Browse > Article

Effects of Aspect Ratio on Local Heat/Mass Transfer in Wavy Duct  

Jang In Hyuk (Department of Mechanical Engineering, Yonei University)
Hwang Sang Dong (Department of Mechanical Engineering, Yonei University)
Cho Hyung Hee (Department of Mechanical Engineering, Yonei University)
Publication Information
Korean Journal of Air-Conditioning and Refrigeration Engineering / v.17, no.6, 2005 , pp. 569-580 More about this Journal
Abstract
The present study investigates the convective heat/mass transfer characteristics in wavy ducts of a primary surface heat exchanger. The effects of duct aspect ratio and flow velocity on the heat/mass transfer are investigated. Local heat/mass transfer coefficients on the corrugated duct sidewall are determined using a naphthalene sublimation technique. The aspect ratios of the wavy duct are 7.3, 4.7 and 1.8 with the corrugation angle of $145\Omega$. The Reynolds numbers, based on the duct hydraulic diameter, vary from 300 to 3,000. The results show that at the low Re(Re $\leq$ 1000) the secondary vortices called Taylor-Gortler vortices perpendicular to the main flow direction are generated due to effect of duct curvature. By these secondary vortices, non-uniform heat/mass transfer coefficients distributions appear. As the aspect ratio decreases, the number of cells formed by secondary vortices are reduced and secondary vortices and comer vortices mix due to decreased aspect ratio at Re$\leq$1000. At Re >1000, the effects of corner vortices become stronger. The average Sh for the aspect ratio of 7.3 and 4.7 are almost same. But at the small aspect ratio of 1.8, the average Sh decreases due to decreased aspect ratio. More pumping power (pressure loss) is required for the larger aspect ratio due to the higher flow instability.
Keywords
Wavy duct; Aspect ratio; Taylor-Gortler vortex; Primary surface heat exchanger; Naphthalene sublimation technique;
Citations & Related Records
Times Cited By KSCI : 1  (Citation Analysis)
연도 인용수 순위
1 McDonald, C. F. and Wilson, D. G., 1996, The utilization of recuperated and regenerated engine cycles for high-efficiency gas turbines in the 21st century, Applied Thermal Eng., Vol. 16, No. 8, pp. 635-653   DOI   ScienceOn
2 Nishimura, T., Yano, K., Yoshino, T. and Kawamura, Y., 1990, Occurrence and structure of Taylor-Gortler vortices induced in two-dimensional wavy channels for steady flow, J. Chemical Engineering of Japan, Vol. 23, No. 6, pp. 697-703   DOI   ScienceOn
3 Jang, I. H., Hwang, S. D. and Cho, H. H., 2004, Effects of corrugation angle on flow and heat/mass characteristics in wavy duct of heat exchanger, Trans. of KSME (B), Vol. 28, No. 7, pp. 789-799   DOI
4 Rokni, M. and Sunden, B., 1998, 3D Numerical investigation of turbulent forced convection in wavy ducts with trapezoidal crosssection, Int. J. Numerical Methods for Heat & Fluid Flow, Vol. 8, pp. 118-141   DOI   ScienceOn
5 Goldstein, L., Jr. and Sparrow, E. M., 1977, Heat/Mass transfer characteristics for flow in a corrugated wall channel, J. Heat Transfer, Vol. 99, pp. 187-195   DOI
6 Utriainen, E. and Sunden, B., 2000, Numerical analysis of a primary surface trapezoidal cross wavy duct, Int. J. Numerical Methods for Heat & Fluid Flow, Vol. 6, pp. 634-648
7 Jang, I. H., Hwang, S. D. and Cho, H. H., 2003, Effects of Reynolds number on flow and heat/mass characteristics inside the wavy duct, Korean Journal of Air-Conditioning and Refrigeration Engineering, Vol. 15, No. 6, pp. 809-820
8 Cho, H. H. and Rhee, D. H., 2001, Local heat/mass transfer measurement on the effusion plate in impingement/effusion cooling system, J. Turbomachinery, Vol. 123, pp. 601-608   DOI   ScienceOn
9 Ambrose, D., Lawrenson, I. J. and Sparke, C. H. S., 1975, The vapor pressure of naphthalene, J. Chem. Thermodynamics, Vol. 7, pp. 1173-1176   DOI
10 Goldstein, R.J. and Cho, H. H., 1995, A review of mass transfer measurements using naphthalene sublimation, Experimental Thermal and Fluid Science, Vol. 10, pp. 416-434   DOI   ScienceOn
11 McDonald, C. F., 1990, Gas turbine recu-peraor renaissance, Heat Recovery Systems & CHP, Vol. 10, No. 1, pp. 1-30   DOI   ScienceOn
12 Bhatti, M. S. and Shah, R. K., 1987, Turbulent and transient flow convective heat transfer in ducts, Handbook of Single-Phase Convective Heat Transfer, eds., Kakac, S., Shah, R. K. and Aung, W., Wiley-Interscience, New York
13 Rokni, M. and Gatski, T. B., 2001, Predicting turbulent convective heat transfer in fully developed duct flows, Int. J. Heat & Fluid Flow, Vol. 22, pp. 381-392   DOI   ScienceOn
14 Sawyers, D. R., Sen, M. and Chang, H. C., 1998, Heat transfer enhancement in threedimensional corrugated channel flow, Int. J. Heat and Mass Transfer, Vol. 41, pp. 3359-3573
15 Kline, S.J. and McClintock, F., 1953, Describing uncertainty in single sample experiments, Mech. Engineering, Vol. 75, pp. 3-8
16 Asako, Y. and Faghri, M., 1987, Finitevolume solutions for laminar flow and heat transfer in a corrugated duct, J. Heat Transfer, Vol. 109, pp. 627-634   DOI
17 Eckert, E. R. G., 1976, Analogies to heat transfer processes, in Measurements in Heat Transfer, ed. Eckert, E. R. G. and Goldstein, R.J., Hemisphere Pub., New York, pp. 397-423
18 Dittus, P. W. and Boelter, M. K., 1985. Heat transfer in automobile radiators of the tubular type, Int. J. Heat Mass Transfer, Vol. 7, pp. 3-22   DOI   ScienceOn