Browse > Article
http://dx.doi.org/10.12989/scs.2018.28.6.719

Non-invasive steel haunch upgradation strategy for seismically deficient reinforced concrete exterior beam-column sub-assemblages  

Kanchanadevi, A. (CSIR-Structural Engineering Research Centre)
Ramanjaneyulu, K. (CSIR-Structural Engineering Research Centre)
Publication Information
Steel and Composite Structures / v.28, no.6, 2018 , pp. 719-734 More about this Journal
Abstract
Prior to the introduction of modern seismic guidelines, it was a common practice to provide straight bar anchorage for beam bottom reinforcement of gravity load designed building. Exterior joints with straight bar anchorages for beam bottom reinforcements are susceptible to sudden anchorage failure under load reversals and hence require systematic seismic upgradation. Hence in the present study, an attempt is made to upgrade exterior beam-column sub-assemblage of a three storied gravity load designed (GLD) building with single steel haunch. Analytical formulations are presented for evaluating the haunch forces in single steel haunch retrofit. Influence of parameters that affect the efficacy and effectiveness of the single haunch retrofit are also discussed. The effectiveness of the single haunch retrofit for enhancing seismic performance of GLD beam-column specimen is evaluated through experimental investigation under reverse cyclic loading. The single steel haunch retrofit had succeeded in preventing the anchorage failure of beam bottom bars of GLD specimen, delaying the joint shear damage and partially directing the damage towards the beam. A remarkable improvement in the load carrying capacity of the upgraded GLD beam-column sub-assemblage is observed. Further, a tremendous improvement in the energy dissipation of about 2.63 times that of GLD specimen is observed in the case of upgraded GLD specimen. The study also underlines the efficacy of single steel haunch retrofit for seismic upgradation of deficient GLD structures.
Keywords
gravity load designed; beam-column sub-assemblage; upgradation; steel haunch; energy dissipation; strength and stiffness degradation;
Citations & Related Records
Times Cited By KSCI : 3  (Citation Analysis)
연도 인용수 순위
1 Sharma, A., Reddy, G.R., Eligehausen, R., Genesio, G. and Pampanin, S. (2014), "Seismic Response of Reinforced Concrete Frames with Haunch Retrofit Solution", ACI Struct. J., 111(3), 673-684.
2 Tsonos, A.G. (1999), "Lateral Load Response of Strengthened Reinforced Concrete Beam-to-Column Joints", ACI Struct. J., 96(1), 46-56.
3 Tsonos, A.G. (2014), "A new method for earthquake strengthening of old R/C structures without the use of conventional reinforcement", Struct. Eng. Mech., Int. J., 52(2), 391-403.   DOI
4 Yilmaz, S., Ozen, M.A. and Yardim, Y. (2013), "Tensile behavior of post-installed chemical anchors embedded to low strength concrete", Constr. Build. Mater., 47, 861-866.   DOI
5 Yu, Q.S., Uang, C.M. and Gross, J. (2000), "Seismic rehabilitation design of steel moment connection with welded haunch", J. Struct. Eng. ASCE, 126(1), 69-78.   DOI
6 Yurdakul, O. and Avsar, O. (2015), "Structural repairing of damaged reinforced concrete beam-column assemblies with CFRPs", Struct. Eng. Mech., Int. J., 54(3), 521-543.   DOI
7 SP34 (1987), Handbook on concrete reinforcement and detailing; Bureau of Indian Standards, New Delhi, India.
8 Akguzel, U. and Pampanin, S. (2012), "Recent Developments in Seismic Strengthening of RC Beam-Column Joints with FRP Materials", Proceedings of the 15th World Conference on Earthquake Engineering, Lisbon, Portugal.
9 Adam, J.M., Gimenez, E. and Calderon, P.A. (2008), "Experimental study of beam-column joints in axially loaded RC columns strengthened by steel angles and strips", Steel Compos. Struct., Int. J., 8(4), 329-342.   DOI
10 Adibi, M., Marefata, M.S., Arani, K.K. and Zare, H. (2017), "External retrofit of beam-column joints in old fashioned RC structures", Earthq. Struct., Int. J., 12(2), 237-250.   DOI
11 Aycardi, L.E., Mander, J.B. and Reinhorn, A.M. (1994), "Seismic resistance of reinforced concrete frame structures designed only for gravity loads: Experimental performance of subassemblages", ACI Struct. J., 91(5), 552-563.
12 Balbuena, G., Gramaxo, J. and Kunz, J. (2011), "Design of Postinstalled Anchors for Seismic Actions", Proceedings of the Ninth Pacific Conference on Earthquake Engineering Building an Earthquake-Resilient Society, Auckland, New Zealand
13 Bansal, P.P., Kumara, M. and Darb, M.A. (2016), "Retrofitting of exterior RC beam-column joints using ferrocement jackets", Earthq. Struct., Int. J., 10(2), 313-328.   DOI
14 Bokey, P.B. and Pajgade, P.S. (2004), "Lessons from Jan, 26, 2001 Gujarat (India) Earthquake", Proceedings of the 13th World Conference on Earthquake Engineering, Vancouver, Canada, Paper No. 1874.
15 Bracci, J.M., Reinhorn, A.M. and Mander, J.B. (1995), "Seismic resistance of reinforced concrete frame structures designed for gravity loads: performance of structural system", ACI Struct. J., 92(5), 597-609.
16 Fakharifar, M., Sharbatdar, M.K., Lin, Z., Dalvand, A., Sivandi-Pour, A. and Chen, G. (2014), "Seismic performance and global ductility of RC frames rehabilitated with retrofitted joints by CFRP laminates", Earthq. Eng. Eng. Vib., 13, 59-73.   DOI
17 Dogan, E. and Opara, N.K. (2003), "Seismic Retrofit with Continuous Slurry-Infiltrated Mat Concrete Jackets", ACI Struct. J., 100(6), 713-723.
18 El-Amoury, T. and Ghobarah, A. (2002), "Seismic rehabilitation of beam-column joint using GFRP sheets", Eng. Struct., 24, 1397-1407.   DOI
19 European Technical Assessment (2016), ETA-05/0255 of 19 January 2016.
20 Campione, G., Cavaleri, L. and Papia, M. (2015), "Flexural response of external R.C. beam-column joints externally strengthened with steel cages", Eng. Struct., 104, 51-64.   DOI
21 Genesio, G. (2012), "Seismic Assessment of RC Exterior Beam-Column Joints and Retrofit with Haunches Using Post-Installed Anchors", Doctor of Philosophy Thesis; University of Stuttgart.
22 Gergely, J., Pantelides, C.P. and Reaveley, L.D. (2000), "Shear Strengthening of RCT-Joints Using CFRP Composites", J. Compos. Constr., 4, 56-64.   DOI
23 Ghobarah, A. and Said, A. (2002), "Seismic rehabilitation of beam-column joints using FRP laminates", J. Earthq. Eng., 5(1), 113-129.   DOI
24 Goltz, J. (1994), "The Northridge, California Earthquake of January 17, 1994: General Reconnaissance Report", Technical Report NCEER-94-0005; National Center for Earthquake Engineering Research.
25 Hadi, M.N.S. and Tran, T.M. (2014), "Retrofitting non-seismically detailed exterior beam-column joints using concrete covers together with CFRP jacket", Constr. Build. Mater., 63, 161-173.   DOI
26 Hadigheh, S.A., Mahini, S.S. and Maheri, M.R. (2014), "Seismic behavior of FRP-retrofitted reinforced concrete frames", J. Earthq. Eng., 18, 1171-1197.   DOI
27 IS:1786-2008 (2008), High Strength Deformed Steel Bars and Wires for Concrete reinforcement - Specifications; Bureau of Indian Standards, New Delhi, India.
28 Kanchanadevi, A. and Ramanjaneyulu, K. (2017), "Comparative performance of seismically deficient exterior beam-column subassemblages of different design evolutions: A closer perspective", Earthq. Struct., Int. J., 13(2), 177-191.
29 IS 456 (2000), Code of practice for plain and reinforced concrete; (Fourth Revision), Bureau of Indian Standards, New Delhi, India.
30 Kalogeropoulos, G.I., Tsonos, A.D.G., Konstandinidis, D. and Tsetines, S. (2016), "Pre-earthquake and post-earthquake retrofitting of poorly detailed exterior RC beam-to-column joints", Eng. Struct., 109, 1-15.   DOI
31 Kheyroddin, A., Khalili, A., Emami, E. and Sharbatdar, M.K. (2016), "An innovative experimental method to upgrade performance of external weak RC joints using fused steel prop plus sheets", Steel Compos. Struct., Int. J., 21(2), 443-460.   DOI
32 Pampanin, S. and Christopoulos, C. (2003), "Non-invasive Retrofit of Existing RC Frames Designed for Gravity Loads Only", Proceedings of the Fib Symposium on Concrete Structures in Seismic Regions, Greece.
33 Pampanin, S., Christopoulos, C. and Chen, T.H. (2006), "Development and validation of a metallic haunch seismic retrofit solution for existing under-designed RC frame buildings", Earthq. Eng. Struct. Dyn., 35, 1739-1766.   DOI
34 Pampanin, S., Bolognini, D. and Pavese, A. (2007), "Performance-Based Seismic Retrofit Strategy for Existing Reinforced Concrete Frame System Using Fiber-Reinforced Polymer Composites", J. Compos. Constr. ASCE, 11, 211-226.   DOI
35 Paulay, T. and Priestley, M.N.J. (1992), "Seismic design of reinforced concrete and masonry building", Wiley Interscience publication.
36 Shafaei, J., Hosseini, A. and Marefat, M.S. (2014), "Seismic retrofit of external RC Beam-column joints by joint enlargement using prestressed steel angles", Eng. Struct., 81, 265-288.   DOI
37 Prota, A., Nanni, A., Manfredi, G. and Cosenza, E. (2004), "Selective Upgrade of Under designed Reinforced Concrete Beam-Column Joints Using Carbon Fiber-Reinforced Polymers", ACI Struct. J., 101(5), 699-707.
38 Realfonzo, R., Napoli, A. and Pinilla, J.G.R (2014), "Cyclic behavior of RC beam-column joints strengthened with FRP systems", Constr. Build. Mater., 54, 282-297.   DOI
39 Santarsiero, G. and Masi, A. (2015), "Seismic performance of RC beam-column joints retrofitted with steel dissipation jackets", Eng. Struct., 85, 95-106.   DOI
40 Sezen, H. (2012), "Repair and Strengthening of Reinforced Concrete Beam-Column Joints with Fiber-Reinforced Polymer Composites", J. Compos. Constr., 16(5), 499-506.   DOI
41 Shannag, M.J., Barakat, S. and Abdul-Kareem, M. (2002), "Cyclic behaviour of HPFRC-repaired reinforced concrete interior beam-column joints", Mater. Struct./Materiaux et Constr., 35, 348-356.   DOI
42 Sharbatdar, M.K., Kheyroddin, A. and Emami, E. (2012), "Cyclic performance of retrofitted reinforced concrete beam-column joints using steel prop", Constr. Build. Materi., 36, 287-294.   DOI
43 Sharma, A. (2013), "Seismic Behavior and Retrofitting of RC Frame Structures with Emphasis on Beam-Column Joints -Experiments and Numerical Modeling", Doctor of Philosophy Thesis; University of Stuttgart.