• Journal of the Korean Society of Fisheries and Ocean Technology
• /
• v.26 no.1
• /
• pp.1-7
• /
• 1990

Theoretical evaluations of the vertical displacement at the epicenter on the circular glass plate have been carried out in the case of the unit point loading(1 dyne force strength) with the Heaviside step-function time dependency. Acoustic emission signals generated during pencil lead($\Phi$=0.5mm, HB) fracture on the soda-lime glass($\Phi$=22cm, thickness=2.8cm) were observed by the optical Michelson interferometer with the stabilized circuit, and then the source function of the observed acoustic emission signals was analyzed by the deconvolution method. The source function of acoustic emission during pencil lead fracture had a 'dip' of~0.7$\mu$sec duration time at the front portion and a step function of~0.5$\mu$sec rise time with a force strength of~4.5N.

• Fire Science and Engineering
• /
• v.23 no.1
• /
• pp.7-14
• /
• 2009

Several electrical loads such as inrush current, normal operation arcing and non-sinusoidal loads have normal current waveforms similar to arc waveforms. To detect arcs in such loads, therefore, it is necessary to analyze difference between current waveforms with or without arcs. In this paper, using apparatuses of arc generation in UL 1699, arcs are generated in these loads and, then, arc current waveforms are investigated in both the time and the frequency domains to find arc characteristics. This investigation shows that arc current signals have shoulders at some zero current points in the time domain and increment of spectrum magnitude in all over frequency domain. It also shows that the arc characteristics at normal operation arcing and non-sinusoidal loads are detected more easily in the frequency domain than in the time domain. This investigated arc characteristics are expected to be utilized as the basis of development of arc-fault circuit interrupters.

• Journal of the Korean Society for Nondestructive Testing
• /
• v.30 no.4
• /
• pp.373-379
• /
• 2010

EMAT has been applied in various fields for flaw detection and material characterization because it has noncontact property in wave generation and a good mode selectivity. Unfortunately, however, EMAT shows low signal to noise ratio relative to commercial contact transducer because of low energy conversion efficiency. If the phase matching through the control of time delay between each coil consisting of the array EMAT is accomplished, it is expected that it will be a solution for the improvement of low signal to noise ratio. In this experiment, the phased array EMATs which consists of 3 or 4 meander coils and one big magnet were fabricated for surface and vertical shear wave generation. Effect of phased delay control on signal directivity and amplitude enhancement was verified. A slit with the depth of 0.5 mm and a side-drill hole of 0.5 mm diameter were clearly detected by fabricated phased array EMATs, respectively.

• Korean Journal of Fisheries and Aquatic Sciences
• /
• v.14 no.4
• /
• pp.265-268
• /
• 1981

The direction and spectra of underwater sound wave were a remarkable contrast to the sound wave in the air because of the difference of transmissive medium. The linear hydrophone array of passive system has so far been applied to find out the direction and spectra of underwater sound wave from the sources for many purposes. The conventional methods are generally classified into two systems such as, the system which varying frequency responses, other parameters and pattern of signal like an adaptive array controlled by internal feedback, and another system which obtaining maximum of S/N ratio by giving a appropriate delay and a weighting coefficient in the output of each hydrophone. The array device of passive system can easily change the amplitude and the phase of signal by separately controlled hydrophone. And here we introduce a method that the spectral analyzing and the direction finding can be simultaneously carried out using a linear array of hydrophones. By making a circular convolution of output of signal from each hydrophone with appropriate rectangular weighting coefficient on the array, a sharp response of single lobe directivity and the spectral analyzing by time averaging were simultaneously obtained. In tile computer simulation of the array system with the length of 250cm and the interhydrophone distance of l0cm the power levels of sound signals received from given array direction were 16dB higher than those from the other directions when processing with rectangular weightings, and 8dB higher when processing with rectangular sound signals and rectangular weightings.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.42 no.4
• /
• pp.739-746
• /
• 2017

Orthogonal frequency division multiplexing(OFDM) systems have many advantages. However, OFDM systems are much affected by a nonlinear distortion because those systems have a high peak to average power ratio(PAPR) value. A selected mapping technology was suggested to reduce a PAPR value. The technology does not have data loss but receivers need side information to know modified phase sequence. Therefore, side information causes decreased a transmission efficiency. In this paper, we suggest a blind SLM receiver using a cross correlation technology. This receiver does not require side information. The proposed blind SLM receiver calculates sums of cross-correlation between transmitted pilot signals multiplied by each phase sequence and received pilot signals. So, this receiver detects side information which has a maximum sum cross-correlation value. We compared our proposed SLM receiver to a conventional blind SLM receiver through bit error rate(BER) and side information error rate(SIER) performances. Simulation results show that the proposed SLM receiver has improved BER and SIER performances than the conventional SLM receiver.

• Journal of the Korean Chemical Society
• /
• v.39 no.1
• /
• pp.35-39
• /
• 1995

Simultaneous measurements of trace platinum and rhodium, based on catalytic reduction of protons by the adsorbed Pt-formazone and Rh-formaldehyde complexes formed in formaldehyde-hydrazine-sulfuric acid medium, were demonstrated. The conditions for the measurements of Pt and Rh both present at trace levels (>10-10 M) were 0.004% (w/v) formaldehyde-0.0012% (w/v) hydrazine-0.75 M sulfuric acid. In this medium method detection limits are 7.3${\times}$10-11 M Pt and 3.2${\times}$10-11 M Rh. And dynamic ranges are 5${\times}$10-10~6${\times}$10-8 M and 1${\times}$10-10∼2${\times}$10-8 M for platinum and rhodium respectively. In the linear dynamic ranges, Rh and Ir interfere platinum in the presence of only 10 and 100 times that of Pt respectively. There are no interferences from other platinum group metal ions for rhodium even in the presence of a 500-fold excess of Ir(IV), a hundredfold excess of platinum.

• Korean Journal of Food Science and Technology
• /
• v.29 no.5
• /
• pp.999-1005
• /
• 1997

The consistant appearance of coliforms in fermenting kimchi was examined and measures of removing coliforms early in the fermentation were investigated. Allyl isothiocyanate $({\geq}50\;ppm)$, horseradish powder $({\geq}0.4%)$, and garlic juice $({\geq}2.0%)$ were effective in removal of coliforms early in kimchi fermentation. However, mustard powder and methyl methanethiosulfonate were not effective. Nisin, known as a promising agent for the prevention of kimchi over-acidification, allowed coliforms to survive in kimchi longer with only marginal extention of edible period. Individual kimchi ingredients such as Chinese cabbage, garlic, red pepper powder, ginger and green onion were all found to contain coliforms. Coliforms were not detected from garlics sold unpeeled and commercially prepared red pepper powder.

• Journal of the Korean Institute of Intelligent Systems
• /
• v.24 no.1
• /
• pp.71-77
• /
• 2014

In this paper, we propose an improved numeric character recognition method which can recognize numeric characters well under low-illuminated and shade-illuminated environment. The LN(Local Normalization) preprocessing method is used in order to enhance low-illuminated and shade-illuminated image quality. The reading area is detected using line segment information extracted from the illumination-normalized meter images, and then the three-phase procedures are performed for segmentation of numeric characters in the reading area. Finally, an efficient hybrid classifier is used to classify the segmented numeric characters. The proposed numeric character classifier is a combination of multi-layered feedforward neural network and template matching module. Robust heuristic rules are applied to classify the numeric characters. Experiments using meter image database were conducted. Meter image database was made using various kinds of meters under low-illuminated and shade-illuminated environment. The experimental results indicates the superiority of the proposed numeric character recognition method.

• The Journal of Korean Association of Computer Education
• /
• v.6 no.4
• /
• pp.37-47
• /
• 2003

In this paper. we propose a new digital watermarking technique which uses the self-similarity of OCT(Discrete Cosine Transform) coefficients for the ownership protection of an image, similar coefficients are classified by SOM(Self-Organizing Map) out of Neural Network. The watermark is inserted into the selected cluster among clusters which consist of coefficients. Generally, the inserted watermark in high frequency regions of an image is eliminated by the compression process such as JPEG compressions, and the inserted watermark in low frequency regions of an image causes the distortion of an image quality. Therefore, the watermark is inserted into the cluster that has many coefficients in the middle frequency regions. This algorithm reduces the distortion of an image quality because of inserting the watermark into an image according to the number of coefficients in selected cluster. To extract watermarks from the watermarked image, the selected cluster is used without an original image. In the experiment, the new proposed algorithm have a good quality and endure attacks(JPEG compressions, filtering. zoom in, zoom out, cropping, noises) very well.

• Journal of the Institute of Electronics Engineers of Korea SP
• /
• v.43 no.4 s.310
• /
• pp.66-73
• /
• 2006

Safety is the most important for all traffic management and control technology. This paper focuses on developing a flexible, reliable and real-time processing algorithm which is able to generate signal for the entering vehicle at the joining road through a camera and image processing technique. The images obtained from the camera located beside and upon the road can be used for traffic surveillance, the vehicle's travel speed measurement, predicted arriving time in joining area between main road and joining road. And the proposed algorithm displays the confluence safety signal with red, blue and yellow color sign. The three methods are used to detect the vehicle which is driving in setted detecting area. The first method is the gray scale normalized correlation algorithm, and the second is the edge magnitude ratio changing algorithm, and the third is the average intensity changing algorithm The real-time prototype confluence safety signal generation algorithm is implemented on stored digital image sequences of real traffic state and a program with good experimental results.