• Transactions of Materials Processing
• /
• v.6 no.2
• /
• pp.102-109
• /
• 1997

The multistage deformation and stress relaxation were carried out to investigate the strain induced precipitation by torsion tests in the range of 1000~80$0^{\circ}C$, 0.05~5/sec for V-microalloyed steel. The starting temperature and time for the initiation of precipitation were determined by stress relaxation tests. The distribution of precipitates increased, as the strain rate increased and the mean size of precipitates was found to be about 10~30nm. The precipitation starting time$(P_s)$ decreased with increasing strain rate and the amount of pre-strain. The effect of deformation conditions on the no-recrystallization temperature$(T_nr)$ was also determined in the multistage deformation. $T_nr$ Tnr decreased with increasing the strain and strain rate. In the controlled rolling simulation, grain refinement and precipitation hardening effects could be achieved by the alternative large pass strain at the latter half pass stage under the condition of low temperature and high strain rate.

• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 2004.11a
• /
• pp.83-88
• /
• 2004

Acoustic modes of internal region of 4-hp scroll compressor are identified by measuring transfer functions between a reference and 84 measuring points. The corresponding acoustic mode-shapes and natural frequencies were calculated by analysis software SYSNOISE. There exist two clearly distinguishable dipole modes of vertical and horizontal direction and a single quadrupole mode in the frequency region of interest. It shows that the natural frequencies of the identified modes are linearly sensitive to suction pressure (Ps) but relatively in sensitive to discharge pressure (Pd) in operating condition.

• Bulletin of the Korean Chemical Society
• /
• v.19 no.8
• /
• pp.868-874
• /
• 1998

An equivalent retention has been experimentally observed in thermal field-flow fractionation (ThFFF) for different polymer-solvent systems. It is shown that iso-retention between two sets of polymer-solvent systems can be obtained by adjusting the temperature difference (ΔT) according to the difference in the ratio of ordinary diffusion coefficient to thermal diffusion coefficient. This method uses a compensation of field strength (ΔT) in ThFFF at a fixed condition of cold wall temperature. It is applied for the calculation of molecular weight of polymers based on a calibration run of different standards obtained at an adjusted AT. The polymer standards used in this study are polystyrene (PS), polymethylmethacrylate (PMMA), and polytetrahydrofuran (PTHF). Three carrier solvents, tetrahydrofuran (THF), methylethylketone (MEK) and ethylacetate (ETAc) were employed. Though the accuracy in the calculation of molecular weight is dependent on the difference in the slope of log λ vs. log M which is related to Mark-Houwink constant a, it shows reasonable agreement within about 6% of relative error in molecular weight calculation for the polymer-solvent systems having similar a value.

• Clinical and Experimental Pediatrics
• /
• v.61 no.7
• /
• pp.210-216
• /
• 2018

Purpose: The present study aimed to evaluate progression and prognosis according to the palliation method used in neonates and early infants aged 3 months or younger who were diagnosed with pulmonary atresia with ventricular septal defect (PA VSD) or tetralogy of Fallot (TOF) with severe pulmonary stenosis (PS) in a single tertiary hospital over a period of 12 years. Methods: Twenty with PA VSD and 9 with TOF and severe PS needed initial palliation. Reintervention after initial palliation, complete repair, and progress were reviewed retrospectively. Results: Among 29 patients, 14 patients underwent right ventricle to pulmonary artery (RV-PA) connection, 11 palliative BT shunt, 2 central shunt, and 2 ductal stent insertion. Median age at the initial palliation was 13 days (1-98 days). Additional procedure for pulmonary blood flow was required in 5 patients; 4 additional BT shunt operations and 1 RV-PA connection. There were 2 early deaths among patients with RV-PA connection, one from RV failure and the other from severe infection. Finally, 25 patients (86%) had a complete repair. Median age of total correction was 12 months (range, 2-31 months). At last follow-up, 2 patients had required reintervention after total correction; 1 conduit replacement and 1 right ventricular outflow tract (RVOT) patch enlargements. Conclusion: For initial palliation of patients with PA VSD or TOF with severe PS, not only shunt operation but also RV-PA connection approach can provide an acceptable outcome. To select the most proper surgical strategy, we recommend thorough evaluation of cardiac anomalies such as RVOT and PA morphologies and consideration of the patient's condition.

• Membrane Journal
• /
• v.14 no.2
• /
• pp.173-184
• /
• 2004

For the application of direct methanol fuel cell (DMFC), sulfonated polystyrene/teflon (PS/PTFE) composite membranes were developed by changing monomer ratio of styrene and DVB. The composite membranes were prepared as follows: first, the monomer mixtures consisting of styrene, divinyl benzene and AIBN were impregnated in porous PTFE film and then, polymerized under 8$0^{\circ}C$ to give PS/PTFE membranes. Finally, the membranes were reacted with chlorosulfonic acid in 1,2-dichloroethane to give the sulfonated composite membranes. The measurements of ATR-FTIR, SEM, solvent uptake test and ion exchange capacity (IEC) were done for the resulting membranes before or after sulfonation, respectively, which showed the composite membranes with proper crosslinking degree and sulfonic acid content were prepared well as a function of styrene/DVB ratio. ion conductivity and methanol permeability were studied for the sulfonated membranes. It was found that with decreasing the ratio of styrene/DVB, methanol permeability decreased from $6.6{\times}10^{-7}∼1.3{\timas}10^{-7}$ $\textrm{cm}^2$/s, which are much lower values than that of Nafion$^{(R)}$117($1.02{\times}10^{-6}$ $\textrm{cm}^2$/s). Under the same monomer condition, ion conductivity decreased from 0.11 S/cm ($25^{\circ}C$) to 0.08 S/cm ($25^{\circ}C$), which are similar or a little higher values compared with $Nafion^{(R)}117 (1.02{\times}10^{-6}$ $\textrm{cm}^2$/s, 0.0824 S/cm). These two results confirmed the composite membranes prepared could be applied successfully to DMFC.C.

• Journal of the Korean Recycled Construction Resources Institute
• /
• v.12 no.3
• /
• pp.239-245
• /
• 2024

PS(Prestressed) tendons are under high tensile stress and have a smaller concrete cover than RC(Reinforced Concrete) member, so that the more conservative specifications on corrosion have been proposed for PS member. In this study, three levels of chloride concentrations(0.0 mol/l, 0.125 mol/l, and 0.25 mol/l) were prepared for evaluating the corrosion behavior in different position of 7 strand wires. For accelerating corrosion and measuring the corrosion amount in tendon, the tendon was embedded in partially saturated soil, and HCP(Half Cell Potential) was measured from the soil surface. During the test period of 28 weeks, HCP was measured every two weeks and the corrosion weight in the tendon was measured at 16 and 28 weeks of test period. Through the test, HCP result in tendon increased as the wires were located toward bottom due to high saturation. HCP in the lowest wire position showed an increase by 5.92 % compared to that in top position in 0.25 mol/l condition. The lower the position of the wire contained more saturation, which yielded increasing corrosion amount and HCP in tendon. In addition, the relation between corrosion weight and chloride concentration was quantitatively obtained through regression analysis.

• KOREAN JOURNAL OF CROP SCIENCE
• /
• v.66 no.3
• /
• pp.190-200
• /
• 2021

The heading response of rice varieties, originated from South Korea, North Korea, and northern China, was examined under the temperature and day-length conditions of 10 low-temperature regions in North Korea. When 30-day-old broadcast tray-raised seedlings (BS) were used, only one or a few varieties reached the heading stage within the safe marginal heading date (SMHD) under the Hamhung, Pyonggang, Huichon, and Kanggye conditions. In the Yangdok and Sinpo environments, no varieties reached heading until SMHD. The South Korean varieties that reached the heading stage between SMHD and late marginal heading date (LMHD) were Jinbuol, Baegilmi, Joun, Jopum, Jinok, Jopyeong, Sanhomi, and Odae for the Hamhung, Pyonggang, Huichon, and Kanggye; Joun for Sinpo; and none for Yangdok, Kimchaek, Sonbong, and Chunggang environments. The number of days to heading (DTH) was positively correlated among all 10 regions. Reduced DTH in the 30-day-old pot tray-raised seedlings (PS), compared to BS, was not consistent with varieties and regions. Reduced DTH in PS, compared to BS, was the largest in Jinok and Sonbong9 among the South and North Korean varieties, respectively, whereas it was small in the northern Chinese varieties. The South Korean varieties that headed until SMHD in PS were Jinok for the Hamhung, Pyonggang, Yangdok, Sinpo, and Kanggye environments; and Jinbuol, Jopum, and Jinok for the Huichon condition. In the Kimchaek and Chunggang conditions, Jinok reached the heading stage within LMHD. With the use of PS for some responsive varieties such as Jinok, varietal adaptability could be improved to the conditions of low-temperature regions in North Korea. None of the PS or BS among the tested varieties reached the heading stage until LMHD for the Chongjin and Sonbong conditions.

• Journal of Biosystems Engineering
• /
• v.6 no.1
• /
• pp.39-47
• /
• 1981

For purpose of investigation the proper paddy field condition in performance of rice transplanter according to the various elapsed times (0.5, 1, 1.5, 2 days) after puddling and plowing (12, 15, 18 cm depth), this experiment was carried out on the paddy field located in Chil Am Dong, Jin Ju City, from April to May in 1980. The results are summarized as follows; 1. The practical working power for the elapsed time 0.5 days and plowing depth 18cm was about 0.8 ps, which was the highest among the plots, so the power out-put(2.5~3.5 p.s) of these engines are considered to be enough for the transplanting under these field conditions. 2. The percentage of slip increased proportional1y to the plowing depth and decreased proportionally to the elapsed time after puddling, and the highest and lowest percentages of slip were 42.5% in elapsed time 0.5 days, plowing depth 18 cm, and 26.5% in elapsed time 2 days, plowing depth 12 cm, respectively. 3. In the plot of elapsed time 2 days and plowing depth 12 cm, the planting distance was 13.9 cm, which was closed to the proper planting distance 14 cm. 4. The percentage of missing hill was lowest(1.5%) in the plot of elapsed time 2 days and plowing depth 12 cm. 5. The planted depth in the plot of the elapsed time 2 days and plowing depth 15 cm was 2. 95 cm, which was closed to the proper planting depth 3 cm. 6. The angle of planting postures in the plot of elapsed time 2 days and plowing depth 12 cm was $89^{\circ}$, which was closed to the desirable posture angle $90^{\circ}$. 7. The deviation from the straight transplanting line was lowest in the plot of the elapsed time 2 days and plowing depth 12 cm. 8. From the results above mentioned, it is recommended that the field condition under the elapsed time 2 days and plowing depth 12 cm is the most favorable one for the working performance of rice thansplanter.

• The Korean Journal of Quaternary Research
• /
• v.18 no.2 s.23
• /
• pp.33-42
• /
• 2004

In South Korea a Pedo-sedimentary Sequence(PS) indicating the Last Glacial Maximun(LGM) is typified y a brown to dark brown, relatively stiff paleosol layers formed by repetitive freezing and thawing processes which in turn left characteristi glossic textures in soil-solum, polygolnal structures with a flagipans, vertical soil wedges or freezing cracks, and horizontal foliations, As a pre-LGM sedimentary sequences (older than 25Ka), the Old Fluvial Sequence(OFS) overlain by the Slope Sedimentary Sequence(SS) are distributed commonly at the base level higher than 14-15m above present river-bed along the major river basin. After the LGM (ca. 18Ka), the Young Fluvial Sequence(YFS) appears at an altitude ascending order of sedimentary profiles. In this fluvial organic muds of Jangheungri site(Jinju), Sorori site(Cheonwon), and Youngsan estruarine rivermouth(Mokpo) were exemplified in order to interpret their formation ages and environments. As result of $^{14}C$ datings, the formation ages of te organic muds are Boelling to Alleroed (MIS-1). These organic muds were fomed in fluvial backswamp or local pond/bog in response to shifting fluvial system. On the basis of palynological production dominant with Abies/Picea-Betula and Ranunculaceae, Compositae, Cyperaceae, and Graminae, it was interpreted that more boreal to subboreal condition was prevailed rather than temperate like today during the formation of organic muds and soil moisture condition was a repetition of wet and dry condition.

• Journal of the Korean Society of Fisheries and Ocean Technology
• /
• v.13 no.2
• /
• pp.21-26
• /
• 1977

The author operated with a six seam trawl net by the stern trawler, No. 85 Parto, 499 GT, 2,200ps, in the Atlantic coast of Africa, from June, 1975 to October, 1977. In the term, towing speed and warp tension were determined, and trawling condition was observed. 1. The condition of trawling was good when the tension was less than 7.5ton. 2. 290 RPM, $13.5^{\circ}\;to\;13.8^{\circ}$ of pitch angle, and 3.5 to 4 knots of towing speed was considered as optimum for the trawler in the relation to the engine condition.