• Journal of Advanced Marine Engineering and Technology
• /
• v.19 no.3
• /
• pp.33-41
• /
• 1995

본 연구는 터보 과급기 부착 디젤 기관의 급가속 운전시 기관과 과급기의 과도 응답 성능을 규명하고 이를 개선하기 위한 실험을 수행하였다. 과도 응답 성능 구명은 일정한 회전 속도로 정상 운전중인 기관의 연료 펌프 랙을 10%에서 40%까지 일정 시간동안 급가속하였을 경우에 대하여 수행하였으며, 이때의 과급기 응답 지연 현상을 개선하기 위한 실험은 급가속과 동시에 압축기 출구의 흡기메니폴드 내에 일정한 압력의 공기를 추가 분사하는 방법을 이용하였다. 그리고 공기 분사 압력, 공기분사 기간, 가속률, 가속 시간 등이 압축기 출구의 압력과 온도, 터빈 입구의 압력과 온도, 실린더 압력, 기관과 과급기 회전 속도 등의 응답 성능에 미치는 영향을 가속전 정상 상태의 기관 회전 속도와 적용부하의 변화에 따라 시간의 함수로 나타내었다.

• Journal of the korean Society of Automotive Engineers
• /
• v.16 no.4
• /
• pp.51-61
• /
• 1994

기관의 출력성능은 기관으로 공급되는 연료공기의 혼합기량에 따라서 크게 달라진다. 이것은 기관의 출력성능은 기관으로 공급되는 흡기 용량에 따라서 변화하기 때문이다. 고출력을 얻기 위하여는 동일한 조건의 경우 흡기량을 증가시켜 기관 실린더 내에서 많은 연소 열에너지를 생성하는 것이 필요하다. 이러한 관점에서 기관의 체적 효율(volumetric efficiency)을 증가시킬 목적으로 여러가지 흡기 계통의 개서을 도모하고 있으나 흡기 용량을 증가시키는 방법의 하나는 과급기(supercharger)를 이용하는 과급 방식이다. 이와같은 과급방식은 기관의 출력성능의 향상을 가져오지만 기관 내부의 노크(knock), 연소 압력 및 열부하의 증가, 연비 문제등에 관한 여러가지 문제점이 제기되고 있다. 여기서는 과급에 적용되는 과급기의 종류와 과급 성능 특성 등에 대하여 살펴보고 과급기관의 성능에 대하여 다루기로 한다.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.19 no.7
• /
• pp.9-15
• /
• 2018

The turbochargers, which are used widely in diesel and gasoline engines, are an effective device to reduce fuel consumption and emissions. On the other hand, turbo-lag is one of the main problems of a turbocharger. Bearing friction losses is a major cause of turbo lag and is particularly intense in the lower speed range of the engine. Current turbochargers are mostly equipped with floating bearings: two journal bearings and one thrust bearing. This study focused on the bearing friction at the lower speed range and the experimental equipment was established with a drive-motor, load-cell, magnetic coupling, and oil control system. Finally, the friction losses of turbochargers were measured considering the influence of the rotating speed from 30,000rpm to 90,000rpm, oil temperature from $50^{\circ}C$ to $100^{\circ}C$, and oil supply pressure of 3bar and 4bar. The friction power losses were increased exponentially to 1.6 when the turbocharger speed was increased. Friction torques decreased with increasing oil temperature and increased with increasing oil pressure. Therefore, the oil temperature and pressure must be maintained at appropriate levels.

• Journal of the Korean Society of Fisheries and Ocean Technology
• /
• v.32 no.3
• /
• pp.310-315
• /
• 1996

엔진 배기가스의 동력과 유량이 배기행정의 직전 단계에서 관찰되었다. 배기가스 양을 적당히 조정함으로써 터보 과급의 입구 압력을 증가시킬 수 있었으며 엔진의 흡기, 소기 및 배기과정에서 가스질량과 엔진의 동력, 그리고 터보과급 효과도 감소하였다. 터보 과급장치를 기하학적으로 적절화시킴으로써 싸이클의 동기화 및 동력의 효율이 고려된 열교환 과정의 효율 기준도 제기되었으며 디젤엔진의 연소싸이클을 재수정하는 과정과 터빈의 동역학적 특성도 제시되었다.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.18 no.1
• /
• pp.585-591
• /
• 2017

Turbocharging is widely used in diesel and gasoline engines as an effective way to reduce fuel consumption. But turbochargers have turbo-lag due to mechanical friction losses. Bearing friction losses are a major cause of mechanical friction losses and are particularly intensified in the lower speed range of the engine. Current turbochargers mostly use oil bearings (two journal bearings and one thrust bearing). In this study, we focus on the bearing friction in the lower speed range. Experimental equipment was made using a drive motor, load cell, magnetic coupling, and oil control system. We measured the friction losses of the turbocharger while considering the influence of the rotation speed, oil temperature, and pressure. The friction power losses increased exponentially when the turbocharger speed increased.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.7 no.7
• /
• pp.86-93
• /
• 1999

Turbocharger has been used to increase the performance of diesel engine, especially ship engine , for years. Recently, the turbocharger is being adopted not only for an agricultural engine but also for an automobile engine. To improve the performance of diesel engine , the problem of the reduction of A/F ratio in high speed should be solved. Turbocharger is well known for its cost effectiveness, reliability and duration . In this study, an experiment was conducted to verify simulation program . The results for natural aspiration engine and turbocharged engine were compared. In order to estimate the characteristics of exhaust gas, D-13 mode was selected. Power, torque and BSFC of turbocharged engine were increased than those of natural aspiration engine by about 48%, 46% and 5%, respectively . The components in exhaust gas except NOx from turbocharger engine were less than the amount set up for 2000-year regulation.

• Journal of the Korean Institute of Gas
• /
• v.17 no.5
• /
• pp.8-14
• /
• 2013

Hydrogen-natural gas blends(HCNG) engine is optimizing technology of performance and emission characteristics with use of hydrogen's fast flame speed and wide flammability limit. As lean-burn limit is extended, the improvement in thermal efficiency and harmful emissions can be achieved. However, the extension of lean-burn limit under a wide open throttle operation point could be realized with the increase in boosting capacity in a lean-burn engine with turbo-charging system. In the present study, the power output characteristics of HCNG engine with turbo-charger change is assessed and feasibility of the increase in boosting capacity is evaluated. The turbo-charger design with high efficiency at higher flow rate rather than higher boosting pressure makes efficient operation possible at relatively rich mixture condition.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.38 no.6
• /
• pp.451-464
• /
• 2014

This study used numerical methods to investigates investigate the exhaust gas recirculation (EGR) effect under the condition of boost pressure condition on a homogeneous charge compression ignition (HCCI) combustion engine using numerical methods. The detailed chemical-kinetic mechanisms and thermodynamic parameters for n-heptane, iso-octane, and PRF50 from the Lawrence Livermore National Laboratory (LLNL) are were used for this study. The combustion phase affects the efficiency and power. To exclude these effects, this study decided to maintain a 50 burn point (CA50) at 5 CA after top dead center aTDC. The results showed that the EGR increased, but the low temperature heat release (LTHR), negative temperature coefficient (NTC), and high temperature heat release (HTHR) were weakened due by theto effect of the O2 reduction. The combined EGR and boost pressure enhanced the autoignition reactivity, Hhence, the LTHR, NTC, and HTHR were enhanced, and the heat-release rate was increased. also In addition, EGR decraeased the indicated mean effective pressure (IMEP), but the combined EGR and boost pressure increased the IMEP. As a results, combining the ed EGR and boost pressure was effective to at increase increasing the IMEP and maintaining the a low PRR.

• Journal of the korean Society of Automotive Engineers
• /
• v.7 no.4
• /
• pp.24-31
• /
• 1985

본 논문은 Comprex압력파 과급기(Pressure-wave Supercharger;이하 PWS)의 공기 역학적인 원 리에 대해 기술하였으며, 또 기체 동력학적인 현상들이 별도의 제어장치없이도 우수한 운전성과 낮은 연료소모율, 적은 배기 배출물을 형성하는 차량들에 대해 기계적으로는 간단하면서도 완벽 한 boosting장치를 만들어 내는데 어떻게 사용될 수 있는지를 설명하였다. 근본적인 목적은 종 래의 turbo charger와 동일이지만 Comprex PWS는 현재 응용되고 있는 승용차가 요구하는 여러 가지면, 즉 1) 부하변동에 대한 충진공기압의 빠른 응답성 2) 엔진속도 전영역에 걸친 높은 boost 효과 3) 배기배출물특성을 좋게할 수 있는 배기가스 재순환(EGR)효과 등에서 종래의 것과 구별된다. 따라서 PWS의 중요한 특징들을 기술하였으며 마지막으로 최근 자동차용 Diesel Engine에의 몇 가지 예를 보았다.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.37 no.10
• /
• pp.879-886
• /
• 2013

This study aims to provide helpful suggestions for understanding the effect of high EGR on DME HCCI combustion. This study determined which between oxygen partial pressure and oxygen concentration was the main factor affecting the LTHR heating ratio. Furthermore, EGR and the supercharging effect were investigated. To define the parameters for the EGR ratio and supercharging pressure, a numerical analysis of the chemical reaction was conducted under the following conditions: (1) variation of EGR ratio, oxygen concentration, and oxygen content; (2) variation of oxygen partial pressure while the oxygen concentration was almost constant; and (3) variation of oxygen concentration while oxygen partial pressure was constant with EGR and supercharging. The results show that an increase in EGR reduces the combustion duration. On the other hand, an increase in boost pressure increases the combustion duration. Finally, the EGR and boost pressure affect the amount of increase in LTHR.