• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.17 no.9
• /
• pp.1001-1005
• /
• 2004

Rye-sensitized solar cell (DSSC) is a new class of solar cell, which consists of nanoporous TiO$_2$ electrode, dye-sensitizer, electrolyte, and counter electrode. Such cell is operated in sunlight via the principle of photosynthetic electrochemistry. In order to obtain the good dispersion of nano size TiO$_2$ particles In slurry, the pH of solvent, the sort and quantify of solvent additive and the quantity of surfactant were adjusted. As results, the lower the pH of solvent was the lower the viscosity of the slurry became. The addition of ethylene glycol and propylene glycol to dilute HNO$_3$ brought about the lowering of viscosity and the enhancement of stability in slurry. The addition of surfactant lowered the viscosity of slurry. It was possible to obtain the homogeneous and uniformly dispersed mesoporous TiO$_2$ film using the dilute HNO$_3$ solvent of pH 2 with the addition of ethylene glycol and neutral surfactant. DSSC was assembled with TiO$_2$ electrode and Pt electrode, and its photoelectric property was measured using the monochromatic wavelength in the rangee of 350∼700 nm.

• Journal of the Korean Ceramic Society
• /
• v.32 no.6
• /
• pp.719-725
• /
• 1995

ZST powders were synthesized by coprecipitation of (Zr4+, Ti4+)-hydroxide in the presence of SnO2 particles. Zn(NO3)2 was used as a sintering additive, and according to the adding sequence, sintering and dielectric properties were investigated. Sintered densities of ZST prepared by adding Zn(NO3)2 before calcination were a little higher than those added after calcination, and dielectric properties of the specimen added by Zn(NO3)2 after calcination were better (sintered at 125$0^{\circ}C$/2 h ; Q$\times$f(GHz)=49, 000, $\varepsilon$r=41) than before calcination (Q$\times$f(GHz)=42, 000, $\varepsilon$r=39.5). Through the observation of TEM, it was identified that the cause was due to the difference of the degree of Zn2+ diffusion into grains. With increasing sintering time from 2 to 8 hrs, grain size was doubled and dielectric properties were somewhat deteriorated.

• Journal of the Korean Ceramic Society
• /
• v.25 no.4
• /
• pp.380-384
• /
• 1988

This investigation includes nitridation phenomena of silicon powder compacts in air. Nitridation reaction condition has been provided with using silicon nitride bed and active carbon additive. Reaction products are Oxynitride, $\alpha$-Si3N4, and $\beta$-Si3N4, Oxynitride(Si2N2O) phase in formed at outer surface layer ofsilicon powder compacts. $\alpha$-Si3N4, and $\beta$-Si3N4 are formed at inner region of powder compacts. Microstructural observation indicates that nitridation mechanism in this work is the same as conventional nitridation mechanism nitrogen gas.

• Journal of the Korean Ceramic Society
• /
• v.41 no.1
• /
• pp.9-12
• /
• 2004

The effect of x wt% CuO-y wt% $V_2O_5$ content on the microwave properties of $(Pb_{0.45}Ca_{0.55})[(Fe_{0.5}Nb_{0.5})_{0.9}Sn_{0.1}]O_3$ (PCFNS) ceramics was investigated. In order to decrease the sintering temperature and use as a Low Temperature co-firing Ceramics (LTCC), CuO-$V_2O_5$ are added in the PCFNS. The bulk density, dielectric constant (${\varepsilon}_r$) and quality factor(Q${\cdot}f_0$) increased with increase in CuO content within a limited value. The microwave properties were degraded with increases in $V_2O_5$ content. The temperature coefficient of the resonant frequency (${\tau}_f$) of PCFNS was shifted to positive value abruptly with increasing the $V_2O_5$ content, while the ${\tau}_f$ was slightly shifted to positive value with increasing the CuO content. The optimized microwave properties, ${\varepsilon}_r$ = 88, Q${\cdot}f_0$ = 6100 (GHz), and ${\tau}_f$ = 18 ppm/$^{\circ}C$, were obtained in $(Pb_{0.45}Ca_{0.55})[(Fe_{0.5}Nb_{0.5})_{0.9}Sn_{0.1}]O_3$ with 0.2wt% CuO 0.05 wt% $V_2O_5$ and sintered at $1000^{\circ}C$ for 3 h. The relationship between the microstructure and microwave dielectric properties of ceramics was studied by X-Ray Diffraction (XRD) and Scanning Electron Microscopy (SEM)

• Journal of Aerospace System Engineering
• /
• v.14 no.3
• /
• pp.24-31
• /
• 2020

A study on the H2O2 based low toxic hypergolic propellant was conducted. The fuel candidates were chosen as a mixture of Amine solvent and reactive additive. The analytical performance was calculated via the NASA CEA code and 96% Isp of the NTO/UDMH was confirmed. The ignition delay measurement with drop test was performed and all candidates showed less than 10 ms in the best performance cases. Based on these results, the feasibility of high response H2O2 based low toxic hypergolic propellant was confirmed.

• Korean Journal of Materials Research
• /
• v.31 no.5
• /
• pp.301-311
• /
• 2021

The conversion of all carbon preforms to dense SiC by liquid infiltration can become a low-cost and reliable method to form SiC-Si composites of complex shape and high density. Reactive sintered silicon carbide (RBSC) is prepared by covering Si powder on top of 0.5-5.0 wt% Y₂O₃-added carbon preforms at 1,450 and 1,500℃ for 2 hours; samples are analyzed to determine densification. Reactive sintering from the Y₂O₃-free carbon preform causes Si to be pushed to one side and cracking defects occur. However, when prepared from the Y₂O₃-added carbon preform, an SiC-Si composite in which Si is homogeneously distributed in the SiC matrix without cracking can be produced. Using the Si + C = SiC reaction, 3C and 6H of SiC, crystalline Si, and Y₂O₃ phases are detected by XRD analysis without the appearance of graphite. As the content of Y₂O₃ in the carbon preform increases, the prepared RBSC accelerates the SiC conversion reaction, increasing the density and decreasing the pores, resulting in densification. The dense RBSC obtained by reaction sintering at 1,500 ℃ for 2 hours from a carbon preform with 2.0 wt% Y₂O₃ added has 0.20 % apparent porosity and 96.9 % relative density.

• Archives of Pharmacal Research
• /
• v.27 no.1
• /
• pp.57-60
• /
• 2004

Glycyrrhizin (18$\beta$-glycyrrhetinic acid-3-O-$\beta$-D-glucuronopyranosyl-(1$\rightarrow2)-\beta$-D-glucuronide, GL) was transformed to 18$\beta$-glycyrrhetinic acid-3-O-$\beta$-D-glucuronide (GAMG) by Streptococcus LJ-22. The antiallergic activities of GL and GAMG was measured using a RBL cell assay system and contact hypersensitivity model mice. GAMG exhibited anti-allergic activity with $IC_{50}$ values of 0.28 mM. GAMG, which is sweeter than GL, and 18$\beta$-glycyrrhetinic acid, which is a GAMG metabolite by human intestinal bacteria, also inhibited the passive cutaneous anaphylaxis and skin contact inflammation. In conclusion, GAMG may be useful as a new sweet food additive and an anti-allergic agent.

• Korean Journal of Materials Research
• /
• v.16 no.12
• /
• pp.747-753
• /
• 2006

(BaSr)$TiO_3$ (BST) thick films were prepared by tape casting method, using $BaTiO_3$ and $SrTiO_3$ powder slurry and their dielectric properties were investigated. With an additive, $Li_2CO_3$, the sintering temperature was lowered by $200^{\circ}C$. Sintering density was 5.7 g/$cm^3$ and the BST thick films exhibited a maximum dielectric constant, tunability at temperatures near phase transition point. Whilst their characteristics were deteriorated above the phase transition temperature, they were unchanged below the phase transition temperature, which is presumedly due to the acceleration of $90^{\circ}$ domain formation, its contribution to the relaxation of internal stress and the increase in sintering according to the replacement of Li.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.7 no.2
• /
• pp.253-258
• /
• 1997

The characteristics of crystal structure and phase transition with dopants ($Nb_2O_5$= 0.1~0.4 mol% and $Y_2O_3$ : 0.2~0.4 mol%) on the PTCR $BaTiO_3$ system were investigated. In the case of $Nb_2O_5$ additive, the lattice parameter of PTCR $BaTiO_3$ was changed linearly with the increasement of $Nb_2O_5$ which substituted B-site of BaTiO$_3$ and the lattice parameter of c-axis decreased abruptly at 0.3 mol%. These phenonmena were assumed to originate from the distortion of octahedron and we could confirm that the change of lattice parameter accorded with the characteristics of the phase transition temperature. $Y^{3+}$ ions substituted both of A- and B-site until the 0.3 mol% addition, but $Y^{3+}$ substitution preferred A- to B-site above 0.3 mol%. This was affirmed by the variation ,of lattice parameter and the characteristics of phase transition. It also was found that $Y^{3+}$ions in the A-site substituted both of $Ba^{2＋}$ and $Ca^{2＋}$ ions with equal ratio by Rietveld method.

• Korean Journal of Materials Research
• /
• v.2 no.4
• /
• pp.263-269
• /
• 1992

Low-firing dielectric materials with negative small temperature coefficients were investigated. The newly developed materials are based on Ti$O_2$(100-x)/ CuOx(X=1~5wt%) with small amount of Mn$O_2$ additive. The sample without CuO was not sintered at 90$0^{\circ}C$. As CuO content was increased the sample could be sintered at low temperature. However, the dielectric constant was decreased and the dielectric loss was increased. In the case of adding 3wt% CuO and 0.6wt% Mn$O_2$, the dielectric constant and the Q values appeared very high.