• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.14 no.12
• /
• pp.2628-2635
• /
• 2010

This paper analyzes the detection probability of FMCW (Frequency Modulated Continuous Wave) radar based on Doppler frequency and analog-digital converter bit and designs and implements signal processing part of FMCW radar. For performance evaluation, the FMCW radar system consists of a transmitted part and a received part and uses AWGN channel. The system model is verified through analysis and simulation. Frequency offset occurs in the received part caused by the mismatching between the received signal and the reference signal. In case of Doppler frequency less than about 38KHz, performance degradation of detection does not occur in FMCW radar with 75cm resolution The analog-digital converter needs at least 6 bit in order not to degrade the detection probability. And, we design and implement digital signal processing part based on DDS chip of digital transmitted signal generator for FMCW radar.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.22 no.1
• /
• pp.33-39
• /
• 2018

An additive noise reduction algorithm for a mass spectrum analyzer is proposed. From the measured ion signal, we first used an estimated threshold from the mode of the measured signal to eliminate background noises with the white Gaussian characteristics. Also, a signal block corresponding to each mass index is constructed to perform a second order curve fitting and a linear approximation to signal block. In this process, the effective signal block composed of only the ion signal can be reconstructed by removing the impulsive noises and the sample signals which are insufficient to be viewed as normal ion signals. By performing curve fitting on the effective signal block, the noise-free mass spectrum can be obtained. To evaluate the performance of the proposed method, a simulation was performed using the signals acquired from the development equipment. Simulation results show the validity of the threshold setting from the mode and the superiority of the proposed curve fitting and linear approximation based noise canceling algorithm.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.27 no.10A
• /
• pp.962-968
• /
• 2002

Reliable high-speed data communications over insufficient channel bandwidth is one of the major challenges of harsh wireless environments that push the achievable spectral efficiency far below its theoretical limits. A Quadrature amplitude modulation (QAM) scheme is a userful modulation technique for achieving high data rate transmission without increasing the bandwidth of wireless communication systems. The exact general bit error rate (BER) expression of arbitrary rectangular quadrature amplitude modulation has not yet been derived. In this paper, a generalized closed-form expression for the BER performance of rectangular QAM with Gray code bit mapping is derived and analyzed in the presence of additive white Gaussian noise (AWGN) channel. First we analyze the BER performance of an I-ary PAM scheme. Regular patterns in the k-th bit error probability are observed while developing the EBR expression. From these patterns we provide the exact and general closed-from EBR expression of an I-ary PAM. Then we present a general closed-from expression for BER of an arbitrary IXJ rectangular QAM by considering that this signaling format consists of two PAM scheme, i.e., I-ary and J-ary PAM. A simple approximate BER expression for rectangular QAM is given as well.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.34 no.9C
• /
• pp.863-870
• /
• 2009

Bilateral filter (BF) is a nonlinear filter for sharpness enhancement and noise removal. The BF performs the function by the two Gaussian filters, the domain filter and the range filter. To apply the BF to infrared (IR) small target detection, the standard deviation of the two Gaussian filters need to be changed adaptively between the background region and the target region. This paper presents a new BF with the adaptive standard deviation based on the analysis of the edge component of the local window, also having the variable filter size. This enables the BF to perform better and become more suitable in the field of small target detection Experimental results demonstrate that the proposed method is robust and efficient than the conventional methods.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.34 no.9C
• /
• pp.922-927
• /
• 2009

Utilization problem of the limited spectrum is the one of the most important issues in wireless communication systems. Cognitive radio technique which is finding and utilizing frequency holes is also one of those techniques. Specially, the spectrum sensing technique to detect the primary user signal is a core technology in cognitive radio area. In this paper, we propose the spectrum sensing algorithm using Bussgang theorem. The proposed algorithm calculates the statistical difference between the Gaussian noise and the primary user signal by applying Bussgang theorem to the received signal. The algorithm is not affected by noise uncertainty and can detect the primary user signal in the very low SNR environment. We evaluate the algorithm through computer simulations with 12 ATSC A/74 DTV signal captures based on IEEE 802.22 WRAN and formulate the sensing threshold for the proposed scheme.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.34 no.9C
• /
• pp.848-854
• /
• 2009

DVB-SSP is a new broadcasting system for hybrid satellite communications, which supports mobile handhold systems and fixed terrestrial systems. An upper layer, including erasure Reed-Solomon error correction combined with cyclic redundancy check. However, a critical factor must be considered in upper layer decoding. If there is only one bit error in an IP packet, the entire IP packet is considered as unreliable bytes, even if it contains correct bytes. If, for example, there is one real byte error, in an If packet of 512 bytes, 511 correct bytes are erased from the frame. Therefore, this paper proposed upper layer decoding methods; hybrid decoding. By means of simulation we show that the performance of the proposed decoding algorithm is superior to that of the conventional one in AWGN channel and TI channel.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.38C no.6
• /
• pp.503-511
• /
• 2013

This paper presents a speech enhancement method using non-negative matrix factorization. In training phase, we can obtain each basis matrix from speech and specific noise database. After training phase, the noisy signal is separated from the speech and noise estimate using basis matrix in enhancement phase. In order to improve the performance, we model the change of encoding matrix from training phase to enhancement phase using independent Gaussian distribution models, and then use the constraint of the objective function almost same as that of the above Gaussian models. Also, we perform a smoothing operation to the encoding matrix by taking into account previous value. Last, we apply the Log-Spectral Amplitude type algorithm as gain function.

• The Journal of the Acoustical Society of Korea
• /
• v.36 no.4
• /
• pp.285-291
• /
• 2017

Many methods have been studied to estimate the time delay between incoming signals to two receivers. In the case of the method based on the channel estimation technique, the relative delay between the input signals of the two receivers is estimated as an impulse response of the channel between the two signals. In this case, the characteristic of the channel has sparsity. Most of the existing methods do not take advantage of the channel sparseness. In this paper, we propose a time delay estimation method using BPD (Basis Pursuit Denoising) optimization technique, which is one of the sparse signal optimization methods, in order to utilize the channel sparseness. Compared with the existing GCC (Generalized Cross Correlation) method, adaptive eigen decomposition method and RZA-LMS (Reweighted Zero-Attracting Least Mean Square), the proposed method shows that it can mitigate the threshold phenomenon even under a white Gaussian source, a colored signal source and oceanic mammal sound source.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.39C no.6
• /
• pp.490-496
• /
• 2014

The thickness of knee joint cartilage causes most diseases of knee. Therefore, an articular cartilage segmentation of knee magnetic resonance imaging (MRI) is required to diagnose a knee diagnosis correctly. In particular, fully automatic segmentation method of knee joint cartilage enables an effective diagnosis of knee disease. In this paper, we analyze a well-known level-set based segmentation method in brain MRI, and apply that method to knee MRI with solving some problems from different image characteristics. The proposed method, a fully automatic segmentation in whole process, enables to process faster than previous semi-automatic segmentation methods. Also it can make a three-dimension visualization which provides a specialist with an assistance for the diagnosis of knee disease. In addition, the proposed method provides more accurate results than the existing methods of articular cartilage segmentation in knee MRI through experiments.

• Journal of Digital Convergence
• /
• v.11 no.7
• /
• pp.201-207
• /
• 2013

The chirp signaling has been mainly used in radar systems due to its good correlation characteristics, and nowadays it is applied to real time locating system(RTLS). The RTLS with chirp signaling was chosen as a standard such as ISO/IEC 24730-5 and IEEE 802.15.4a. In this paper, the performance of a real time locating system with chirp signaling was evaluated and simulated with relative distance error rates. We considered three cases of S/I = -30[dB], -20[dB], and -10[dB] with Rician factor K=10 and K=20. The performance was enhanced with K factor improvement by 25%, 27% and 50% for respective three cases of S/I. As results, in case of S/I < -20[dB], the minimum signal power is required for performance improvement even though the line of sight component is helpful. And also, in case of S/I ${\geq}$ -20[dB], as the line of sight component is stronger the better performance is obtained.