• Journal of Nuclear Fuel Cycle and Waste Technology(JNFCWT)
• /
• v.7 no.1
• /
• pp.17-23
• /
• 2009

Dihexyloctanamide(DHOA) was used as an extractant or phase modifier with the diamide extractants in a solvent extraction process for a radioactive liquid waste treatment. The degradation compounds of the DHOA extractant, irradiated with $^{60}Co$ gamma ray, were octanoic acid and dihexylamine which are identified by a Fourier transform infrared(FT-IR) and gas chromatograph/mass spectrometer(GC/MS) analysis, and determined by the GC/MS with selected ion monitoring(SIM) mode. Retention behavior of octanoic acid, tridecane (internal standard) and dihexylamine in total ion chromatogram (TIC) were 8.65 min., 9.79 min., and 10.27 min., respectively. With increasing the absorbed dose of the $\gamma$-ray irradiated DHOA, the concentration of octanoic acid was decreased and that of dihexylamine was increased.

• Journal of the Korean institute of surface engineering
• /
• v.11 no.1
• /
• pp.5-13
• /
• 1978

This experiment intends to study Zn-coating weight through galvanixing process. A through examination has been carried out on the change of steel-composition, galvanizing-temperature, dipping-rime, Fe-loss when other factors were regular. Activation energy needed for Fe-loss was obtained and within this sample, the best condition which has influence on coating weight was found so as to reduce Fe-loss. As Fe-loss was diminidhed, the amount of product of Dross and Zn-using amount per total products could be reduced. The results of experiments are as follow. 1. Zn-coating thickness was increased by the rising Zn-bathtemperature and was the maximum at 8-minutes dipping time. 2. The coating weight was greatly influency by Si. As in other samples, the proportion of increasing was very rate after 20minutes. If the dipping time prolonged, the increasing amounts of Fe-loss are more greatly. 3. Activation Energy needed for Fe-loss was as follows Such numerical values were most equal to those of the activation energy which had influences on the growth of ${\gamma}$-phase. Sample - I = 18,500 Cal/mole Sample - III = 22,000 Cal/mole Sample - V = 42,300 Cal/mole

• Proceedings of the KIEE Conference
• /
• 1996.07c
• /
• pp.1682-1684
• /
• 1996

Recently, because diffusion of cordless machine and smart card and so on, and concern of unpolluted materials, one are concerned with Li secondary batteries. Li secondary batteries have high voltage, high energy density and high power density, and heavy metal pollution problems are little. Mn is low price and is distributed much quantity. Therefore, we investigated $MnO_2$. In this study, we worked the electrochemical properties and charge/discharge characteristics of $MnO_2/Li$ cells. In results, the more heating temperature is high, the more ${\gamma}-phase$ varied ${\beta}-phase$, and when $MnO_2$ is heated at $320^{\circ}C$ and super-s-black 20wt% is mixed, characteristics are the best.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.16 no.5
• /
• pp.179-189
• /
• 2008

The performance of Lean NOx Trap (LNT) based on the catalysts of Pt/K/Ba/$\gamma-Al_2O_3$ with proprietary washcoat formulation is studied using a bench flow reactor system. To investigate the effect of temperature and gas hourly space velocity (GHSV) on the nitrogen oxides (NOx) trapping capacity as well as NOx breakthrough time and final ratio of $NO_2$ to NO of LNT, series of adsorption isotherms are carried out with simulated exhaust gases of the lean burn engines. Since typical operation of LNT requires periodic regeneration with a short rich excursion, where the stored or trapped NOx is released and subsequently reduced to $N_2$, the effect of the duration of lean and rich phase and type of reductants on the NOx conversion is investigated. NOx storage capacity and breakthrough time obtained from adsorption isotherms shows a volcano-type dependence on the temperature with a maximum NOx storage capacity occurring $350^{\circ}C$ and with a maximum breakthrough time occurring $400^{\circ}C$ at all GHSVs investigated in this study. Also, maximum ratio of $NO_2$ to NO is obtained at $400^{\circ}C$ with a GHSV of $75,000\;hr^{-1}$ Lean/rich cycle of 100 s lean and 5 s rich used with a concentration of 1.33% of $H_2$ and 4% of CO in the rich phase is found to be optimum at operating temperature of $350^{\circ}C$ and a GHSV of $50,000\;hr^{-1}$.

• The Journal of Korean Academy of Prosthodontics
• /
• v.23 no.1
• /
• pp.83-95
• /
• 1985

The purpose of this study was to evaluate microstructures on the etched surface of 11 base metal alloys for dental restorations and to observe the relationship between the etching pattern and beryllium. For this purpose, the following experiments were done; 11 base metal alloys were etched in (1) 10% $H_2SO_4$, (2) 10% $H_2SO_4$, 9 parts+methanol 1 part (3) Conc. $HNO_3$ 25%+glacial acetic acid 25%+$H_2O$ 50% (4) Conc. $HNO_3$ 5% (5) 2% glacial acetic acid added to Conc. $HNO_3$ 1% solution, with their etching conditions varied. Etched surface of alloys were examined under the scanning electron microscope. Results were as follows; 1. Almost all of Ni-Cr-Be alloys showed gooed etchd surface in $H_2SO_4$, solution, while some of those alloys which contains no beryllium showed good etched surface in $HNO_3$ solution. 2. Main components of etching solution can vary etching pattern of alloys. 3. Gamma prime phase relief, which can be found in all Ni-Cr-Be alloys, can't be found in any alloy that contains no beryllium.

• Korean Journal of Materials Research
• /
• v.14 no.4
• /
• pp.265-269
• /
• 2004

Plasma nitrocarburising and post oxidation were performed on SCM435 steel by a pulsed plasma ion nitriding system. Plasma oxidation resulted in the formation of a very thin ferritic oxide layer 1-2 $\mu\textrm{m}$ thick on top of a 15～25 $\mu\textrm{m}$ $\varepsilon$-F $e_{2-3}$(N,C) nitrocarburized compound layer. The growth rate of oxide layer increased with the treatment temperature and time. However, the oxide layer was easily spalled from the compound layer either for both oxidation temperatures above $450^{\circ}C$, or for oxidation time more than 2 hrs at oxidation temperature $400^{\circ}C$. It was confirmed that the relative amount of $Fe_2$$O_3$, compared with $e_3$$O_4$, increased rapidly with the oxidation temperature. The amounts of ${\gamma}$'-$Fe_4$(N,C) and $\theta$-$Fe_3$C, generated from dissociation from $\varepsilon$-$Fe_{2-3}$ /(N,C) phase during $O_2$ plasma sputtering, were also increased with the oxidation temperature.e.

• Journal of Powder Materials
• /
• v.11 no.2
• /
• pp.118-123
• /
• 2004

A formation of aluminum hydroxide by hydrolysis reaction in the water has been studied by using nano aluminum powder fabricated by pulsed wire evaporation(PWE) method. The hydroxide type and morphology depending on temperature and pH were examined by structural analysis. The Boehmite($Al_2O_3$.$H_2O$ or AIO(OH)) was predominantly formed in high temperature region over 4$0^{\circ}C$, while the Bayerite($Al_2O_3$.$H_2O$ or $Al(OH)_3$) below $30^{\circ}C$ of hydrolysis temperature. The Boehmite formation was preferred to the Bayerite in acidic solution in the same hydrolysis temperature. The slowly formed Bayerite phase showed facet crystalline structure, while the fast formed Boehmite was fine fiber with a large aspect ratio of several nm in diameter and several hundred nm in length, and with much larger specific surface area(SSA) than that of Bayerite. The highest SSA was about $420m^2$/g.

• Conservation Science in Museum
• /
• v.24
• /
• pp.17-36
• /
• 2020

This paper describes the consevation treatment of eleven bigyeokjincheolloe bomb shells that were excavated from the Joseon-period local government office and fortress of Mujang-hyeon (present-day Mujang-myeon) in Gochang in 2018. It also provides information on the production method of the shells revealed through CT scanning, gamma-ray transmission imaging, and metallographic analysis. In preparation for the special exhibition "Bigyeokjincheolloe" at the Jinju National Museum in 2019 (July 16 to August 25), contaminants were removed from the shells and their surface was reinforced during the first phase of conservation treatment. Furthermore, the closures for the shells were identified for the first time. Regarding the production of the shells, the CT scanning and gamma-ray transmission imaging identified many blowholes in the interior of the body and the use of a chaplet on the side of one shell. The side of the body proved to be relatively thinner than the top and bottom. The traces of a hole for pouring molten metal into the center of the bottom indicates that molten metal was indeed emptied into the inverted body. In the metallographic analysis of two of the bodies and one lid, cementite and pearlite structures were identified on the body, indicating that it was made by casting. The presence of the ferrite structure with a partial distribution of the pearlite along with non-metallic inclusion in the lid suggested that the lid was made by forging.

• Asian Pacific Journal of Cancer Prevention
• /
• v.13 no.4
• /
• pp.1289-1295
• /
• 2012

The use of herbal products as radiosensitizers is a promising approach to increase the efficacy of radiotherapy. However, adverse effects related to the use of herbal medicine on radiotherapy are not well characterized. The present study concerns the impact of Derris scandens Benth extract on the radiosensitivity of Hep-2 laryngeal cancer cells. Pretreatment with D. scandens extract prior to gamma irradiation significantly increased clonogenic survival and decreased the proportion of radiation-induced abnormal nuclei of Hep-2 cells. Furthermore, the extract was found to enhance radiation-induced G2/M phase arrest, induce Akt activation, and increase motility of Hep-2 cells. The study thus indicated that D. scandens extract potentiates radioresistance of Hep-2 cells, further demonstrating the importance of cellular background for the adverse effect of D. scandens extract on radiation response in a laryngeal cancer cell line.

• Preventive Nutrition and Food Science
• /
• v.11 no.2
• /
• pp.100-104
• /
• 2006

The in vitro antimicrobial and antioxidant activities of the essential oil and methanol extracts of Ledum palustre L. were investigated. Using GC-MS analysis, we identified 37 compounds in the essential oil, constituting 87.58% of the total oil. There are several monoterpenes, of which sabinene is the major compound ($16{\sim}17%$). There are several oxygenated monoterpenes of which terpinen-4-ol(7.6%) and myrtenal (3.5%) are the main constituents. $\beta$-Selinene, a-selinene, $\gamma$-elemene, a-caryophyllene are the main sesquiterpenes ($2{\sim}6%$ range). The oil strongly reduced the diphenylpicrylhydrazyl radical ($IC_{50}=1.56{\mu}g/mL$) formation and exhibited a hydroxyl radical scavenging effect in the $Fe^{3+}-EDTA-H_2O_2$ deoxyribose system ($IC_{50}=2.7{\mu}g/mL$), and also inhibited the nonenzymatic lipid peroxidation of rat liver homogenate ($IC_{50}=13.5{\mu}g/mL$). The polar phase of the extract showed antioxidant activity. The oil showed antimicrobial activity against Streptococcus pneumoniae, Clostridium perfringens, Candida albicans, Mycobacterium smegmatis, Acinetobacter lwoffii and Candida krusei while the water-insoluble parts of the methanolic extracts exhibited slight or no activity. This study confirms that the essential oil of Ledum palustre L. possesses antioxidant and low antimicrobial properties in vitro.