• Proceedings of the Korean Vacuum Society Conference
• /
• 2011.08a
• /
• pp.319-319
• /
• 2011

KSTAR ICRF 안테나 장치에서 외곽 플라즈마 밀도분포는 고주파 출력이 내부로 전달되는 효율을 위해 중요하게 다루어 진다. 따라서 1.5T의 자기장에서 플라즈마에 간섭없이 0~$10^{14}/cm^3$의 외곽 플라즈마 밀도분포를 측정할 수 있는 Q-band 대역의 x-mode 반사계가 필요 하였다. 헬리콘 플라즈마는 $10^{13}/cm^3$ 이상의 높은 플라즈마 밀도를 수 kW 이내의 rf power와, 수 MHz 대역의 고주파원을 사용하여 높은 에너지 효율로 얻을 수 있다. 이때 높은 플라즈마 밀도는 외곽 플라즈마 밀도 와 비슷하여 제작한 반사계를 테스트 할 수 있다. 본 연구에서는 x-mode microwave 반사계를 제작하고, 1kW rf power와 10MHz 고주파원으로 헬리콘 플라즈마를 생성하여 정전 탐침으로 진단하였고, 반사계의 Q-band대역의 주파수를 가변 하여 반사되어 나오는 마이크로파의 beat 주파수를 통해 밀도 분포를 얻어서 정전탐침과 비교 분석하였다.

• Korean Chemical Engineering Research
• /
• v.40 no.6
• /
• pp.676-680
• /
• 2002

The specific gravity meter is the instrument used to measure the density of fluids under the reference conditions and it can be widely used in industrial areas, especially in massive flow rate natural gas industry. This study has been carried out in an attempt to improve measurement accuracy of natural gas flow rate calculation, providing the adequate installation and proper operation conditions of specific gravity meter. The test results are 1) the density measurement errors in case of using methane and standard gas as calibration gases are smaller than using methane and nitrogen gas, 2) the periodical calibration to maintain accurate density measurements is essential, and 3) the specific gravity meter is sensitive to changes of environmental conditions, especially environmental temperature surrounding the specific gravity meter.

• Proceedings of the Korean Society of Precision Engineering Conference
• /
• 2004.05a
• /
• pp.54-54
• /
• 2004

집속체의 드래프트 공정(롤러 인발 공정)의 경우, 선밀도의 변동성(irregularity)은 드래프트 비, 롤러 간격 등의 공정조건과 집속체, 응집도, 엉킴 등으로 대표되는 openness 애 큰 영향을 받는다. 본 연구에서는 유동계 내에서의 집속체 동적거동을 묘사하는 기본 방정식을 바탕으로 openness 와 직접적인 관련이 있는 구성모델의 주요 파라메타($\mu$)의 변동을 auto-covariance function 으로 묘사되는 확률과정 신호(stochastic signal)로 생각하여, 이 신호를 생성하고, 모델 시뮬레이션을 통하여 출력 집속체의 선밀도 변동을 살펴 보았으며, 출력 집속체의 선밀도가 거의 일정하게 유지되는 출력구간 근처에서 선밀도 불균제 특성을 해석하였다.(중략)

• Proceedings of the Korean Vacuum Society Conference
• /
• 2011.02a
• /
• pp.218-218
• /
• 2011

Tokamak 플라즈마는 ICRF 영역에서 외곽 플라즈마 부근에 CUT-OFF밀도가 있으며, 이보다 낮은 밀도에서는 ICRF 전파가 투과하지 못하는 전파 장벽이 존재하게 된다. 이때 전달되는 효율은 안테나 부하저항으로 알 수 있으며, 이는 전파장벽이 낮을수록 큰 값을 갖는다. 따라서, 전파장벽은 에너지 전달 효율을 급격히 떨어뜨리므로 전파 장벽의 특성을 분석하고 이를 낮추는게 매우 중요하다. CUT-OFF 밀도는 자기장, k_par, 구동주파수, 플라즈마 밀도에 의존하게 되고, 측정한 밀도 분포를 통해 전파장벽의 구간을 안다면,이를 이용하여 안테나의 부하저항과의 의존성을 알 수 있다. 본 연구에서는 이러한 외곽 플라즈마 밀도 분포를 얻기 위해 토카막의 언저리 영역에서 플라즈마에 간섭없이 $10^{18}{\sim}10^{19}m^{-3}$의 플라즈마 밀도를 진단할 수 있는 9GHz~30GHz의 microwave를 사용하는 반사계를 설계하였으며,플라즈마 변수와 ICRF 운전 변수에 따른 부하저항의 계산결과와 반사계 시스템 설계에 대한 내용이 발표될 것이다.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2012.08a
• /
• pp.264-264
• /
• 2012

자화된 플라즈마 매질 내부에 진행하는 전자기파중에서 ${\omega}_{ci}$ ${\ll}({\omega}_{ci}{\omega}_{ce})_{1/2}{\ll}{\omega}{\ll}{\omega}_{ce}{\ll}{\omega}_{pe}$의 주파수 대역을 사용하여 헬리콘 방전을 발생시킨다. 수 kW의 RF 출력을 사용하는 헬리콘 플라즈마원은 자기장, 중성가스 압력 및 RF 주파수 등을 포함한 방전 조건에 따라 급격하게 플라즈마 밀도가 증가하고, 유사한 플라즈마 발생원에 비하여 높은 효율을 가진다. 이러한 헬리콘 플라즈마가 높은 이온화 효율을 갖는 원인을 알아보기 위해 반사계로 플라즈마 밀도를 측정하였다. 본 연구에서는 helical 타입의 안텐를 이용하여 직경 15 cm pyrex관 내부에 플라즈마를 발생시켰고, 플라즈마 진단을 위해 33~40 GHz의 주파수로 FMCW방식을 이용한 반사계로 플라즈마 밀도를 측정하였다.

• Journal of the Korea Society for Simulation
• /
• v.22 no.3
• /
• pp.1-6
• /
• 2013

The ecosystem is the complex system consisting of various biotic and abiotic factors and the factors interact with each other in the hierarchical predator-prey relationship. Since the competitive relation spatiotemporally occurs, the initial state of population density and species distribution are likely to play an important role in the stability of the ecosystem. In the present study, we constructed a lattice model to simulate the three-trophic ecosystem (predatorprey- plant) and using the model, explored how the ecosystem stability is affected by the initial density. The size of lattice space was $L{\times}L$, (L=100) with periodic boundary condition. The initial density of the plant was arbitrarily set as the value of 0.2. The simulation result showed that predator and prey coexist when the density of predator is less than or equal to 0.4 and the density of prey is less than or equal to 0.5. On the other hand, when the predator density is more than or equal to 0.5 and the density of prey is more than or equal to 0.6, both of predator and prey were extinct. In addition, we found that the strong nonlinearity in the interaction between species was observed in the border area between the coexistence and extinction in the species density space.

• KSBB Journal
• /
• v.14 no.5
• /
• pp.633-637
• /
• 1999

Supercritical fluid of carbon dioxide was used to investigate the effects of its temperature and density on the distribuion coefficients of fatty-acid esters composing fish oil. The distribution coefficient of fatty acid ester was greatly different from each other according to the temperature and density of the supercritical fluid. The possibility of separation of a certain fatty acid from the mixture of fatty acids was tested. The density of the supercritical fluid showing the great differences ofthe distribution coefficients among the fatty acid esters ranged from 0.3 g/mL to 0.4 g/mL. The retrograde condensation took place at high densities of the supercritical fluid.

• Journal of the Korean Wood Science and Technology
• /
• v.45 no.5
• /
• pp.629-639
• /
• 2017

Tripitaka Koreana in Haein Temple, Hapcheon Province is the most historical and largest heritage in this country, however the species of their blocks have yet been unknown. A nondestructive test method is necessary to investigate their species. The oven-dry density of wood was measured by inversely using the principle of high frequency moisture meter. The oven-dry densities of more than 100 domestic species of specimens estimated by measurement method and high frequency moisture meter were compared and following conclusions were obtained. There was highly close correlation between the oven-dry density estimated by measurement method and the oven-dry density estimated by high frequency moisture meter. The densities of Tripitaka Koreana that was a global cultural heritage could be correctly estimated by using high frequency moisture meter and the equilibrium moisture content under which Tripitaka Koreana equilibrated, thus, it was expected to provide the key to species identification.

• Proceedings of the Korean Institute of Building Construction Conference
• /
• 2017.05a
• /
• pp.210-211
• /
• 2017

According to KS F 2560, water-reducing agents used when mixing concrete are to undergo quality evaluation testing slump, air contents, setting time, etc., when delivered from the admixture factory to the ready mixed concrete site. Yet in actual acceptance testing this could be substituted by the score report of the admixture company, in which a possibility of low reliability lies. Therefore this study sought to analyze whether by artificially changing the solid content rate of lignin- and naphthalene-based water-reducing agents and using a liquid densimeter evaluate the quality of the admixture. The results showed that the Type B liquid densimeter was most appropriate and 50cc the most appropriate capacity for the mass cylinder. Also, judging from the changes in density and pH according to the changes in solid content rate, it concludes that a rapid appraisal of the quality of lignin- and naphthalene-based water-reducing agents would be possible using a Type B liquid densimeter.

• The Journal of Engineering Geology
• /
• v.18 no.4
• /
• pp.483-492
• /
• 2008

The characteristics of joint system (joint orientation and density) were studied for Cretaceous sedimentary rocks in the Nakdong River mid-basin (Haman-Gun, Changnyeong-Gun, and Uiryeong-Gun areas), and were related with faults, river system, and groundwater usage in the study area. The joint system was classified into JI ($N90^{\circ}-110^{\circ}E$), J2 ($N0^{\circ}-35^{\circ}E$), and J3 ($(N0^{\circ}-35^{\circ}W$), and was dominant along N-S and E-W directions. The N-S trending joint system is dominant in Haman Formation in the eastern and western parts of the study area, while the E-W trending joint system is prevalent in Chilgok Formation in the central part. The joint system may be associated with the faults located in the eastern and western parts in the study area which are elongated to NNE-SSW direction. Additionally, the joint density is higher along the Nakdong River, indicating close relationship between E-W trending joints and the river. Daily groundwater discharge versus joint density shows weak positive relationship, and specific capacity versus joint density appears negatively related. This indicates that groundwater occurrence does not greatly rely on joint density.