Browse > Article
http://dx.doi.org/10.12989/scs.2018.29.4.527

Structural evaluation of all-GFRP cable-stayed footbridge after 20 years of service life  

Gorski, Piotr (Department of Roads and Bridges, Faculty of Civil Engineering and Architecture, Opole University of Technology)
Stankiewicz, Beata (Department of Roads and Bridges, Faculty of Civil Engineering and Architecture, Opole University of Technology)
Tatara, Marcin (Department of Roads and Bridges, Faculty of Civil Engineering and Architecture, Opole University of Technology)
Publication Information
Steel and Composite Structures / v.29, no.4, 2018 , pp. 527-544 More about this Journal
Abstract
The paper presents the study on a change in modal parameters and structural stiffness of cable-stayed Fiberline Bridge made entirely of Glass Fiber Reinforced Polymer (GFRP) composite used for 20 years in the fjord area of Kolding, Denmark. Due to this specific location the bridge structure was subjected to natural aging in harsh environmental conditions. The flexural properties of the pultruded GFRP profiles acquired from the analyzed footbridge in 1997 and 2012 were determined through three-point bending tests. It was found that the Young's modulus increased by approximately 9%. Moreover, the influence of the temperature on the storage and loss modulus of GFRP material acquired from the Fiberline Bridge was studied by the dynamic mechanical analysis. The good thermal stability in potential real temperatures was found. The natural vibration frequencies and mode shapes of the bridge for its original state were evaluated through the application of the Finite Element (FE) method. The initial FE model was created using the real geometrical and material data obtained from both the design data and flexural test results performed in 1997 for the intact composite GFRP material. Full scale experimental investigations of the free-decay response under human jumping for the experimental state were carried out applying accelerometers. Seven natural frequencies, corresponding mode shapes and damping ratios were identified. The numerical and experimental results were compared. Based on the difference in the fundamental natural frequency it was again confirmed that the structural stiffness of the bridge increased by about 9% after 20 years of service life. Data collected from this study were used to validate the assumed FE model. It can be concluded that the updated FE model accurately reproduces the dynamic behavior of the bridge and can be used as a proper baseline model for the long-term monitoring to evaluate the overall structural response under service loads. The obtained results provided a relevant data for the structural health monitoring of all-GFRP bridge.
Keywords
GFRP bridge structure; finite element analysis; free-decay vibration; dynamic characteristics; dynamic mechanical analysis; structural stiffness;
Citations & Related Records
Times Cited By KSCI : 1  (Citation Analysis)
연도 인용수 순위
1 Sousa, J.M, Correia, J.R., Cabral-Fonseca, S. and Diogo, A.C. (2014), "Effects of thermal cycles on the mechanical response of pultruded GFRP profiles used in civil engineering applications", Compos. Struct., 116, 720-731.   DOI
2 Sousa, J.M., Correia, J.R. and Cabral-Fonseca, S. (2016), "Durability of glass fibre reinforced polymer pultruded profiles: comparison between QUV accelerated exposure and natural weathering in a Mediterranean climate society for experimental mechanics", Exp. Tech., 40(1), 207-219.   DOI
3 Stankiewicz, B. and Tatara, M. (2015), "Applications of glass and glass fiber retrofit polymer in modern footbridges", J. Civil Eng. Architect., 9, 791-797.
4 Stratford, T. (2012), "The condition of the Aberfeldy Footbridge after 20 years of service", Proceedings of the 14th International Conference on Structural Faults and Repair, Edinburgh, UK, July.
5 The Weather Company (2018), https://www.wunderground.com/history
6 Tuwair, H., Volz, J., ElGawady, M., Mohamed, M., Chandrashekhara, K. and Birman, V. (2016), "Behavior of GFRP bridge deck panels infilled with polyurethane foam under various environmental exposure", Structures, 5, 141-151.   DOI
7 Verghese, N.E., Hayes, M., Garcia, K., Carrier, C., Wood, J. and Lesko, J.J. (1998), "Effects of temperature sequencing during hygrothermal aging of polymers and polymer matrix composites: the reverse thermal effect", Proceedings of the 2nd International Conference on Composites in Infrastructure, Tucson, Arizona, USA, January.
8 Votsis, R., Stratford, T., Chryssanthopoulos, M. and Tantele, E. (2017), "Dynamic assessment of a FRP suspension footbridge through field testing and finite element modelling", Steel Compos. Struct., Int. J., 23(2), 205-215.   DOI
9 Wu, H.C., Fu, G., Gibson, R.F. and Yan, A. (2006), "Durability of FRP composite bridge deck materials under freeze-thaw and low temperature conditions", J. Bridge Eng., 11(4), 443-451.   DOI
10 Apicella, A., Migliaresi, C., Nicodemo, L., Nicolais, L., Iaccarino, L. and Roccotelli, S. (1982), "Water sorption and mechanical properties of a glass-reinforced polyester resin", Compos., 13(4), 406-410.   DOI
11 Ascione, F., Mancusi, G., Spadea, S., Lamberti, M., Lebon, F. and Maurel-Pantel, A. (2015), "On the flexural behaviour of GFRP beams obtained by bonding simple panels: An experimental investigation", Compos. Struct., 131, 55-65.   DOI
12 Bacinskas, D., Rimkus, A., Rumsys, D., Meskėnas, A., Bielinis, S., Sokolov, A. and Merkevicius, T. (2017), "Structural analysis of GFRP truss bridge model", Procedia Eng., 172, 68-74.   DOI
13 Bai, Y. and Keller, T. (2008), "Modal parameter identification for a GFRP pedestrian bridge", Compos. Struct., 82(1), 90-100.   DOI
14 Caetano, E., Cunha, A ., Hoorpah, W. and Raoul, J. (2009), Footbridge Vibration Design, CRC Press, London, UK.
15 Brincker, R., Zhang, L. and Andersen, P. (2000), "Modal identification from ambient responses using frequency domain decomposition", Proceedings of the 18th International Modal Analysis Conference, Kissimmee, FL, USA, February.
16 Brownjohn, J.M.W., Bocian, M., Hester, D., Quattrone, A., Hudson, W., Moore, D., Goh, S. and Lim, M.S. (2016), "Footbridge system identification using wireless inertial measurement units for force and response measurements", J. Sound Vib., 384, 339-355.
17 Butz, C., Feldmann, M., Heinemeyer, C., Sedlacek, G., Chabrolin, B., Lemaire, A., Lukic, M., Martin, P.O., Caetano, E., Cunha, A ., Goldack, A., Keil, A. and Schlaich, M. (2007), Advanced Load Models for Synchronous Pedestrian Excitation and Optimised Design Guidelines for Steel Footbridges, Final Report RFS-CR-03019, Brussels, Belgium, July.
18 El-Salakawy, E. and Benmokrane, B. (2004), "Serviceability of concrete bridge deck slabs reinforced with fiber-reinforced polymer composite bars", Struct. J., 101(5), 727-736.
19 Correia, J.R., Cabral-Fonseca, S., Branco, F.A., Ferreira, J.G., Eusebio, M.I. and Rodrigues, M.P. (2005), "Durability of glass fibre reinforced polyester (GFRP) pultruded profiles used in civil engineering applications", Proceedings of the 3th International Conference on Composites in Construction, Lyon, France, July.
20 Cortright, R.S. (2003), Bridging the World, Bridge INK, Wilsonville, OR, USA.
21 EN1990 (2004), Basis of structural design; Eurocode 0, European Committee for Standardization; Brussels, Belgium.
22 Fiberline Composites A/S website I (2018), https://fiberline.com/print/1297
23 Gentile, C. and Bernardini, G. (2008), "Output-only modal identification of a reinforced concrete bridge from radar-based measurements", NDT&E Int., 41(7), 544-553.   DOI
24 Fiberline Composites A/S website II (2018), https://fiberline.com/fiberline-bridge-kolding
25 Friswell, M.I. and Mottershead, J.E. (1995), Finite Element Model Updating in Structural Dynamics, Kluwer Academic Publishers, London, UK.
26 GangaRao, H.V.S., Vijay, P.V. and Dutta, P.K. (1995), "Durability of composites in infrastructure", Proceedings of Corrosion, Paper No. 550, pp. 1-8.
27 Grammatikos, S.A., Jones, R.G., Evernden, M. and Correia, J.R. (2016), "Thermal cycling effects on the durability of a pultruded GFRP material for off-shore civil engineering structures", Compos. Struct., 153, 297-310.   DOI
28 Hassiotis, S. and Jeong, G.D. (1995), "Identification of stiffness reduction using natural frequencies", J. Eng., Mech. ASCE, 121(10), 1106-1113.
29 Jamond, R.M., Hoffard, T.A., Novinson, T. and Malvar, L.J. (2000), Composites in Simulated Marine Environments, NFESC Special Publication SP-2083-SHR, May.
30 ISO 14125 (1998), Fibre-Reinforced Plastic Composites; Determination of Flexural Properties, Int. Standard.
31 Ji, H.S., Song, W. and Ma, Z.J. (2010), "Design, test and field application of a GFRP corrugated-core sandwich bridge", Eng. Struct., 32(9), 2814-2824.   DOI
32 Karbhari, V.M. and Pope, G. (1993), "Effect of cold region type environment on impact and flexure properties of glass/ vinyelester composites", ASCE J. Cold Reg. Eng., 8(1), 1-20.
33 Li, Y.F., Badjie, S., Chen, W. and Chiu, Y.T. (2014), "Case study of first all-GFRP pedestrian bridge in Taiwan", Case Studies in Constr. Mater., 1, 83-95.
34 Keller, T. (2003), Use of Fibre Reinforced Polymers in Bridge Construction, ETH Honggerberg, Zurich, Switzerland.
35 Kutz, M. (2002), Handbook of Materials Selection, John Wiley & Sons, New York, USA.
36 Lopez-Anido, R., Michael, A.P. and Sandford, T.C. (2004), "Freeze-thaw resistance of fiber-reinforced polymer composites adhesive bonds with underwater curing epoxy", J. Mater. Civil Eng., 16(3), 135-148.
37 Lu, T., Solis-Ramos, E., Yi, Y.B. and Kumosa, M. (2016), "Synergistic environmental degradation of glass reinforced polymer composites", Polym. Degrad. Stabil., 131, 1-8.
38 Maes, K., Van Nimmen, K., Lourens, E., Rezayat, A., Guillaume, P., De Roeck, G. and Lombaert, G. (2016), "Verification of joint input-sate estimation for force identification by means of in situ measurements on a footbridge", Mech. Syst. Signal Pr., 75, 245-260.
39 Magalhăes, F., Cunha, A., Caetano, E. and Brincker, R. (2010), "Damping estimation using free decays and ambient vibration tests", Mech. Syst. Signal Pr., 24, 1274-1290.   DOI
40 Malvar, L.J., Jamond, R.M., Hoffard, T.A. and Novinson, T. (2002), "GFRP composites in simulated marine environments", Proceedings of the 2nd International Conference on Durability of FRP Composites for Construction, Montreal, Quebec, Canada, May.
41 Pantak, M., Jarek, B. and Marecik, K. (2018), "Vibration damping in steel footbridges", Proceedings of the 9th International Symposium Steel Bridges, Prague, Czech Republic, September.
42 Moser, P. and Moaveni, B. (2011), "Environmental effects on the identified natural frequencies of the Dowling Hall Footbridge", Mech. Syst. Signal Pr., 25, 2336-2357.
43 Murphy, N. (2013), "Feasibility analysis of a fiber reinforced polymer bridge", Ph.D. Dissertation; KTH Royal Institute of Technology, Stockholm, Sweden.
44 Nishizaki, I., Sakuraba, H. and Tomiyama, T. (2015), "Durability of pultruded GFRP through ten-year outdoor exposure test", Polymers, 7, 2494-2503.
45 Potyrala, P.B. (2011), "Use of fibre reinforced polymer composites in bridge construction - state of the art in hybrid and allcomposite structures", Ph.D. Dissertation; University of Catalonia, Barcelona, Spain.
46 Ramboll (2013), Generaleftersyn Samt Undersogelse af Egenskaber for Glasfibermateriale, Technical Report 1100002180\LF00001-2-NTO, Denmark, February. [In Danish]
47 ROBOT (2018), Autodesk Robot Structural Analysis Professional software.
48 SETRA (2006), Assessment of vibrational behaviour of footbridges under pedestrian loading; Footbridges Technical Guide, Technical Department for Transport, Roads and Bridges Engineering and Road Safety; Paris, France.
49 Skinner, J.M. (2009), "A critical analysis of the Aberfeldy Footbridge, Scotland", Proceedings of the 2nd Conference on Bridge Engineering, Bath, UK., April.