Browse > Article
http://dx.doi.org/10.12989/sss.2019.24.4.447

TMD effectiveness in nonlinear RC structures subjected to near fault earthquakes  

Domizio, Martin N. (Faculty of Engineering, National University of Cuyo)
Ambrosini, Daniel (Faculty of Engineering, National University of Cuyo)
Curadelli, Oscar (Faculty of Engineering, National University of Cuyo)
Publication Information
Smart Structures and Systems / v.24, no.4, 2019 , pp. 447-457 More about this Journal
Abstract
The use of Tuned mass dampers (TMD) has proved to be effective in reducing the effects of vibrations caused by wind loads and far-field seismic action. However, its effectiveness in controlling the dynamic response of structures under near-fault earthquakes is still under discussion. In this case, the uncertainty about the TMD performance arises from the short significant duration of near-fault ground motions. In this work, the TMD effectiveness for increasing the safety margin against collapse of structures subjected to near-fault earthquakes is investigated. In order to evaluate the TMD performance in the proposed scenario, the nonlinear dynamic response of two reinforced concrete (RC) frames was analyzed. TMDs with different mass values were added to these structures, and a set of near-fault records with frequency content close to the fundamental frequency of the structure was employed. Through a series of nonlinear dynamic analysis, the minimum amplitude of each seismic record that causes the structural collapse was found. By comparing this value, called collapse acceleration, for the case of the structures with and without TMD, the benefit produced by the addition of the control device was established.
Keywords
tuned mass damper; seismic action; near-fault earthquakes; reinforced concrete structures;
Citations & Related Records
Times Cited By KSCI : 9  (Citation Analysis)
연도 인용수 순위
1 Cheng, C.T. and Chen, F.L. (2014), "Seismic performance of a rocking bridge pier substructure with frictional hinge dampers", Smart Struct. Syst., 14(4), 501-516. http://dx.doi.org/10.12989/sss.2014.14.4.501.   DOI
2 Choi, E. et al. (2017), "Cyclic compressive behavior of polyurethane rubber springs for smart dampers", Smart Struct. Syst., 20(6), 739-757. https://doi.org/10.12989/sss.2017.20.6.739.   DOI
3 CIRSOC (1982), "Reglamento CIRSOC 201: Proyecto, Calculo y Ejecucion de Estructuras de Hormigon Armado y Pretensado" Centro de Investigaion de los Reglamentos Nacionales de Seguridad para las Obras Civiles
4 Daniel, Y. and Lavan, O. (2013), "Allocation and sizing of multiple tuned mass dampers for seismic control of irregular structures", In, Geotechnical, Geological and Earthquake Engineering., 323-338.
5 Domizio, M. (2016), "Effectiveness analysis of tuned mass damper against structural collapse due to near fault earthquakes", PhD Thesis (in Spanish). 2016.
6 Domizio, M. et al. (2017), "Nonlinear dynamic numerical analysis of a RC frame subjected to seismic loading", Eng. Struct., 138, 410-424. https://doi.org/10.1016/j.engstruct.2017.02.031.   DOI
7 Domizio, M. et al. (2015), "Performance of TMDs on nonlinear structures subjected to near-fault earthquakes", Smart Struct. Syst., 16(4), 725-742. http://dx.doi.org/10.12989/sss.2015.16.4.725.   DOI
8 Domizio, M. et al. (2015), "Performance of tuned mass damper against structural collapse due to near fault earthquakes", J. Sound Vib., 336, 32-45. https://doi.org/10.1016/j.jsv.2014.10.007.   DOI
9 Elias, S. et al. (2017), "Distributed tuned mass dampers for Multimode control of benchmark building under seismic excitations", J. Earthq. Eng., 2469, 1-36. https://doi.org/10.1080/13632469.2017.1351407.
10 Engle, T. et al. (2015), "Hybrid tuned mass damper and isolation floor slab system optimized for vibration control", J. Earthq. Eng., 19(8), 1197-1221. https://doi.org/10.1080/13632469.2015.1037406.   DOI
11 Fadel Miguel, L.F. et al. (2016), "A novel approach to the optimum design of MTMDs under seismic excitations", Struct. Control Heal. Monit., 23(11), 1290-1313. https://doi.org/10.1002/stc.1845.   DOI
12 Greco, R. et al. (2014), "Robust design of tuned mass dampers installed on multi-degree-of-freedom structures subjected to seismic action", Eng. Optim., 47(8), 1-22. https://doi.org/10.1080/0305215X.2014.941288.
13 Hallquist, J.O. (2006), "LS-DYNA theory manual"
14 Hoang, T. et al. (2016), "Structural impact mitigation of bridge piers using tuned mass damper", Eng. Struct., 112, 287-294. https://doi.org/10.1016/j.engstruct.2015.12.041.   DOI
15 Hsiao, P.-C. et al. (2016), "Development and testing of naturally buckling steel braces", J. Struct. Eng., 142(1), 4015077. https://doi.org/10.1061/(ASCE)ST.1943-541X.0001319.   DOI
16 INPRES (1980), "Normas Antisismicas Argentinas NAA-80" Instituto Nacional de Prevencion Sismica.
17 Jiang, Q. et al. (2014), "Shaking table model test and FE analysis of a reinforced concrete mega-frame structure with tuned mass dampers", Struct. Des. Tall Spec. Build., 23(18), 1426-1442. https://doi.org/10.1002/tal.1150.   DOI
18 Jimenez-Alonso, J.F. and Saez, A. (2018), "Motion-based design of TMD for vibrating footbridges under uncertainty conditions", Smart Struct. Syst., 21(6), 727-740. https://doi.org/10.12989/sss.2018.21.6.727.   DOI
19 Lin, G.-L. et al. (2015), "Vibration control performance of tuned mass dampers with resettable variable stiffness", Eng. Struct., 83, 187-197. https://doi.org/10.1016/j.engstruct.2014.10.041.   DOI
20 Losanno, D. et al. (2017), "Design and retrofit of multistory frames with elastic-deformable viscous damping braces", J. Earthq. Eng., 1-24. https://doi.org/10.1080/13632469.2017.1387193.
21 Lu, Z. et al. (2016), "An experimental study of vibration control of wind-excited high-rise buildings using particle tuned mass dampers", Smart Struct. Syst., 18(1), 93-115. https://doi.org/10.12989/sss.2016.18.1.093.   DOI
22 Miranda, J.C. (2013), "A method for tuning tuned mass dampers for seismic applications", Earthq. Eng. Structual D., 42(7), 1103-1110. https://doi.org/10.1002/eqe.2271.   DOI
23 Lu, Z. et al. (2017), "Experimental and analytical study on the performance of particle tuned mass dampers under seismic excitation", Earthq. Eng. Struct. D., 46(5), 697-714. https://doi.org/10.1002/eqe.2826.   DOI
24 Matta, E. (2013), "Effectiveness of tuned mass dampers against ground motion pulses", J. Struct. Eng., 139(2), 188-198. https://doi.org/10.1061/(ASCE)ST.1943-541X.0000629.   DOI
25 Matta, E. (2011), "Performance of tuned mass dampers against near-field earthquakes", Struct. Eng. Mech., 39(5), 621-642. https://doi.org/10.12989/sem.2011.39.5.621.   DOI
26 Nigdeli, S.M. and Bekdas, G. (2013), "The effect of implsive motions on optimum tuned mass damper parameters", Proceedings of the 11th International Conference on Vibration Problems., 2-10.
27 Niu, H. et al. (2018), "Mitigation of wind-induced vibrations of bridge hangers using tuned mass dampers with eddy current damping", Smart Struct. Syst., 22(6), 727-741. https://doi.org/10.12989/sss.2018.22.6.727.   DOI
28 Ottosen, N.S. (1977), "A failure criterion for concrete", J. Eng. Mech., 527-535.   DOI
29 Quaranta, G. et al. (2016), "Effectiveness of design procedures for linear TMD installed on inelastic structures under pulse-like ground motion", Earthq. Struct., 10(1), 239-260. https://doi.org/10.12989/eas.2016.10.1.239.   DOI
30 Pisal, A.Y. and Jangid, R.S. (2016), "Vibration control of bridge subjected to multi-axle vehicle using multiple tuned mass friction dampers", Int. J. Adv. Struct. Eng., 8(2), 213-227.   DOI
31 Rakicevic, Z.T. et al. (2012), "Effectiveness of tune mass damper in the reduction of the seismic response of the structure", Bull. Earthq. Eng., 10(3), 1049-1073.   DOI
32 Sun, S. et al. (2018), "Development of magnetorheological elastomers.based tuned mass damper for building protection from seismic events", J. Intel. Mat. Syst. Str., 29(8), 1777-1789. https://doi.org/10.1177/1045389X17754265.   DOI
33 Salvi, J. and Rizzi, E. (2016), "Closed-form optimum tuning formulas for passive Tuned Mass Dampers under benchmark excitations", Smart Struct. Syst., 17(2), 231-256. http://dx.doi.org/10.12989/sss.2016.17.2.231.   DOI
34 Shen, S. et al. (2017), "Development of a double-sliding friction damper (DSFD) ", Smart Struct. Syst., 20(2), 151-162. https://doi.org/10.12989/sss.2017.20.2.151.   DOI
35 Sun, C. and Nagarajaiah, S. (2014), "Study on semi-active tuned mass damper with variable damping and stiffness under seismic excitations", Struct. Control Health. Monit., 21(6), 890-906. https://doi.org/10.1002/stc.1620.   DOI
36 Broadhouse, B.J. and Neilson, A.J. (1987), "Modelling reinforced concrete structures in DYNA3D", Rep. AEEW-M2465, UK At. Energy Authority, Winfrith.
37 Trifunac, M. and Brady, A.G. (1975), "A study on the duration of strong earthquake ground motion", Bull. Seismol. Soc. Am., 65, 581-626.
38 Warburton, G.B. (1982), "Optimal absorber parameters for various combinations of response and excitation parameters", Earthq. Eng. Struct. D., 10(3), 381-402. https://doi.org/10.1002/eqe.4290100304.   DOI
39 Yu, Y.-J. et al. (2010), "Analytical studies of a full-scale steel building shaken to collapse", Eng. Struct., 32(10), 3418-3430. https://doi.org/10.1016/j.engstruct.2010.07.015.   DOI