Browse > Article
http://dx.doi.org/10.12989/eas.2022.22.5.475

Enhancement of in-plane load-bearing capacity of masonry walls by using interlocking units  

Kayaalp, Fatma Birinci (Department of Civil Engineering, Karadeniz Technical University)
Husem, Metin (Department of Civil Engineering, Karadeniz Technical University)
Publication Information
Earthquakes and Structures / v.22, no.5, 2022 , pp. 475-485 More about this Journal
Abstract
This paper presents a comparative experimental study on structural behavior of the interlocking masonry walls under in-plane cyclic loading. The main purpose of this study is to increase lateral load-bearing capacities of masonry walls by using interlocking units. The interlocking units were designed by considering failure modes of masonry walls and produced using lightweight foamed concrete. To this end, three masonry walls which are hollow, fully grouted, and reinforced were constructed with interlocking units. Also, a traditional masonry brick wall was built for comparison reasons. The walls were tested under in-plane cyclic loading. Then, structural parameters of the walls such as lateral load bearing and total energy dissipation capacities, ductility, stiffness degradation as well as failure modes obtained from the tests were compared with each other. The results have shown that the walls with the interlocking units have better structural performance than traditional masonry brick walls and they may be used in the construction of low-rise masonry structures in rural areas to improve in-plane structural performance.
Keywords
in-plane behavior; interlocking masonry; mortared joints; masonry structures; structural parameters;
Citations & Related Records
Times Cited By KSCI : 3  (Citation Analysis)
연도 인용수 순위
1 Turkish Statistical Institute (2000), "Building Census 2000", Publication No. 2471, State Institute of Statistics, Ankara, Turkey.
2 TS 2510 (1977), Design and Construction Method of Masonry Buildings, Turkish Standards Institute; Ankara, Turkey.
3 Ural, A. (2013). "19th May 2011 Simav (Kutahya) earthquake and response of Masonry Halil Aga Mosque", Earthq. Struct., 4(6), 671-83. https://doi.org/10.12989/eas.2013.4.6.671.   DOI
4 Farghaly, A.A. and Rahim, H.H.A.A. (2013), "Contribution of non-structural brick walls distributions on structures seismic responses", Earthq. Struct., 5(5), 553-570. https://doi.org/10.12989/EAS.2013.5.5.553.   DOI
5 Husem, M., and Birinci Kayaalp, F. (2019), "Design of interlocking masonry units and mechanical properties of masonry assemblages", Comput. Concrete, 23(2), 97-106. https://doi.org/10.12989/cac.2019.23.2.097.   DOI
6 Celep, Z., Erken, A., Taskin, B. and Ilki, A. (2011), "Failures of masonry and concrete buildings during the March 8, 2010 Kovancilar and Palu (Elazig) earthquakes in Turkey", Eng. Failure Analysis, 18(3), 868-889. https://doi.org/10.1016/j.engfailanal.2010.11.001.   DOI
7 Qu, B., Stirling, B.J., Jansen, D.C., Bland, D.W. and Laursen, P.T. (2015), "Testing of flexure-dominated interlocking compressed earth block walls", Construct. Build. Mater., 83, 34-43. https://doi.org/10.1016/j.conbuildmat.2015.02.080.   DOI
8 Ramamurthy, K. and Nambiar, E.K. (2004). "Accelerated masonry construction review and future prospects", Progress Struct. Eng. Mater., 6(1), 1-9. https://doi.org/10.1002/pse.162.   DOI
9 Oyguc, R. and Oyguc, E. (2017), "2011 Van earthquakes: lessons from damaged masonry structures", J. Performance Construct. Facilities, 31(5), 04017062. https://doi.org/10.1061/(ASCE)CF.1943-5509.0001057.   DOI
10 Porto, F., Garbin, E., Modena, C. and Valluzzi, M.R. (2005), "Failure modes for in plane loaded masonry walls made with thin layer mortar", 10th Canadian Masonry Symposium, Banff, Alberta, June.
11 Safiee, N.A., Nasir, N.A.M., Ashour, A.F. and Abu Bakar, N. (2018), "Behaviour of interlocking mortarless hollow block walls under in-plane loading", Australian J. Struct. Eng., 19(2), 87-95. https://doi.org/10.1080/13287982.2018.1433489.   DOI
12 Sanada, Y., Nakamura, Y., Yamauchi, N. and Nakano, Y. (2006), "Seismic performance of masonry walls using interlocking units", First European Conference on Earthquake Engineering and Seismology, Geneva, September.
13 Sokairge, H., Rashad, A. and Elshafie, H. (2017), "Behavior of post-tensioned dry-stack interlocking masonry walls under out of plane loading", Construct. Build. Mater., 133, 348-357. https://doi.org/10.1016/j.conbuildmat.2016.12.071.   DOI
14 Ayed, H.B., Limam, O., Aidi, M. and Jelidi, A. (2016), "Experimental and numerical study of interlocking stabilized earth blocks mechanical behavior", J. Build. Eng., 7, 207-216. https://doi.org/10.1016/j.jobe.2016.06.012.   DOI
15 Narayanan, S.S., and Ramamurthy, K. (2013), "Development of foam concrete solid interlocking blocks and studies on short masonry specimen", Masonry Intl. J. Masonry Soc., 26(1), 7-16.
16 Majid, A., Ronald J.G. and Chouw, N. (2012), "Capacity of innovative interlocking blocks under monotonic loading", Construct. Build. Mater., 37, 812-821. https://doi.org/10.1016/j.conbuildmat.2012.08.002.   DOI
17 Miranda, T., Silva, R.A., Oliveira, D.V., Leitao, D., Cristelo, N., Oliveira, J. and Soares, E. (2017), "ICEBs stabilised with alkaliactivated fly ash as a renewed approach for green building: exploitation of the masonry mechanical performance", Construct. Build. Mater., 155, 65-78. https://doi.org/10.1016/j.conbuildmat.2017.08.045.   DOI
18 Nazar, M.E., and Sinha, S.N. (2007), "Loading-unloading curves of interlocking grouted stabilised sand-flyash brick masonry", Mater. Struct., 40(7), 667-678. https://doi.org/10.1617/s11527-006-9177-x.   DOI
19 Sturm, T., Ramos, F.F. and Lourenco, P.B. (2015), "Characterization of dry-stack interlocking compressed earth blocks", Mater. Struct., 48(9), 3059-3074. https://doi.org/10.1617/s11527-014-0379-3.   DOI
20 Fay, L., Cooper, P. and Fay de Morais, H. (2014), "Innovative interlocked soil-cement block for the construction of masonry to eliminate the settling mortar", Construct. Build. Mater., 52, 391-95. https://doi.org/10.1016/j.conbuildmat.2013.11.030.   DOI
21 FEMA 306 (1998), Evaluation of Earthquake Damaged Concrete and Masonry Wall Building, Federal Emergency Management Agency; Washington, USA.
22 Isik, E., Aydin, M.C., and Buyuksarac, A. (2020), "24 January 2020 Sivrice (Elazig) earthquake damages and determination of earthquake parameters in the region", Earthq. Struct., 19(2), 145-156. https://doi.org/10.12989/EAS.2020.19.2.145.   DOI
23 Jaafar, M.S., Alwathaf, A.H., Thanoon, W.A., Noorzaei, J. and Abdulkadir, M.R. (2006), "Behaviour of interlocking mortarless block masonry", Proc. Institution Civil Eng. Construct. Mater., 159(3), 111-117. https://doi.org/10.1680/coma.2006.159.3.111.   DOI
24 Laursen, P.T., Herskedal, N.A., Jansen, D.C. and Qu, B. (2015) "Out-of-plane structural response of interlocking compressed earth block walls", Mater. Struct., 48(1-2), 321-336. https://doi.org/10.1617/s11527-013-0186-2.   DOI
25 Lee, Y.H., Shek, P.N. and Mohammad, S. (2017), "Structural performance of reinforced interlocking blocks column", Construct. Build. Mater., 142, 469-481. https://doi.org/10.1016/j.conbuildmat.2017.03.110   DOI
26 Yurdakul, O., Duran, B., Tunaboyu, O. and Avsar, O. (2021). "Field reconnaissance on seismic performance of RC buildings after the January 24, 2020 Elazig-Sivrice earthquake", Natural Hazards, 105, 859-887. https://doi.org/10.1007/s11069-020-04340-x.   DOI
27 Anand, K.B., and Ramamurthy K. (2000), "Development and performance evaluation of interlocking-block masonry", J. Architectural Eng., 6(2), 45-51. https://doi.org/10.1061/(ASCE)1076-0431(2000)6:2(45).   DOI
28 Arslan, M.E., Emiroglu, M. and Yalama, A. (2017), "Structural behavior of rammed earth walls under lateral cyclic loading: a comparative experimental study", Construct. Build. Mater., 133, 433-442. https://doi.org/10.1016/j.conbuildmat.2016.12.093.   DOI
29 Thanoon, W.A., Alwathaf, A.H., Noorzaei, J., Jaafar, M.S. and Abdulkadir, M.R. (2008). "Nonlinear finite element analysis of grouted and ungrouted hollow interlocking mortarless block masonry system", Eng. Struct., 30(6), 1560-1572. https://doi.org/10.1016/j.engstruct.2007.10.014.   DOI
30 ASTM C140 / C140M - 17a (2017), Standard Test Methods for Sampling and Testing Concrete Masonry Units and Related Units, American Society for Testing Materials; USA.
31 Thanoon, W.A., Jaafar, M.S., Kadir, M.R.A., Ali, A.A.A., Trikha, D.N. and Najm, A.M.S. (2004), "Development of an innovative interlocking load bearing hollow block system in Malaysia", Construct. Build. Mater., 18(6), 445-454.   DOI
32 Tomasevic, M. (2000), "Shaking table tests of small-scale models of masonry buildings: advantages and disadvantages", Massivbau 2000, 67-83.
33 Tomazevic, M. (1999), Earthquake-Resistant Design of Masonry Buildings, Imperial College Press, London, United Kingdom.
34 Liu, H., Liu, P., Lin, K. and Zhao, S. (2016), "Cyclic behavior of mortarless brick joints with different interlocking shapes", Materials, 9(3), 166. https://doi.org/10.3390/ma9030166.   DOI
35 FEMA 461 (2007), Interim Protocols for Determining Seismic Performance Characteristics of Structural and Nonstructural Components Through Laboratory Testing, Federal Emergency Management Agency; Washington, USA. https://doi.org/10.1016/j.conbuildmat.2004.03.013.
36 Khan, H.A., Nanda, R.P. and Das, D. (2017), "In-plane strength of masonry panel strengthened with geosynthetic", Construct. Build. Mater., 156, 351-361. ttps://doi.org/10.1016/j.conbuildmat.2017.08.169.   DOI