Browse > Article
http://dx.doi.org/10.21022/IJHRB.2020.9.4.325

Interfacial Stress Concentrations of Vertical Through-plate to H-beam Connections in CFT Column  

Choi, Insub (Department of Architectural and Architecture Engineering, Yonsei University)
Chang, HakJong (Department of Architectural and Architecture Engineering, Yonsei University)
Kim, JunHee (Department of Architectural and Architecture Engineering, Yonsei University)
Publication Information
International Journal of High-Rise Buildings / v.9, no.4, 2020 , pp. 325-334 More about this Journal
Abstract
This paper aims to evaluate the interfacial stress concentrations on connection between vertical through-plate and H-beam in CFT column. Full-scale experiments were performed on three specimens with varying thickness of the vertical through-plate to investigate the interfacial stress concentration factor in the connections. The specimens underwent brittle failure at the location where the steel beam is connected to the vertical through-plate before the steel beam reached its plastic moment. The strain data of the part were analyzed, and the sectional analyses were conducted to determine appropriate residual stress models. In addition, the stress concentration factor was quantified by comparing the analytical local behavior in which the stress concentration is not reflected and the experimental data reflecting the stress concentration. The results showed that the maximum reduction of the stress concentration factor due to an increase in the thickness of the vertical through-plate is 50.3%.
Keywords
Interfacial stress concentration; Vertical through-plate; Thermally-induced initial damage; Concrete-filled steel tube; Residual stress;
Citations & Related Records
Times Cited By KSCI : 1  (Citation Analysis)
연도 인용수 순위
1 Srinivasan, C. N., Schneider, S. P. (1999). "Axially Loaded Concrete-Filled Steel Tubes." J. Struct. Eng., 125(10), 1202-1206.   DOI
2 KATS. (2014). "Rolled steels for welded structures (KS D 3515)." Korean Agency for Technology and Standards.
3 Torabian, S., Mirghaderi, S. R., Keshavarzi, F. (2012). "Moment-connection between I-beam and built-up square column by a diagonal through plate." J. Constr. Steel Res., 70, 385-401.   DOI
4 Xiao, Y., Zhang, Z., Hu, J., Kunnath, S. K., Guo, P. (2011). "Seismic Behavior of CFT Column and Steel Pile Footings." J. Bridg. Eng., 16(5), 575-586.   DOI
5 Yang, B., Nie, S., Xiong, G., Hu, Y., Bai, J., Zhang, W., Dai, G. (2016). "Residual stresses in welded I-shaped sections fabricated from Q460GJ structural steel plates." J. Constr. Steel Res., 122, 261-273.   DOI
6 Young, B., Ellobody, E. (2006). "Experimental investigation of concrete-filled cold-formed high strength stainless steel tube columns." J. Constr. Steel Res., 62(5), 484-492.   DOI
7 Young, B. W. (1972). "Residual stresses in hot-rolled members." IABSE Int. Colloq. column strength, University of Cambridge.
8 Young, B. W., Schulz, G. W. (1977). "Mechanical properties and residual stresses." Second Int. Colloqium Stab. Steel Struct. Liege Introd. Report, ECCS IABSE.
9 Zeinizadeh Jeddi, M., Ramli Sulong, N. H., Arabnejad Khanouki, M. M. (2017). "Seismic performance of a new through rib stiffener beam connection to concrete-filled steel tubular columns: An experimental study." Eng. Struct., 131, 477-491.   DOI
10 Chan, J., Chen, J., Jin, W. L. (2010). "Experiment investigation of stress concentration factor of concrete-filled tubular T joints." J. Constr. Steel Res., 66(12), 1510-1515.   DOI
11 Chen, C. C., Lin, C. C., Tsai, C. L. (2004). "Evaluation of reinforced connections between steel beams and box columns." Eng. Struct., 26(13), 1889-1904.   DOI
12 Chen, M. cheng, Wen, Q. qing, Zhu, Q., Huang, H., Xie, L. (2017). "Simulation of corrosion process for concrete filled steel tubular columns with the cellular automata method." Eng. Fail. Anal., 82, 298-307.   DOI
13 Choi, I., Kim, J. H., Kim, H.-R. (2015). "Composite Behavior of Insulated Concrete Sandwich Wall Panels Subjected to Wind Pressure and Suction." Materials (Basel)., 8, 1264-1282.   DOI
14 Choi, I., Kim, J. H., You, Y.-C. (2016). "Effect of cyclic loading on composite behavior of insulated concrete sandwich wall panels with GFRP shear connectors." Compos. Part B Eng., 96, 7-19.   DOI
15 Choi, S., Lee, S., Hong, S., Kim, J. (2008). "Structural capacities of tension side for CFT square column-to-beam connections with combined-cross diaphragm." Adv. Struct. Eng., 11(2), 209-227.   DOI
16 ECCS. (1976). Manual on stability of steel structures - Part 2.2. Mechanical properties and residual stresses. European Convention for Constructional Steelwork, Brussels.
17 Abambres, M., Quach, W. M. (2016). "Residual stresses in steel members: A review of available analytical expressions." Int. J. Struct. Integr., 7(1), 70-94.   DOI
18 Bu, Y., Gardner, L. (2019). "Finite element modelling and design of welded stainless steel I-section columns." J. Constr. Steel Res., 152, 57-67.   DOI
19 ECCS. (1984). Ultimate limit states calculations of sway frames with rigid joints. European Convention for Constructional Steelwork, Brussels.
20 Galambos, T. V, Ketter, R. L. (1959). "Columns under combined bending and thrust." J. Eng. Mech. Div., 85(2), 1-30.   DOI
21 Gardner, L., Bu, Y., Theofanous, M. (2016). "Laser-welded stainless steel I-sections: Residual stress measurements and column buckling tests." Eng. Struct., 127, 536-548.   DOI
22 Gupta, P. K., Singh, H. (2014). "Numerical study of confinement in short concrete filled steel tube columns." Lat. Am. J. Solids Struct., 11(8), 1445-1462.   DOI
23 Hajjar, J. F., Schiller, P. H., Molodan, A. (1998). "A distributed plasticity model for concrete-filled steel tube beam-columns with interlayer slip." Eng. Struct., 20(8), 663-676.   DOI
24 Huang, C., Yeh, Y.-K., Liu, G.-Y., Hu, H.-T., Tsai, K., Weng, Y., Wang, S., Wu, M.-H. (2002). "Axial Load Behavior of Stiffened Concrete-Filled Steel Columns." J. Struct. Eng., 128(9), 1222-1230.   DOI
25 Kang, L., Leon, R. T., Lu, X. (2014). "A general analytical model for steel beam-to-CFT column connections in OpenSEES." J. Constr. Steel Res., 100, 82-96.   DOI
26 Kim, J. H., Ghaboussi, J., Elnashai, A. S. (2010). "Mechanical and informational modeling of steel beam-to-column connections." Eng. Struct., 32(2), 449-458.   DOI
27 Kim, J. H., Ghaboussi, J., Elnashai, A. S. (2012). "Hysteretic mechanical-informational modeling of bolted steel frame connections." Eng. Struct., 45, 1-11.   DOI
28 Kim, J. H., You, Y.-C. (2015). "Composite Behavior of a Novel Insulated Concrete Sandwich Wall Panel Reinforced with GFRP Shear Grids: Effects of Insulation Types." Materials (Basel)., 8, 899-913.   DOI
29 Kim, Y.-J., Shin, K.-J., Kim, W.-J. (2008). "Effect of Stiffener Details on Behavior of CFT Column-to-Beam Connections." Steel Struct., 8(2), 119-133.
30 Kuranovas, A., Kvedaras, A. K. (2007). "Behaviour of hollow concrete?filled steel tubular composite elements." J. Civ. Eng. Manag., 13(2), 131-141.   DOI
31 Lee, S. H., Yang, I.-S., Choi, S.-M. (2010). "Structural characteristics of welded built-up square CFT column-to-beam connections with external diaphragms." Steel Compos. Struct., 10(3), 261-279.   DOI
32 Qin, Y., Chen, Z., Wang, X. (2014a). "Experimental investigation of new internal-diaphragm connections to CFT columns under cyclic loading." J. Constr. Steel Res., 98, 35-44.   DOI
33 Long, H., Gery, D., Carlier, A., Maropoulos, P. G. (2009). "Prediction of welding distortion in butt joint of thin plates." Mater. Des., 30(10), 4126-4135.   DOI
34 Mirghaderi, S. R., Torabian, S., Keshavarzi, F. (2010). "I-beam to box-column connection by a vertical plate passing through the column." Eng. Struct., 32(8), 2034-2048.   DOI
35 Musa, I. A., Mashiri, F. R., Zhu, X., Tong, L. (2018). "Experimental stress concentration factor in concrete-filled steel tubular T-joints." J. Constr. Steel Res., 150, 442-451   DOI
36 Qin, Y., Chen, Z., Wang, X., Zhou, T. (2014b). "Seismic behavior of through-diaphragm connections between CFRT columns and steel beams-experimental study." Adv. Steel Constr., 10(3), 351-371.
37 Qin, Y., Chen, Z., Yang, Q., Shang, K. (2014c). "Experimental seismic behavior of through-diaphragm connections to concrete-filled rectangular steel tubular columns." J. Constr. Steel Res., 93, 32-43.   DOI
38 Sakino, K., Nakahara, H., Morino, S., Nishiyama, I. (2004). "Behavior of Centrally Loaded Concrete-Filled SteelTube Short Columns." J. Struct. Eng., 130(2), 180-188.   DOI
39 Samarakkody, D. I., Thambiratnam, D. P., Chan, T. H. T., Moragaspitiya, P. H. N. (2017). "Differential axial shortening and its effects in high rise buildings with composite concrete filled tube columns." Constr. Build. Mater., 143, 659-672.   DOI
40 Sewel, J. S. (1902). "Column for Buildings." Eng. News, 48(17), 36-39.
41 Shin, K.-J., Kim, Y.-J., Oh, Y.-S., Moon, T.-S. (2004). "Behavior of welded CFT column to H-beam connections with external stiffeners." Eng. Struct., 26(13), 1877-1887.   DOI