DOI QR코드

DOI QR Code

Experimental investigation on bolted rock mass under static-dynamic coupled loading

  • Qiu, Pengqi (College of energy and mining engineering, Shandong University of Science and Technology) ;
  • Wang, Jun (College of energy and mining engineering, Shandong University of Science and Technology) ;
  • Ning, Jianguo (College of energy and mining engineering, Shandong University of Science and Technology) ;
  • Shi, Xinshuai (College of energy and mining engineering, Shandong University of Science and Technology) ;
  • Hu, Shanchao (College of energy and mining engineering, Shandong University of Science and Technology)
  • Received : 2021.04.26
  • Accepted : 2022.01.25
  • Published : 2022.04.25

Abstract

Instability of bolted rock mass has been a major hazard in the underground coal mining industry for decades. Developing effective support guidelines requires understanding of complex bolted rock mass failure mechanisms. In this study, the dynamic failure behavior, mechanical behavior, and energy evolution of a laboratory-scale bolted specimens is studied by conducting laboratory static-dynamic coupled loading tests. The results showed that: (1) Under static-dynamic coupled loading, the stress-strain curve of the bolted rock mass has a significant impact velocity (strain rate) correlation, and the stress-strain curve shows rebound characteristics after the peak; (2) There is a critical strain rate in a rock mass under static-dynamic coupled loading, and it decreases exponentially with increasing pre-static load level. Bolting can significantly improve the critical strain rate of a rock mass; (3) Compared with a no-bolt rock mass, the dissipation energy ratio of the bolted rock mass decreases exponentially with increasing pre-static load level, the ultimate dynamic impact energy and dissipation energy of the bolted rock mass increase significantly, and the increasing index of the ratio of dissipation energy increases linearly with the pre-static load; (4) Based on laboratory testing and on-site microseismic and stress monitoring, a design method is proposed for a roadway bolt support against dynamic load disturbance, which provides guidance for the design of deep underground roadway anchorage supports. The research results provide new ideas for explaining the failure behavior of anchorage supports and adopting reasonable design and construction practices.

Keywords

Acknowledgement

The research described in this paper was financially supported by National Key R&D Program of China (no. 2018YFC0604703); National Natural Science Foundation of China (no. 52074170, 52074166, 51904163); Youth Foundation of Natural Science Foundation of Shandong Province (no. ZR2019QEE002, ZR2017BEE013). The authors express sincere thanks to the reviewers for their helpful comments and suggestions for improving this paper.

References

  1. Ai, D., Zhao, Y., Wang, Q. and Li, C. (2019), "Experimental and numerical investigation of crack propagation and dynamic properties of rock in SHPB indirect tension test", Int. J. Impact En., 126, 135-146. https://doi.org/10.1016/j.ijimpeng.2019.01.001.
  2. Ali, M. and Fatemeh, T. (2013), "A numerical study of the behavior of fully grouted rockbolts under dynamic loading", Soil Dyn. Earthq. Eng., 54, 66-72. https://doi.org/10.1016/j.soildyn.2013.08.003.
  3. Aydan, O. (2019), "Dynamic response of support systems during excavation of underground openings", J. Rock Mech. Geotech., 11, 954-964. https://doi.org/10.1016/j.jrmge.2019.06.002.
  4. Chang, X., Li, Z., Wang, S., Wang, S., Fu, L. and Tang, C. (2018), Pullout performances of grouted rockbolt systems with bond defects", Rock Mech. Rock Eng., 51, 861-871. https://doi.org/10.1007/s00603-017-1373-1.
  5. Chang, X., Wang, G., Liang, Z., Yang, J. and Tang, C. (2017), "Study on grout cracking and interface debonding of rockbolt grouted system", Constr. Build. Mater., 135, 665-673. https://doi.org/10.1016/j.conbuildmat.2017.01.031.
  6. Chen, F., Tang, C., Sun, X., Ma, T. and Du, Y. (2019), "Supporting characteristics analysis of constant resistance bolts under coupled static-dynamic loading", J. Mountain Sci., 16(5), 1160-1169. https://doi.org/CNKI:SUN:SDKB.0.2019-05-015. https://doi.org/10.1007/s11629-018-5044-9
  7. Du, H., Dai, F., Xu, Y., Liu, Y., Xu, Y., Liu, Y. and Xu, H. (2018), "Numerical investigation on the dynamic strength and failure behavior of rocks under hydrostatic confinement in SHPB testing", Int. J. Rock Mech. Min. Sci., 108, 43-57. https://doi.org/10.1016/j.ijrmms.2018.05.008.
  8. Eremenko, A., Mashukov, I. and Eremenko, V. (2017), "Geodynamic and seismic events under rockburst-hazardous block caving in Gornaya Shoria", J. Min. Sci., 53(1), 65-70. https://doi.org/10.1134/s1062739117011859.
  9. Faham, T., Zhang, C., Ismet, C., Onur, V. and Serkan, S. (2018), "Numerical and analytical simulation of the structural behaviour of fully grouted cable bolts under impulsive loading", Int. J. Min. Sci. Technol., 28, 807-811. https://doi.org/10.1016/j.ijmst.2018.08.012.
  10. Feng, J., Wang, E., Chen, X. and Ding, H. (2018), "Energy dissipation rate: An indicator of coal deformation and failure under static and dynamic compressive loads", Int. J. Min. Sci. Technol., 28(3), 397-406. https://doi.org/10.1016/j.ijmst.2017.11.006.
  11. Field, J., Walley, S., Proud, W., Goldrein, H. and Siviour, C. (2004), "Review of experimental techniques for high rate deformation and shock studies", Int. J. Impact Eng., 30(7), 725-775. https://doi.org/10.1016/s0734-743x(04)00052-1.
  12. Freeman, T.J. (1978), "The behavior of fully bonded rock bolts in the kielder experimental tunnel", Tunn. Tunnelling, 10(5), 37-40. https://doi.org/10.1016/0148-9062(78)91073-2.
  13. Frid, V. (2001), "Calculation of electromagnetic radiation criterion for rockburst hazard forecast in coal mines", Pure Appl. Geophys., 158(5), 931-944. https://doi.org/10.1007/pl00001214.
  14. Fu, Y., Sun, Z. and Ju, W. (2019), "Experimental study on static and dynamic mechanical properties of bolting wire mesh in rock burst roadway", J. China Coal Soc., 44(7), 2020-2029. https://doi.org/10.13225/j.cnki.jccs.2018.1392.
  15. Gracaecosta, R., Alfaiate, J., Diasdacosta, D., Neto, P. and Sluys, J. (2013), "Generalisation of non-iterative methods for the modelling of structures under non-proportional loading", Int. J. Fracture, 182(1), 21-38. https://doi.org/10.1007/s10704-013-9851-2.
  16. He, M., Ren, F. and Liu, D. (2018), "Rockburst mechanism research and its control", Int. J. Min. Sci. Technol., 28, 829-837. https://doi.org/10.1016/j.ijmst.2018.09.002.
  17. Hosseini, N. (2017), "Evaluation of the rockburst potential in longwall coal mining using passive seismic velocity tomography and image subtraction technique", J. Seismology, 21(5), 1101-1110. https://doi.org/10.1007/s10950-017-9654-4.
  18. Kang, H., Yang, J., Gao, F. and Li, J. (2020). "Experimental study on the mechanical behavior of rock bolts subjected to complex static and dynamic loads", Rock Mech. Rock Eng., 53(11), 4993-5004. https://doi.org/10.1007/s00603-020-02205-0.
  19. Kozyrev, A., Panin, V., Semenova, I. and Zhuravleva, O. (2018), "Geodynamic safety of mining operations under rockburst-hazardous conditions in the Khibiny apatite eeposits", J. Min. Sci., 54(5), 734-743. https://doi.org/10.15372/ftprpi20180504.
  20. Ning, J., Qiu, P., Yang, S., Shen, Z., Li, Z. and Wang, J. (2020), "Damage mechanism and support of surrounding rock anchorage structure of deep large section chamber under static-dynamic coupling loading", J. Min. Saf. Eng., 37(1), 50-61. https://doi.org/10.13545/j.cnki.jmse.2020.01.006.
  21. Ning, J., Wang, J., Tan, Y. and Xu, Q. (2020), "Mechanical mechanism of overlying strata breaking and development of fractured zone during close-distance coal seam group mining", Int. J. Min. Sci. Technol., 30(2), 207-215. https://doi.org/CNKI:SUN:ZHKD.0.2020-02-008. https://doi.org/10.1016/j.ijmst.2019.03.001
  22. Peng, K., Liu, Z., Zou, Q., Zhang, Z. and Zhou, J. (2019), "Static and dynamic mechanical properties of granite from various burial depths", Rock Mech. Rock Eng., 52(10), 3345-3566. https://doi.org/10.1007/s00603-019-01810-y.
  23. Sabetamal, H., Nazem, M., Carter, J. and Sloan, S. (2014), "Large deformation dynamic analysis of saturated porous media with applications to penetration problems", Comput. Geotech., 55, 117-131. https://doi.org/10.1016/j.compgeo.2013.08.005.
  24. Vandermaat, D., Saydam, S., Hagan, P. and Crosky, A. (2016), "Examination of rockbolt stress corrosion cracking utilising full size rockbolts in a controlled mine environment", Int. J. Rock Mech Min. Sci., 81, 86-95. https://doi.org/10.1016/j.ijrmms.2015.11.007.
  25. Wang, A., Gao, Q., Dai, L., Pan, Y., Zhang, J. and Chen, J. (2018), "Static and dynamic performance of rebar bolts and its adaptability under impact loading", J. China Coal Soc., 43(11), 2999-3006. https://doi.org/10.13225/j.cnki.jccs.2018.8020.
  26. Wang, B., Li, X., Ma, C. and Fan, B. (2014), "Principle and preliminary application of combined static-dynamic support to rockburst disaster controlling", Chinese J. Rock Mech. Eng., 33(6), 1169-1178. https://doi.org/CNKI:SUN:YSLX.0.2014-06-010. https://doi.org/10.3901/CJME.2014.0707.118
  27. Wang, W., Song, Q., Xu, C. and Gong, H. (2018), "Mechanical behaviour of fully grouted GFRP rock bolts under the joint action of pre-tension load and blast dynamic load", Tunn. Undergr. Sp. Tech., 73, 82-91. https://doi.org/10.1016/j.tust.2017.12.007.
  28. Wu, Q., Chen, L., Shen, B., Dlamini, B., Li, S. and Zhu, Y. (2019a), "Experimental investigation on rockbolt performance under the tension load", Rock Mech. Rock Eng., 52, 4605-4618. https://doi.org/10.1007/s00603-019-01845-1.
  29. Wu, Q., Zhao, F., Wang, S., Zhou, Z., Wang, B. and Li, Y. (2019b), "Mechanical response characteristics of full grouted rock boltssubjected to dynamic loading", Rock Soil Mech., 40(3), 942-950. https://doi.org/10.16285/j.rsm.2017.1831.
  30. Wu, Y., Chen, J., Jiao, J., Zheng, Y. and He, J. (2018), "Damage and failure mechanism of anchored surrounding rock with impact loading", J. China Coal Soc., 43(9), 2389-2397. https://doi.org/10.13225/j.cnki.jccs.2018.0415.
  31. Yu, S., Zhu, W., Niu, L., Zhou, S. and Kang, P. (2019), "Experimental and numerical analysis of fully grouted long rockbolt load-transfer behavior", Tunn. Undergr. Sp. Tech., 85, 56-66. https://doi.org/10.1016/j.tust.2018.12.001.
  32. Zhu, W., Jing, H., Yang, L., Pan, B. and Su, H. (2018), "Strength and deformation behaviors of bedded rock mass under bolt reinforcement", Int. J. Min. Sci. Technol., 28(4), 593-599. https://doi.org/10.1016/j.ijmst.2018.03.006.