• Information Display
• /
• v.22 no.4
• /
• pp.34-44
• /
• 2021

90년대 초 LCD (Liquid Crystal Display)는 연관된 반도체 산업과 함께 제2산업의 쌀로 불리며 정부와 관련업계의 높은 관심 속에 큰 성장을 이루었다. 삼성은 일본 기업에 비해 LCD 개발을 늦게 시작했지만 패널 대형화와 넓은 광시야각을 구현한 PVA (Patterned Vertical Alignment) 모드 (mode)를 실현하고, 여기에 더하여 측면 시인성 문제까지 해결한 공정이 단순하며 높은 대비비를 구현하는 SPVA (Super Patterned Vertical Alignment) 및 PSVA (Polymer-Stabilized Vertical Alignment) 모드를 개발하였다. 이와 동시에 새로운 액정 주입 방식인 ODF (One Drop Filling) 기술을 최초로 양산에 접목함으로써 LCD 산업에서 경쟁사들이 따라올 수 없는 훨씬 앞선 제1 주자가 되었다. 이 보고서는 삼성이 SPVA와 PSVA 모드를 역경 속에서 타사들과 어떻게 경쟁하며 발전시켜 왔는가에 대한 내용과 ODF 기술에 대해 삼성의 고유 자산권을 침해하지 않는 범위 내에서 서술하고자 한다. ※ 대비비: 화면의 백색상태 (white state)와 암흑 상태 (black state)의 광비 (光比)

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.15 no.11
• /
• pp.1075-1081
• /
• 2004

In this paper, a VCO of a general advance warning system for vehicle's speed limitation in the X-band used in Japan is designed using a small signal scattering coefficient of PHEMT. A varactor diode that wide tuning range and series resistance 0 H is used for designing the VCO and -85 dBc/Hz of phase noise at 10 kHz of offset frequency is obtained by adjusting the reflection coefficient between the micro-strip line and the varactor device which determines transistor's operation voltage and resonant frequency, In addition +4.5 dBm of basic frequency signal output level and -25.6 dEc of the second harmonic constraint are acquired. Sample that produce in this paper could confirm that more excellent special quality appears than existing products in sensitivity.

• Journal of Advanced Marine Engineering and Technology
• /
• v.39 no.1
• /
• pp.68-74
• /
• 2015

This paper describes about the efficiency improvement of switched reluctance generator (SRG) over the rated speed region. Since the current shape has a great influence on the loss of the machine, so the system efficiency can be improved by optimizing the current shape. In case the wide speed range application such as wind power and medium size hydraulic power generation, a method of switching angle control is suggested to obtain the wanted current shapes. In order to verify the method, the experimental platform is set up. The feasibility of the theory is verified by simulation and experimental results.

• Journal of the Korean Chemical Society
• /
• v.26 no.6
• /
• pp.407-413
• /
• 1982

The rate constants of the nucleophilic addition of cysteine to 3,4-methylenedioxyphenylmethylene malononitrile were determined by UV Spectrophotometry and a rate equation which can be applied over wide pH range was obtained. On the basis of rate equation, it may be concluded that the rate constants were dependent upon only the concentration of hydroxide ion above pH 9.0, however, below pH 6.0, the reaction were initiated by the addition of neutral cysteine molecule to carbon-carbon double bond and at pH 7.0~9.0, the addition of a neutral cysteine molecule and it's anion occurred competitively.

• Proceedings of the KWS Conference
• /
• 2010.05a
• /
• pp.20-20
• /
• 2010

GTA (Gas Tungsten Arc)용접은 불활성 분위기에서 용접이 이루어지기 때문에 타 아크용접법에 비해 용접부 품질이 우수하여 고품질이 요구되는 산업분야에 널리 이용되고 있다. 하지만 스테인리스강으로 pipe를 제조하기 위해 GTA 용접을 적용할 경우, Laser 및 고주파 용접 (HFIW)에 비해 용접부 품질 및 용접속도가 낮기 때문에 pipe를 제조하는 산업에서 적용에 제한을 받고 있다. 하지만, GTA는 laser 혹은 HFIW에 비해 가격이 1/10수준으로 낮고, 용접부 gap tolerance 및 용접면 관리범위가 넓은 장점이 있기 때문에 GTA의 용접속도 및 용접품질을 향상시키기 위한 연구가 꾸준히 진행되고 있다. 일반적으로 스테인리스강 GTA용접 시 용접속도를 향상시키기 위해, 모재의 성분 제어 (합금성분 최적화-Al, S, Se, O등), Flux 도포 기술 (산화물을 용접전에 도포하여 용접속도 향상) 및 혼합보호가스 적용 등이 있다. 스테인리스강 용접 시 보호가스로는 용접부 품질을 확보하기 위해 Ar을 주로 사용하고 있다. 하지만 용입 특성을 향상시키기 위해 아크의 온도를 높일 수 있는 He, 혹은 $H_2$ gas를 단독 혹은 혼합하여 사용하고 있다. 오스테나이트계 스테인리스의 경우 용입특성을 향상시키기 위해 Ar에 $H_2$를 2~10%정도 혼합하여 사용하고 있다. 페라이트계 스테인리스강은 수소에 대한 고용도가 상대적으로 작아 용접부 수소 취화를 일으킬 수 있기 때문에 적용에 제한을 받고 있어 그 대안으로 산소를 극히 소량을 혼합하여 용입성 향상에 대한 연구가 보고 되고 있다. 따라서 본 연구에서는 페라이트계 스테인리스강의 용입특성을 향상시킬 목적으로 Ar에 산소를 미량 첨가 (1%미만) 하여 용접전류 및 산소 함량에 따른 용입특성의 변화에 대해 연구하였다. 또한 기계적인 물성 및 부식특성을 평가하였고, 최종적으로 실용화 가능성을 파악하기 위해 용접전극의 수명 테스트를 실시하였다. 실시한 결과, 산소가 첨가량 증가 할수록 용입특성은 상승하였으며, 기계적인 물성 또한 산소를 첨가하지 않은 경우에 비해 거의 유사한 값을 얻을 수 있었다, 하지만 산소함량이 증가 할수록 전극의 수명은 감소하여 교체주기가 증가함을 알 수 있다. 본 연구를 통해 얻어진 기술을 상용화시키기에는 극복해야할 문제가 있지만, 소재 합금성분 설계 시 용접생산성 향상위한 산소성분 범위를 제시할 수 있으리라 판단된다.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.20 no.1
• /
• pp.48-56
• /
• 2006

This paper studies particularly applicable method for sensorless PM BLDC motor drive system. The waveform of the motor internal voltages(or back emf) contains a fundamental and higher order frequency harmonics. Therefore the third harmonic component is extracted from the stator phase voltage. The resulting third harmonic signal keeps a constant phase relationship with the rotor flux for any motor speed and load condition. Also because of low resolution of estimated signal obtained by the proposed sensorless algorithm, to improve the wide range of speed response characteristic more exactly, we propose the rotor position signal synthesizer using PLL circuit based on estimated signals. Some experimental results are provided to demonstrate the validity of the proposed control method.

• Journal of the Korean Chemical Society
• /
• v.41 no.4
• /
• pp.198-204
• /
• 1997

The rate constants for the hydrolysis of N-(2,4-dinitrophenyl)benzhydrazonyl bromide and its derivatives were determined by ultraviolet visible spectrophotometry at 20$^{\circ}C$ and a rate equation which could be applied over a wide pH range was obtained. On the basis of rate equations derived and judging from the solvent effect, substituent effect, salt effect, thermodynamic parameter, plausible mechanisms of hydrolysis have been proposed. It may be concluded that the hydrolysis through SN1 mechanism via carbonium ion intermdiate to pH 3.0, and pH 10.0, the hydrolysis proceeds through 1,3-dipolar or SN2 mechanism.

• 한국생물공학회:학술대회논문집
• /
• 2003.04a
• /
• pp.719-723
• /
• 2003

The dispersing activity and physical properties of exopolysaccharide (Cystan) produced by Cystobacter sp. MSL-9 was studied. Dispersing activity of Cystan was measured by using bentonite, calcium carbonate, and kaolin. Rheological properties of Cystan were investigated by using a rheometer MCR300. It was found that dispersing activity of Cystan was maintained under various pH and temperature conditions. A particle size analyzer BI-9000AT was used for the particle size measurement of Cystan in aqueous solution. The high dispersing activity and stability under various pH and temperature conditions showed the feasibility of Cystan as a industrial biodispersant.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.43 no.5
• /
• pp.405-412
• /
• 2015

This paper represents a filter design to estimate the airspeed of a spin-stabilized, trajectory-correctible artillery ammunition. Due to the limited power and space in operational point of view, the airspeed sensor is not installed, and thus the airspeed need to be estimated using limited sensor measurements. The only IMU measurements(three-axis specific forces and angular rates) are used in this application. The extended Kalman filter algorithm is applied since a linear filter can not cover the its wide operational range in airspeed and altitude. In the implementation of the EKF, the state and measurement equations are transformed into the no-roll frame for simple form of Jacobian matrix. The simulation study is conducted to evaluate the performance of the filter under various environment conditions of sensor noise and wind turbulence. In addition, the effect of the choice in filter design parameters, i.e. process error covariance matrices is analyzed on the performance of the estimation of airspeed and angular rates.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.6 no.2
• /
• pp.202-208
• /
• 2001

A Switched Reluctance Motor(SRM) has double salient poles structure and the phase windings are wound in stator. SRM hase more simple structure that of other motor, thus manufacture cost is low, mechanically strong, reliable to a poor environment such as high temperature, and maintenance cost is low because of brushless. SRM needs position detector to get rotator position information for phase excitation and tachometer or encoder for constant speed operation. But, this paper doesn\`s use an encoder of high cost for velocity measurement of rotator. Instead of it, the algorithm for position detection and velocity estimation from simple slotted disk has been proposed and developed. To implement variable speed digital control system with velocity estimation algorithm, the TMS320F240-20MIPS fixed point arithmetic processor of TI corporation is used. The experimental results of the developing system are enable to control speed with wide range, not only single pulse, hard chopping mode and soft chopping, ut also variable speed control, and advance angle control.