지 회로는 기존의 1차 측 전류 비대칭성을 보상하여 보다 넓은 부하 영역에서 영전압 스위칭이 가능하며 스위칭 손실과 이에 의한 EMI가 감소하게 된다. 제안된 방식은 기존 하드웨어와 비교하여 그 성능을 검증하였다.

• Proceedings of the Optical Society of Korea Conference
• /
• 2000.02a
• /
• pp.280-281
• /
• 2000

Internet사용자의 급격한 증가에 따라 저가격이며 대용량의 optical access network의 구축이 시급한 실정이다. 광통신의 infrastructure를 구성하기 위해서는 광모듈의 저가격화가 가장 시급한 문제이다. 광모드 변환기가 집적된 반도체 레이저(SSC-LD)는 단일모드광섬유와의 광결합 손실 및 정렬허용오차, 동작시간, 광출력 등을 향상시킬 수 있어, 광가입자계 광송수신모듈의 가격을 낮출 수 있어 최근 매우 활발히 연구되고 있다. (중략)

• The Transactions of the Korean Institute of Power Electronics
• /
• v.12 no.3
• /
• pp.234-240
• /
• 2007

In this paper, a novel multi-level inverter for low cost high speed switched reluctance(SR) drive is proposed. The proposed multi-level converter has reduced number of power switches and diodes than that of a conventional asymmetric converter for SRM and smaller voltage rating of the dump capacitor comparing with energy efficient c-dump converter. It can supply five operating modes that is boosted, DC-link, zero, negative bias and negative boosted voltage. The proposed multi-level converter has fast excitation and demagnetization modes of phase current, so dynamic response can be achieved. The proposed multi-level converter is verified by computer simulation and experimental results.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.22 no.9
• /
• pp.1949-1956
• /
• 1997

The mode parameters of asymmetrical coupled microstrip lines on composite substrates are derived by using closed form expression. A 10 dB directional couplers, where the center frquency is 1.8 GHZ, are fabricated on a single-layer substrate and on compsite substrates respectively. It is shown that coupler on a single-layer substrate.

• Transactions of the Korean Society for Noise and Vibration Engineering
• /
• v.13 no.10
• /
• pp.813-820
• /
• 2003

Conventional modal analysis techniques are known to be inappropriate for asymmetrical rotor systems, when the equations of motion are written in the stationary coordinates, due to the presence of time varying parameters. This paper presents a generalized modal analysis method for asymmetrical rotor systems in the stationary coordinates, employing the modulated coordinates and the lambda matrix formulation. A numerical example with a flexible asymmetric rotor model is provided to demonstrate the effectiveness of the proposed modal analysis method. As an application of the proposed method, modal analysis is also performed with an open cracked rotor system.

• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 2003.11a
• /
• pp.304-309
• /
• 2003

A new modal analysis method for rotor systems with periodically time-varying parameters is proposed. The essence of method is to introduce modulated coordinates to derive the equivalent time-invariant equation. This paper presents a modal analysis method using modulated coordinates fur general rotors, of which rotating and stationary parts both possess asymmetric properties. The equation of motion with time-varying parameters is transformed to an infinite order matrix equation with the time-invariant parameters. A theory of modal analysis for the system is presented with the infinite order equation and a couple of reduced order equations. A numerical example with simple asymmetric rotor is provided to demonstrate the effectiveness of the proposed method