• Transactions of the Korean hydrogen and new energy society
• /
• v.27 no.2
• /
• pp.169-175
• /
• 2016

The electrolyte added the chlorosulfuric acid ($HSO_3Cl$) as an additive was tested for the electrolyte in all-vanadium redox flow battery (VRFB) to increase the thermal stability of electrolyte. The electrolyte property was measured by the CV (cyclic voltammetry) method. The maximum value of a voltage and current density in the electrolyte added $HSO_3Cl$ was higher than that in the electrolyte non-added $HSO_3Cl$. The thermal stability of the pentavalent vanadium ion solution, which was tested at $40^{\circ}C$, increased by adding $HSO_3Cl$. The performances of VRFB using the electrolyte added and non-added $HSO_3Cl$ were measured during 30 cycles of charge-discharge at the current density of $60mA/cm^2$. An average energy efficiency of the VRFB was 72.5%, 82.4%, and 81.6% for the electrolyte non-added $HSO_3Cl$, added 0.5 mol of $HSO_3Cl$, and added 1.0 mol of $HSO_3Cl$, respectively. VRFB using the electrolyte added $HSO_3Cl$ was showed the higher performance than that using the electrolyte non-added $HSO_3Cl$.

• Journal of the Korean Chemical Society
• /
• v.55 no.4
• /
• pp.685-690
• /
• 2011

Novel acidic ionic liquids, 1-(${\omega}$-sulfonicacid)propyl-3-methylimidazolium bromide ([$HSO_3$pmim]Br)and 1-(${\omega}$-sulfonicacid)butyl-3-methylimidazolium bromide ([$HSO_3$bmim]Br), were prepared and used as brominating agents, catalysts and solvents in the synthesis of 1,7-dibromoheptane, respectively. 1,7-dibromoheptan with a yield of 95% was obtained at $100^{\circ}C$ for 2 h by simple phase separation. The acidic ionic liquid [$HSO_3$pmim]Br was recycled for 5 times and the yield of 1,7-dibromoheptane did not decrease remarkably, which indicates that catalysts still maintain good selectivity and activity after recycling. The structure of the acidic ionic liquid [$HSO_3$pmim]Br was characterized with IR, and it was found that [$HSO_3$pmim]Br had stronger acidity than other ionic liquid.

• Journal of the Korean Chemical Society
• /
• v.52 no.1
• /
• pp.47-51
• /
• 2008

A simple synthetic strategy is described for one-pot synthesis of 5,7-diaryl-4,4-dimethyl-4,5,6,7-tetrahydropyridino[3,4-d]-1,2,3-selenadiazoles (11-15) in the presence of NaHSO4.SiO2 as a heterogeneous catalyst in dry media under microwave irradiation.Key words: One-pot synthesis, 3,3-Dimethyl-2,6-diarylpiperidin-4-one; 1,2,3-Selenadiazoles; Selenium dioxide; NaHSO4.SiO2 Heterogeneous catalyst.

• Journal of Sericultural and Entomological Science
• /
• v.39 no.2
• /
• pp.197-202
• /
• 1997

To hydrolyze silk fibroin was treated with NaOH solution on various concentrations and times. And it was examined that the addition effects of NaHSO3 solution on the solubility and colouring of silk fibroin. As obtained results are as follows; The more increasement of concentration and time of NaOH treatment, the more increasement of solubility but solubility was slight above 3% concentration of NaOH. Fibroin yield was decreased above 3% concentration. This was due to formation of peptide or amino acids below molecular weight 3,000. Most of molecular weight distribution came out to be under 3,000 in 2% concentration and 4hrs of NaOH treatment. The more increasement of adding concentration and 4hrs of NaOH treatment. The more increasement of adding concentration of NaHSO3, the more reduction of solubility but white index of powder increased. In the results of FT-IR spectras of silk fibroin powder obtained by various concentrations of NaHSO3 treatment, the absorbent peak at 3,400 cm-1 which was considered as -CH=N- (azomethine) was disappeared by the more addition of NaHSO3. It showed that absorbent peak of $\beta$-fibroin moved into low temperature region and transferred to $\alpha$- and random coil structure through the DSC experiment. In the results of amino acid analysis, alkali hydrolysis reduced the oxy amino contents acid like serine and tyrosine, but increased the glycine content by the more addition of NaHSO3.

• Polymer(Korea)
• /
• v.28 no.2
• /
• pp.149-153
• /
• 2004

The cesium hydrogen sulfate (CsHSO$_4$) crystal is a superprotonic conductor above 140$^{\circ}C$ and possesses protonic conductivity three to low orders of magnitude higher than that at room temperature. Recently, the possibility of it as an electrolyte material for fuel cell system draws much attention. However, its plasticity and absorption of humidity place a limitation on its application. In this study, composites consisting of CsHSO$_4$ and polyacrylonitrile were prepared, and their phase transition properties and the ionic conductivities were evaluated. When the content of CsHSO$_4$ was about 80 vol%, a mechanically strong film with the protonic conductivity of 1${\times}$10$\^$-3/ Scm$\^$-1/ were made.

• Journal of Electrochemical Science and Technology
• /
• v.11 no.4
• /
• pp.368-378
• /
• 2020

In the paper, corrosion behavior of T91 steel in different concentrations of NaHSO₃ solution was studied in combination with scanning electron microscope (SEM) and electrochemical measurements. The results showed that the steel exhibited active anodic dissolution characteristics in the solution, and NaHSO₃ concentration affected both cathodic and anodic behaviors. The steel surface was covered by intact corrosion products in the solutions, but the compactness and mechanical properties of the corrosion products degraded with the increase of NaHSO₃ concentration. In low-concentration NaHSO₃ solution the steel tended to undergo uniform corrosion with slight corrosion pits, but its corrosion mode gradually transited to localized corrosion as the NaHSO₃ concentration increased. The mechanical property degradation of the corrosion products caused by sulfur compounds and the pH decrease of the solution are the important factors to accelerating its corrosion process.

• Journal of the Korean Chemical Society
• /
• v.54 no.4
• /
• pp.437-442
• /
• 2010

Sodium hydrogen sulphate ($NaHSO_4$), n-tetra butyl ammonium bromide (TBAB) as a phase transfer catalyst (PTC) in water, and 1-butyl-3-methyl imidazolium hydrogen sulphate [bmim]$HSO_4$ as ionic liquid (IL) has been used as a mild reaction promoter for the cyclocondensation of formalin, ${\beta}$-naphthol and aromatic amines to afford respective 2,3-dihydro-2-phenyl-1H-naphtho-[1,2-e] [1,3] oxazine derivatives. The present protocols are greener, high yielding and involved the nonchromatographic isolation procedure.

• Korean Chemical Engineering Research
• /
• v.48 no.5
• /
• pp.583-588
• /
• 2010

Esterification of free fatty acid with methanol to biodiesel was investigated in a batch reactor using various solid acid catalysts, such as polymer cation-exchanged resins with sulfuric acid functional group(Amberlyst-15, Dowex 50Wx8), acidic ionic liquids (ILs)-modified silica gels respectively with $-SO_3H$ and $-SO_2Cl$ functional group ($SiO_2-[ASBI][HSO_4]$, $SiO_2-[ASCBI][HSO_4]$) and grafted silica gels respectively with $-SO_3H$ and $-SO_2Cl$ functional group ($SiO_2-R-SO_3H$, $SiO_2-R-SO_2Cl$). The effects of reaction time, temperature, reactant concentration(molar ratio of methanol to oleic acid), and catalyst amount were studied. Allylimidazolium-based ILs on modified silica gels were superior to other tested solid acid catalysts. Especially, the performance of $SiO_2-[ASBI][HSO_4]$ (immobilized by grafting of 3-allyl-1-(4-sulfobutyl)imidazolium hydrogen sulfate on silica gel) was better than that of a widely known Amberlyst-15 catalyst at the same reaction conditions. A high conversion yield of 96% was achieved in the esterification reaction of the simulated cooking oil at 353 K for 2 h. The high catalytic activity of $SiO_2-[ASBI][HSO_4]$ was attributed to the presence of strong Brønsted acid sites from the immobilized functional groups. The catalyst was recovered and the biodiesel product was separated by simple processes such as decantation and filtration.

• Bulletin of the Korean Chemical Society
• /
• v.25 no.7
• /
• pp.1075-1077
• /
• 2004

• Bulletin of the Korean Chemical Society
• /
• v.24 no.11
• /
• pp.1683-1685
• /
• 2003