• Journal of Korean Society of Transportation
• /
• v.26 no.4
• /
• pp.265-273
• /
• 2008

Video Image Processing (VIP) for traffic surveillance has been used not only to gather traffic information, but also to detect traffic conflicts and incident conditions. This paper presents a system development of gathering traffic information and conflict detection based on automatic calculation of pixel length within the detection zone on a Video Detection System (VDS). This algorithm improves the accuracy of traffic information using the automatic detailed line segmentsin the detection zone. This system also can be applied for all types of intersections. The experiments have been conducted with CCTV images, installed at a Bundang intersection, and verified through comparison with a commercial VDS product.

• Journal of the Korean Society of Marine Environment & Safety
• /
• v.25 no.1
• /
• pp.111-116
• /
• 2019

The fire detectors used in the engine rooms of ships offer only a slow response to emergencies because smoke or heat must reach detectors installed on ceilings, but the air flow in engine rooms can be very fluid depending on the use of equipment. In order to overcome these disadvantages, much research on video-based fire detection has been conducted in recent years. Video-based fire detection is effective for initial detection of fire because it is not affected by air flow and transmission speed is fast. In this paper, experiments were performed using images of smoke from a smoke generator in an engine room. Data generated using LBP and GLCM operators that extract the textural features of smoke was classified using SVM, which is a machine learning classifier. Even if smoke did not rise to the ceiling, where detectors were installed, smoke detection was confirmed using the image-based technique.

• Journal of the Korean Society for Railway
• /
• v.15 no.6
• /
• pp.604-608
• /
• 2012

Traditionally, the track circuits have been used for the purpose of train locating. However, the recent train control systems like a CBTC(Communications Based Train Control) do not utilize the track circuits to minimize the amount of ground signal devices. Therefore, there are increasing concerns over the system that can locate the position of train exactly without using the track circuits. Then, the contactless locating methods are added to ensure safety when the shunting sensitivity of the track circuit becomes low for the existing sections equipped with the track circuits. In this paper, a prototype of train locating device has been designed and tested, which utilizes the current phase difference upon magnetic field variation. The results show improved features of this method over the conventional track circuits method.

• Journal of Korean Society of Transportation
• /
• v.25 no.6
• /
• pp.79-88
• /
• 2007

Design Hourly Volume (DHV) is the hourly volume used for designing a section of road. DHV is also used to estimate the expected number of vehicles to pass or traverse the relevant section of road in a future target year. The Design Hour Factor (DHF) is defined as the ratio of DHV to Average Annual Daily Traffic (AADT). In addition to high precision of predicted traffic volume, in order to design a roadway to be the proper scale, applying appropriate DHFs considering traffic flow characteristics and type of area which surrounds the relevant roadway is important. This study categorizes sections of expressway (Suh Hae An Expressway) according to their area type and estimates DHFs utilizing traffic data obtained from a vehicle detection system (VDS). This study shows that DHFs calculated using VDS data are different from those using traffic data acquired from a coverage survey. While AADTs from both data show similar values, peak hour volumes from both data show significant differences especially for recreational areas. DHFs from the coverage survey are quite different from the values provided by the Korean design guide or previous research results and DHFs for urban areas are higher than recreational areas. However, DHFs from VDS shows similar values to previous research results. The result of this study suggests that using VDS for estimating DHFs is more reliable than using a coverage survey.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.1 no.1
• /
• pp.22-32
• /
• 2002

This paper describes about non-burial AVI (Automatic Vehicle Identification) system using general vehicle as probe car for obtaining more accurate traffic information while conserving road pavement surface. Existing spot traffic detectors have their own limits of not obtaining right information owing to its mathematical method. Burial AVI systems have some defects, causing traffic jam, needing much maintenance cost because of frequent cutting of loop and piezo-electric sensors. Especially, they have hard time to make right detection, when it comes to jamming time. Therefore, in this paper, we propose non-burial AVI system with laser trigger unit. Proposed non-burial AVI system is developed to obtain regional traffic information from normal Passing vehicle by automatic license number recognition technology. We have adapted it to national highway section between Suwon city and Pyong$\~$Taek city(9.5km) and get affirmative results. Vehicle detection rate of laser trigger unit is more than 95$\%$, vehicle recognition rate is 87.8$\%$ and vehicle matching rate is about 14.3$\%$. So we regard these as satisfying results to use the system for traffic information service. We evaluate proposed AVI system by regulation of some institutions which are using similar AVI system and the proposed system satisfies all conditions. For future study, we have plan of detailed research about proper lane number from all of the target lanes, optimal section length, information service period, and data fusion method for existing spot detector.

• Journal of Energy Engineering
• /
• v.25 no.1
• /
• pp.145-152
• /
• 2016

Recently, we can find news about toxic and combustible gas accident. So, we have to develop gas detector that can measure gas at dangerous area for preventing gas accidents. In this paper, we calculate a approximation function from sensor's output using the linear regressiong. And we develop software algorithm using Neville's algorithm for measuring gas concentration. Finally, we compare our algorithm with combustible gas detectors that are already developed, by using standard gas samples manufactured Korea Gas Safety. As a result of this experiment, we confirm that performance of our algorithm is more improved than performance of already developed combustible gas detectors. In the future, we'll research how to improve reliability from using count, temperature and humidity. And we'll design hardware applied explosion proof for safety.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.11 no.5
• /
• pp.62-69
• /
• 2012

Traffic simulation models have been used for assessing various transportation strategies. Through comparing results from a simulation model and real field data, researchers try to show how close the model can reproduce the real world traffic. This model verification step is one of the most essential tasks in modeling procedure. Traffic counts and speeds have been frequently used for the verification or validation. Authors modeled severe PM peak bottleneck situation on the I-40 corridor in Raleigh, North Carolina using DYNASMART-P, a mesoscopic traffic simulation tool and verified the model. NCDOT has Traffic Information Management System which has archive capability for the traffic speeds on the I-40 corridor. However, the authors selected travel time as the field measure for model verification and collected the data using a GPS equipment because the speed data from NCDOT speed detectors are spot speeds which are not appropriate for comparison with link average speed from the simulation model. This paper describes the GPS field data collection procedure, the model verification method, and the results.

• 한국ITS학회:학술대회논문집
• /
• 2003.11a
• /
• pp.122-126
• /
• 2003

• Transportation Technology and Policy
• /
• v.10 no.3
• /
• pp.69-76
• /
• 2013

• Proceedings of the Korea Institute of Fire Science and Engineering Conference
• /
• 2008.04a
• /
• pp.226-229
• /
• 2008