Browse > Article
http://dx.doi.org/10.3795/KSME-B.2003.27.11.1618

Detailed Measurement of Flow and Heat Transfer Downstream of Rectanglar Vortex Generators Using a Transient Liquid Crystal Technique  

Hong, Cheol-Hyun (부산대학교 기계설계전산화인력양성센터)
Yang, Jang-Sik (부산대학교 기계기술연구소)
Lee, Ki-Baik (부산대학교 기계공학과 기계기술연구소)
Publication Information
Transactions of the Korean Society of Mechanical Engineers B / v.27, no.11, 2003 , pp. 1618-1629 More about this Journal
Abstract
The effects of the interaction between flow field and heat transfer caused by the longitudinal vortices are experimentally investigated using a five hole probe and a transient liquid crystal technique. The test facility consists of a wind tunnel with vortex generators protruding from a bottom surface and a mesh heater. In order to control the strength of the longitudinal vortices, the angle of attack of vortex generators used in the present experiment is 20$^{\circ}$, and the spacing between the vortex generators is 25mm. The height and cord length of the vortex generator is 20mm and 50mm, respectively. Three-component mean velocity measurements are made using a f-hole probe system, and the surface temperature distribution is measured by the hue capturing method using a transient liquid crystal technique. The transient liquid crystal technique in measuring heat transfer has become one of the most effective ways in determining the full surface distributions of heat transfer coefficients. The key point of this technique is to convert the inlet flow temperature into an exponential temperature profile using the mesh heater set up in the wind tunnel. The conclusions obtained in the present experiment are as follows: The two maximum heat transfer values exist over the whole domain, and as the longitudinal vortices move to the farther downstream region, these peak values show the decreasing trends. These trends are also observed in the experimental results of other researchers to have used the uniform heat flux method.
Keywords
Transient Liquid Crystal Technique; Vortex Generator; Heat Transfer Coefficient; Mesh Heater; Heat Exchanger;
Citations & Related Records
Times Cited By KSCI : 2  (Citation Analysis)
연도 인용수 순위
1 Baugh, J. W., 1995, 'Liquid Crystal Methods for Studying Turbulent Heat Transfer,' International Journal of Heat and Fluid Flow, Vol. 16, No.5, pp. 364-375   DOI   ScienceOn
2 Sim, S. Y., Yang, W. J., 1987, 'New Performance-evaluation Analyses on Heat Transfer Surfaces by Single-blow Technique,' International Journal of Heat and Mass Transfer, Vol. 30, No. 8, pp. 1587-1594   DOI   ScienceOn
3 Yang, J. S., Lee, K. B., 2000, 'A Numerical Simulation of Longitudinal Vortex in Turbulent Boundary Layers,' Journal of KSME(B), Vol. 24, No.6, pp. 802-813   과학기술학회마을
4 Tiggelbeck, S., Mitra, N. K. and Fiebig, M., 1994, 'Comparison of Wing-type Vortex Generators for Heat Transfer Enhancement in Channel Flow,' ASME Journal of Heat Transfer, Vol. 116, No.4, pp.880-885   DOI   ScienceOn
5 Ireland, P. T. , Neely, A. J., Gillespie, D. R. H. and Robertson, A. J. , 1999, 'Turbulent Heat Transfer Measurements Using Liquid Crystals,' International Journal of Heat and Fluid Flow, Vol. 20, pp. 355-367   DOI   ScienceOn
6 Han, D. J., 1999, An experimental Study on the Interaction and Flow Characteristics of Longitudinal Vortex Pairs, Master of Science Thesis, Pusan National University
7 Weshphal, R. V., Pauley, W. R. and Eaton, J. K.,1987, 'Interaction Between a Vortex and a Turbulent Boundary Layer-Part I: Mean Flow Evolution and Turbulence Properties,' NASA TM88361
8 Park, B. K., Hong, T. and Park, S. H., 1999, 'Performance Evaluation Technique of a Heat Exchanger Using a Transient Response Analysis,' The Society of Air-Conditioning and Refrigerating Engineers of Korea, Vol. 11, No.1, pp. 81-90
9 Park, B. K., Hong T., and Park, S. H., 1999, 'Measurement of Surface Heat Transfer Using Exponential Temperature Variations,' Journal of KSME(B), Vol. 23, No.9, pp. 1121-1128
10 Fiebig, M., 1997,'Vortices and Heat Transfer,' Zeitschrift fur Angewandte Mathematik und Mechanik, Vol. 77, No. 1, pp. 3-18   DOI   ScienceOn
11 Reichert, B. A. and Wendt, B. J., 1993, 'An Experimental Investigation off S-Duct Flow Control Using Arrays of Low Profile Vortex Generations,' AIAA Paper 93-0019
12 Pauley, W. R. and Eaton, J. K., 1988, 'The Fluid Dynamics and Heat Transfer Effects of Streamwise V ortices Embedded in a Turbulent Boundary Layer,' Report MD-51, Department of Mechanical Engineering, Stanford University
13 Moffat, R. J., 1982, 'Contributions to the Theory of Single-Sample Uncertainty Analysis,' Journal of Fluids Engineering, Vol. 104, June, pp. 250-260   DOI
14 Gillespie, D. R. H., 1996, 'Intricate Internal Cooling Systems for Gas Turbine Blading,' Doctor of Philosophy Thesis, University of Oxford
15 Hong, C. H., Yang, J. S., and Lee, K. B., 2000, 'An Experimental Study on the Effects of the Boundary Layer and Heat Transfer by Vortex Interactions (I),' Journal of KSME(B), Vol. 24, No.2, pp. 288-297
16 Kwon, S. J., Yang, J. S. and Lee, B. K., 2002, 'The Experimental Study of the Interaction Between the Flow and Temperature Field and a Boundary Layer Due to a Variety of the Height of a Vortex Generator,' Journal of KSME(B), Vol. 26, No.1, pp. 82-93   과학기술학회마을   DOI