Browse > Article
http://dx.doi.org/10.7839/ksfc.2019.16.2.001

A Study on the Impact Load Quantification of the Jaw Crusher  

Hong, Sung Ju (Department of Mechanical Design Engineering, Korea Polytechnic University)
Yang, Hae Jeong (Department of Mechanical Design Engineering, Korea Polytechnic University)
Publication Information
Journal of Drive and Control / v.16, no.2, 2019 , pp. 1-7 More about this Journal
Abstract
Jaw crusher is a device that breaks rock collected from mines or quarries to produce aggregates of the size desired by user. A representative method for measuring load is to measure them by attaching force sensors directly to the part where the load is generated. However, the direct method has many limitations such as high-impact loads generation in equipment or space constraints, sensor capacities and costs. Therefore, Transfer Path Analysis (TPA) was used to indirectly measure impact loads by attaching acceleration sensors. In this study, both direct and TPA methods were used to measure the impact load of Jaw crusher. This study finally quantifies the impact of the load generated by the Jaw crusher using direct method and TPA method, and comparing the impact load measured calculated the derive the error rate.
Keywords
Jaw Crusher; Transfer Path Analysis; Impact Load;
Citations & Related Records
Times Cited By KSCI : 1  (Citation Analysis)
연도 인용수 순위
1 J.-W. Kwon, N.-I. Kim and J. Ki, "The Balancing Analysis on the Jaw Crusher of a Mobile Jaw Crusher System", Proceedings of the KSNVE Annual Spring Conference, pp.1-5, 2015.
2 J. H. Kee et al., "Development of a 220ton/hr Mobile Crusher with Load Sensing Control and Hydraulic Tension System", Proceedings of the KSMTE Annual Spring Conference, p.12, 2015.
3 J. S. Song et al., "Dynamic Modeling and Verification for the Driving System of a Mobile Crusher", Proceedings of the KSMTE Annual Spring Conference, p.211, 2015.
4 K. Y. Baek, H. G. Kim and T. W. Seo, "Experimentral Study on Different Principles of Variable Stiffness Actuactors," Journal of the Korean Society for Precision Engineering, Vol.32, No.12, pp.1049-1054, 2015.   DOI
5 S. J. Hong et al., "Impact Load Measurements of Jaw Crusher using Transfer Path Analysis (TPA)", Proceedings of the KSME Spring Conference, pp.439-440, 2016.
6 C. H. Song, D. J. Kim and O. K. Kang, "Behavior Analysis of Hydraulic Breaker Housing using TPA", Journal of the Drive and Control, Vol.13, No.1, pp.72-77, 2016.
7 J. H. Youn and K. K. Ahn, "Simulation of EPPR Valve of Flow Force Characteristic using CFD Analysis", Journal of the Drive and Control, Vol.14, No.1, pp.14-22, 2017.   DOI
8 C. N. Lee, K. C. Hong and H. S. Jeong, "Analysis of the Influence of the Design Factors and Modeling for the 8inch Class Down-the-Hole Hammer", Journal of Drive and Control, Vol.14, No.4, pp.1-8, 2017.   DOI