• Proceedings of the Materials Research Society of Korea Conference
• /
• 2009.05a
• /
• pp.52.1-52.1
• /
• 2009

Cupric oxide (CuO) is a p-type semiconductor with band gap of ~1.7 eV and reported to be suitable for catalysis, lithium-copper oxide electrochemical cells, and gas sensors applications. The nanoparticles, plates and nanowires of CuO were found sensing to NO2, H2S and CO. In this work, we report about the comparison about hydrogen sensing of nano thin film and nanowires structured CuO deposited on single-walled carbon nanotubes (SWNTs). The thin film and nanowires are synthesized by deposition of Cu on different substrate followed by oxidation process. Nano thin films of CuO are deposited on thermally oxidized silicon substrate, whereas nanowires are synthesized by using a porous thin film of SWNTs as substrate. The hydrogen sensing properties of synthesized materials are investigated. The results showed that nanowires cupric oxide deposited on SWNTs showed higher sensitivity to hydrogen than those of nano thin film CuO did.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2009.06a
• /
• pp.462-462
• /
• 2009

$CeO_2$는 고체 산화물 연료전지 (SOFC, soild oxide fuel cell)의 전해질 재료와 CMP(Chemical Mechanical Polishing) 슬러리 재료, 자동차의 3원 촉매, gas sensor, UV absorbent등 여러 분야에서 사용되고 있다. 본 연구에서는 위의 활용범위 외에 $CeO_2$의 구조적 안정성과 빠른 $Ce^{3+}/Ce^{4+}$의 전환 특성을 이용하여 lithium ion battery의 anode 재료로서 전기화학적 특성을 알아보고자 실험을 실시하였다. $CeO_2$ 합성에 사용되는 전구체인 cerium carbonate의 형상 및 크기, 비표면적과 같은 물리화학적 특성이 $CeO_2$ 분말의 특성에 직접적인 영향을 주기 때문에 전구체의 합성 단계에서 입자의 특성을 조절하였다. 전구체 합성의 출발원료로 cerium nitrate hexahydrate 와 ammonium carbonate를 사용하였고 반응온도 및 농도 등을 변화시켜 입자의 형상 및 결정상을 fiber형태의 orthorombic $Ce_2O(CO_3)_2{\cdot}H_2O$와 구형의 hexagonal $CeCO_3OH$의 세리아 전구체를 합성하였다. 이를 $300^{\circ}C$에서 30분 동안 하소하여 전구체의 입자형상을 유지하는 cubic $CeO_2$를 합성하고 X-ray diffraction, FE-SEM, micropore physisorption analyzer 분석을 통하여 입자의 결정상과 형상, 비표면적 등을 비교 분석하고 $Li/CeO_2$ couple의 충,방전 용량과 수명특성을 비교 분석하여 $CeO_2$의 전기화학적 특성을 알아보았다.

• Journal of Powder Materials
• /
• v.27 no.2
• /
• pp.146-153
• /
• 2020

The co-doping effect of aliovalent metal ions such as Mg²⁺, Ca²⁺, Sr²⁺, Ba²⁺, and Zn²⁺ on the photoluminescence of the Y₂O₃:Eu³⁺ red phosphor, prepared by spray pyrolysis, is analyzed. Mg²⁺ metal doping is found to be helpful for enhancing the luminescence of Y₂O₃:Eu³⁺. When comparing the luminescence intensity at the optimum doping level of each Mg²⁺ ion, the emission enhancement shows the order of Zn²⁺ ≈ Ba²⁺ > Ca²⁺ > Sr³⁺ > Mg²⁺. The highest emission occurs when doping approximately 1.3% Zn²⁺, which is approximately 127% of the luminescence intensity of pure Y₂O₃:Eu³⁺. The highest emission was about 127% of the luminescence intensity of pure Y₂O₃:Eu³⁺ when doping about 1.3% Zn²⁺. It is determined that the reason (Y, M)₂O₃:Eu³⁺ has improved luminescence compared to that of Y₂O₃:Eu³⁺ is because the crystallinity of the matrix is improved and the non-luminous defects are reduced, even though local lattice strain is formed by the doping of aliovalent metal. Further improvement of the luminescence is achieved while reducing the particle size by using Li₂CO₃ as a flux with organic additives.

• Nano
• /
• v.13 no.10
• /
• pp.1850119.1-1850119.6
• /
• 2018

$Eu^{3+}/Tb^{3+}$ co-doped nanocomposite containing $CeO_2$ nanocrystals was successfully prepared by an in situ sol-gel polymerization approach. High-resolution transmission electron microscopy demonstrated the homogeneous precipitation of $CeO_2$ nanocrystals among the polymethylmethacrylate (PMMA) matrix. The thermal stability and UV-shielding capability of the obtained nanocomposite were improved with increase of $CeO_2$ content. The tuning of the emissive color from green and yellow to red can be easily achieved by varying the dopant species and concentration. These results suggested that the obtained nanocomposite could be potentially applicable in transparent solid-state luminescent devices.

• Journal of the Korean Electrochemical Society
• /
• v.3 no.2
• /
• pp.100-103
• /
• 2000

Polymeric gel electrolytes based on polyacrylronitile blended with poly(vinylidene fluoride-co-hexafluoro-propylene)(P(VdF-co-HFP), which were reinforced with glass fiber cloth(GFC) to increase the mechanical strength, were prepared for the practical use in secondary battery. Test cell consisting of $LiCoO_2$ as a cathode and mesophase pich-based ca.bon fiber (MCF) as an anode material showed a capacity of 110 mAh/g based on the cathode weight at 0.2C rate at room temperature. Over $80\%$ of initial capacity was retained after 400cycles, indicating that GFC is suitable for a reinforcing material to increase the mechanical strength of gel based electrolytes.

• 한국신재생에너지학회:학술대회논문집
• /
• 2011.11a
• /
• pp.172.1-172.1
• /
• 2011

본 연구에서는 매립지에서 발생하는 주요한 가스인 $CO_2$(47~55%)와 $CH_4$(47~55%)가스를 분리하기 위하여 여러 $CO_2$ capture 방법 중 Zeolite를 사용한 흡착법을 이용하였다. 국내에서 시판되고 있는 powder형 Zeolite 13X에 Inorganic binder와 organic binder를 최적의 비율로 혼합한 후 증류수를 이용하여 Pellet type 흡착제를 제조하였다. 또한 최종적으로 $CO_2$의 흡착능을 높이기 위하여 양이온(1M의 KCl, NaCl, $CaCl_2$, $LiCl_2$)으로 이온교환을 하였다. 매립지 모사가스($CO_2$:40%, $CH_4$:60%)를 이용하여 실시간 분석기(Delta1600S)를 이용 두 가스의 분리와 $CO_2$ 흡착성능(mg-CO2/g-흡착제)을 확인하였다. 개발된 흡착제(AjouEpl 13X)는 ICP, XRD, XRF, BET 분석으로 제올라이트의 구조와 성분을 분석하였다.

• Journal of the Korean Electrochemical Society
• /
• v.26 no.1
• /
• pp.11-18
• /
• 2023

As the use of lithium-ion secondary batteries is rapidly increasing due to the rapid growth of the electric vehicle market, the disposal and recycling of spent batteries after use has been raised as a serious problem. Since stored energy must be removed in order to recycle the spent batteries, an effective discharging process is required. In this study, graphite and NCM622 were used as active materials to manufacture coin-type half cells and full cells, and the electrochemical behavior occurring during overdischarge was analyzed. When the positive and negative electrodes are overdischarged respectively using a half-cell, a conversion reaction in which transition metal oxide is reduced to metal occurs first in the positive electrode, and a side reaction in which Cu, the current collector, is corroded following decomposition of the SEI film occurs in the negative electrode. In addition, a side reaction during overdischarge is difficult to occur because a large polarization at the initial stage is required. When the full cell is overdischarged, the cell reaches 0 V and the overdischarge ends with almost no side reaction due to this large polarization. However, if the full cell whose capacity is degraded due to the cycle is overdischarged, corrosion of the Cu current collector occurs in the negative electrode. Therefore, cycled cell requires an appropriate treatment process because its electrochemical behavior during overdischarge is different from that of a fresh cell.

• Journal of Fisheries and Marine Sciences Education
• /
• v.19 no.1
• /
• pp.1-7
• /
• 2007

The purpose of this study was to investigate geochemical characteristics of surface sediments in the Keum river estuary adjacent to coastal area. For this study we collected the 21 surface sediments samples. Mean size of surface samples was $3.24{\sim}6.65{\phi}$ on inner estuary and was $2.15{\sim}3.42{\phi}$ on outside estuary. Surface samples were composed of silt on inner estuary and were composed of sand which was more larger than $4{\phi}$ on outside estuary. Most major elements except CaO, $Na_2O$ showed good relationships between variation of contents and grain size. Contents of $Al_2O_3$, $Fe_2O_3$, MgO, $K_2O$, $TiO_2$, $P_2O_5$ and $M_nO$ were increased predominately owing to the variation of mean size of surface samples. Contents of Co, Cr, Cu, Li, Sr, Zn, La, Ce, Pb, Rb, Nd have a good relationships with grain size but Ba, Th, Sm have not. All of major and minor elements contents except $K_2O$ and Ba were less than world mean contents of shallow surface sediments but apprehend a high pollution possibility on silt sediments in the estuaries.

• Journal of the Korean Applied Science and Technology
• /
• v.30 no.3
• /
• pp.494-503
• /
• 2013

In this study, $CO_2$ adsorbent was produced for minimizing energy loss due to ventilation within the building. For improved selectivity about low concentration of $CO_2$ in multiple-use facilities, the ball type adsorbent was modified from a commercial zeolite, alumina, alkali metals and activated carbon with mixing LiOH, binder, and $H_2O$. We measured specific surface area, pore characteristic, and crystal structure of the modified adsorbent. Effects of alkalization on the absorptive properties of the adsorbents were investigated. Continuous column tests (2,000 ppm) and batch chamber tests ($4m^3$, 5,000ppm) showed that the modified adsorbent indicated about the selectivity of $CO_2$ more than 9.7% (0.613 mmol/g) compared with ordinary adsorbents and $CO_2$ removal efficiency of 88.8% within l hour, respectively. It was estimated that the modified adsorbent was applicable to indoor environments.

• The Journal of Engineering Geology
• /
• v.10 no.1
• /
• pp.51-62
• /
• 2000

The $CO_2$-richrich water pumps or springs out at two sites (Sinchon and Kohran) consisting of Cretaceous sedimentary rocks in Kyungpook area. The water has been long known as its soda pop-liketaste and therapeutic effect against calcium deficit, stomach and skin troubles, etc. The water arecharacterized by a high $CO_2$ concentration $(P_{CO2}=0.29~l.01 atm)$ and electrical conductance (1,093~2,810$\mu$S/cm). The $CO_2$-rich water belongs to Ca(Na)-$HCO_3$ type in chemical classification. The contents of Ca, Mg, Na, HCO$_3$ and Fe of $CO_2$-rich water show much higher values than those of general groundwater Environmental isotopic data $(^2H/^1H, ^{18}O/^{16}O and ^3H/^1H)$ indicate that the water is ofmeteoric origin recharged after 1950s. The $CO_2$ in the springs seems to be originated from deep-seatedsource related to acidic porphyry and granite nearby sedimentary rocks. Carbonate minerals and albiteare likely to be the major source minerals of the dissoved inorganic constituents in the $CO_2$-rich water.The equilibrium state between major minerals and $CO_2$-rich water was calculated by a thermodynamicprogram.