• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2000년도 추계학술대회 논문집
• /
• pp.575-578
• /
• 2000

In this work, all solid-state thin film supercapacitor(TFSC) was fabricated using tungsten trioxide (WO$_3$) with a structure WO$_3$/LiPON/WO$_3$/Pt/TiO$_2$/Si (substrate). After TiO$_2$ was deposited on Si(100) wafer by d.c. reactive sputtering, the Pt current collector films were grown on TiO$_2$glue layer without breaking vacuum by d.c. sputtering. Fabrication conditions of WO$_3$ thin film were such that substrate temperature, working pressure, gas ratio of $O_2$/Ar and r.f. power were room temperature, 5 mTorr, 20% (O$_2$(8sccm)/Ar(32sccm)) and 200W, respectively. LiPON electrolyte film were grown on the WO$_3$ film using r.f. magnetron sputtering at room temperature. The XRD pattern of the as-deposited WO$_3$ thin film were shown no crystalline peak (amorphous). The SEM image of as-deposited WO$_3$ thin film showed that the surface is smooth and uniform. The capacitiy of as-fabricated TFSC was 0$\times$10$^{-2}$ F/$\textrm{cm}^2$-${\mu}{\textrm}{m}$.

• 한국세라믹학회지
• /
• 제32권12호
• /
• pp.1369-1376
• /
• 1995

The WO3 thin-film NOx sensor which is of practical use and includes the heater and the temperature sensor was fabricated. The WO3 thin films as a gas-sensing layer was deposited at ambient temperature in a high-vacuum resistance heated evaporator. The highest sensitivity of the WO3 thin-film sensor to NOx was obtained under the condition of the annealing temperature of 50$0^{\circ}C$ and the operating temperature of 30$0^{\circ}C$. The gas sensing characteristics of this sensor was excellent, i.e. high sensitivity (Rgas/Rair in 3 ppm NO2=53) and fast response time (4 seconds).

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2000년도 하계학술대회 논문집
• /
• pp.536-539
• /
• 2000

The effects of annealing on the electrical and structural characteristics for the rf sputter deposited WO$_3$thin film. The sputtered thin films are annealed at 773K for 1 hour in air atmosphere. Oxygen flow rate were changed from 0 to 70% during sputtering. It is observed from the results of the AFM measurement that the average roughness for the rf sputter deposited WO$_3$thin film would be increased from 2.45 angstrom to 152 angstrom by annealing. The sheet resistance of the sputtered WO$_3$film is changed from insulting to MOhm after annealing. According to the results of the XRD, the as-deposited films revealed the amorphous state whereas the peaks of X-ray diffraction at 2 theta= 28 degrees and 2 theta = 25 degrees corresponding to the (111) and (200) plane of the WO$_3$film respectively are observed after annealing.

• 전기화학회지
• /
• 제8권1호
• /
• pp.32-36
• /
• 2005

본 연구는 $WO_3$ 박막과 $NiO-WO_3$ 박막을 고진공 저항가열식 thermal evaporation 법으로 (100) n형의 실리콘 단결정 기판 위에 증착시켰고, 막의 결정성 증진을 위하여 공기 중 $500^{\circ}C$에서 30분 동안 열처리하였다. 박막의 결정성 및 결정구조를 분석하기 위해서 X선 회절분석기를 사용하였고, 표면 및 단면 관찰을 위해서는 주사전자현미경을 이용하였다. 그리고 화학 조성 결합에너지는 XPS를 이용하였다. 순수 $WO_3$ 박막의 결정 크기는 $500^{\circ}C$에서 30분 동안 공기중 열처리에 의해서 $0.6{\mu}m$로 성장하였고 $WO_3$ 박막의 두께가 증가할수록 거의 변화 없이 일정하였다. 반면, NiO가 첨가된 $WO_3$ 박막 두께별 결정크기는 각각 $0.12{\mu}m,\;0.28{\mu}m,\;0.32{\mu}m$및 $0.43{\mu}m$로 순수 $WO_3$ 박막에 비해 치밀한 표면을 형성하였고, 최대 5배정도 성장이 억제되었다. 가스감도 측정은 대기 중에서의 센서 저항 값을 기준으로 측정가스 저항 값의 비율 $(R_{NOx}/R_{air})$로 가스감도를 나타내었다. 전기적 성질은 MFC로 NOx가스 5ppm을 일정히 유지시켰고, Multimeter로 계측하여 컴퓨터에 자동 계측되는 시스템을 사용하였다. 순수 $WO_3$박막보다는 $NiO-WO_3$ 박막이 우수한 NOx 감도특성을 보였고 센서의 작동온도는 $250^{\circ}C$에서 우수한 감도를 나타내었다.

• 전기학회논문지
• /
• 제63권11호
• /
• pp.1533-1537
• /
• 2014

$WO_3/Ag/WO_3$ multilayer was researched by using RF magnetron sputtering with transparent electrode. Process gas flow ratio with $Ar/O_2$ were selected the optimum conditions at 70sccm/2sccm and $WO_3$ thin film at its conditions was appeared at transmittance about 80% in the visible light region to the average. $WO_3/Ag/WO_3$ multilayer thin films were fabricated from the same process condition which was the same gas flow ratio of Ar and $O_2$ $WO_3/Ag/WO_3$ thin films were appeared transmittance about 93% and sheet resistance about $6.41{\Omega}/{\square}$. From the SEM images, each thin films were appeared when $WO_3$ is 40nm and $O_2$ is 10nm.

• 센서학회지
• /
• 제15권2호
• /
• pp.120-126
• /
• 2006

Physicochemical and electrical properties for hydrogen gas sensors based on Pd-deposited $WO_3$ thin films were investigated as a function of Pd thickness, annealing temperature, and operating temperature. $WO_3$ thin films were deposited on an insulating material by thermal evaporator. XRD, FE-SEM, AFM, and XPS were used to evaluate the crystal structure, microstructure, surface roughness, and chemical property, respectively. The deposited films were grown $WO_3$ polycrystalline with rhombohedral structure after annealing at $500^{\circ}C$. The addition effect of Pd is not the crystallinity but the suppression of grain growth of $WO_3$. Pd was scattered an isolated small spherical grain on $WO_3$ thin film after annealing at $500^{\circ}C$ and it was agglomerated as an irregular large grain or diffused into $WO_3$ after annealing at $600^{\circ}C$. 2 nm Pd-deposited $WO_3$ thin films operated at $250^{\circ}C$ showed good response and recovery property.

• 센서학회지
• /
• 제5권5호
• /
• pp.39-46
• /
• 1996

$WO_{3}$에 미량의 Pd 또는 Pt가 첨가된 박막을 이용한 NOx 센서를 제조하였다. $WO_{3}$계 박막은 고진공, 저항가연식 evaporator를 이용하여 분위기온도에서 증착한 다음 $500^{\circ}C$에서 열처리하였다. 5 ppm의 $NO_{2}$가스에 대하여 $200^{\circ}C$에서 측정한 가스감도($R_{gas}/R_{air}$)는 0.5 wt.% $Pt-WO_{3}$ 센서에서 50으로서 최대값을 가졌다.

• 한국진공학회지
• /
• 제8권2호
• /
• pp.136-140
• /
• 1999

The stability and response time of $WO_3$ thin films for EC device are critical problems being solved. Those are affected by the species of electrolyte, preparation conditions and fabricating methods of specimen. In this paper, we compared the stabilities of three kinds of tungsten oxide film in electrolyte. Each of three films was prepared by different manufacturing conditions, that is, one is a thermal oxidation film of tungsten metal deposited on pure glass substrate, another is a $WO_3$ film made on ITO glass directly, the other is a thermally oxidized film on tungsten plate. It was observed that thermally oxidized $WO_3$ films has a remarkable stability (the lifetime was above $10^6$ cycle). From these results, we found that the stability was closely related to the stoichiometric bonding between tungsten and oxygen atoms in addition to crystallinity and density of film.

• 한국표면공학회지
• /
• 제55권2호
• /
• pp.96-101
• /
• 2022

The effects of the growth temperature on the structural, optical, and morphological properties of BaWO₄:Sm³⁺ phosphor thin films were investigated. The BaWO₄:Sm³⁺ thin films were grown on quartz substrates at several growth temperatures by radio-frequency magnetron sputtering. All the thin films crystallized in a tetragonal structure with a main BaWO₄ (112) diffraction peak. The 830 nm-thick BaWO₄:Sm³⁺ thin films grown at 300 ℃ exhibited numerous polygon-shaped particles. The excitation spectra of BaWO₄:Sm³⁺ thin films consisted of a broad excitation band in the 200-270 nm with a maximum at 236 nm due to the O^2--Sm³⁺ charge transfer and two small bands peaked at 402 and 463 nm, respectively. Under 236 nm excitation, the BaWO₄:Sm³⁺ thin films showed an intense red emission peak at 641 nm due to the ⁴G_5/2→⁶H_9/2 transition of Sm³⁺, indicating that the Sm³⁺ ions occupied sites of non-inversion symmetry in the BaWO₄ host lattice. The highest emission intensity was observed for the thin film grown at 300 ℃, with a 51.8% transmittance and 5.09 eV bandgap. The average optical transmittance in the wavelength range of 500-1100 nm was increased from 53.2% at 200 ℃ to 60.8% after growing at 400 ℃. These results suggest that 300 ℃ is the optimum temperature for growing redemitting BaWO₄:Sm³⁺ thin films.

• 한국전기전자재료학회논문지
• /
• 제25권8호
• /
• pp.602-610
• /
• 2012

The powders for the $Na_xWO_3$ (x= 1 and 0.75) sputtering targets were synthesized by the calcination in reductive atmosphere. Near single-phase $NaWO_3$ and single-phase $Na_{0.75}WO_3$ powder targets were prepared. By using the targets, thin films of each composition were deposited by rf magnetron sputtering on the $SiO_2$ (100 nm)/Si substrates and annealed by RTP (rapid thermal processing) for crystallization. In the case of the $NaWO_3$ composition, single-phase $Na_xWO_3$ thin films, where x was believed to be slightly less than 1, were fabricated accompanying the Na-diffusion into the substrates during RTP. However, in the case of the $Na_{0.75}WO_3$ thin film preparation, it was unable to make single-phase thin films. From the phase formation behaviors of both powders and thin films, it was revealed that $Na_xWO_3$ with nonstoichiometric composition of x, which was slightly less than 1, was favorable. The good electrical conduction properties were obtained from the single-phase $Na_xWO_3$ thin films. Their electrical resistivities were as low as $7.5{\times}10^{-4}{\Omega}{\cdot}cm$.