• Journal of the Korean Geotechnical Society
• /
• v.17 no.3
• /
• pp.103-110
• /
• 2001

관입체 주변에서 발생하는 지반의 과잉간극수압은 그 측정위치에 따라 영향을 받는 것으로 알려져 있다. 특히 관입체의 선단과 축표면에서의 간극수압반응은 상당히 다른 것으로 알려져 있다. 본 연구에서는 지반에 대한 관입시험시 주변지반에서 발생하는 간극수압의 반응에 대하여 Louisiana State University의 시험토조를 사용하여 조사하였다. 또한 시험결과를 비등방성 수정 Cam Clay 모델을 이용한 유한요소해석과 비교하였다. 본 연구로부터 관입체 주위에서 발생하는 간극수압은 예측한 바와 같이 선단부위에서 크게 나타나고, 뒤로 갈수록 작아지는 현상을 나타내었다. 이와 같은 현상은 전단에 의하여 발생한 간극수압과 압축에 의하여 발생한 간극수압의 상호간섭에 의한 것으로 나타났다.

• Proceedings of the Korean Society of Propulsion Engineers Conference
• /
• 2010.11a
• /
• pp.33-36
• /
• 2010

Lots of studies about turbine loss have been done especially about tip leakage loss. But these studies deals with small tip clearances which is less than 5 percent chord. Now, like turbopumps, small turbines have larger tip clearance and it is hardly found related papers in open literature. On this study, with varying tip clearance 1% to 20% chord, loss is measured under inlet velocity at 30m/s and Reynolds number based on chord at 210000. It is found that maximum loss coefficient is 0.113 at 10% clearance, and when tip clearance is larger than 10%, loss is not linearly increased anymore.

• Proceedings of the Korea Water Resources Association Conference
• /
• 2020.06a
• /
• pp.86-86
• /
• 2020

수리구조물에 관한 기존 연구들은 대부분 기능성과 안정성 측면에서 본체에 작용하는 유체력에 대한 안정성에 주안점을 두고 있다. 수리구조물 상·하류의 수위차에 기인한 기초지반내의 흐름 및 간극수압 변화는 하천 구조물의 안정성을 연구하는데 매우 중요하다. 해양에서는 파랑하중에 의한 과잉간극수압이 액상화를 발생시켜 해안구조물의 안정에 큰 영향을 미치는 것으로 보고되며, 이에 관련 연구들이 활발하게 진행되고 있다. 반면, 하천구조물 주변 지반의 흐름 및 간극수압 뿐 아니라, 액상화에 관한 연구는 아직 미진한 실정이다. 본 연구에서는 수리구조물 주변의 유동 및 와동 현상 뿐 아니라, 수위차에 따른 지반 내부 유동장과 간극수압에 관한 특성을 분석하기 위해 유체-구조물-지반 비선형 상호작용을 고려할 수 있는 수치수조를 새롭게 제안하였다. 그리고 제안하는 수치수조의 타당성 및 유효성을 검증하기 위해 기존 실험값과 비교·검토를 수행하였고, 그 결과는 거의 유사한 경향을 나타내었다. 또한 이 수치수조에 다양한 입사조건(상·하류 수위차)에 적용하여 유체-구조물-지반의 비선형동적상호간섭 해석을 수행하였다. 최종적으로 수치수조에서 측정한 구조물 주변의 유동, 와동, 수위로부터 수리특성을 논의하였다. 게다가 지반내의 흐름과 간극수압을 측정하여 상·하류 수위차가 수리구조물의 안정성에 미치는 영향을 분석할 수 있었다.

• The Journal of Engineering Geology
• /
• v.18 no.2
• /
• pp.127-136
• /
• 2008

Geophysical survey for establishing a wide site for the distribution of water content, wetting front infiltration due to the rainfall, and distribution of groundwater level has been performed by using 8round penetration radar (GPR) method, electrical resistivity method, and so on. On the other hand, a narrow area survey was performed to use a permittivity method such as time domain reflectometry, frequency domain reflectometry, and amplitude domain reflectometry methods for estimating volumetric water content, soil density, and concentration of contaminant in surface and subsurface. The permittivity methods establish more corrective physical parameters than different found survey technologies mentioned above. In this study for establishment of infiltration behaviors for wetting front in the unsaturated soil caused by an artificial rainfall, soil physical parameters for volumetric water content, pore water pressure, and pore air pressure were measured by FDR measurement device and pore water pressure meter which are installed in the unsaturated weathered granite soil with different depths. Consequently, the authors were proposed to a new establishment method for analyzing the variations of volumetric water content and wetting front infiltration from the responses of infiltrating pore water in the unsaturated soil.

• Proceedings of the Korean Society of Propulsion Engineers Conference
• /
• 2008.11a
• /
• pp.145-148
• /
• 2008

Korea Aeronautics Research Institute (KARI) is developing a turbo pump that has 1-stage impulse turbine and relatively high tip clearance for safety. The objective of this research is to investigate the effect of reaction on tip clearance loss in axial turbines. Both cascades were tested in a subsonic wind tunnel. In each cascade, total pressure was measured for tip clearance ranging from 1% to 20% of chord. In results, increasing tip clearance, total pressure loss in reaction turbines is continually increased but impulse turbines keep almost same level of mass averaged total pressure loss. When tip clearance becomes more than 10% of chord, mass-averaged total pressure loss in impulse turbines is less than in reaction. This means that when tip clearance is more than 10% of chord, impulse turbines have better efficiency than reaction turbines.

• Journal of the Korean GEO-environmental Society
• /
• v.7 no.1
• /
• pp.55-66
• /
• 2006

Laboratory tests have revealed that the liquefaction resistance of sands depends strongly upon the degree of saturation, which is expressed in terms of the pore pressure coefficient, B. The velocity of compression waves(i.e. P-waves), which have been known to be influenced largely by the degree of saturation and can be measured conveniently in the field, appears as an indicator of saturation. In this paper, the Stokoe type torsional shear(TS) testing equipment is modified to saturate the specimen and measure the velocities of P-wave and S-wave and pore pressure buildup. The velocities of P-wave and S-wave for Toyoura sand from Japan is measured and compared at the various B-value (degree of saturation) which are partially saturated to fully saturated conditions. Additionally, the variation of the pore water pressure induced during undrained TS tests at the various B-value is measured and analyzed.

• Journal of the Korea Convergence Society
• /
• v.8 no.10
• /
• pp.193-199
• /
• 2017

Mechanical tappet is used to reduce the cost and friction loss compared with hydraulic tappet. But the mechanical tappet doesn't have the ability to control the clearance between cams and valves and is selected by measuring the distance between valves and cams in order to minimize the clearance of valves by considering thermal expansion of valves. So, the valve clearance is nearly zero after fully warming-up periods, but there is valve clearance before warming-up. Especially at cold condition, the clearance is relatively large and can bring about some problems. In this study, the valve motions like lift, velocity, seating velocity and bouncing height were studied at various valve clearance conditions by experiment and analysis. As the valve clearance increases, the ramp area becomes shorten and it causes the valve train motion to have bad effects.

• The Journal of Engineering Geology
• /
• v.14 no.1
• /
• pp.47-60
• /
• 2004

The permeability coefficients were calculated by the homogenization analysis method with sufficient consideration of fracture geometry dependent on aperture change. According to the results of aperture measurements using a confocal laser scanning microscope, apertures on each measuring point display different magnitudes, indicating that fracture walls can not be assumed as parallel feature. After construction of fracture model based on the aperture values measured on each pressure level, the homogenization analysis was conducted to compute permeability coefficients. The calculated permeability coefficients distribute in the ranges of $10^{-1}~10^{-3}cm/sec$. Most of the specimens show decreasing permeability coefficients with the increase of the applied pressure. However, the decreasing rates of permeability coefficients do not show a constant trend on each pressure level. This phenomenon is well matched to the observation results of Chae et al. (2003). It proves that aperture change strongly influences on permeability characteristics. Three sections of each specimen have all different values of permeability coefficient. It suggests that the variation of permeability coefficient depends sensitively on aperture magnitudes and characteristics of fracture geometry. It is very important to consider accurate fracture geometries for analysis of permeability characteristics in rock fractures bearing different aperture distribution. Therefore, it needs to consider sufficiently the fracture geometries for calculating the permeability coefficients of fractures.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.9 no.4
• /
• pp.499-505
• /
• 1998

This paper presents the method for an estimation of discharge current waveshapes in short gap discharge by a radiated electromagnetic field. The method of currentwaveform estimation described is using the one antenna method(single field method) with a measured electric or magnetic fields at given field point by a time domain antenna. In order to verify the availability of the estimated theory, the discharge current waveshape estimation was performed by one antenna method using the measured electric fields of Wilson & Ma and compared with experiments.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.14 no.3
• /
• pp.583-594
• /
• 1994

One of the major elements of a natural landslide is the increase of the pore water pressure in a weakened layer. Therefore, the measurement of the pore water pressure in the layer is important. This work is a laboratory model study of the measurement of the pore water pressure with regard to the confined groundwater level, the permeability of the crack zone and the weathering degree of the weakened layer. By the model of the Tertiary period failure type and the Colluvium failure type, the reactions of the pore air pressure and the pore water pressure were measured in the weakened layer according to the permeability of the filter on the condition of the confined groundwater states. On the reaction phase of the pore pressure according to the during time, the Tertiary period failure type proved to be a step type and the Colluvium failure type turned out to be a wave type. The reaction ratios of the pore water pressure in the Tertiary period failure type are higher than the Colluvium failure type, decrease according to increasing of the weathering degree of the weakened layer.