• Polymer(Korea)
• /
• v.26 no.5
• /
• pp.661-669
• /
• 2002

The purpose of this research is to absorb and remove sulfur dioxide existing in the air by using ion exchange non-woven fabric. So we found out very appropriate condition of anionic exchange fabric scrubber by measuring amount of SO$_2$ adsorption under the atmosphere that concentration, velocity, and humidity was 100∼200 ppm, 0.6∼1.0 m/sec, and 30∼90 RH%, respectively. Ion exchange capacity of ion exchanger showed the maximum value, 3.75 meq/g at pH 4, and adsorption equilibrium time was the maximum value, 30 h when gas velocity was 0.6 m/sec, moreover, at 80$\^{C}$, adsorption equilibrium time tended to decrease more than 10 h. When concentration was 200 ppm, while reaction speed between SO$_2$ and ligand of fibrous ion exchanger was getting faster, adsorption break point had a tendency to get faster as well. In addition, when relative humidity in the scrubber was 90%, adsorption efficiency was 7.6%/h that seemed to be 30% higher than 4.6%/h coming from the condition that relative humidity had been 30%, and it was totally absorbed under 5 wt% NaOH solution in 5 minutes.

• Environmental Analysis Health and Toxicology
• /
• v.24 no.3
• /
• pp.181-191
• /
• 2009

As an effort to prevent serious accidents involving oxygen deficiency and suffocation in confined spaces and to identify the causes of such accidents, the present study investigated relevant accidents and systems in Korea and other countries. This study also conducted a number of experiments at lethal concentration levels of oxygen deficiency using SD rats and observed the changes of experimental animals with humidity, organic gas (toluene), hydrogen sulfide, carbon monoxide and so on at the oxygen deficient environment. The results of the study are as follows. 1. The results from the experiment conducted using SD rats at lethal concentration levels of oxygen showed that there were no casualties at the 7% oxygen concentration level, but the mortality increase to 20% at 6% oxygen, it was jumped to 90% at 5% oxygen, and it was also dramatically reached 100% at 4% oxygen concentration. Therefore, 5.5% was calculated as the $LC_{50}$ (rat, 4hr) from these dose-response experiments with oxygen deficiency. 2. When we changed the level of toluene, $H_2S$, CO, humidity, and so on, in an oxygen deficient environment, it was observed that the small concentrations of $H_2S$ and CO make the highest effect on animals. In case of 350 ppm $H_2S$, it resulted in 30% mortality, and the 100% mortality was shown in 1,200 ppm CO concentration. The mortality increased as an oxygen deficient condition. However in the case of toluene up to 1,000 ppm, it were not affected with oxygen deficiency, and it did not indicate any significant differences in mortality as 20%, 90% humidities.

• Journal of Radiation Protection and Research
• /
• v.36 no.4
• /
• pp.223-229
• /
• 2011

Ba is the most useful element to get the $Ba(Ra)SO_4$ precipitate. However, when the high concentrations of ions such as sulfate, calcium are existed in the leachate of phosphogypsum stack, it is difficult to get the $Ba(Ra)SO_4$ precipitate. Since this reason, the developed method for the Ba coprecipitate using EDTA was performed to determine the $^{226}Ra$ concentration in the high sulfate sample. The average concentration of $^{226}Ra$ in a leachate of phosphogypsum using this method was 0.102 $Bq{\cdot}kg^{-1}$ and the minimal detectable activity is 3.4 $mBq{\cdot}kg^{-1}$. The $mBq{\cdot}kg^{-1}$ method was 0.102 $Bq{\cdot}kg^{-1}$ and the minimal detectable activity is 3.4 $mBq{\cdot}kg^{-1}$. The $^{226}Ra$ stock solution and the CRM (Certified Reference Material) were analyzed to verify this method. In analyzed $^{226}Ra$ stock solution, bias with added concentration was approximately 1% and the correlation curve between $^{226}Ra$ concentration in simulated standard sample and measured $^{226}Ra$ concentration showed good agreement with a correlation coefficient ($R^2$) of 0.99. In analyzed CRM, maximum bias with reference value was 5.8% (k=1) and the analytical results were in good agreement with the reference value.

• Journal of Environmental Science International
• /
• v.23 no.1
• /
• pp.69-79
• /
• 2014

The seasonal variation of pH and ion components in precipitation were investigated from January to December 2009 at Busan, Korea. The precipitation was acidic with a volume-weighted mean pH concentration of 5.32, which ranged from 3.79 to 8.66. The volume-weighted mean conductivity showed 86.77 ${\mu}S/cm$ and indicated higher concentration about 96.69 ${\mu}S/cm$ in summer. The volume-weighted mean equivalent concentration of components followed the order: $K^+$ > $Ca^{2+}$ > $nss-Ca^{2+}$ > $NH_4^+$ > $Mg^{2+}$ > $Na^+$ > $Li^+$ in cations and $Cl^-$ > $SO_4^{2-}$ > $nss-SO_4^{2-}$ > $NO_3^-$ > $NO^{2-}$ > $F^-$ > $Br^-$ in anions. Particularly, concentration of $K^+$ and $Cl^-$ showed 56 and 78 % in cations and anions. The higher concentration in $K^+$, $Na^+$, $Mg^{2+}$ and $Cl^-$ were shown in Busan city as compared to the other cities. The neutralization factors have been found to have higher value for potassium ion in winter compared with different seasons, indicating significant neutralization of acidic components over the region by potassium. Therefore, the precipitation characteristics at Busan had both continental and coastal as consequence of pH, conductivity and ionic analyses.

• Journal of Hydrogen and New Energy
• /
• v.19 no.2
• /
• pp.111-117
• /
• 2008

A Bunsen reaction section is a primary stage of Sulfur-iodine thermochemical hydrogen production cycle. This section is important, because it decides the efficiency of next stages. In order to produce hydrogen very efficiently, the characteristics of Bunsen reaction were investigated via two experimental methods. The one is a phase separation of $H_2SO_4-HI-H_2O-I_2$ mixture system, and the other is a direct Bunsen reaction. The characteristics of each method were investigated and compared. As the result of this study, the amount of HI and $I_2$ in $H_2SO_4$ phase via Bunsen reaction was more decreased than that via $H_2SO_4-HI-H_2O-I_2$ mixture system with increasing $I_2$ concentration. However, the amount of $H_2SO_4$ in $HI_x$ phase via Bunsen reaction was remarkably increased with increasing $I_2$ concentration, while that via $H_2SO_4-HI-H_2O-I_2$ mixture system was decreased. On the other hand, the range of initial composition which is able to separate into two liquid phases without $I_2$ solidification was almost alike.

• Journal of Plant Biology
• /
• v.18 no.1
• /
• pp.1-10
• /
• 1975

Development of a model system for mode of action studies of $SO_2$ was attempted with a plant tissue. Leaf disks, 1.0cm diameter, cut from the lamina of lettuce leaves, were floated on the testing medium and placed in light or dark condition to investigate the discoloration pattern with various sources of $SO_2$. Discoloration of leaf disks tended to be more serious with higher concentrations of $SO_2$ and on exposure to the light. Leaf disks were more severely discolored at lower pH with constant SO2 concentration. These discoloration patterns were highly reproducible and similar in all sources of $SO_2$. Spectrophotometric evidence suggested that light-mediated discoloration of leaf disks in the presence of $SO_2$ might occur mainly through chlorophyll ${\alpha}$ degradation.

• Journal of Powder Materials
• /
• v.18 no.3
• /
• pp.244-249
• /
• 2011

Spherical nanosized cobalt powder with an average size of 150-400 nm was successfully prepared at room temperature from cobalt sulfate heptahydrate ($CoSO_4{\cdot}7H_2O$). Wet chemical reduction method was adopted to synthesize nano cobalt powder and hypophosphorous acid ($H_3PO_2$) was used as reduction agent. Both the HCP and the FCC Co phase were developed while $CoSO_4{\cdot}7H_2O$ concentration ranged from 0.7 M to 1.1 M. Secondary phase such as $Co(OH)_2$ and $CO_3O_4$ were also observed. Peaks for the crystalline Co phase having HCP and FCC structure crystallized as increasing the concentration of $H_3PO_2$, indicating that the amount of reduction agent was enough to reduce $Co(OH)_2$. Consequently, a homogeneous Co phase could be developed without second phase when the $H_3PO_2/CoSO_4{\cdot}7H_2O$ ratio exceeded 7.

• Journal of Surface Science and Engineering
• /
• v.32 no.3
• /
• pp.444-446
• /
• 1999

The structure and composition of anodic films, formed on 6063 commercial aluminium alloy at constant current density of $1.5A/^dm2$ with various superimposed cathodic current ratio, in the range 0~33%, in the 11% $H_2SO_4$ with various concentration of $CuSO_4{\cdot}5H_2O$, in the range 0~75 g/l, without cathodic current are generally porous-type and no sign of Cu co-deposition appearance, suggesting that cathodic current is an important factor in the Cu co-deposition. Comparison with the anodic film thickness measurement results obtained from anodic film formed by direct anodic current and anodic film formed by superimposed various portion of cathodic current, the portion of cathodic current of input current increases with decrease of anodic film thickness and increases with increase of concentration of $Cu_2S{\;}and{\;}Cu_2O$ in the anodic film.

• Journal of Korean Society for Atmospheric Environment
• /
• v.29 no.5
• /
• pp.642-655
• /
• 2013

In this study, semi-continuous measurements of $PM_{2.5}$ mass, organic and elemental carbon (OC and EC), black carbon (BC), and ionic species concentrations were made for the period of April 03~13, 2012, at a South Area Supersite at Gwangju. Possible sources causing the high concentrations of major chemical species in $PM_{2.5}$ observed during a haze episode were investigated. The measurement results, along with meteorological parameters, gaseous pollutants data, air mass back trajectory analyses and PSCF (potential source contribution function) results, were used to study the haze episode. Substantial enhancements of OC, EC, BC, $K^+$, $SO{_4}^{2-}$, $NO{_3}{^-}$, $NH{_4}{^+}$, and CO concentrations were closely associated with air masses coming from regions of forest fires in southeastern China, suggesting likely an impact of the forest fires. Also the PSCF maps for EC, OC, $SO{_4}^{2-}$, and $K^+$ demonstrate further that the long-range transport of smoke plumes of forest fires detected over the southeastern China could be a possible source of haze phenomena observed at the site. Another possible source leading to haze formation was likely from photochemistry of precursor gases such as volatile organic compounds, $SO_2$, and $NO_2$, resulting in accumulation of secondary organic aerosol, $SO{_4}^{2-}$ and $NO{_3}{^-}$. Throughout the episode, local wind directions were between 200 and $230^{\circ}C$, where two industrial areas are situated, with moderate wind speeds of 3~5 m/s, resulting in highly elevated concentration of $SO_2$ with a maximum of 15 ppb. The $SO{_4}^{2-}$ peak occurring in the afternoon hours coincided with maximum ambient temperature ($24^{\circ}C$) and ozone concentration (~100 ppb), and were driven by photochemistry of $SO_2$. As a result, the pattern of $SO{_4}^{2-}$ variations in relation to wind direction, $SO_2$ and $O_3$ concentrations, and the strong correlation between $SO_2$ and $SO{_4}^{2-}$ ($R^2=0.76$) suggests that in addition to the impact of smoke plumes from forest fires in the southeastern China, local $SO_2$ emissions were likely an important source of $SO{_4}^{2-}$ leading to haze formation at the site.

• Journal of Korean Society for Atmospheric Environment
• /
• v.14 no.4
• /
• pp.333-342
• /
• 1998

Plasma process has great possibilities to remove SOx, NOx simultaneously with high treatment efficiency and is expected to be suitable for small or middle plants. It was accomplished to evaluate SO2, NOx control possibility and achieve basic data to control pollutants by use of Surface Discharge Induced Plasma Chemical Process (SPCP) in this study. O3 generation characteristics by discharge of a plate was proportional to O2 concentration and power consumption and inversely proportional to temperature and humidity, In case of dry air, NOx was highly generated by N2 and O2 in air during the plasma discharge process but it was decreased considerably as H2O was added. SO2 removal efficiency was very high, and removal rate was 170,350 mEA at 30,50 watt respectively in flue gas which is usually contain HIO. NOx removal efficiency was about 57% at 40 watt power consumption with 7.5% humidity. It is estimated that H2O has an important role in reaction mechanism with pollutants according to plasma discharge.