DOI QR코드

DOI QR Code

A study on transport and plugging of sodium aerosol in leak paths of concrete blocks

  • Sujatha Pavan Narayanam (Environmental Assessment Division, Safety, Quality & Resource Management Group, Indira Gandhi Centre for Atomic Research) ;
  • Soubhadra Sen (Environmental Assessment Division, Safety, Quality & Resource Management Group, Indira Gandhi Centre for Atomic Research) ;
  • Kalpana Kumari (Civil Engineering Group, IGCAR) ;
  • Amit Kumar (Homi Bhabha National Institute, Training School Complex) ;
  • Usha Pujala (Homi Bhabha National Institute, Training School Complex) ;
  • V. Subramanian (Homi Bhabha National Institute, Training School Complex) ;
  • S. Chandrasekharan (Environmental Assessment Division, Safety, Quality & Resource Management Group, Indira Gandhi Centre for Atomic Research) ;
  • R. Preetha (Civil Engineering Group, IGCAR) ;
  • B. Venkatraman (Environmental Assessment Division, Safety, Quality & Resource Management Group, Indira Gandhi Centre for Atomic Research)
  • Received : 2023.04.07
  • Accepted : 2023.09.13
  • Published : 2024.01.25

Abstract

In the event of a severe accident in Sodium Cooled Fast Reactors (SFR), the sodium combustion aerosols along with fission product aerosols would migrate to the environment through leak paths of the Reactor Containment Building (RCB) concrete wall under positive pressure. Understanding the characteristics of sodium aerosol transport through concrete leak paths is important as it governs the environmental source term. In this context, experiments are conducted to study the influence of various parameters like pressure, initial mass concentration, leak path diameter, humidity etc., on the transport and deposition of sodium aerosols in straight leak paths of concrete. The leak paths in concrete specimens are prepared by casting and the diameter of the leak path is measured using thermography technique. Aerosol transport experiments are conducted to measure the transported and plugged aerosol mass in the leak paths and corresponding plugging times. The values of differential pressure, aerosol concentration and relative humidity taken for the study are in the ranges 10-15 kPa, 0.65-3.04 g/m3 and 30-90% respectively. These observations are numerically simulated using 1-Dimensional transport equation. The simulated values are compared with the experimental results and reasonable agreement among them is observed. From the safety assessment view of reactor, the approach presented here is conservative as it is with straight leak paths.

Keywords

Acknowledgement

The authors acknowledge Dr. Sharat D, SO/D and Menaka, Head, RAMS, RESD for measurement of leak path diameter in concrete sample using thermography. The authors sincerely acknowledge Dr. C.V. Srinivas, Head, EAD for useful scientific discussions which helped in the improvement of the manuscript.

References

  1. L.R. Bishnoi, R.P. Vedula, Prediction of air leakage and aerosol transport through concrete cracks with a fractal based crack morphology model, Nucl. Eng. Des. 265 (December) (2013) 393-401. https://doi.org/10.1016/j.nucengdes.2013.06.032
  2. D. Mitrakos, S. Chatzidakis, E.P. Hinis, L.E. Herranz, F. Parozzi, C. Housiadas, A simple mechanistic model for particle penetration and plugging in tubes and cracks, Nucl. Eng. Des. 238 (2008) 3370-3378. https://doi.org/10.1016/j.nucengdes.2008.07.002
  3. PFBR Preliminary safety analysis report, PFBR-PSAR. Chapter 15-Engineered Safety Features to Mitigate Accidents, 2004.
  4. F. Parozzi, D.J. Eduardo, Christophe Journeau Caracciolo, Piluso Pascal, Investigation on aerosol transport in containment cracks, in: International Conference on Nuclear Energy for New Europe, Bovec, Slovenia, September 12-15, 2011.
  5. T. Gelain, J. Vendel, Research works on contamination transfers through cracked concrete walls, Nucl. Eng. Des. 238 (2008) 1159-1165. https://doi.org/10.1016/j.nucengdes.2007.08.007
  6. C.T. Nelson, R.P. Johnson, Aerosol Leakage Tests, Status of Safety Technology for Radiological Consequences of Postulated Accidents in Liquid Metal Fast Breeder Reactors, Energy Resources and Development Administration, 1975. ERDA-56.
  7. S.L. Sutter, J.W. Johnston, J. Mishima, P.E. Owzarski, L.C. Schwendiman, G. B. Long, Depleted uranium dioxide powder flow through very small openings, Nucl. Technol. 52 (1981) 100-104. https://doi.org/10.13182/NT81-A32693
  8. J.P. Mitchell, R.T. Edwards, M.A.E. Ball, The penetration of aerosols through fine capillaries, RAMTRANS 1 (3) (1990) 101-106. https://doi.org/10.1179/rmt.1990.1.2.101
  9. A.C. Burton, J.P. Mitchell, D.A.V. Morton, The influence of pressure on the penetration of aerosol through fine capillaries, J. Aerosol Sci. 24 (suppl. 1) (1993) s559-s560. https://doi.org/10.1016/0021-8502(93)90372-G
  10. D.A.V. Morton, J.P. Mitchell, Aerosol penetration through capillaries and leaks: experimental studies on the influence of pressure, J. Aerosol Sci. 26 (1995) 353-367. https://doi.org/10.1016/0021-8502(94)00093-E
  11. D.A.V. Morton, B.M. North, J.P. Mitchell, Aerosol leakage through short capillaries, J. Aerosol Sci. 23 (suppl. 1) (1992) S27-S30. https://doi.org/10.1016/0021-8502(92)90340-2
  12. S. Lewis, Solid particle penetration into enclosures, J. Hazard Mater. 43 (1995) 195-216. https://doi.org/10.1016/0304-3894(95)00037-U
  13. R.B. Mosley, D.J. Greenwell, L.E. Sparks, Z. Guo, W.G. Tucker, R. Fortmann, C. Whitfield, Penetration of ambient fine particles into the indoor environment, Aerosol Sci. Technol. 34 (1) (2001) 127-136. https://doi.org/10.1080/02786820117449
  14. J.P. Mitchell, I.A. Marshall, L.J. Latham, M.H.E. Ball, The Penetration of Aerosols through Fine Orifices, RAMTRANS, 1992, pp. 5-17.
  15. D.-L. Liu, W.W. Nazaroff, Particle penetration through building cracks, Aerosol. Sci. Technol. 37 (2003) 565-573. https://doi.org/10.1080/02786820300927
  16. A. Li, T. Ren, C. Yang, Study on particle penetration through straight, L, Z and wedge-shaped cracks in buildings, Build. Environ. 114 (2017) 333-343. https://doi.org/10.1016/j.buildenv.2016.12.024
  17. A.C.K. Lai, J.L.S. Fung, M. Li, K.Y. Leung, Penetration of fine particles through rough cracks, Atmos. Environ. 60 (2012) 436-443. https://doi.org/10.1016/j.atmosenv.2012.06.053
  18. E.U. Vaughan, Simple model of plugging of ducts by aerosol deposits, Trans. ANS 22 (1978) 507.
  19. H.A. Morewitz, Leakage of aerosol from containment buildings, Health Phys. 42 (1982) 195.
  20. M.M.R. Williams, Particle deposition and plugging in tubes and cracks (with special reference to fission product retention), Prog. Nucl. Energy 28 (1994) 1-60. https://doi.org/10.1016/0149-1970(94)90015-9
  21. C.F. Clement, Aerosol penetration through capillaries and leaks: theory, J. Aerosol Sci. 26 (1995) 369-385. https://doi.org/10.1016/0021-8502(94)00128-L
  22. V. Subramanian, P. Sahoo, N. Malathi, R. Anathanarayanan, R. Baskaran, B. Saha, Studies on chemical speciation of sodium aerosols produced in sodium fire, Nucl. Technol. 165 (2009) 257-269. https://doi.org/10.13182/NT09-A4100
  23. P.N. Sujatha, Kumar Amit, Soubhadra Sen, Usha Pujala, V. Subramanian, C. V. Srinivas, R. Baskaran, Experimental measurements and theoretical simulation of sodium combustion aerosol leakage through capillaries, Prog. Nucl. Energy 18 (January 2020), 103111, https://doi.org/10.1016/j.pnucene.2019.103111.a.
  24. IS 456:2000, Indian Standard- Plain and Reinforced Concrete- Code of Practice (Fourth Revision), Bureau of Indian Standard, New Delhi, 2000.
  25. IS 8112:2013, Indian Standard-Ordinary Portland Cement, 43 Grade- Specification (Second Revision), Bureau of Indian Standard, New Delhi, 2013.
  26. IS 1199: 2018, Fresh Concrete - Methods of Sampling, Testing and Analysis. Part 1 Sampling of Fresh Concrete (First Revision), Bureau of Indian Standard, New Delhi, 2018.
  27. V. Subramanian, R. Baskaran, Initial size distribution of sodium combustion aerosols, Nucl. Technol. 160 (2007) 308.
  28. R. Baskaran, T.S. Selvakumaran, V. Subramanian, Aerosol test facility for fast reactor safety studies, Indian J. Pure Appl. Phys. 42 (2004) 873-878.
  29. P.N. Sujatha, Kumar Amit, V. Subramanian, R. Baskaran, Effect of Pressure on Sodium Aerosol Leakage through Capillaries, IASTA-2016, 6-8 Dec., 2016, PRL, Ahmedabad, 2016.
  30. P.N. Sujatha, A. Kumar, U. Pujala, V. Subramanian, C.V. Srinivas, R. Venkatesan, et al., Theoretical simulation on evolution of suspended sodium combustion aerosols characteristics in a closed chamber, Nucl. Eng. Technol. (2021), https://doi.org/10.1016/j.net.2021.12.029, 0-6.
  31. J.G. Crump, Richard C. Flagan, John H. Seinfeld, Particle wall loss rates in vessels, Aerosol. Sci. Technol. 2 (3) (1982) 303-309. https://doi.org/10.1080/02786828308958636
  32. M. Tian, H. Gao, X. Han, Y. Wang, R. Zou, Experimental study on the penetration efficiency of fine aerosols in thin capillaries, J. Aerosol Sci. 111 (2017) 26-35. https://doi.org/10.1016/j.jaerosci.2017.06.001
  33. A. Kumar, V. Subramanian, R. Baskaran, B. Venkatraman, Size evolution of sodium combustion aerosol with various RH, Aerosol Air Qual. Res. 15 (2015) 2270-2276. https://doi.org/10.4209/aaqr.2015.03.0150
  34. K.M. Haneefa, M. Santhanam, F.C. Parida, Review of concrete performance atelevated temperature and hot sodium exposure applications in nuclear industry, Nucl. Eng. Des. 258 (2013) 76-88. https://doi.org/10.1016/j.nucengdes.2013.01.018
  35. T.C. Chawla, D.R. Pederesen, A review of modeling concepts for sodium-concrete reactions and a model for liquid sodium transport to the unreacted concrete surface, Nucl. Eng. Des. 88 (1985) 85-91. https://doi.org/10.1016/0029-5493(85)90047-0