• Journal of Advanced Marine Engineering and Technology
• /
• v.38 no.1
• /
• pp.23-30
• /
• 2014

To improve efficiency of diesel engine which requests high output recently and is used all kinds of industrial areas, this thesis experimented dynamic characteristics and exhaust gas characteristics of diesel engine installed by supercharger of correspondent output 200HP and natural inhalation diesel engine through the dynamometer and exhaust gas analyzer in same condition. As the result of experiment with natural inhalation diesel engine and diesel engine installed by supercharger, there were a few differences of output, but dynamic characteristics at high speed showed increased output and efficiency of the engine installed by supercharger. On the contrary, in exhaust gas characteristics, the model installed by supercharger showed increased exhaust gas such as $NO_X$, $O_2$, etc, but added value of exhaust gas is low if considering $CO_2$ reduction and efficiency of dynamic characteristic's increase. Based on the results, diesel engine installed by supercharger is expected to show higher economic feasibility than natural inhalation diesel than natural inhalation engine from an angle of efficiency. Keywords: 200hp class Turbocharger, Exhaust Gas, Engine Performance, Marine Diesel Engine.

• Journal of Advanced Marine Engineering and Technology
• /
• v.37 no.8
• /
• pp.911-917
• /
• 2013

This is a thesis about the experiment of comparison characteristic of power and exhaust gas in the same condition between diesel engine that is equipped response power 220HP turbocharger to increase effectiveness of the engine which is recently used in a lot of industry which requires high power. Resulting of the experiment with natural aspiration diesel engine and turbocharger diesel engine, difference in low speed is not significant, but in high speed, effectiveness of turbocharger diesel engine is much higher than the other one. In other hand, in exhaust gas experiment, turbocharger model exhausts more $NO_X$ and $O_2$, but it doesn't significantly affect the result when it comes with decreasing of $CO_2$ and effectiveness of increased power characteristic. As a result, the turbocharger diesel engine is economically effective comparing with the natural aspiration diesel engine.

• Journal of the Korean Society of Fisheries and Ocean Technology
• /
• v.32 no.3
• /
• pp.310-315
• /
• 1996

엔진 배기가스의 동력과 유량이 배기행정의 직전 단계에서 관찰되었다. 배기가스 양을 적당히 조정함으로써 터보 과급의 입구 압력을 증가시킬 수 있었으며 엔진의 흡기, 소기 및 배기과정에서 가스질량과 엔진의 동력, 그리고 터보과급 효과도 감소하였다. 터보 과급장치를 기하학적으로 적절화시킴으로써 싸이클의 동기화 및 동력의 효율이 고려된 열교환 과정의 효율 기준도 제기되었으며 디젤엔진의 연소싸이클을 재수정하는 과정과 터빈의 동역학적 특성도 제시되었다.

• Journal of Energy Engineering
• /
• v.11 no.2
• /
• pp.90-98
• /
• 2002

The effects of swirl and combustion parameters on the performance and emission in a turbo-charged D.I. diesel engine of the displacement 9.4L were studied experimentally in this paper. Generally the swirl in the combustion process of diesel engine promotes mixing of the injection fuel and the intake air. It is a major factor to improve the engine performance because the fuel consumption and NO$_{x}$ is trade-off according to the high temperature and high pressure of combustion gas in a turbocharged D.I. diesel engine, it's necessary to thinking over the intake and exhaust system, the design of combustion bowl and so on. In order to choose a turbocharger of appropriate capacity. As a result of steady flow test, when the swirl ratio is increased, the mean flow coefficient is decreased, whereas the gulf factor is increased. Also, through engine test its can be expected to meet performance and emissions by optimizing the main parameter's; the swirl ratio is 2.43, injection timing is BTDC 13$^{\circ}$ CA, compression ratio is 16, combustion bowl is re-entrant 5$^{\circ}$, nozzle hole diameter is $\Phi$0.28*6, turbocharger is GT40 model which are compressor A/R 0.58 and turbine A/R 1.19.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.36 no.11
• /
• pp.1065-1072
• /
• 2012

Due to its oxygen (O) content, biodiesel (BD) is advantageous in that it lowers PM emissions in CI engines. Therefore, BD is considered one of the best candidates for low temperature combustion (LTC) operation because its use can extend the regime for simultaneous reduction of PM and $NO_x$. Thus, in this study, LTC operation was realized using BD and diesel with a 5~7% $O_2$ fraction. Engine test results show that the use of BD increased the efficiency and reduced emissions such as PM, THC, and CO; furthermore, IMEP reduced by 10~12% owing to the lower LHV of the fuel. In particular, smoke was suppressed by up to 90% because O atoms in the BD enhanced the soot oxidation reaction. To compensate the IMEP loss, turbocharging (TC) was then tested, and the results showed that the power output increased and PM was reduced further. Moreover, TC in BD engine operation allowed a similar level of reduction in both $NO_x$ and PM at 11~12% $O_2$ fraction, suggesting that there is a potential to widen the operating range by the combination of TC and BD.

• Journal of Advanced Marine Engineering and Technology
• /
• v.39 no.6
• /
• pp.626-632
• /
• 2015

The International Maritime Organization (IMO) has adopted several regulations for the prevention of air pollution from ships. In addition, there is a requirement for shipping liners to reduce greenhouse gas emissions. Accordingly, we need to take measurements to ensure that the steps taken are both efficient and environmentally friendly. It has been determined that the application of the Miller cycle in diesel engines has the effect of both reducing the amount of NOx and improving thermal efficiency. However, this method requires a considerably larger charge air pressure. Therefore, we consider a two-stage turbo-charging system, which not only results in a high charging pressure, but also improves the part load performance with an exhaust-gas bypass system or the application of the Miller cycle. Because of complications associated with the two-stage turbo-charging system, it is complex and difficult to realize a design that optimizes matching between diesel engine and turbo-chargers. Accordingly, it is necessary to perform a quantitative analysis to determine the effects and optimal conditions of these different systems in the early stage of system design. In this paper, we develop a simulation program to model these systems, and we verify that the results of this program are reliable. Further, we discuss methods that can be employed to improve its efficiency.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.11 no.11
• /
• pp.4137-4144
• /
• 2010

In this study, the simulations were carried out to show the effect of the EGR configuration in a passenger diesel engine with 2-stage turbocharger on the EGR rate. The AMESim and IFP Engine Library were used to make the program for the simulation. Three EGR configurations, HPL(high pressure loop), LPL(low pressure loop), and SLPL(semi low pressure loop), were considered. The EGR rate in the HPL and LPL EGR routes were 6.4% and 10.0% respectively but the rate in SLPL route was 18.0% and their air/fuel ratio for all three cases was 21. Therefore the SLPL EGR configuration may be positively considered in the design of the passenger diesel engine with 2-stage turbocharger.

• LP가스
• /
• s.71
• /
• pp.49-53
• /
• 2000

대형디젤엔진의 대체용으로 LPG 엔진을 개발함에 있어서 차세대 연료공급방식인 LPG 연료의 액상분사방식을 채택하여 기존의 믹서방식의 연료공급시스템을 가진 LPG 엔진보다 고출력, 고효율, 저공해성을 추구하고자 하였다. 이를 위한 기초연구로서 먼저 단기통 연소엔진을 이용하여 대형엔진에 LPG 연료 적용 가능성, 액상분사 시스템을 포함한 여러 가지 연료공급방식에 따른 엔진의 성능파악, 대형엔진에 적합한 최적 선회비의 결정, 연료조성에 따른 엔진성능의 변화 등을 알아보았다. 실험결과, 대형엔진에 LPG 연료의 적용은 아무런 문제점이 없었으며 LPi 연료공급방식은 다른 방식에 비해서 10%정도의 체적효율 및 출력의 증가를 확인할 수 있었다. 최적의 선회비는 2.0 부근에서 형성되었고, 연료 조성은 프로판 대 부탄의 비율이 60 : 40에서도 정상적으로 운전됨을 확인하였다. 시제품 엔진의 경우, 과급방식의 KL6i 엔진을 개발하기 앞서 좀더 기술적 접근이 용이한 자연흡입방식의 K-1엔진의 개발이 선행되었으며 현재 개발 진행중인 K-1엔진의 성능평가 결과, 기존의 디젤엔진에 비해 출력성능이 20% 정도 향상됨을 확인할 수 있었다. 특히 대형차량에서 중요시 생각되는 저속토크 성능이 매우 우수한 것으로 파악되었다. 이러한 결과를 바탕으로 단기통 연소엔진에서 확인된 최적화된 연료조성과 선회비를 향후 K-1엔진에 적용할 예정이다. 최근 열린 가스학회 추계발표회와 LPG자동차세미나의 주요내용을 게재한다.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.7 no.5
• /
• pp.778-783
• /
• 2006

Numerous researches have been conducted to investigate an optimal EGR rate which minimizes emission levels of NOx without increasing PM or loosing an engine power. In this research, the interrelation among engine parameters were intensively investigated and evaluated quantitatively, and proposed some directions in design of a heavy diesel engine by applying EGR and Oxygen-enriched system.

• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 2010.05a
• /
• pp.578-579
• /
• 2010

최근 내연 기관에서 엔진상태 및 잠재적인 결함의 발견을 위해 연료분사, 실린더 내 연소과정, 실린더 내부와 피스톤 마모상태, 흡 배기 밸브 및 과급기 (turbocharger) 등의 상태 모니터링을 통해서 결함에 대한 진단 및 경향관리에 대한 연구들이 진행되고 있다. 본 연구에서는 기 개발된 선박용 대형디젤엔진에 대한 상시 모니터링 시스템을 이용하여 엔진상태 및 잠재적인 결함을 진단하고자 하였으며, 일차적으로 가속도 신호를 이용하여 실린더 내 연소과정에서 정상적인 상태와 착화실패에 따른 진동 양상을 비교 분석하였다. 신호 분석 기법으로 시간-주파수 분산 기법들은 충격파 신호인 엔진 폭발신호를 분석하는데 적합하였으며, 그 기법들 중 Short Time Fourier Transform 기법과 Wavelet Transform 기법을 이용하였다.