• Proceedings of the KIEE Conference
• /
• 2003.07c
• /
• pp.1496-1498
• /
• 2003

The $(Sr_{0.85}Ca_{0.15})TiO_3$(SCT) thin films were deposited on Pt-coated electrode (Pt/TiN/$SiO_2$/Si) using RF sputtering method according to the deposition condition. The optimum conditions of RF power and Ar/$O_2$ ratio were 140[W] and 80/20, respectively. Deposition rate of SCT thin films was about 18.75[${\AA}/min$] at the optimum condition. The capacitance characteristics had a stable value within ${\pm}4[%]$. The drastic decrease of dielectric constant and increase of dielectric loss in SCT thin films were observed above 200[kHz].

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2005.07a
• /
• pp.303-304
• /
• 2005

Add $Li_2CO_3$ to $(Ba_{0.6}Sr_{0.4})$ $TiO_3$ powder to lower sitering temperature in this research, made thick film by tape casting method. Investigated about sitering temperature and physical properties that added $Li_2CO_3$ Even if lower sitering temperature about $200^{\circ}C$ adding $Li_2CO_3$ 10wt.%, density was near to 5.7$g/cm^3$ that is theoretical values, and crystal structure examined as perobeuseukaiteu senior after sintering.

• Applied Chemistry for Engineering
• /
• v.10 no.3
• /
• pp.407-414
• /
• 1999

We have studied the reduction of NO by CO over perovskite-type oxides prepared by malic and method. The catalysts were modified to enhance the activity by substitution of metal into A or B site of perovskite oxides. In the $LaCoO_3$ type catalyst, the partial substitution of Sr into A site enhanced the catalytic activity on the conversion of NO at less than $350^{\circ}C$. In the $La_{0.6}Sr_{0.4}Co_{1-x}Fe_xO_3$ catalyst, the partial substitution of Fe or Mn into B site enhanced the conversion of NO, but excess amount of Fe decreased the conversion of NO. In addition, $La_{0.6}Sr_{0.4}Co_{0.8}Fe_{0.2}O_3$ mixed with $SnO_2$ or $MnO_2$ showed the synergy effect on the reduction of NO. The introduction of water into reactants feed decreased the catalytic activity but the deactivation was shown to be reversible. The introduction of $SO_2$ into reactants feed also decreased the catalytic activity.

• 한국정보디스플레이학회:학술대회논문집
• /
• 2002.08a
• /
• pp.635-638
• /
• 2002

In $ABCO_4$ and $ABC_3O_7$ (A=Ca, Sr; B=Y, Rare earth; C=Al, Ga), random distribution of static crystalline fields in activator sites results in inhomogeneous broadening of spectral lines of luminescent materials. In this study, we investigated luminescent properties of above-mentioned materials by excitation and emission spectra. In result, both $ABCO_4$:Tb and $ABC_3O_7$:Tb phosphors emit the green light. $ABC_3O_7$:Tb phosphors absorbed shorter wavelength energy than $ABCO_4$ phosphors so that the emission efficiencies of $ABC_3O_7$:Tb phosphors were higher than those of $ABCO_4$:Tb phosphors under vacuum UV.

• Journal of Environmental Science International
• /
• v.9 no.6
• /
• pp.517-522
• /
• 2000

Separation of strontium ion from synthetic seawater in the contained liquid membrane permeator with two micro-porous films was performed. The permeator consisted of a liquid membrane and two cells for aqueous solutions. The liquid membrane consisted of $D_2EHPA(di-2-ethylhexy1-phosphoric acid)$ and DCH18C6 (dicyclohexano-18-crown-6),diluted to 30 vol% with kerosine and was trapped between two micro-porous hydrophilic films. This liquid membrane separated two aqueous solutions, one of which was synthetic seawater and the other of which was the stripping solutions consisting of 1mol/L $H_2SO_4$ solution. The effects of various operating parameters on the extraction rate and equilibrium extraction ratio of strontium ion from synthetic seawater were experimentally examined. The addition of DCH18C6 to the $D_2EHPA$ solution caused synergy effect on the extraction of strontium ion. The permeator extracted strontium ion from synthetic seawater effectively with high membrane life time.

• Proceedings of the KIPE Conference
• /
• 2003.11a
• /
• pp.109-112
• /
• 2003

SRM(switched reluctance motor) provides a excellent adjustable speed and torque characteristics. SRM has the possibility of maintaining full power over a wide speed range. So, many attempts are being done from home appliances to industrial applications. Especially, a traction drive of an SRM is one of a good application for it's DC-series characteristic. However, because of the switching mechanism and reluctance torque, it has some disadvantage Of noise and Vibration. It is difficult to adopt to an appliance demanding silency. A performance and noise tests with 6/4 and 12/8 SRM were done to compare the characteristics.

• KSBB Journal
• /
• v.14 no.3
• /
• pp.342-350
• /
• 1999

Photobacterium phosphoreum was used in order to study response to heavy metal including $HgCl_2$, $CdCl_2$, $MnSO_4$ and $ZnSO_4$ in view of developing monitoring system for toxic substances. The concentrations of heavy metal causing 50% reduction($EC_{50}$) in bioluminescence intensity were determined with both free and immobilized P. phosphoreum. The bioluminescence responses were examined at various concentrations of heavy metal after 10, 20 and 30 min of exposure. The linear correlation between Gamma values and concentrations of heavy metal was obtained and $EC_{50}$ was calculated from the linear correlation. The significant inhibitory concentrations for bioluminescence emission were found to be 0.05mg/L for $HgCl_2$, 25mg/L for $CdCl_2$, 50mg/L for $MnSO_4$ and 12.5mg/L for $ZnSO_4$, respectively. The free cell and disc type were shown to be more sensitive to heavy metal than cells mixed with Na-alginate or immobilized on Sr-alginate. However, the linear regression curves were derived from the Sr-alginate immobilized cells indicating the immobilization method is a useful tool for monitoring of heavy metal under more stable condition of bioluminescence.

• Journal of the Korean Society of Food Science and Nutrition
• /
• v.43 no.8
• /
• pp.1248-1256
• /
• 2014

The purpose of this study was to investigate the mechanisms of behind $SO_2$ formation and elevated cause of reducing power in purple bamboo salt (PBS) along with an analysis of physicochemical properties, content of sulfur compounds, oxidation reduction potential (ORP), mineral contents of salt type (MSS, mudflat solar salt; BS, bamboo salt), and addition of raw bamboo (RB). $SO_2$ content of 630 ppm was detected in PBS. $SO_2$ was not detected in MSS, BS, or RB, whereas $SO_2$ (782 ppm) from $K_2SO_4$ was detected after heating a NaCl, KCl, $MgCl_2$, $MgSO_4$, MgO, $CaCl_2$, $K_2SO_4$, and $FeSO_4$ with RB. $SO_2$ content of BS increased with baking time, and it originated from BSRB1 (13.88 ppm) to BSRB4 (109.13 ppm). $SO_3{^{2-}}$ originated only from MSSRB4 and BSRB2~BSRB4. Sulfate ion content decreased along with increasing $SO_2$ and sulfite ion contents. ORP increased with baking time of MSS and BS, and it was present at higher levels in BSRB4 (-211.40 mV) of BS than MSS. Insoluble content was higher in BS than MSS. Further, Ca, K, and Mg ion contents decreased in MSS and increased in BS with baking time. BSRB4 had 1.4 fold higher levels of Ca, 1.5 fold higher levels of Mg, and 1.8 fold higher levels of K than BS. Li, Al, Mn, Fe, and Sr in MSS as well as Al, Fe, and Ni in BS increased with baking time. Anions (Cl, $NO_3$, and Br) and heavy metals (Pb, Cd, Hg, and As) between MSS and BS were not significantly different. These results suggest that the reducing power of BS was due to $SO_2$ and sulfite ion. To increase the amounts of these compounds and reducing power, higher melting temperature and longer baking time are necessary along with BS, which is created by the addition of RB to roasted salt.

• Journal of Life Science
• /
• v.34 no.3
• /
• pp.191-198
• /
• 2024

To verify the nutritional value and safety of larvae fed with a soymilk residue-added food source, we compared and analyzed the nutritional components of and harmful substances in Tenebrio molitor larvae reared on wheat bran. Crude protein content based on dry weight was 1.2 times higher in the 10% soymilk residue-fed group (SR) (54.0%) than in the wheat bran-fed group (WB) (43.5%). Dietary fiber also tended to be 1.9 times more in the SR (4.9%) than the WB (2.5%). Among unsaturated fatty acids, the linoleic acid content was found to be 1.1-fold higher in the SR (32.9%) than in the WB (29.0%). Potassium, which was the most abundant among the macro minerals, was 1.1-fold more abundant in the WB (1,074.5 mg/100 g) than in the SR (1,014.0 mg/100 g). Among the micro minerals, zinc content was 1.2-fold higher in the SR (14.5 mg/100 g) than in the WB (11.9 mg/100 g). The results of the analysis of hazardous substances in the WB and SR revealed that the amount of heavy metals met the standards for heavy metals in edible insects, and food poisoning-inducing bacteria such as Escherichia coli and Salmonella spp. were not detected in all groups. These results indicate that mealworm larvae fed with 10% soymilk residue have abundant nutrients and are safe for intake. Thus, food sources with added soymilk residue has the potential to be used as feed ingredients.

• Journal of the Korean Ceramic Society
• /
• v.36 no.4
• /
• pp.403-409
• /
• 1999

The dielectric and pyroelectric properties of $Ba_{0.66}$$Sr_{0.38}$$TiO_{3}$(BST) thin films growtn on Pt/Ti/NON/Si us-ing RF magnetron sputtering have been investigated. With increasing the substrate temperature during de-position of the BST film in the range of 300-$600^{\circ}C$ the dielectric and pyroelectric constants of the film were increased due to improved crystallinity of the film. In addition the dependence of the microstructural and electrical properties of BST films onthe deposition temperature of the bottom Pt electrode was studied. The preferred orientation of the BST films as well as the microstructure of the Pt film was greatly in-fluenced by the deposition temperature of the bottom Pt electrode was studied. The preferred orientation of the BSt films as well as the microstructure of the Pt film was greatly in-fluenced by the deposition temperature of the bottom Pt electrodes. and thus so were the pyrolelectric pro-perties of the BST film. The highest value of pyroelectric coefficient at room temperature obtained in this work was $nCcm^{-2}K^{-1}$ which is much higher than those previously reported on other perovskite fer-roelectric thin films.