• Korean Journal of Optics and Photonics
• /
• v.18 no.4
• /
• pp.235-240
• /
• 2007

A ceramic stem based TO package incorporating a coplanar waveguide feed-line has been proposed allowing for 10 Gbps grade data transmission. The frequency response of a cylindrical feed-line fer a conventional metal based TO package was first analyzed, and compared with that of the CPW feed-line used for a ceramic based package such as a butterfly package. For the case where a DFB LD chip is packaged to an LD module, the measured 3 dB frequency bandwidths for the conventional and proposed packages were 3.5 GHz and 7.8 GHz respectively, which agree well with the theoretical results obtained from the modeling based on the small signal equivalent circuits. Consequently, we proposed a novel ceramic based TO package with a CPW feed-line in ceramic material as a stem to improve the frequency characteristics of the conventional one. And, its performance was theoretically observed to confirm that the proposed package provides even wider frequency bandwidth compared to the conventional one.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.44 no.4
• /
• pp.1-9
• /
• 2007

Linearity is the one of the most important features for analog-optic transmission system. In our research, the available bandwidth for the feed-forward compensation circuit is enhanced by using a 180 hybrid coupler in the circuit. The bandwidth having the decreased 3rd-order intermodulation distortion(IMD3) over 10 dB is extended over 200 MHz with the center frequency of 1.6 GHz. We performed an efficient bandwith measurement for the feed-forward compensation system, which uses the network analyzer instead of the traditional measuring system that uses two RF signal generators and the spectrum analyzer. We identify the usefulness of this method from experimental results. In this study, we used cheap digital-purpose laser diodes for economical aspect, which proves the efficiency of the proposed analog system. The spurious-free dynamic range is improved about 6 dB/Hz.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.19 no.1
• /
• pp.136-142
• /
• 2005

In this paper, we wrote about the basic experimentation of Optical CT's temperature characteristic to measure high-current in a super-high-voltage electric power equipment which is using Faraday effect. We used the 1310[nm] Laser Diode as the light source and PIN Photodiode as receiver. For the transmission line of light, we used 30[m] single mode fiber which could maintain the state of polarization in the optical fiber. For the experiment, the temperature transformation device make by aluminium. the The range of current was from 400[A] and 1300[A] and the range of temperature was from $-40[^{\circ}C]\;to\;50[^{\circ}C]$. In a same experimental condition, magnitude increased input current increase follow by increasing proportion of input current.

• The KIPS Transactions:PartC
• /
• v.9C no.4
• /
• pp.581-588
• /
• 2002

In this paper, we newly propose the optical CDMA routing scheme for the radio access network. At the radio base station (RBS), the received radio signals are multiplied by the PN codes and converted to the CDMA radio signals. In the next optical CDMAS are performed and multiplxed by using the PN codes which are the addresses of the routing mobile switching center (MSC). At the MSC, the CDMA radio signals are routined to another MSC by the CDM receiver at the routing node. In the case MSC is equal to the desired MSC, the radio signal is correlated by the two-layerd spectrum despreading at a time. Finally we theoretically analyze the signal-to-interference and noise power ratio of regenerated signal and the routing error probability and show the availability of proposed scheme.

• Journal of the Korean Electrochemical Society
• /
• v.14 no.3
• /
• pp.145-151
• /
• 2011

ZnSe, as a II-VI compound semiconductor which has a wide band gap in the visible region is applicable to the various fields such as laser diode, display and solar cell. By using the electrochemical deposition method, ZnSe thin film was synthesized on the ITO glass substrate. The synthesis of ZnSe grains and their structure having zinc blende shape were verified through the analysis of XRD and SEM. UV spectrophotometric method determined the band gap as the value of 2.76 eV. Applying the DFT (Density Functional Theory) in the molecular dynamics, the band structure of ZnSe grains was analyzed. For ZnSe grains with zinc blende structure, the band structure and its density of state were simulated using LDA (Local Density Approximation), PBE (Perdew Burke Ernzerhof), and B3LYP (Becke, 3-parameter, Lee-Yang-Parr) functionals. Among the calculations of energy band gap upon each functional, the simulated one of 2.65 eV based on the B3LYP functional was mostly near by the experimental measurement.

• Analytical Science and Technology
• /
• v.25 no.4
• /
• pp.223-229
• /
• 2012

Analytical signal from ICP was compensated by the light scattering of sample aerosols. Reference scattering signal was generated by a He-Ne or diode laser, monitored for the amount of aerosol producing and used for the compensation of analytical signals. The result showed that significant improvement in precision could be achieved for the short-term signal (within 1 minute) from 3.4% to 0.9% RSD in signal and 14.9% to 4.2% for the long-term (10 minutes) for Be, Pb and Co. This method is very useful not only for the pulse type but for continuous type signals especially when a nebulizer is unstable. To improve long-term precision, higher stability is required in the scattering cell and detector as well as the reduction of noise from the line between a nebulizer and plasma.

• The Journal of Korean Physical Therapy
• /
• v.14 no.4
• /
• pp.87-94
• /
• 2002

Low intensity laser irradiation is potential physical agent that triggers the muscle regeneration by previous study. In muscle regeneration, a number of growth factors also promotes that is triggered in response to muscle damage. The transforming growth factor(TGF)-$\beta$ is involved in the activation of cell proliferation and the inhibition of cell differentiation in muscle regeneration. This is secreted not only autocrine system but also paracrine and endocrine. Therefore, We investigated that effects of Gallium aluminum arsenide(GaAlAs) diode laser for the expression of TGF-$\beta$ on lumbar spinal cord after extensor digitorum muscle crush injury. After laser irradiation, the immunoreactivity of TGF-$\beta$ was increased bilaterally in gray mater of spinal cord. Especially, in 1 day, experimental group was highed than control, and in 3 day, lateral motor nucleus were storong immunoreactivy of TGF-$\beta$. Also, in 1 and 2 day, TGF-$\beta$ was showed in white mater as well as gray mater, but in 3 day, only showed in gray mater. These data may suggests to the establishment of laser irradiation on spinal cord for skeletal muscle injury.

• Journal of the Korean Society of Manufacturing Technology Engineers
• /
• v.21 no.3
• /
• pp.459-464
• /
• 2012

The point of impact, the shot group, and the flight traces depend on the combination of unique features which decide moving traces of the arrow (paradox of the archer, length of the arrow shaft, weight, angle of the feather, and spline of the arrow shaft). The more dense the impact points in the shot group and the earlier elimination of paradox of the archer, the higher assessment is given for the product. However, there is no way to objectively assess the efficiency and quality of the arrow, and there is no numeric data to be used as the basis for comparison with other products. Although capturing the images of flying arrow using a high-speed motion picture camera is possible, we are limited to observation from specific view angle only. Hence, the criteria for efficiency and quality assessment are mostly based on subjective opinions of experts or hunters, or review on consumers' remarks. In this paper, we propose a hardware composition that are based on three detection frames consisting of line lasers and photo diode arrays without the high-speed motion picture camera. Predicated on measured coordinates data, a nobel method for the archer's paradox measurement, a key parameter that determine the arrow's trajectory, and corresponding numerical analysis model is proposed.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2012.02a
• /
• pp.297-297
• /
• 2012

양자점은 공간적으로 세 방향 모두 전하의 운동을 제한하는 0차원 구조로 불연속적인 상태 밀도를 가진다. 이런 양자점의 특성은 광통신용 소자, 레이저 다이오드 등과 같은 광학 및 전자 장치에 응용될 수 있기 때문에 많은 주목을 받아 활발히 연구되어 왔다. 본 연구에서는 MBE 장비를 이용하여 GaAs 기판위에 InAs 양자점을 성장시키는 동안 As의 공급을 임의로 차단시켜 양자점 형성 조건을 변화시킨 시료들의 광학적 특성을 Photoluminescence (PL) 와 Time-resolved PL (TRPL) 실험을 이용하여 분석하였다. GaAs (001) 기판 위에 GaAs buffer layer를 $610^{\circ}C$에서 성장한 후, $470^{\circ}C$에서 As 공급 조건 변화에 따른 InAs 양자점을 성장하였다. 양자점을 성장한 후 GaAs cap layer를 $610^{\circ}C$에서 성장하였다. InAs 양자점 시료들은 In을 20초 공급하는 동안 As의 공급과 차단을 각각 1초, 2초, 3초의 일정한 간격으로 반복하였다. 10 K에서 각각의 시료들의 PL을 측정한 결과 As 공급과 차단을 2초씩 반복한 T2시료에서 PL 세기가 가장 좋게 나타났으며, 3초씩 반복한 T3시료에서 가장 나쁘게 나타났다. PL 피크는 공급과 차단을 1초씩 반복한 T1 시료가 1.23 eV, T2 시료가 1.24 eV, T3 시료가 1.26 eV에 나타났으며, As의 차단시간이 증가함에 따라 PL 피크가 높은 에너지로 이동함을 보였다. 발광파장에 따른 PL 소멸은 파장이 증가함에 따라 점차 느려지다가 PL 피크 근처에서 가장 느린 소멸곡선을 보이고, 파장이 더 증가하였을 때 점차 빠르게 소멸하였다. As 공급 조건의 변화에 따라 InAs 양자점의 크기와 밀도, 모양 등이 변하는 것을 Atomic Force Microscope (AFM) image를 통하여 확인하였으며, PL과 TRPL을 이용하여 InAs 양자점의 광학적 특성을 분석하였다.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.10 no.6
• /
• pp.1186-1190
• /
• 2009

In this paper, we studied on a characteristic of movement of charged particle in equal electric field. In order to fabricate a panel, we used positive charged toner particles of black and negative one of yellow. Panel was biased rectangle pulse without any overshoot. Also, panel's optical characteristics with contrast ratio and viewing angle is measured with RT-200. Response time was measure by using incident laser and detective photodiode. The distribution of m/q of particles by driving in panel throughout the contrast ratio and response time. As a results, driving voltage, contrast ratio, and response time are decided by m/q of charged particles and when m/q of charged particles in panel have regular distribution, it is induce improvement driving characteristics.