Browse > Article
http://dx.doi.org/10.7464/ksct.2019.25.4.329

Effects of Hexaaluminate Manufacturing on the Synthetic Time of Hydrothermal Synthesis Using Urea  

Kim, Seo Young (Graduate School of Energy Science and Technology, Chungnam National University)
Park, Ji Yun (Graduate School of Energy Science and Technology, Chungnam National University)
Rhee, Young Woo (Graduate School of Energy Science and Technology, Chungnam National University)
Publication Information
Clean Technology / v.25, no.4, 2019 , pp. 331-335 More about this Journal
Abstract
Interest in environmental pollution is increasing all over the world, and technology development to solve it is actively carried out. In areas where heat is used, especially, combustion is causing countless pollutants in the air environment. Combustion catalyst is a technology that reduces NOx and CO by lowering combustion temperature and enabling complete combustion. Traditional combustion catalysts are expensive and complex in the synthesis process using precious metal catalyst. In this study, hexaaluminate, a high-temperature combustion catalyst, was manufactured using urea, and the properties were investigated according to the synthesis time. The combustion performance and characteristics were evaluated using this catalyst. As the temperature increased, the changing methane conversion rate was shown in two patterns. The conversion rates for 1 hour, 9 hours, and 12 hours were similar, while the conversion rates for 3 hours and 6 hours showed similar patterns. Methane combustion performance increased rapidly as the synthesis time increased from 6 hours to 9 hours, whereas the temperature at T50 was approximately 745 ℃. The performance of the synthesized combustion catalyst for 9 hours was optimum as the NOx emission of this combustion catalyst was not present and the maximum emission of CO was 72 ppm.
Keywords
High temperature combustion catalyst; Hexaaluminate; Urea;
Citations & Related Records
Times Cited By KSCI : 1  (Citation Analysis)
연도 인용수 순위
1 Yin, F., Ji, S., Wu, P., Zhao, F., and Li, C., "Preparation, Characterization, and Methane Total Oxidation of $AAl_{12}O_{19}$ and $AMAl_{11}O_{19}$ Hexaaluminate Catalysts Prepared with Urea Combustion Method," J. Mol. Catal. A: Chem., 294, 27-36 (2008).   DOI
2 Park, J. Y., Jung, Y. S., and Rhee, Y. W., "Effects of Concentration of Precipitants and Aging Time on Synthesis of Mn-Substituted Barium Hexaaluminates by Homogeneous Precipitation," Korean Chem. Eng. Res., 56(3), 349-355 (2018).   DOI
3 Beguin, B., Garbowski, E., and Primet, M., "Stabilization of Alumina toward Thermal Sintering by Silicon Addition," J. Catal., 127(2), 595-604 (1991).   DOI
4 Groppi, G., Bellotto, M., Cristiam, C., Forzatti, P., and Villa, P. L., "Preparation and Characterization of Hexaaluminate-Based Materials for Catalytic Combustion," Appl. Catal. A: Gen., 104(2), 101-108 (1993).   DOI
5 Mao, C. F., and Vannice, M. A., "High Surface Area a-alumina. I.: Adsorption Properties and Heats of Adsorption of Carbon Monoxide, Carbon Dioxide, and Ethylene," Appl. Catal. A: Gen., 111(2), 151-173 (1994).   DOI
6 Romero, A., Jobbagy, M., Laborde, M., Baronetti, G., and Amadeo, N., "Ni(II)-Mg(II)-Al(III) Catalysts for Hydrogen Production from Ethanol Steam Reforming: Influence of the Mg Content," Appl. Catal. A: Gen., 470(30), 398-404 (2014).   DOI
7 Seo, Y. S., Jung, Y. S., Yoon, W. L., Jang, I. J., and Lee, T. W., "The Effect of Ni Content on a Highly Active Ni-$Al_2O_3$ Catalyst Prepared by the Homogeneous Precipitation Method," Int. J. Hydrogen Energy, 36, 94-102 (2011).   DOI
8 Roh, H. S., Jung, Y. S., Koo, K. Y., Jung, U. H., Seo. Y. S., and Yoon, W. L., "Steam Reforming of Methane over Highly Active and KOH-resistant $Ni/{\gamma}-Al_2O_3$ Catalysts for Direct Internal Reforming (DIR) in a Molten Carbonate Fuel Cell (MCFC)," Appl. Catal. A: Gen., 383(1-2), 156-160 (2010).   DOI
9 Cheng, H., Yue, B., Wang, X., Lu, X., and Ding, W, "Hydrogen Production from Simulated Hot Coke oven Gas by Catalytic Reforming over Ni/Mg(Al)O Catalysts," J. Nat. Gas. Chem., 18(2), 225-231 (2009)   DOI
10 Prefferle, L. D., and Prefferle, W. C., "Catalytically Stabilization Combustion," Catal. Rev. Sci. Eng., 29(2&3), 219-267 (1987).   DOI
11 Arai, H., Yamada, T., and Eguchi, K., "Catalytic Combustion of Methane over Perovskite-Type Oxides," Appl. Catal., 26, 265-276 (1986).   DOI
12 McCarty, J. G., and Wise, H., "Perovskites Catalyst for Methane Combustion", Catal. Today, 8, 231-248 (1990).   DOI
13 Machida, M., Eughi, K., and Arai, H., "Effect of Additives on the Surface Area of Oxide Supports for Catalytic Combustion," J. Catal., 103, 385-393 (1987).   DOI
14 Beguin, B., Garbowski, E., and Primet, M., "Stabilization of Alumina by Addition of Lanthanum," Appl. Catal., 75(1), 119-132 (1991).   DOI
15 Shishido, T., Yamamoto, Y., Morioka, H., TaKaKi, K., and TaKehira, K., "Active Cu/ZnO and Cu/ZnO/$Al_2O_3$ Catalysts Prepared by Homogeneous Precipitation Method in Steam Reforming of Methanol," Appl. Catal. A: Gen., 263, 249-253 (2004).   DOI
16 Bell T. E., Gonzalez-Carballo J. M., Tooze R. P., and Torrente-Murciano L., "${\gamma}-Al_2O_3$ nanorods with tuneable dimensions - a mechanistic understanding of their hydrothermal synthesis," RSC. Adv., 7, 22369-22377 (2017).   DOI
17 Machida, M., Eguchi, K., and Arai, H., "Effect of Structural Modification on the Catalytic Property of Mn-Substituted Hexaaluminates," J. Catal., 123(2) 477-485 (1990).
18 Maeda, K., Mizukami, F., Watanabe, M., Arai, N., Toba, M., and Shimizu, K., "Synthesis of Thermostable High-Surface-Area Alumina for Catalyst Support," J. Mater. Sci. Lett., 9(5), 522-523 (1990).   DOI
19 Serantoni M., Costa, A. L., Zanelli, C., and Esposito, L., "Crystallization Behaviour of Yb-doped and Undoped YAG Nanoceramics Synthesized by Microwave-Assisted urea Precipitation," Ceram. Int., 40(8), 11837-11844 (2014).   DOI
20 Bernhard, A. M., Peitz, D., Elsener, M., Wokaun, A., and Krocher, O., "Hydrolysis and Thermolysis of Urea and Its Decomposition Byproducts Biuret Cyanuric Acid and Melamine over Anatase $TiO_2$," Appl. Catal. B: Environ., 115, 129-137 (2012).
21 Chen B.,, Wang J. X., Wang D., Zeng X. F., Clarke S. M., and Chen J. F., "Synthesis of Transparent Dispersions of Aluminium Hydroxide Nanoparticles," J. Nanotechnol, 29(305605), 1-7 (2018).
22 Mishra, D., Anand, S., Panda, R. K., and Das, R. P., "Preparation of Barium Hexa-Aluminate through a Hydrothermal Precipitation-Calcination Route and Characterization of Intermediate and Final Products," Mater. Lett., 56(6), 873-879 (2002).   DOI
23 Mishra, D., Anand, S., Panda, R. K., and Das, R. P., "Studies on Characterization, Microstructures and Magnetic Properties of Nano-Size Barium Hexa-Ferrite Prepared through a Hydrothermal Precipitation-Calcination Route," Mater. Chem. Phys., 86(1), 132-136 (2004).   DOI
24 Mohapatra, M., Pattanaik, D. M., Anand, S., and Das, R. P., "Effect of Barium to Aluminium Ratio on Phases Leading to Barium Aluminates," Ceram. Int., 33(4), 531-535 (2007).   DOI