• Journal of the Institute of Electronics and Information Engineers
• /
• v.53 no.2
• /
• pp.36-44
• /
• 2016

In this paper, an Impulse Radio-Ultra Wide band RF Transceiver for WBAN applications is implemented in $0.18{\mu}m$ CMOS technology. The designed RF transceiver support 3-5GHz UWB low band and employs OOK(On-Off Keying) modulation. The receiver employs non-coherent energy detection architecture to reduce complexity and power consumption. For the rejection of the undesired interferers and improvement of the receiver sensitivity, RF active notch filter is integrated. The VCO based transmitter employs the switch mechanism. As adapt the switch mechanism, power consumption and VCO leakage can be reduced. Also, the spectrum mask is always same at each center frequency. The measured sensitivity of the receiver is -84.1 dBm at 3.5 GHz with 1.579 Mbps. The power consumption of the transmitter and receiver are 0.3nJ/bit and 41 mW respectively.

• Korean journal of food and cookery science
• /
• v.25 no.2
• /
• pp.252-259
• /
• 2009

Ergosterol is the significant component of the cell wall of fungi. Its presence is regarded as evidence of fungi contamination in grain and other foods. Many studies on ergosterol detection have been carried out using chemical methods, but those methods required complicated pre-treatments and long analysis times. In this study, an amperometric biosensor was developed for fast and precise ergosterol detection. The biosensor system used the electron transfer of hydrogen peroxide produced from the reaction of ergosterol with cholesterol oxidase. The biosensor system consisted of a peristaltic pump, a syringe loading sample injector, an enzyme reactor, a fabricated flow-through cell containing a working electrode, a reference electrode and a counter electrode, and a potentiostat/recorder. The working electrode was prepared by coating modified multi-wall carbon nanotube (MWNT) on glassy carbon electrode. The $MWNT-NH_2$ coated glassy carbon electrode linearly responded to hydrogen peroxide in the range of $1{\times}10^{-5}{\sim}8{\times}10^{-5}$ M with a detection limit of $10^{-7}$ M in the basic performance test. The currents produced from the ergosterol biosensor showed the linearity in a range from $1.0{\times}10^{-6}$ M to $1.0{\times}10^{-5}$ M ergosterol.

• Journal of the Korean Wood Science and Technology
• /
• v.35 no.6
• /
• pp.65-72
• /
• 2007

The VOC (volatile organic compound) analyzer is devised to measure the four main aromatic hydrocarbon gases: toluene, ethylbenzene, xylene and styfene. It is not affected by ambient temperature and humidity. In addition, standby and measuring time of VOC Analyzer is a short as below 30 min and 8 min, respectively. Since the semiconductor gas sensor is supersensitive to gas components, it is not necessary to use a conventional gas concentrator or other complicated equipment. In this study, VOC emission behavior from 4 types paints (lacquer, urethane vanish, water-base paint, enamel paint) for wood-based panel was investigated using VOC Analyzer. After a specimen was spreaded on aluminum foil ($6.32{\times}6.32cm$) in $3{\ell}$ polyester bag, after 24 hours we could measure maximum VOC emission level that is a stabilized VOC value. Xylene of VOCs was high emitted from lacquer, urethane vanish and water-based paint, and TVOC (Toluene + Ethylbenzene + Xylene + Styrene) of lacquer was the highest emission concentration than another.

• Analytical Science and Technology
• /
• v.17 no.3
• /
• pp.240-250
• /
• 2004

A gas chromatography-mass spectrometric (GC-MS) assay method was developed for the rapid and sensitive determination of volatile- and semivolatile organic compounds in water. Two hundreds mL of water sample was extracted in a 250 mL separatory funnel with 1 ml of pentane at pH 6.5. Fluorobenzene and 1,2-dichlorobenzene-d4 as internal standards were added to water sample and the solution was mechanically shaken for 5 min and analyzed by GC-MS (selected ion monitoring) without more any concentration or purification steps. The peaks had good chromatographic properties and the extraction of these compounds from water also gave relatively high recoveries with small variations. The range of detection limits of the assay was 0.5-10 ng/L. Turnaround time for up to about 40 samples was one day. This method is simple, convenient, and can be learned easily by relatively inexperienced personnel. This method was used to analyze 15 volatile- and semivolatile organic compounds in water of a Lake, and raw and treated water from three Water Treatment Plants in Korea. As the analytical results, benzene, toluene, xylene, isopropylbenzene, 1,3,5-trimethylbenzene, 1,2,4-trimethylbenzene, naphthalene and 2,4,6-trichlorophenol were detected at concentrations of up to 0.4, 1.9, 1.3, 0.2, 1.8, 13.0, 1.7 and $1.1{\mu}g/L$, respectively. But chlorobenzene, trichloroethylene, tetrachloroethylene, ethylbenzene, n-butylbenzene and dibromochloropropane levels during that period were not significant. The removal effect of the compounds in three Water Treatment Plants was calculated. The compounds studied were generally removed during conventional water treatment, especially during the active carbon filtration.

• Journal of Environmental Impact Assessment
• /
• v.30 no.1
• /
• pp.1-12
• /
• 2021

This study focused on verifying the identification of freshwater fish species in Korea using Environmental DNA (eDNA) technique. The research of DNA is increasing in the field of ecology, since this is more sensitive of identify rather than traditional investigation method. Which is difficult to detect species hidden in water and be easily influenced by diverse factors (sites, bad weather, researchers and so on). We applied the pilot test in aquarium (Freshwater Fish Ecological Learning Center in Yangpyeong, Gyeonggi Do), where freshwater fish species are inhabits. We conducted to sampling and analyzing the sixteen water samples (50 species from 7 orders and 13 families) using MiFish primer set. The results showed that 45 species (90%) was investigated by eDNA. It highlight that eDNA with universal primer is possible to detect freshwater fish species of Korean. However, the errors on species identification seems to be caused by the primer that be not suited perfectly and the pollution such as aquarium, sampling collectors.

• Journal of Energy Engineering
• /
• v.13 no.2
• /
• pp.93-100
• /
• 2004

The smear media possible to sampling and radiation detection was prepared and evaluated for the surface contamination using indirect method. The films were made by impregnating Cerium Activated Yttrium Silicate (CAYS) in a polysulfone membrane. The membranes used solution as a dimethylformamide (DMF) and methylene chloride (MC), polysulfone as a polymer matrix and CAYS as a inorganic scintillator. The proximity membranes were prepared with single- and double-layered structure. The solidified methods were immersion to the nonsolvent bath such at water and ethanol and solvent evaporation. The measurement of the photon produced by interaction with radiation and inorganic scintillator used a photomultiflier tube (PMT), amplifier, and counter. In the comparison with the low background alpha/beta counter, the counter rate using inorganic scintillator proximity membrane for the $\^$14/C surface contamination was about 50%. Also. the $^3$H counting results revealed that the prepared membranes were efficient to monitor the surface contaminated with the low energy be-ray emitter nuclides.

• Clean Technology
• /
• v.11 no.2
• /
• pp.69-74
• /
• 2005

A metal ion detector with a submicron size electrode was fabricated by field-induced AFM oxidation. The square frame of the mesa pattern was functionalized by APTES for the metal ion detection, and the remaining portion was used as an electrode by the self-assembly of MPTMS for Au metal deposition. The conductance changed with the quantity of adsorbed copper ions, due to electron tunneling between the mobile and surface electrodes. The smaller electrode has a lower limit of detection due to the enhancement in electron tunneling through metal ions that are adsorbed between the conductive-tip (mobile) and the surface (fixed) electrode. This two-electrode system immobilized with different functional groups was successfully used in the selective adsorption and detection of target materials.

• Analytical Science and Technology
• /
• v.6 no.4
• /
• pp.349-357
• /
• 1993

Analytical methods of thromboxane $B_2(TXB_2)$ using various techniques of Fast Atom Bombardment mass spectrometry (FAB MS) were studied, static FAB condition was investigated to obtain linear response curve using docosanoic acid as a internal standard. For maximum sensitivity, a continuos-flow(CF-) FAB MS by selected-ion monitoring(SIM) with devised sample introduction system, has been developed to quantiate thromboxane $B_2$ in biological sample. Instrumental parameters affecting sensitivity, reproducibility has been studied. The method has been optimized with respect to the eluent, 0.75% glycerol(in EtOH v/v) and flow rate of $3.7{\mu}l/min.$ Under the condition, detection limits were below 10pg in SIM mode and a good linear relationship between dose and response was achieved.

• Journal of the Korean Chemical Society
• /
• v.43 no.5
• /
• pp.517-521
• /
• 1999

Gas chromatography using sulfur chemiluminescence detection (GC-SCD) which exhibits very good selectivity, linearity, and sensitivity was applied to the analysis of suIfur compounds in gaseous fuel. The expectmental method used in this study was to resolve the problems of repeatability and reproducibility by means of the adsorption of sulfur compounds, which is different from the existing analysis method of these compounds by GC-SCD. The calibration curves of the standard gases including dimethyl sulfide, t-butylmercaptan and ethyl methyl sulfide exhibited an excellent linearity. As the result of precision tests for the above three compounds, the high reproducibility for tests showed while repeating three times during four days, respectively. In addition, the coefficient of variation was less than 3%. In consequence, the expectmental method of this study is very effective not only with low uncertainty but also with better accuracy, which can quickly determine the concentration of gas odorants in LPG (Liquefied Petroleum Gas) from oil reservoirs and filling stations.

• Korean Journal of Food Science and Technology
• /
• v.42 no.5
• /
• pp.521-526
• /
• 2010

A high-performance liquid chromatography (HPLC) method was established for the determination of fluoroquinolones in milk. Protein was removed by using trichloroacetic acid in order to increase a mean recovery of milk. The extracts were using $Strata^{TM}$-X solid-phase extraction cartridge. The analytes were detected by HPLC on a $C_{18}$ column. HPLC method with fluorescence detection system (Ex: 278 nm, Em: 456 nm) provided a high degree of sensitivity in detecting fluoroquinolones. The limits of quantitation (LOQ) and mean recoveries of fluoroquinolones were 40 ${\mu}g$/kg and 73.6-95.2% (ofloxacin), 10 ${\mu}g$/kg and 77.3-91.9% (norfloxacin), 20 ${\mu}g$/kg and 91.6-94.3% (ciprofloxacin), 10 ${\mu}g$/kg and 81.0-87.8% (enrofloxacin), 10 ${\mu}g$/kg and 71.3-81.0% (sarafloxacin), 10 ${\mu}g$/kg and 89.4-90.8% (orbifloxacin), 2 ${\mu}g$/kg and 69.4-85.5% (danofloxacin).