• The Journal of Korea Institute of Information, Electronics, and Communication Technology
• /
• v.16 no.6
• /
• pp.406-412
• /
• 2023

In this paper, we studied the effect of noise caused by ambient light on a reflective PPG measurement device using infrared light. Noise caused by ambient light was examined by dividing it into general situations and special situations. In the general situation, noise due to changes in time and ambient light sources was randomly observed, and in the special situation, a halogen lamp was used to observe the effect of noise variations. In the experiment, PPG signals were measured and data acquired in real-time depending on each situation, and the measured data was analyzed in the time domain and frequency domain. First, through a general situation experiments, it was visually observed that noise increases with the brightness of ambient light, and through frequency analysis, it was observed that the noise sources were white noise, power line noise, and internal noise of the circuit. Futhermore, using a halogen lamp, we experimented with the change in noise depending on the change in distance from the ambient light and calculated the SNR. As a result of the experiment, an SNR of 3.2 dB was shown at a distance of 50 cm with an irradiance of 278.3 W/m². It was observed that normal measurement was difficult at SNRs below that, and an irradiance of 27.7 W/m² was obtained. It showed a value of 18.2 dB at a distance of 2 m, and it was observed that normal PPG measurement was possible through a filter at values above that.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.51 no.7
• /
• pp.26-36
• /
• 2014

The needs of active phased arrays antenna system is getting more increased for IMT-Advanced system efficiency. The active phased array structure consists of lots of small transceivers and radiation elements to increase system efficiency. The minimized module of high efficiency transceiver is key for system implementation. The power amplifier of transmitter decides efficiency of base-station. In this paper, we design and implement minimized module of high efficiency transceiver for IMT-Advanced active phased array system. The temperature compensation circuit of transceiver reduces gain error and the analog pre-distorter of linearizer reduces implemented size. For minimal size and high efficiency, the implented power amplifier consist of GaN MMIC Doherty structure. The size of implemented module is $40mm{\times}90mm{\times}50mm$ and output power is 47.65 dBm at LTE band 7. The efficiency of power amplifier is 40.7% efficiency and ACLR compensation of linearizer is above 12dB at operating power level, 37dBm. The noise figure of transceiver is under 1.28 dB and amplitude error and phase error on 6 bit control is 0.38 dB and 2.77 degree respectively.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.39 no.12
• /
• pp.547-552
• /
• 2002

In this paper, the path loss in domestic terrain environments for IMT-2000 are measured and considered. Domestic terrain environments are classified and received power is measured at 1.9201GHz. In addition, the Path loss is calculated with consideration of the radiation pattern of antennas based on the results of measurement. For the consideration of path loss in domestic terrain environments, each path loss are fitted with the same slope of a reference model as "COST-231 HATA Urban Model", and then both are compared. As a result, all of the path loss in domestic terrain environments are lower than the path loss of a reference model as "COST-231 HATA Urban Model". We found that a difference of path loss in domestic terrain environments and a reference model is 5dB in urban, 8dB in sparse urban, 12dll in dense suburban, 13dB in suburban, 19dB in sparse suburban, and 29dB in road.

• Korean Journal of Optics and Photonics
• /
• v.25 no.6
• /
• pp.315-325
• /
• 2014

A combination of MHL and LED fish-luring light is used in this study. Its yield, characteristics, and irradiance distribution are evaluated and analyzed. To obtain an irradiance distribution similar to that of an MHL, we suggest the optimal arrangement of MHL and LED.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.21 no.8
• /
• pp.911-918
• /
• 2010

With limitation of frequency bandwidth, the range accuracy of typical radars is limited. In this paper, for short distance measurements, the use of an AM(Amplitude Modulated) radar which provides improved range accuracy is proposed. The AM radar signal consists of a carrier frequency signal and double-sideband components. The fabricated AM radar operates with +10 dBm output power and 35 dB receiver gain at 24.128 GHz center frequency with 20 MHz bandwidth, and the range accuracy is measured as ${\pm}15\;cm$.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.19 no.4
• /
• pp.451-460
• /
• 2008

Gregorian offset dual-shaped reflector antennas have been widely used in the satellite communication systems for their high gain and low sidelobe characteristics. However, in this paper, it is designed as the CATR(Compact Antenna Test Range) reflector system, and its near-field characteristics are investigated. The CATR facility needs to provide an uniform plane wave with the minimum amplitude and phase ripple and the low cross polarization to the test region. Therefore, the reflector near-field patterns are calculated and presented with the variations of the aperture power distribution, the feed horn pattern, and the distance from the aperture to the test zone. Also, the offset dual-shaped reflector is fabricated at 30 GHz, and its near-field patterns are measured. The measured results are in good agreement with the calculated results. From theses results, we confirm that the designed offset dual-shaped reflector can be used as the reflector system for the compact antenna test range.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.22 no.1
• /
• pp.1-8
• /
• 2011

This study is about the limits of GTEM cell using correlation factor between the OATS(Open area Test Site) and the GTEM cell. First, the field strengths at the 10 m distance OATS and in GTEM cell to obtain the experimental correlation factor are measured. Also, the EMI limits of radiated power are derived in GTEM cell as 3 position method is inversely transformed. The field strengths that calculated from theoretical models by 3 and 15 position methods are programmed and compared with measured data at the OATS. As the EMI limits of GTEM cell is newly defined, it will be use to substitute GTEM cell for OATS to efficiently measure EMI(Electromagnetic Interference).

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.17 no.1 s.104
• /
• pp.74-80
• /
• 2006

This paper presents the characteristics of electromagnetic field uniformity in a reverberation chamber that can be used alternatively for the analysis, test and evaluation of electromagnetic interference and immunity. The dual-band diffuser, which can be used at two different frequency bands in a reverberation chamber, is applied, and it is made of two different single-band Schroeder's Quadratic Residue Diffusers. The FDTD method is used to analyze the field characteristics. Compared with single-band diffuser, the dual-band diffuser shows the improvement in not only expansion of test frequency band but also in characteristics of the field uniformity, polarity, power efficiency, and tolerance. Therefore, the reverberation chamber with the dual-band diffuser is a better facility, for the analysis and measurement of electromagnetic interference and immunity, than the reverberation chamber with a single-band diffuser.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.19 no.2
• /
• pp.207-213
• /
• 2008

A simplified design procedure for quasi-Yagi antenna arrays using an ultra-wideband balun is presented. The proposed antenna design procedure is based on the simple impedance matching among antenna components: i.e., balun, feed, and antenna This new broadband and high gain antenna array is possible due to the ultra-wideband performance of the balun. As design examples, wideband $1\times4$ and $1\times8$ quasi-Yagi antenna arrays are successfully designed and implemented in Ku-band with frequency bandwidths of about 50 % and antenna gains of 9$\sim$10 dBi and 11$\sim$12 dBi, respectively. And the simulated and measured results demonstrate wide bandwidths and good radiation properties. These antenna arrays can be applied to various phased-array and spatial power combining systems.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.50 no.6
• /
• pp.43-55
• /
• 2013

In this paper, we propose a cylindrical active phased array antenna of Beam Steering Characteristics in the horizontal plane(H-plane) and vertical plane(E-Plane) on the cylinder form array structure. We design the bent dipole antenna of the cylindrical array structure adapted excellent mutual-coupling characteristics, designed and manufactured the cylindrical array antennas and power combiner/divider unit for power dividing and combining on the antenna. The radiating elements array spacing of Cylindrical array antenna were determined to avoid grating lobes at half power beam steering. Beam steering of the antenna was implemented with 6-bit phase shifter in the transceiver and have been designed based on the characteristics the antenna beam steering at -24 degrees to 24 degrees horizontal, vertical 0 degrees to 36 degrees beam steering. A cylindrical active phased array antenna that produced for verification the performance of the antenna are measured radiation characteristics in accordance with beam steering at L-Band.