• Journal of the Korean Ceramic Society
• /
• v.38 no.2
• /
• pp.193-198
• /
• 2001

유한요소법을 이용하여 STS VOD 래들에서 내장 내화물의 재질 및 back filler의 시공 위치에 따른 열응력을 수행하였다. 불소성 내화물의 경우 높은 열전도율에 의해 가동면과 배면(back face)간의 온도구배가 소성품에 비해 감소하였으며 탄성계수도 낮아 발생되는 열응력이 2~4배 낮았다. Back filler는 dolomite 내화물의 열간 팽창을 흡수하기 위해 시공하는 것으로, 상대적으로 낮은 열전도율을 가지고 있기 때문에 back filler의 내부와 외부에 급격한 온도구배가 발생된다. 결과적으로 래들의 내부는 고온을 유지하여 내화물이 팽창이 되고, 외부는 온도가 낮아지므로 수축되어 열응력이 증가하였다.

• Applied Biological Chemistry
• /
• v.27 no.3
• /
• pp.204-210
• /
• 1984

Hydration of twelve japonica (j) and nine j x indica rice varieties was analyzed in terms of mathematical rate equation and a tentative classification of milled rice was attempted primarily on the basis of water uptake race of rice grain at room temperature. No two rice varieties had the same water uptake rate or diffusion coefficient. The rice samples could be classified into three groups. Rices which are considered as having good eating quality had lower water uptake rate.

• Proceedings of the KSME Conference
• /
• 2007.05b
• /
• pp.3418-3422
• /
• 2007

The neutron imaging technique was used to investigate the water discharge characteristics at PEMFC. Prior to investigation of water discharge characteristics, the linear attenuation coefficient for water at Neutron Radiography Facility (NRF) was calibrated. The feasibility test apparatus was consisted of pressurized air and water in order to simulate the actual operating PEMFC. The feasibility tests have been performed at 1-parallel serpentine type with 100 $cm^2$ active area and different air flow rate (1, 2, and 4 lpm). The total water volume variations at each condition were calculated from the neutron images. The water at channel is well discharged as soon as supplying the pressurized air into the PEMFC. However, because the water at MEA isn't removed the total water volume is constant after 150. Therefore more effective method is needed in order to discharge water at MEA, and the neutron imaging technique is helpful for it.

• Economic and Environmental Geology
• /
• v.48 no.2
• /
• pp.147-160
• /
• 2015

In 2014, on 31 August and 1 September, the emissions of $CH_4$, $CO_2$, and $O_2$ gases were measured six times using the closed chamber method from exposed tidal flat sediments in the same position relative to the low point of the tidal cycle in the Eoeun-ri, Taean-gun, on the Mid-western Coast of Korea. The concentrations of $CH_4$ in the air sample collected in the chamber were measured using gas chromatography with an EG analyzer, model GS-23, within 6 hours of collection, and the other gases were measured in real time using a multi-gas monitor. The gas emission fluxes (source (+), and sink (-)) were calculated from a simple linear regression analysis of the changes in the concentrations over time. In order to see the surrounding parameters (water content, temperature, total organic carbon, average mean size of sediments, and the temperature of the inner chamber) were measured at the study site. On the first day, across three measurements during 5 hours 20 minutes, the observed $CO_2$ flux absorption was -137.00 to $-81.73mg/m^2/hr$, and the $O_2$ absorption, measured simultaneously, was -0.03 to $0.00mg/m^2/hr$. On the second day using an identical number of measurements, the $CO_2$ absorption was -20.43 to $-2.11mg/m^2/hr$, and the $O_2$ absorption -0.18 to $-0.14mg/m^2/hr$. The $CH_4$ absorption before low tide was $-0.02mg/m^2/hr$ (first day, Pearson correlation coefficient using the SPSS statistical analysis is -0.555(n=5, p=0.332, pronounced negative linear relationship)), and $-0.15mg/m^2/hr$ (second day, -0.915(n=5, p=0.030, strong negative linear relationship)) on both measurement days. The emitted flux after low tide on both measurement days reached a minimum of $+0.00mg/m^2/hr$ (+0.713(n=5, p=0.176, linear relationship which can be almost ignored)), and a maximum of $+0.03mg/m^2/hr$ (+0.194(n=5, p=0.754, weak positive linear relationship)) after low tide. However, the absolute values of the $CH_4$ fluxes were analyzed at different times. These results suggest that rate for $CH_4$ fluxes, even the same time and area, were influenced by changes in the tidal cycle characteristics of surface sediments for understanding their correlation with these gas emissions, and surrounding parameters such as physiochemical sediments conditions.

• Proceedings of the Korea Concrete Institute Conference
• /
• 2002.10a
• /
• pp.161-166
• /
• 2002

The modification factor( k-factor) of equivalent damping ratio utilized in the current state-of-the-practice to account for the imperfection of reinforced concrete structures in hysteresis loop is investigated. From this, it is found that the current modification factor does not include the effect of cyclic loading, one of the important characteristic properties of earthquake loading. This could be taken into account by considering the energy absorption efficiency based on the cummulative plastic deformation. From the study, it is suggested that the current approach for the modification factor for the equivalent damping ratio should be reformed.

• Journal of Environmental Health Sciences
• /
• v.28 no.2
• /
• pp.131-139
• /
• 2002

초기생애단계의 일본송사리를 실험어류로 사용하여 TCDD와 PCB 126의 생물농축정도를 비교 측정하였고, TCDD와 PCB 126의 체외 배설에 대한 동태학적 특성을 비교 분석하였다. 생물농축실험은 초기생애단계의 새끼치어 및 어린 물고기에 TCDD와 PCB 126을 여러 농도로 물에 용해시켜 96시간 동안 정체된 상태로 폭로시킨 후 생물농축계수(BCF)와 지방-표준화한 생물농축계수(BCF$_{L}$)를 측정하였다. TCDD와 PCB 126의 일본송사리 초기생애단계의 새끼치어 및 어린 물고기에서 측정된 96-h BCF값 및 96-h BCF$_{L}$값은 폭로된 농도와 상관없이 비슷하게 나타나 반면, 생체크기가 클수록 그 값은 작게 나타났다. 일본송사리 새끼치어, 어린 물고기, 성어의 생체 내 총 지방함량은 각각 5.7, 4.2, 4.6%로 측정되었다. 체외배설 동태실험은 어린 물고기에 TCDD와 PCB 126을 3가지 농도롤 물에 용해시켜 96시간 동안 정체된 상태로 폭로시킨 후, flow-through장치로 공급되는 맑은 물로 옮겨 42일간 사양하면서 0, 7, 14, 21, 28, 42일에 생체 내 TCDD와 PCB 126 잔류량을 측정하여 분석하였다. 배설은 1차 반응속도론적으로 이루어졌으며 한 구획모형보다 두 구획모형이 더 적합한 것으로 분석되었다. 두 구획모형을 사용한 분석에서 TCDD와 PCB 126의 체외배설 반감기(t$\frac{1}{2}$) 및 배설속도상수($\beta$)는 각각 27.2일과 32.3일 및 0.025/d와 0.021/d로 측정되었다.

• Proceedings of the KSME Conference
• /
• 2004.11a
• /
• pp.1658-1663
• /
• 2004

The feasibility test was performed to check the possibility of 2-phase flow visualization and water distribution at inside the PEMFC using neutron radiography image technique. It was composed using water and pressured air. From the image, several 2-phase flow patterns were discovered and water fraction was estimated by the reference specimen and image analysis.

• Korean Journal of Air-Conditioning and Refrigeration Engineering
• /
• v.4 no.4
• /
• pp.332-341
• /
• 1992

An absorption heat pump cycle has been modeled and simulated to analyze the system performance of water-cooled, series-flow, double-effect absorption heat pump, which can be applied to a direct gas fired cooling system with the medium range of cooling capacity (15RT level). Effect of absorption cooling system parameters, such as concentration difference, inlet temperature of cooling water, 1st generator temperature, leaving temperature differences of condenser and evaporator and efficiency of solution heat exchanger, has been investigated in the view of system cooling performance.

• Transactions of the Korean Society of Mechanical Engineers
• /
• v.8 no.2
• /
• pp.162-170
• /
• 1984

대부분의 동적댐퍼들은 주구조물의 진동진폭을 정해진 주파수 변위내에서 최대로 줄이는 것을 목 표로 한다. 그러나 공작기계의 안정성은 시편과 공구사이의 상대변위와 절삭력에 의해 결정되는 전달함수의 최대크기에 의해서보다는 실수부분의 최소치에 의해 결정된다는 것이 잘 알려져 있 다. 본 논문에서는 이 사실에 착안하여 공작기계에서 발생하는 채터를 흡수하기 위한 최적의 댐 퍼를 설계하는 절차를 제시하고 1 자유도로 대표될 수 있는 구조물의 경우에 대하여 구체적인 방 법을 예시하였다. 종래의 최적 댐퍼의 성질을 구하는 방법에 비해 수학적인 절차가 약간 복잡해 지기는 하나 전산기를 이용하여 큰 어려움이 없이 최적의 설계자료를 얻을 수 있다. 댐퍼 질량이 정해졌을 때 감쇠율과 스프링 계수를 변수로 하는 목표함수가 하나의 식으로 유도될 수 없기 때 문 에 간단한 최적화 방법으로 이변수 황금분할법을 사용하였다. 수치적인 예를 통하여 종래의 다른 방법에 의한 결과와 비교하고 제안된 방법론의 타당성을 입증하였다.

• Korean Journal of Air-Conditioning and Refrigeration Engineering
• /
• v.13 no.8
• /
• pp.720-729
• /
• 2001

The effect of vapor flow direction on falling film heat transfer was experimentally investigated by using water. Parallel flow (both water and vapor downwards) showed higher heat exchange performance than counterflow(downward water and upward vapor). The difference became significant as the vapor flow rate was increased. It is supposed that the uprising vapor disturbs the solution film flow and heat transfer is reduced by uneven distribution or detachment of water film.