Journal of the Korean Geosynthetics Society (한국지반신소재학회논문집)

Korean Geosynthetics Society (한국지반신소재학회)
권호 표지
DOI QR코드

DOI QR Code

A Study on the Load Sharing Ratio and the Settlement of Prebored Open-Ended Steel Pipe Piles

매입 개단 강관말뚝의 하중분담률과 침하량 분석 연구

  • Received : 2022.12.16
  • Accepted : 2023.03.20
  • Published : 2023.03.30
Download PDF
⟨ Previous Next ⟩

Abstract

The bearing capacity of the prebored pile has been studied by many researchers. However, The bearing capacity of the prebored pile has been studied by many researchers. However, comparative studies between design data and pile load test data on the load sharing ratio and the settlement were insignificant. Therefore, the design data and the static load test results were compared for the prebored open-end steel piles. In the compressive static pile load test, the load sharing ratios of the base resistance and the shaft resistance were 13%~40% and 60%~87%, respectively and the settlements were measured 2.2mm~4.7mm. In the current bearing capacity calculation formula, the base resistance was shared between 54% and 75%, and the shaft resistance was shared between 25% and 46% and the settlements were calculated about 19.8mm~23.6mm. The settlement in the current bearing capacity calculation formula was 321% to 776% (average : 445%) larger than the settlement in the result of load test. When the settlement were calculated using the load sharing ratio in the pile load tests, it was 137% to 525% larger than the test settlement, and it was as large as 204% on average. It was confirmed that an appropriate evaluation of the load sharing ratio had an important effect on the calculation of pile settlement.

매입말뚝의 지지력은 많은 연구자들에 의해 연구되었다. 하지만 하중분담률과 침하량에 대하여 설계 자료와 말뚝재하시험 지료를 비교한 연구는 미미하였다. 그래서 매입 개단 강관말뚝에 대하여 설계식 자료와 정재하시험 결과를 비교하였다. 압축재하시험에서는 선단지지하중과 주면마찰하중의 분담률이 각각 13%~40%, 60%~87%로 나타났고, 이때의 침하량은 2.2mm~4.7mm로 측정되었다. 현행 지지력 산정식에서는 선단지지력과 주면마찰력이 각각 54%~75%, 25%~46%를 분담하는 것으로 나타났고, 침하량은 19.8mm~23.6mm로 계산되었다. 현행지지력 산정식에서의 침하량은 시험에서의 침하량보다 321%~776% 만큼 크게 나타났으며, 평균적으로 445%만큼 크게 나타났다. 말뚝재하시험에서의 하중분담률을 이용하여 침하량을 산정하면, 시험 침하량보다 137%~525% 만큼 크게 나타났으며, 평균적으로 204% 만큼 크게 나타났다. 하중분담률의 적절한 평가는 말뚝 기초의 침하량 산정에 중요한 영향을 미치는 것으로 확인되었다.

Keywords

References

  1. Architectural Institute of Korea (2005), Design Standards for Building Foundation Structure. (in Korean)
  2. Das, B. M. (1999), Principles of Foundation Engineering, 4th ed, PWS, Boston, USA, pp.615-617.
  3. Hong, W. P, and Chai, S. G. (2003), "Skin Friction Capacity of SDA Pile", Proc, of 13th Int, Offshore and Polar Engineering Conf., Hawaii, USA, pp.740-745.
  4. Hong, W. P. and Chai, S. G. (2005), "Bearing Capacity of the SDA Pile in Cohesive Soil", Proc, of 15th Int, Offshore and Polar Engineering Conf., Seoul, Korea, pp.548-554.
  5. Jeong, S. and Kim, D. (2018), "Estimation of the Load Sharing Ratio of Pre-installed Columns in Top-down Buildings on Korean Rock", KSCE Journal of Civil Engineering, Vol.22, No.12, pp.4852-4861. https://doi.org/10.1007/s12205-017-1102-z
  6. Jung, G., Kim, D., Lee, C. and Jeong, S. (2017a), "Analysis of Skin Friction behavior in Prebored and Precast Piles based on Field Loading Test", Journal of Korean Geotechnical Society, Vol.33, pp.31-38.
  7. Jung, G. J., Nam, M. S., Park, Y. H., Jo, S. M. and An, J. H. (2017b), Development of limit state design method for prebored and precast pile, Publication No. KECRI-2017-41-534.9607, Expressway & Transportation Research Institute, Gyeonggi-do, Korea, pp.58-87.
  8. Kim, D., Park, J., Chang, Y. and Jeong, S. (2018), "Proposed Shear Load-transfer Curves for Prebored and Precast Steel Piles", Journal of the Korean Geotechnical Society, Vol.34, No.12, pp.43-58. https://doi.org/10.7843/KGS.2018.34.12.43
  9. Kim, J. S. (2003), A Study on the Estimation of Bearing Capacity of SIP Pile embedded in Weathered-Granite Layer, Ph.D Thesis, Hanyang Univ.
  10. Korea Land and Housing Corporation (2008), Improvement of Pile foundation design. (in Korean)
  11. Korean Geotechnical Society (2018), Standards for Foundation Design of Structures. (in Korean)
  12. Korean Society of Civil Engineers (2008), Design Standards Commentary for Road Bridge. (in Korean)
  13. Kwon, O. K., Nam, M. S., Lee, W. J., Yea, G. G. and Choi, Y. K. (2019), "Study(VII) on Development of Charts and Equations Predicting Bearing Capacity for Prebored PHC Piles Socketed into Weathered Rock through Sandy Soil Layers - Allowable Axial Compressive Bearing Capacity Formulae -", Journal of Korean Geotechnical Society, Vol.35, No.12, pp.69-99.
  14. Lee, I. M. (2014), Principle of foundation engineering, CIR, p.125. (in Korean)
  15. Lee, S. W., Yoon, M. S. and Kim, M. H. (2011), "A study on correlation between SPT N value and unit side resistance", Korea Geotechnical Society Fall National Conference, Ghuncheon, Gangwon University, pp.541-548.
  16. Lee, W. J. (2000), Measurement of pile load transfer using fiber-optic sensor and characteristics of bored precast pile bearing capacity, Ph.D Thesis, Korea Univ.
  17. Nam, M. S., Kwon, O. K., Park, M. C., Lee, C. U. and Choi, Y. K. (2019), "A Study(VI) on the Development of Charts and Equations Predicting Bearing Capacity for Prebored PHC Piles Socketed into Weathered Rock through Sandy Soil Layers - Axial Compressive Bearing Capacity Prediction Table Solution or Chart Solution -", Journal of Korean Geotechnical Society, Vol.35, No.11, pp.75-95.
  18. Ng, C., Zhang, L. and Nip, D. (2001), "Response of Laterally Loaded Large-Diameter Bored Pile Groups", ASCE Journal of Geotechnical and Geoenvironmental Engineering, Vol.127, No.8, pp.658-669. https://doi.org/10.1061/(ASCE)1090-0241(2001)127:8(658)
  19. Park, J. J., Kim, D. H., Jung, G. J. and Jeong, S. S. (2021), "An Empirical Formula of Bearing Capacity on Prebored and Precast Steel Piles", Journal of Korean Geotechnical Society, Vol.37, No.6, pp.5-20.
  20. Park, M. C., Kwon, O. K., Kim, C. M., You, D. K., and Choi, Y. K. (2019), "Study(V) on Development of Charts and Equations Predicting Allowable Compressive Bearing Capacity for Prebored PHC Piles Socketed into Weathered Rock through Sandy Soil Layers - Analysis of Results and Data by Parametric Numerical Analysis -", Journal of Korean Geotechnical Society, Vol.35, No.10, pp.47-66.
  21. Tomlinson, M. J. (1994), Pile design and construction practice, 4th ed., E & FN Spon., London, U.K., pp.133-134.
  22. Vesic, A. S. (1977), Design of pile foundations, National Cooperative Highway Research Program, Synthesis of Highway Practice 42, Transportation Research Board, National Research Council, Washington, D. C. pp.26-33.
  23. Yoon, M. S., Lee, C. K. and Kim, M. H. (2013), "Evaluation of Unit Side Resistance of Drilled Shafts by Revised SPT N Value", Journal of Korean Geotechnical Society, Vol.29, No.12, pp.5-10.  https://doi.org/10.7843/kgs.2013.29.12.5