DOI QR코드

DOI QR Code

Analysis of beam-column joints reinforced with SMAs under monotonous loading with existence of transverse beam

  • Halahla, Abdulsamee M. (Department of Civil Engineering, Palestine Polytechnic University) ;
  • Tahnat, Yazan B. Abu (Department of Civil and Water Engineering, Laval University) ;
  • Dwaikat, Monther B. (Department of Building Engineering, An-Najah National University)
  • 투고 : 2019.11.14
  • 심사 : 2022.02.12
  • 발행 : 2022.03.25

초록

Beam-column joints (BCJs) are recognized among the most crucial zones in reinforced concrete structures, as they are the critical elements subjected to a complex state of forces during a severe earthquake. Under such conditions, BCJs exhibit behaviors with impacts that extend to the whole structure and significantly influence its ductility and capability of dissipating energy. The focus of this paper is to investigate the effect of undamaged transverse beam (secondary beams) on the ductility of concrete BCJs reinforced with conventional steel and shape memory alloys bars using pushover analysis at tip of beam under different axial load levels at the column using a nonlinear finite element model in ABAQUS environment. A numerical model of a BCJ was constructed and the analysis outcomes were verified by comparing them to those obtained from previous experiments found in the literature. The comparison evidenced the capability of the calibrated model to predict the load capacity response of the joint. Results proved the ability of undamaged secondary beams to provide a noticeable improvement to the ductility of reinforced concrete joints, with a very negligible loss in load capacity. However, the effect of secondary beams can become less significant if the beams are damaged due to seismic effects. In addition, the axial load was found to significantly enhance the performance of BCJs, where the increase in axial load magnified the capacity of the joint. However, higher values of axial load resulted in greater initial stiffness of the BCJ.

키워드

참고문헌

  1. ABAQUS (2014), Standard Analysis User's Manual v14.2, SIMULIA.
  2. Abdulsamee, H. (2014), Modeling of Cyclic Behavior of Retrofitted Reinforced Concrete Beam-Column Joint, Ph.D. Dissertation, King Fahd University of Petroleum and Minerals, Saudi Arabia.
  3. Abu Tahnat, Y.B., Dwaikat, M.M. and Samaaneh, M.A. (2018), "Effect of using CFRP wraps on the strength and ductility behaviors of exterior reinforced concrete joint", Compos. Struct., 201, 721-739. https://doi.org/10.1016/j.compstruct.2018.06.082.
  4. ACI Committee 318-14 (2014), Building Code Requirements for Structural Concrete, Detroit, Michigan: American Concrete Institute
  5. ACI Committee 363 (1992), State-of-the-Art Report on High Strength Concrete, Farmington Hills, Michigan, American Concrete Institute
  6. Alam M.S., Youssef M.A. and Nehdi M. (2007), "Seismic behaviour of concrete beam-column joints reinforced with superelastic shape meory alloys", Proceedings of the 9th Canadian Conference in Earthquake Engineering, ON, Canada, June.
  7. Asran, A.G., El-Esnawi, H.H. and Fayed, S.E. (2016), "Numerical investigation of RC exterior beam-column connections under monotonic loads", J. Mech. Civil Eng., 13(1), 60-67. https://doi.org/10.9790/1684-13166067.
  8. Chalioris, C.E. and Bantilas, K.E. (2017), "Shear strength of reinforced concrete beam-column joints with crossed inclined bars", Eng. Struct., 140, 241-255. https://doi.org/10.1016/j.engstruct.2017.02.072
  9. Eslami, A. and Ronagh, H.R. (2015), "Numerical investigation on the seismic retrofitting of RC beam-column connections using flange-bonded CFRP composites", J. Compos. Construct., 20(1), 04015032. https://doi.org/10.1061/(asce)cc.1943-5614.0000590.
  10. Favvata, M., Karayannis, C. and Liolios A., (2009), "Influence of exterior joint effect on the inter-story pounding interaction of structures", Struct. Eng. Mech., 33(2), 113-136, https://doi.org/10.12989/sem.2009.33.2.113.
  11. Halahla, A.M., Tahnat, Y.B.A., Almasri, A.H. and Voyiadjis, G.Z. (2019), "The effect of shape memory alloys on the ductility of exterior reinforced concrete beam-column joints using the damage plasticity model", Eng. Struct., 200, 109676. https://doi.org/10.1016/j.engstruct.2019.109676.
  12. Hu, H.T. and Schnobrich, W.C. (1989), "Constitutive modeling of concrete by using nonassociated plasticity", J. Mater. Civil Eng., 1(4), 199-216. https://doi.org/10.1061/(asce)0899-1561(1989)1:4(199).
  13. Kakaletsis D. Konstantinos D. and Karayannis, C. (2011), "Effectiveness of some conventional seismic retrofitting techniques for bare and infilled R/C frames", Struct. Eng. Mech., 39(4), 499-520, https://doi.org/10.12989/sem.2011.39.4.499.
  14. Kmiecik, P. and Kaminski, M. (2011), "Modelling of reinforced concrete structures and composite structures with concrete strength degradation taken into consideration", Arch. Civil Mech. Eng., 11(3), 623-636. https://doi.org/10.1016/s1644-9665(12)60105-8.
  15. Kupfer, H., Hilsdorf, H.K. and Rusch, H. (1969), "Behavior of concrete under biaxial tresses", ACI J. Proceedings, 66(8), 656-666. https://doi.org/10.14359/7388.
  16. Lu, X., Urukap, T.H., Li, S. and Lin, F. (2012), "Seismic behavior of interior RC beam-column joints with additional bars under cyclic loading", Earthq. Struct., 3(1), 37-57. https://doi.org/10.12989/eas.2012.3.1.037.
  17. Najafgholipour, M., Dehghan, S., Dooshabi, A. and Niroomandi, A. (2017), "Finite element analysis of reinforced concrete beam-column connections with governing joint shear failure mode", Latin Amer. J. Solids Struct., 14(7), 1200-1225. https://doi.org/10.1590/1679-78253682.
  18. Nayal, R. and Rasheed, H.A. (2006), "Tension stiffening model for concrete beams reinforced with steel and FRP bars", J. Mater. Civil Eng., 18(6), 831-841. https://doi.org/10.1061/(asce)0899-1561(2006)18:6(831).
  19. Oudah, F. and El-Hacha, R. (2017), "Joint performance in concrete beam-column connections reinforced using SMA smart material", Eng. Structures, 15(1), 745-760. https://doi.org/10.1016/j.engstruct.2017.08.054.
  20. Pagni, C. and Lowes, L. (2006), "Fragility functions for older reinforced concrete beam-column joints", Earthq. Spectra - 22(1), 215-238, https://doi.org/10.1193/1.2163365.
  21. Rahman M., Halahla A., Algadhib A. and Baluch M. (2014), "Response of CFRP retrofitted exterior beam-column joint under cyclic loading", Proceedings of the 7th International Conference on FRP Composites in Civil Engineering.
  22. Rezaee Azariani H., Esfahani M.R. and Shariatmadar H. (2018), "Behavior of exterior concrete beam-column joints reinforced with Shape Memory Alloy (SMA) bars", Steel Compos. Struct., 28. https://doi.org/10.12989/scs.2018.28.1.083.
  23. Saenz, L.P. (1964), "Discussion of the paper - equation for the stress-strain curve of concrete - by Desayi and Krishnan", ACI J. Proceedings, 61(9), 1229-1235
  24. Santarsiero, G. (2018), "FE Modelling of the seismic behavior of wide beam-column joints strengthened with CFRP systems", Buildings, 8(2), 31. https://doi.org/10.3390/buildings8020031.
  25. Shaaban, I.G. and Said, M. (2018), "Finite element modeling of exterior beam-column joints strengthened by ferrocement under cyclic loading", Case Studies Construct. Mater., 8, 333-346. https://doi.org/10.1016/j.cscm.2018.02.010.
  26. Taqieddin, Z.N., Voyiadjis, G.Z. and Almasri, A.H. (2011), "Formulation and verification of a concrete model with strong coupling between isotropic damage and elastoplasticity and comparison to a weak coupling model", J. Eng. Mech., 138(5), 530-541. https://doi.org/10.1061/(asce)em.1943-7889.0000344.
  27. Tsonos, A. (2007), "Cyclic load behavior of reinforced concrete beam-column subassemblages of modern structures", ACI Struct. J., 104(4), 468-478.
  28. Tsonos, A. (2009), "Performance enhancement of R/C building columns and beam-column joints through shotcrete jacketing", Eng. Struct., 32(2010), 726-740, https://doi.org/10.1016/j.engstruct.2009.12.001.
  29. Tsonos, A. (2014), "An innovative solution for strengthening of old R/C structures and for improving the FRP strengthening method", Struct. Monit. Maintenance, 1(3), 323-338, https://doi.org/10.12989/smm.2014.1.3.323.
  30. Wahalathantri, B.L., Thambiratnam, D.P. and Chan, T. (2011), "A material model for flexural crack simulation in reinforced concrete elements using ABAQUS", Proceedings of the First International Conference on Engineering, Designing and Developing the Built Environment for Sustainable Wellbeing, Brisbane, Australia.
  31. Youssef, M.A., Alam, M.S. and Nehdi, M. (2008), "Experimental investigation on the seismic behavior of beam-column joints reinforced with superelastic shape memory alloys", J. Earthq. Eng., 12(7), 1205-1222. https://doi.org/10.1080/13632460802003082
  32. Zafar, A. and Andrawes, B. (2012), "Incremental dynamic analysis of concrete moment resisting frames reinforced with shape memory composite bars", Smart Mater. Struct., 21(2), 025013. https://doi.org/10.1088/0964-1726/21/2/025013.