• The KIPS Transactions:PartC
• /
• v.9C no.4
• /
• pp.531-542
• /
• 2002

An input and output buffering ATM switch conventionally operates in either Queueloss mode or Backpressure mode. Recently, a new mode, which is called Hybrid mode, was proposed to overcome the drawbacks of Queueloss mode and Backpressure mode. In Hybrid mode, when both the destined output buffer and the originfted input buffer are full, a cell is dropped. This thesis analyzes the cell loss rate and the cell delay of Queueloss, Backpressure and Hybrid modes in a switch adopting output-port expansion scheme under uniform traffic. Output-port expansion scheme allows only one cell from an input buffer to be switched during one time slot. If several cells switch to a same destined output port, the number of maximum transfer cells is restricted to K (Output-port expansion ratio). The simulation results show that if an offered load is less than 0.9, Hybrid mode has lower cell loss rate than the other modes; otherwise, Queueloss mode illustrates the lowest cell loss rate, which is a different result from previous researches. However, the difference between Hybrid and Queueloss modes is comparably small. As expected, the average cell delay in Backpressure mode is lower than those of Queueloss mode and Hybrid mode, since the cell delay due to the retransmission of higher number of dropped cells in Backpressure mode is not considered.

• Journal of Advanced Navigation Technology
• /
• v.15 no.4
• /
• pp.571-577
• /
• 2011

This paper presents a novel balanced filter design based on a metamaterial structure applicable to differential-mode excitation. The metamaterial structure is based on a unit-cell which under a differential-mode excitation behaves like composite right/left-handed(CRLH) metamaterial with filter characteristics. In contrast, the metamaterial unit-cell is below cut-off under a common-mode excitation. Experimental results are used to verify the proposed metamaterial's differential-mode characteristics. The metamaterial is fabricated with a balanced filter design resulting in an operating frequency range of 960~1000 MHz with a insertion loss of 4.1 dB.

• Journal of Broadcast Engineering
• /
• v.7 no.4
• /
• pp.300-309
• /
• 2002

The object of this paper is to make temporal direct mode clear by providing a solution to the following problem : if the co-located block in the list 1 reference picture for direct mode has only the 1ist 1 motion vector or both the 1ist 0 and list 1 motion vectors, then which motion vector will be used for the direct mode motion vector calculation\ulcorner This paper also shows how to derive reference picture index and direct mode motion vector for each list in order to guarantee the high coding efficiency. when the co-located macroblock is in intra mode. Furthermore, the reasonable calculation methods for the direct mode motion vectors in the various cases are presented. Finally, experimental results show that the proposed temporal direct mode provides the comparable performance against the spatial direct mode. Therefore, the simulation proves that the proposed temporal direct mode is acceptable.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.16 no.3
• /
• pp.429-436
• /
• 2021

The wind profilers operated by the Korea Meteorological Administration observe in a low mode for intensive observation of the low levels and a high mode for intensive observation of the high levels. The LAP-3000 wind profiler installed in Bukgangneung and Changwon is characterized by the same sampling frequency of the low mode and the high mode, allowing to compare winds observed in both modes at the same altitude. As a result of analyzing the wind speed of the two points for one year in 2020, the correlation between the two modes was up to 0.2 lower than the correlation with radiosonde. The T-test for the wind speed of the two modes showed a particularly significant difference in October, where the temperature and specific humidity fluctuate frequently. The difference in the development of the atmospheric boundary layer affects the accuracy of the wind speed depending on the observation mode.

• Journal of Broadcast Engineering
• /
• v.13 no.1
• /
• pp.152-161
• /
• 2008

We investigate that when we restrict the encoding modes on the enhancement layer based on that of the base layer exploiting the high correlation between the best modes at base and enhancement layers, we should determine the set of surviving search modes to yield the minimum excessive RD-cost caused by the restriction. Based on these sets, we implement a fast mode decision algorithm for H.264 Scalable Extension (SE). Simulation results show that the proposed algorithm is superior in the sense of the RD-performance to the conventional mode restriction method which is based on the conditional probabilities of the best modes.

• Journal of KSNVE
• /
• v.8 no.6
• /
• pp.1166-1171
• /
• 1998

The influences of the coupler consisting of stiffness and mass between neighboring two spans on mode localization are studied theoretically, and the results are confirmed by numerical examples. The mass of the coupler makes a structure sensitive to mode localization especially in higher modes while the stiffness does in all modes. A new type of delocalization phenomenon is observed for the first time in some modes for which mode localization does not occur or is very weak although structural disturbances are severe. A spring-mass system consisting of two substructures and a coupler connecting them is considered in the part of analytical study. As example structures for numerical analysis. simply supported continuous two-span beams with a coupler having a rotational stiffness and a mass moment of inertia on the mid support are considered.

• Transactions of the Korean Society of Mechanical Engineers A
• /
• v.40 no.11
• /
• pp.955-962
• /
• 2016

In recent years, there have been emerging needs for standardized software-based motion application development for better scalability and support for multiple operation modes for small quantity batch production. Although a software-based motion system provides a basis for constructing multiple operation modes on a machine, it is not easy to construct such systems without tools for defining multiple motion operation modes and standardized mode-change protocols. This paper proposes a motion recipe concept to overcome this problem; the concept includes the authoring of multiple motion operation modes using the PLCopen-compliant motion function blocks and communication protocols to trigger operation mode changes from an external interface. The motion recipe was implemented by extending an IEC 61131-3 compliant IDE called Beremiz, and the correctness of the motion recipe-based application behavior was verified on a real testbed.

• Journal of KSNVE
• /
• v.6 no.1
• /
• pp.35-44
• /
• 1996

This paper presents a new type of fuzzy-sliding mode controller for robust tip position control of a single-link flexible manipulator subjected to parameter variations. A sliding mode controller is formulated with an assumption that imposed parameter variations are bounded so that certain deterministic performance can be guaranted. In the design of the sliding mode controller, so called moving sliding surface is adopted to minimize the reaching phase and thus mitigate system sensitivity to the variations. The sliding mode controller is then incorporated with a fuzzy technique to reduce inherently ever-existing chattering which is impediment in position control of flexible manipulators. A set of fuzzy parameters and control rules are obtained from a relation between predetermined sliding surface and representative points in the state space. Computer simulations are undertaken in order to demonstrate superior control performance of the proposed methodology.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.44 no.4
• /
• pp.18-23
• /
• 2007

This paper presents a transmissive dispersion compensator based on tilted chirped fiber Bragg grating pairs which happen mode coupling between core mode and cladding mode. And, as a result of simulation, the phase matching condition and optimum tilted angle to maximize the mode-coupling in the dispersion compensator are shown and the dispersion slope and bandwidth in the proposed dispersion compensator is respectively 3,068ps/nm and 0.45nm.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2003.10a
• /
• pp.967-969
• /
• 2003

Because of the rapid growth of Internet, the firewall is generally used to protect the network sorority. The firewall on Linux or FreeBSD Kernal, which is widely used, supports either Gateway or Bridge Mode. In this study, we present the firewall which supports simultaneously Gateway and Bridge Mode. For the application service, it is suggested that the firewall which has excellent expandability ran construct a network without another proxy.