• Journal of Korea Water Resources Association
• /
• v.41 no.12
• /
• pp.1219-1230
• /
• 2008

Stream inflows induced by flood runoffs have a higher density than the ambient reservoir water because of a lower water temperature and elevated suspended sediment(SS) concentration. As the propagation of density currents that formed by density difference between inflow and ambient water affects reservoir water quality and ecosystem, an understanding of reservoir density current is essential for an optimization of filed monitoring, analysis and forecast of SS and nutrient transport, and their proper management and control. This study was aimed to quantify the characteristics of inflow density current including plunge depth($d_p$) and distance($X_p$), separation depth($d_s$), interflow thickness($h_i$), arrival time to dam($t_a$), reduction ratio(${\beta}$) of SS contained stream inflow for different flood magnitude in Daecheong Reservoir with a validated two-dimensional(2D) numerical model. 10 different flood scenarios corresponding to inflow densimetric Froude number($Fr_i$) range from 0.920 to 9.205 were set up based on the hydrograph obtained from June 13 to July 3, 2004. A fully developed stratification condition was assumed as an initial water temperature profile. Higher $Fr_i$(inertia-to-buoyancy ratio) resulted in a greater $d_p,\;X_p,\;d_s,\;h_i$, and faster propagation of interflow, while the effect of reservoir geometry on these characteristics was significant. The Hebbert equation that estimates $d_p$ assuming steady-state flow condition with triangular cross section substantially over-estimated the $d_p$ because it does not consider the spatial variation of reservoir geometry and water surface changes during flood events. The ${\beta}$ values between inflow and dam sites were decreased as $Fr_i$ increased, but reversed after $Fr_i$>9.0 because of turbulent mixing effect. The results provides a practical and effective prediction measures for reservoir operators to first capture the behavior of turbidity inflow.

• Journal of the Korea Concrete Institute
• /
• v.19 no.6
• /
• pp.785-793
• /
• 2007

An electrochemical transient response technique was used to study the corrosion of reinforcing steel bar in the concrete. Analysis of the transient electrochemical potential response in a corrosion interface to an applied current has enabled the separate components that make up the measured transient response to be isolated. These components display a range of resistances and capacitances, dependent on the corrosion conditions of the reinforcing steel, which may be attributed to the corrosion process, to effects within the concrete cover or to film effects on the surface of the concrete. In this technique, the corrosion rate was evaluated by summing all of the resistances in the separate components to obtain an aggregated corrosion resistance. However, it is possible that not all resistances identified are associated with the corrosion process. The results obtained show that the corrosion rates are significant dependent on the assignment of the separate components to either corrosion or to other processes. The assignment of resistive components associated with the corrosion rate can be clearly identified by taking a series of the transient measurement at different lateral distances from the corroding reinforcing steel. An inappropriate selection of measurement time however may result in an additional resistance, which is not associated with corrosion, being included or part of the resistance associated with corrosion being left out.

• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.4 no.2
• /
• pp.91-107
• /
• 1992

A numerical formulation is developed to solve the linear three-dimensional hydrodynamic equations which describes wind induced flows in a homogeneous shelf sea. The hydmdynamic equations are at the outset separated into two systems. namely, an equation containing the gradient of sea surface elevation and the mean flow (external mode) and an equation describing the deviation from the mean flow (internal mode). The Galerkin method is then applied to the internal mode equation. The eigenvalues are determined from the eigenvalue problem involving the vertical eddy viscosity subject to a homogeneous boundary condition at the surface and a sheared boundary condition at the sea bed. The model is tested in a one-dimensional channel with uniform depth under a steady, uniform wind. The analytical velocity profile by Cooper and Pearce (1977) using a constant vertical eddy viscosity in channels of infinite and finite length is chosen as a benchmark solution. The model is also tested in a homogeneous, rectangular basin with constant depth under a steady, uniform wind field (the Heaps' Basin of the North Sea scale).

• The KIPS Transactions:PartD
• /
• v.15D no.5
• /
• pp.599-608
• /
• 2008

Advanced wireless network and sensor technologies are capable of collecting information such as temperature, humidity, weight, and location about objects at real time in logistics area. Besides, users want to be notified of contextual information about interest of objects whenever they want it and wherever they want it. To satisfy these requirements, applications should collect and analyze contextual information at real time, and must support a service that can notify it to wanted users. Event-based service is one of the way to satisfy these requirement of users. In this paper, we design an event notification system focused on location- and RFID-based logistics area. To do this, we present XML-based event expression model, ECA-based profile definition model, and an algorithm that has high scalability by distinguishing event filtering in two steps. Based on these designs, our implemented system can apply to not only logistics area but also intelligent traffic control system based on RFID or GPS devices.

• Journal of Korean Society of Transportation
• /
• v.21 no.2
• /
• pp.71-82
• /
• 2003

The shortest path problems(SPP) are critical issues in the military logistics such as the simulation of the War-Game. However, the existing SPP has two major drawbacks, one is its accuracy of solution and the other is for only one solution with focused on just link cost in the military transportation planning models. In addition, very few previous studies have been examined for the multi-shortest path problems without considering link capacity reflecting the military characteristics. In order to overcome these drawbacks, it is necessary to apply the multi-shortest paths algorithm reflecting un-expected military incidents. This study examines the multi-shortest paths in the real networks using Shier algorithm. The network contains both military link capacity and time-based cost. Also, the modes are defined as a platoon(group) rather than unit which is used in most of previous studies in the military logistics. To verify the algorithm applied in this study. the comparative analysis was performed with various sizes and routes of network which compares with Dijkstra algorithm. The major findings of this study are as follows ; 1) Regarding the unique characteristics of the military transportation plan, Shier algorithm, which is applied to this study, is more realistic than Dijkstra algorithm. Also, the time based concept is more applicable than the distance based model in the military logistics. 2) Based on the results from the various simulations of this study the capacity-constraint sections appeared in each scenarios. As a consequence, the alternatives are necessary such as measures for vulnerable area, improvement of vehicle(mode), and reflection of separated-marching column in the military manuals. Finally. the limits and future research directions are discussed : 1) It is very hard to compare the results found in this study. which is used in the real network and the previous studies which is used in arbitrary network. 2) In order to reflect the real military situations such as heavy tanks and heavy equipment vehicles. the other constraints such as the safety load of bridges and/or the height of tunnels should be considered for the future studies.

• Journal of Food Hygiene and Safety
• /
• v.14 no.4
• /
• pp.422-427
• /
• 1999

Antimicrobial activity of Korean leek was effective on Staphylococcus aureus, Bacillus cereus, Bacillus subtilis, E. coli O157:H7, Pseudomonas fluorescens, Pichia membranaefaciens. Extract from raw Korean leek and that from frozen one showed antimicrobial activity; in contrast, extract stored frozen condition or extract from blanched one lost antimicrobial activity. Filtration, centrifugation, and vacuum concentration did not affect antimicrobial activity of the leek, nor did the changes in storage pHs. Addition of ground leek to soy milk, soy curd, and broth for cold noodle resulted in the prolonged shelf life by significantly reducing the number of viable cells.

• Journal of the Korean Society of Propulsion Engineers
• /
• v.1 no.2
• /
• pp.74-83
• /
• 1997

The definition of burning admittance and conventional n-$\tau$ stability rating technique are combined to investigate the high frequency combustion instabilities inside the cylindrical combustion chamber. Perturbed flow variables are written as the sum of fluctuating and time-averaged mean quantities on the assumption that the terms of the order higher than unity are sufficiently small, hence linearized governing equations could be formulated. Chamber admittances up and downstream of the flame front calculated with appropriate boundary conditions result in the burning admittance and corresponding n-$\tau$ neutral stability curve. Configurational and operational design factors are tested to detect the unstable wave-induced LOX-RP1 combustion instabilities. Operational design factors, e.g. pressure or O/F ratio, appear less influential to drive high frequency instability while the location of the flame front and configurational factors enhance or deteriorate the stabilities strongly. Conclusively, LOX-RP1 combustion inside the cylindrical combustion chamber is apt to be unstable against long residence time and shortened chamber length.

• Korean Chemical Engineering Research
• /
• v.56 no.2
• /
• pp.222-228
• /
• 2018

Benzene is one of the most widely used basic materials in the petrochemical industry. Generally, benzene exists as a mixture with alcohols rather than as a pure substance. Further, the alcohols-added mixtures usually exhibit an azeotropic composition. In this context, knowledge of the phase equilibrium behavior of the mixture is essential for its separation and purification. In this study, the vapor-liquid equilibrium data were measured in favor of a recirculating VLE apparatus under constant pressure for the 1 - propanol / benzene system. The measured vapor - liquid equilibrium data were also correlated by using the UNIQUAC and WILSON models and the thermodynamic consistency test based on the Gibbs/Duhem equation was followed. The results of the phase equilibrium experiment revealed RMSEs (Root Mean Square Error) and AADs (Average Absolute Deviation) of less than 0.05 for both models, indicating a good agreement between the experimental value and the calculated value. The results of the thermodynamic consistency test also confirmed through the residual term within ${\pm}0.2$.

• Journal of KIISE:Databases
• /
• v.32 no.6
• /
• pp.650-661
• /
• 2005

As the Internet is growing, the use of XML which is a standard of semi-structured document is increasing. Therefore, there are on going works about integration and retrieval of XML documents. However, the basis of efficient integration and retrieval of documents is to cluster XML documents with similar structure. The conventional XML clustering approaches use the hierarchical clustering algorithm that produces the demanded number of clusters through repeated merge, but it have some problems that it is difficult to compute the similarity between XML documents and it costs much time to compare similarity repeatedly. In order to address this problem, we use clustering algorithm for transactional data that is scale for large size of data. In this paper we use common structures from XML documents that don't have DTD or schema. In order to use common structures of XML document, we extract representative structures by decomposing the structure from a tree model expressing the XML document, and we perform clustering with the extracted structure. Besides, we show efficiency of proposed method by comparing and analyzing with the previous method.

• KSBB Journal
• /
• v.19 no.4
• /
• pp.274-283
• /
• 2004

Six lumbrokinase (LK) fractions from Lumbricus rubellus lysates were purified by a series of column chromatographies. The molecular weights of the six LK fractions appeared to range from 24.6 to 33.1 kDa. In the experimental model of rat venous thrombosis, the thrombus weight and PAI activity decreased significantly when the LK was administered orally. However, the activities of APTT, PT and plasmin showed a significant increase. The aggregation of rat platelets pretreated with various LK doses was inhibited by thrombin, and the MDA generation decreased. The rat thoracic aorta and mesentric arteries contracted with phenylephrine relaxed due to the treatment of the LK fractions. These results suggest that the fibrinolytic effects of LK were mediated not only by proteolytic activity, but also by the inhibition of platelet agregation and the relaxation of blood vessels. It is concluded that the LK may be useful as a hemolytic agent for treatment of fibrin clot.