|
1 |
Die Stress Reduction Design and Mechanical Properties Analysis of Warm Forging Process for the Application of Warm-Closed Forging of Automative Steering Unit Yoke
Seong, S.G.;Kim, K.H.;Lee, Y.S.;Lee, S.Y.;Yoon, E.Y.;
/
The Korean Society for Technology of Plasticity and materials processing
, v.31, no.2, pp.51-56,
|
|
2 |
A Study on the Forming Process of High-strength Aluminum Sheet for Electric Vehicle Heat Exchanger Separator Through Parametric Analysis
Jung, S.H.;Yang, J.H.;Kim, Y.B.;Lee, K.J.;Kim, B.H.;Lee, J.S.;Bae, G.H.;
/
The Korean Society for Technology of Plasticity and materials processing
, v.31, no.2, pp.57-63,
|
|
3 |
Correlation Between Tensile-compressive Behavior and Formability of Al7050 Alloy
Bae, D.H.;Oh, J.H.;Jeong, C.;Kim, J.G.;
/
The Korean Society for Technology of Plasticity and materials processing
, v.31, no.2, pp.64-72,
|
|
4 |
Microstructure and Mechanical Properties of Very-high-speed Extruded Mg-Bi-Al-Mn Alloy
Cha, J.W.;Jin, S.C.;Park, S.H.;
/
The Korean Society for Technology of Plasticity and materials processing
, v.31, no.2, pp.73-80,
|
|
5 |
Estimating Strain Rate Dependent Parameters of Cowper-Symonds Model Using Electrohydraulic Forming and Artificial Neural Network
Byun, H.B.;Kim, J.;
/
The Korean Society for Technology of Plasticity and materials processing
, v.31, no.2, pp.81-88,
|
|
6 |
A Study on Tensile Strength According to Various Output Conditions of PLA+ Materials Using 3D Printing
Na, D.H.;Kim, S.G.;
/
The Korean Society for Technology of Plasticity and materials processing
, v.31, no.2, pp.89-95,
|
|
7 |
Multi-point Dieless Forming Technology Using Local Heating Effect
Park, J.W.;
/
The Korean Society for Technology of Plasticity and materials processing
, v.31, no.2, pp.96-102,
|
|
8 |
A Study on the Prediction of Die Wear Based on Piezobolt Sensor Measurement Data in the Trimming Process of an Automobile Part
Kwon, O.D.;Moon, H.B.;Kang, G.P.;Lee, K.;Hur, M.C.;
/
The Korean Society for Technology of Plasticity and materials processing
, v.31, no.2, pp.103-108,
|
|