• The Korean Journal of Zoology
• /
• v.35 no.4
• /
• pp.518-525
• /
• 1992

본 연구에서는 horizontal clinostat과 원심분리 방법의 이용으로 각각 저중력 상태($\mu$G)와 고중력 상태(3G)를 유도하여, 중력장의 변화가 양서류 수정란의 초기 형태 형성에 미치는 영향을 북방산개구리(Rano dybows비름를 대상으로 조사하였다. 중력장의 변화는 첫번째 수평 분열인 제3분열면의 위치에 영향을 미쳤다. 즉 저중력 상태에서는 분열면이 적도면 근처에서, 또 고중력 상태에서는 분열면이 동물극 근처에서 형성되었다. 이와 같은 변화는 포배기로 이어져 할강의 위치와 동물극 정단 세포층 수에 영향을 미쳤다. 즉 저중력에 노출된 포배는 정상배(1G)에 비해 할강이 중앙에 위치했으며 동물극 정단의 세포층 수가 증가하는 반면 고중력에 노출된 포배는 할강이 보다 동물극 폭에 위치했으며 동물극 정단의 세포층 수도 감소하였다. 그러나 낭배기에 도달하면 동물극 정단 세포층 수의 차이는 정상 상태로 조절되었다. 한편 중력장의 변화는 낭배기에 이르는 발생 속도와 원구상순부의 위치를 변경시켰다. 낭배기 이후의 발생 단계에서 중력에 의한 변화로는 tail fin circulation(stage 22)시기의 머리크기의 변화를 들 수 있다. 이상의 결과로 무미 양서류의 초기 형태 형성은 중력장에 의해 변형될 수 있으며 이러한 변화는 발생이 진행됨에 따라 조절되는 것으로 보인다.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.11 no.8
• /
• pp.1414-1419
• /
• 2000

In this paper, we propose a resolution enhancement method for estimating direction-of-arrival (DOA) of narrowband incoherent signals incident on a general array. The resolution of DOA algorithm is dependent on the aperture size of antenna array. But it is very impractical to increase the physical size of antenna array in real environment. Therefore we propose the method that increases the aperture size by virtually expanding the sensor spacing of original antenna array and then construct the steering matrix of the virtual array using the proper transformation matrix. Superior resolution capabilities achieved with this method are shown by simulation results in comparison with the standard MUSIC for incoherent signals incident on a uniform circular array.

• Korean Journal of Food Science and Technology
• /
• v.40 no.3
• /
• pp.349-353
• /
• 2008

This study was performed to determine the adherence rates of standard type Salmonella Typhimurium (ST) and wild type Salmonella spp.(WT) in pork after the following contact types and times at $10^{\circ}C$: pork meat (2, 6, 24 hr), conveyer belt (2, 6 hr), stainless steel (2, 6 hr), and cutting board (2, 6 hr). After 6 hr of pork meat to meat fat contact, the adherence rates for ST and WT were approximately 4.21 and 26.87%, respectively, and after 6 hrs of pork meat to red meat contact they were 16.40 and 27.48%, respectively. However, after 24 hr of both types of contact, ST and WT showed 100% adherence rates. The adherence rates for ST after 2 hr and 6 hr of pork meat to conveyer belt contact were 1.34 and 0.60%, respectively, while the adherence rate for WT was 5.14% after 6 hr of contact. After pork meat to stainless steel contact, ST showed adherence rates of zero and 1.59% after 6 and 24 hr of contact, respectively, while the adherence rates for WT ranged from 0.17% after 2 hr to 5.01% after 6 hr. On the other hand, neither ST nor WT offered adherence data following pork meat to cutting board contact. These results suggest that the adherence rates of ST and WT after pork meat to pork meat contact or pork meat to processing surface contact were significantly affected by the contact time and WT presented much higher adherence rates for both types of transmission than ST.

• Journal of the Korean Geotechnical Society
• /
• v.24 no.6
• /
• pp.69-75
• /
• 2008

Shear tests were carried out on interface between two concrete eco-blocks which comprise segmental retaining wall. Three interface conditions were considered : 1) direct contact of two blocks, 2) placing rubber pad between two blocks, 3) placing rubber pad and shear key between two blocks. According to shear tests, shear load-shear displacement relationship which was obtained from direct contact of two blocks was similar to elastic-perfectly plastic behavior. Ductile behavior of shear load-shear displacement relationship was observed for the interface condition of placing rubber pad. Apparent minimum shear capacities and apparent friction angles for the interface conditions of direct contact of two blocks, placing rubber pad between two blocks, placing rubber pad and shear key were 1.7 kN/m, $27.6^{\circ}$ and 4.2 kN/m, $26.2^{\circ}$ and 20.9 kN/m, $26.0^{\circ}$ respectively.

• Journal of the Korean Society for Marine Environment & Energy
• /
• v.12 no.1
• /
• pp.55-59
• /
• 2009

As one of the methods for recycling the FRP from the small and medium waste ships, separation of roving layer from the mat has some merits in a sense of the recycling energy and the environmental effects. Similar characteristics, however, between the roving and the mat even with different ratio of the resin and the glass and the thickness of the roving, much thinner than the mat, make the mechanically automatic differentiation difficult. In this study spectrochemical differentiation between the two layers has been made using (1) boiling concentrated sulfuric acid which can dissolve the resin in the FRP layer, (2) methanol and isopropanol solution saturated with KOH which can dissolve the glass, or (3) hydrogen fluoride(HF) solution which can reacts with $SiO_2$ fragments of the glass. Furthermore coloring water-soluble dye following the HF treatment makes the roving layer more distinguishable photo-physically.

• Journal of the Korean Society for Marine Environment & Energy
• /
• v.13 no.1
• /
• pp.43-46
• /
• 2010

As one of the methods for recycling the FRP used for the small and medium-sized waste ships, separation of the roving layer from the mat has some merit in a sense of the recycling energy and the environmental effects. Similar characteristics between the roving and the mat make the mechanically automatic differentiation difficult. They, however, contain different ratio of the resin and the glass and the thickness. In this study photo physical differentiation between the two layers has been made using (1) boiling concentrated sulfuric acid which can dissolve the resin in the FRP layer and (2) hydrogen fluoride(HF) solution which can reacts with $SiO_2$ fragments of the glass. Furthermore coloring the FRP sample with water-soluble dye following the HF treatment makes the roving layer more distinguishable photophysically. The implementation of HF treatment has been successfully tested in this study.

• Convergence Security Journal
• /
• v.23 no.1
• /
• pp.9-17
• /
• 2023

Due to COVID-19, the concept of Zero Trust, a safe security in a non-face-to-face environment due to telecomm uting, is drawing attention. U.S. President Biden emphasized the introduction of Zero Trust in an executive order to improve national cybersecurity in May 2021, and Zero Trust is a global trend. However, the most difficulty in introd ucing new technologies such as Zero Trust in Korea is excessive regulation of cloud and network separation, which is based on the boundary security model, but is limited to not reflecting all new information protection controls due to non-face-to-face environments. In particular, in order for the government's policy to ease network separation to b ecome an effective policy, the zero trust name culture is essential. Therefore, this paper aims to study legal improve ments that reflect the concept of zero trust under the Electronic Financial Transactions Act.

• Membrane Journal
• /
• v.17 no.1
• /
• pp.1-13
• /
• 2007

Pervaporation process using membrane is newly emerging energy saying and cost effect process instead of distillation process. Especially, in pertrochemical industry, pervaporation process is a strong candidate to substitute the conventional energy consuming processes because that petrochemical industry has much energy consuming separation processes, many azeotrope mixtures to separate and needs to compact space to install new process units. Aromatic/aliphatic separation including benzene/cyclohexane mixture, olefin/paraffin separation, xylene isomer separation, reactive monomer recovery and sulfur compound removal from gasoline have been inversitigated for the application of pervaporation membrane process by many researchers and are under commercializing.

• Tuberculosis and Respiratory Diseases
• /
• v.45 no.1
• /
• pp.176-183
• /
• 1998

Background: The total and differential cell count of bronchoalveolar lavage(BAL) fluid are useful assessing activity, prognosis and response to therapy in diffuse interstitial lung disease. But controversy exist as to the appropriate method in processing BAL fluid. Therefore we investigated the effect of gauze filtration, centrifugation and different storage time of BAL fluid on the total and differential cell count. Methods: We obtained BAL fluid from 6 persons with no active lung lesion and divided pooled BAL fluid into several siliconized glass tubes and filtered through 0, 1, 2, 4 folds of cotton guaze(pore size: 1mm), and compared total cell count using hemocytometer after trypan blue staining and differential cell count after Wright-Giemsa staining of cytocentrifuged preparations. And we also counted total and differential cell count after centrifugation(400g for 30 min) and various storage time(2hr, 24hr, and 48hr). Results: There was no difference in total and differential cell count according to folds of gauze filtraion. But without gauze filtration, mucus threads that hampered total and differential cell count were found in 2 cases (33%). Centrifugation resulted in loss of total cell count($24{\pm}18%$) without change in differential cell count. There was no change in total cell count after 2hr storage but significant cell loss was found after 24hr storage time(24hr : $28{\pm}21%$, 48hr : $41{\pm}24%$). However there was no change in differential cell count with 48hr storage time. Conclusion: Total and differential cell count of BAL fluid may be best performed after cotton gauze filtration without centrifugation and within 2 hours.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.25 no.4B
• /
• pp.715-724
• /
• 2000

This Paper presents 3-D subband filter banks which are effective for progressive and lossless compression of volumetric images. For such a purpose, ORT(Overlapping Rounding Transform), applied so far to 1-D losslesssubband filter banks, is now used to implement two types of 3-D lossless subband filter banks: separable andnon-separable types. Separable fiter banks are implemented form applying 1-D lossless filter banks consecutively.Non-separable later banks are developed by expanding the 1-D ORT into 3-D one. In particular, the proposed ORT based 3-D non-separable filter banks generalizes the 3-D HINT(Hierarchical INTerpolation) algorithm.Through the experiment comparisons on various volumetric medical images, we prove that the proposedseparablefnon-separable filter banks perform better, in terms of compression ratio (first order entropy), than theother lossless compression techniques such as block based transform and conventional 3-D HINT.