• Transactions of the Korean Society of Mechanical Engineers
• /
• v.15 no.5
• /
• pp.1462-1471
• /
• 1991

본 연구에서는 미소 결함주위에서 발생, 전파하는 균열들에 미치는 초기 결함 깊이와 상호 간섭 영향을 검토하기 위하여 기존 재료가 갖고 있는 결함이나 비금속 개 재물로 대신할 수 있다고 생각되는 미소 원공의 크기를 변화시킨 모델에 대해 유한 요 소법을 이용하여 3차원적으로 응력을 해석하였다. 실제 사용하고 있는 부재에 결함 들이 존재할 경우 응력장의 간섭으로 피로 균열 진전이 가속화됨으로 미소 원공 주위 의 응력 분포 및 미소 원공사이의 응력장의 간섭과 미소 원공에서 발생, 전파하는 표 면 균열의 응력 확대 계수에 미치는 영향에 대하여 비교검토 하였다.

• Journal of Korea Water Resources Association
• /
• v.48 no.1
• /
• pp.9-21
• /
• 2015

This study examined pollution level of sediment in Sookchun lake, and studied dredging validity by examining phosphorous release characteristics on surface polluted soil. Total phosphorous, the principal cause of algal blooms, exceeded dredging assessment standards regarding Daechung lake (1.5 mg/g) at all points. Also at all points, total nitrogen exceeded the dredging assessment standard regarding Paldang Lake (1.1 mg/g), but fell short of the standard regarding Daechung lake (3.0 mg/g). Dredging zone was suggested in this study is Chuso water body (WS-6~WS-12) in Sookchun lake. In relation to sediment pollution levels measured at different depths, LOI tended to decrease as it became deeper. The concentrations of T-N varied depending upon the depth as well as points, but no regular pattern was observed. The depth and site did not significantly influence T-P. From the results of phosphorous release tests, it was shown that total phosphorous release flux was calculated to be $7.2{\sim}15.4mg/m^2/d$ for anaerobic condition, $0.5{\sim}2.0mg/m^2/d$ for aerobic condition and $2.0{\sim}4.1mg/m^2/d$ for facultative condition. Release flux and T-P concentration of surface sediments had positive correlation ($R^2$ 0.7871). And The corelation between release flux and DO condition in reactor had strong negative correlation ($R^2$ 0.8824).

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.13 no.3
• /
• pp.69-78
• /
• 1993

A testing system has been developed to evaluate the seasonal variation of the resilient modulus of granular subgrade soils. Two sites were successfully instrumented with soil moisture-temperature cells to monitor over a period of one year, the field temperature and moisture content underneath the pavement. Multiple regression equations were developed to determine the resilient modulus under environmental conditions. It is noted that the use of the effective resilient modulus at the location of the Average Depth of Significant Stress (ADSS) provides a reasonable basis for determining subgrade properties. In addition, a theoretical model has been developed to predict the resilient modulus due to the change of temperature and moisture condition.

• Korean Journal of Optics and Photonics
• /
• v.10 no.4
• /
• pp.348-353
• /
• 1999

Ray-optics approach based on the rigorous coupled wave theory, called by the rigorous ray-optics method (RROM), is developed for the calculation of couling coefficients of waveguide grating devices. The coupling coefficients of several grating structures, such as rectangular, sinusoidal, triangle, and trapezoidal shapes, are determined by the RROM, and they are compared with those obtained by conventional methods of the ray-optics method (ROM) and the coupled mode method (CMM). In the case of rectangular gratings, the coupling coefficients is evaluated in detail by various depths and duty-cycles of the grating. We have found that the RROM gives more exact solutions for the coupling coefficients of even arbitrary shapes of diffractive waveguide grating devices than the other conventional methods.

• Journal of the Korean Geotechnical Society
• /
• v.28 no.2
• /
• pp.43-55
• /
• 2012

In this study, the resistance bias factors are calculated to determine the resistance factor of Gravel Compaction Piles which is one of the soft ground improvement methods. In order to calculate resistance bias factors for gravel compaction piles, two ultimate bearing capacities were analyzed. One is the ultimate bearing capacity in 2.54 cm settlement measured using data of the field loading test on 41 piles and the other is the ultimate bearing capacity calculated using the seven equations concerning bulging failure. The results of analysis show that the probability density function of the calculated ultimate bearing capacities has a lognormal distribution. Resistance bias factor and the coefficient of variation for Greenwood equation are 0.91 and 0.38, respectively, and for those of Hughes & Withers are 1.19 and 0.39. The two equations are suitable for calculating resistance factors for LRFD of soil improvement using gravel compaction piles.

• Journal of the Korean Geotechnical Society
• /
• v.20 no.8
• /
• pp.159-166
• /
• 2004

In this study, experiments on the SWCC were performed in order to find out the characteristics of unsaturated soil and to analyze the stability of unsaturated weathered slopes with rainfall-induced wetting. Several soil types classified by mixture portion of clay (CH) in the weathered soil (SW) were used in experimental tests. To achieve the SWCC, the filter paper method was used on SW with varying clay contents. A tensiometer test was used for measuring wetting front suction of the soils in a laboratory with varying relative densities. Based on the experimental results, it is shown that the wetting front suction increases as clay contest of mixture soil increases : in particular, the wetting front suction increases sharply as the clay contents increase. It is also found that wetting front suction affects the initial wetting band depth and stability of the slope.

• Journal of the Korea institute for structural maintenance and inspection
• /
• v.13 no.5 s.57
• /
• pp.160-168
• /
• 2009

After steel bar was corroded it removes concrete contaminated, it does steel bar corrosion protection, repairing method and corrosion inhibitor spreading method are difficult to secure corrosion protection performance. Accordingly, in this research before Research and Development to penetrate corrosion inhibitor to high pressure by steel bar position, it measures penetration depth through corrosion inhibitor high pressure penetration experiment and amount of nitrite by position and then it predicts penetration depth in accordance with water-cement ratio, pressure, pressure time and it computed water-cement ratio, pressure, pressure time to be more than 0.6 mol ratio of chloride ion and nitrite to have outstanding corrosion protection performance. As a result of experiment, water-cement ratio gives the biggest influence to penetration of corrosion inhibitor and also the more depth of specimen becomes deep, concentration of penetrated corrosion inhibitor does not equal and becomes low.

• Journal of The Korean Society of Agricultural Engineers
• /
• v.57 no.3
• /
• pp.41-54
• /
• 2015

시간-면적 기법을 이용해 유역의 수문과정을 묘사하는 분산형 (distributed) 연속 (continuous) 강우유출모형인 HYSTAR의 거동특성과 주요 매개변수에 대한 민감도를 분석하였다. 유역의 수문조건에 따른 모형거동의 변화를 분석하기 위해 연속되는 4개의 개별 강우사상에 대한 민감도를 조사하고 비교하였다. 또한, 매개변수의 상호작용이 민감도 분석결과에 미치는 영향을 파악하기 위해 두 가지 서로 다른 기법 (one-factor-at-a-time 과 all-factor-at-a-time 방법)을 이용하여 산정된 민감도를 비교하였다. 분석결과, 모형의 직접유출량, 첨두유량 및 도달시간 모의결과는 유출곡선번호 (curve number)에 가장 민감하게 반응하는 것으로 나타났으며, 토양의 깊이, van Genuchten 식의 매개변수, 작물계수에 큰 영향을 받았다. 한편, 모의된 기저유출량은 토양의 깊이를 비롯하여 van Genuchten 식의 매개변수, 작물계수 (crop coefficient), 이방성계수 (anisotropic coefficient), 유출곡선번호의 변화에 민감하였다. 매개변수에 대한 민감도는 분석에 이용된 강우사상에 따라 다르게 나타났으며, 유역의 토양수분조건에 따라 다르게 거동하는 모형의 중요한 특성을 잘 반영하였다. 두 가지 서로 다른 기법을 이용한 민감도 분석결과는 모의된 직접유출량 및 기저유출량의 변화가 매개변수의 상호작용에 의해 제한될 수 있음을 보여 주었다. 본 연구는 HYSTAR 모형의 매개변수에 대한 민감도 분석을 통해서 해당 모형의 거동을 정량적으로 보여주었고, 이를 통해 모형의 건전성 (soundness)을 입증할 수 있는 하나의 근거를 제시하였다. 본 연구결과는 향후 HYSTAR 모형을 이용한 수문분석 시 보정을 위한 매개변수 선정에 활용될 수 있을 것으로 사료된다. 또한, 본 연구결과에서 나타난 민감도의 수문조건 (또는 선정된 강우사상)에 대한 의존성은 연속유출 모형의 민감도 분석을 위한 강우 사상 선정 및 민감도 분석결과의 해석에 유용한 정보를 제공할 수 있을 것으로 기대된다.

• Journal of the Korean Society for Nondestructive Testing
• /
• v.32 no.2
• /
• pp.192-197
• /
• 2012

In this paper, a non-contact microwave technique was presented to detect the surface crack of the metals. An open-ended coaxial cable line was used as a sensor at 11 GHz, and the reflection coefficients were measured by scanning along the metal surface including artificial surface cracks. A parameter, the K value which was defined as the difference between maximum and minimum reflection coefficients, was measured and used to estimate the crack depth. A linear relationship between the K value and crack depth was found. This study showed that non-contact detection of the surface cracks of metals is possible using the open-ended coaxial line sensor at X-band.

• Journal of the Korean Geotechnical Society
• /
• v.15 no.5
• /
• pp.29-41
• /
• 1999

This Paper applied a simple strength parameter averaging method to double layered systems consisting of the strong sand layer overlying the soft clay deposit. This study derived a formula which defines a critical depth as the strength parameters, and used the correction parameter, $\alpha$ to reduce an error of the strength parameter averaging method. The results of the method were presented in the form of dimensionless charts and were compared with the results of several solutions proposed by Satyanarayana & Grag, Sreenivasulu, and Meyerhof & Hanna. The results of the proposed method coincided with the method of Meyerhof & Hanna and the results obtained from FLAC. But the Satyanarayana & Grag method and the Sreenivasulu method overestimated the bearing capacity. Consequently, the bearing capacity of foundation on sand layer overlying soft clay layer can be approximately estimated by using the proposed dimensionless charts.